• The KIPS Transactions:PartA
• /
• v.16A no.3
• /
• pp.169-180
• /
• 2009

With fixed sinks, the network stability could be improved while the network life time could be decreased by the rapid energy dissipation around the fixed sink because of the concentrated network traffic from sensor nodes to the fixed sink in wireless sensor network. To address this problem, mobile sinks, which decentralize the network traffic, has received a lot of attention from many researchers recently. Since a mobile sink has a limited period to communicate with each sensor nodes, it is necessary for a scheduling algorithm to provide the fairness of data collection from each sensor nodes. In the paper, we propose the new scheduling algorithm, ASF(Availability based Scheduling scheme for Fair data collection), for the fair data collection by a mobile in the sensor networks. The ASF takes account of the distance between each sensor nodes and the mobile sink as scheduling metric, as well as the amount of collected data from each sensor nodes. Experiment results shows that the ASF improves the fairness of data collection among the sensor nodes, comparing to existing algorithm.

• Membrane Journal
• /
• v.14 no.3
• /
• pp.192-200
• /
• 2004

It is an anaerobic germ that Lactobacillus cell concentrated using ceramic membrane has high stability and long lifetime as compared with polymeric membrane. The effects of operating pressure, temperature, crossflow velocity on cell harvesting have been studied. Also the variation of flux and transmembrane pressure (TMP) with increasing concentration ratio and the change of TMP at constant concentration ratio (volumetric concentration factor: VCF) regarding the optimization have been examined. It showed that the permeate flux increased gradually with the increasing of transmembrane pressure, crossflow velocity, and volumetric concentration factor. The higher initial flux was due to the reduction of viscosity at elevated temperature. However, as operating time progressed, the effect of temperature was negligible since the effect of viscosity became minor. As a result, that operate in a constant concentration ratio, decreased degree could know that become slowly although the flux decreases according as operating time progressed. The flux is a very stable in the condition of constant VCF range. The yield of Latobaciilus (PS 406) which was cultivated at $37^{\circ}C$ was concentrated about 4.9{\times}10^9$ after operation.

• Microbiology and Biotechnology Letters
• /
• v.28 no.3
• /
• pp.180-184
• /
• 2000

Tn order to be helpful to control dispersed microorganisms for stabLlization of wastewater treatment in a paper-makillg process, dominant strains were isolated aerobically and anaerobically. and identified and physiological characteristics were also analyzed. Pseudomonas carboxydohydrogena, Cardiobacten'm hominis, lvIicrococcus lylae, XanfomonCls campestris p" juglandis, Micrococcus diversus, and Comamonas terrigencl as aerobic dominants, and Streptococcus bovis and Prevotella buccae as anaerobIc dominants were identified fi'om the supernatent of the primary settling tank. It seemed that microflora in the treatment process would consist of many kinds of microorganisms, whose dominant would change easily according to environmental conditions, They all grew well at $37^{\circ}C$ and at different initial medium pH's. Especially, some of them required sulfate ion for their growth, which came from a chemical coagulant of aluminium sulfate in the primary settling tank. Interestingly. many anaerobes grew well even in the aerobic wastewater treatment process and seemed to have some functions. Population of anaerobes increased three times in the supematant of primary settling tank and ten times in Lhe bottom sludge of primary settling tank than in the prime wastewater. Therefore, these anaerobes contributed to the producH tion of offensive gases, which would make some microorganisms not precLpitate and be buoyant.

• The korean journal of orthodontics
• /
• v.36 no.1 s.114
• /
• pp.55-62
• /
• 2006

Orthodontic mini-implants, despite its usefulness as anchorage, have some limits such as loosening. Therefore, various shapes and lengths have been studied. The aim of this study is to analyze the shape and length of mini-implants mechanically. The shapes of mini-implants (1.6 mm, Dual Top, Jeil Medical Co., Seoul, Korea) were cylindrical and taper. The lengths of mini-implants were 6 mm and 8 mm. The tested groups were 5 groups (cylindrical 6 mm, cylindrical 8 mm, taper 6 mm, taper 8 mm and taper 8 mm modified whose thread is reduced from the middle to upper part). All were inserted and removed on the polyurethane foam with the torque measured. During insertion and removal, the taper shape needed higher torque than the cylindrical shape, and the 8 mm length than the 6 mm length (p<0.001). The taper 6mm group showed superior insertion torque (p<0.001) and similar removal torque to the cylindrical 8 mm group. The taper 8 mm modified group with gradually reduced threads, showed continuous high removal torque after the peak. The initial mechanical stability can be provided by the tapered shape and also, affected by length and thread design.

• Microbiology and Biotechnology Letters
• /
• v.29 no.4
• /
• pp.206-211
• /
• 2001

In order to overexpress constitutively the Kluyveromyces marxianus exoinulinase gene (INUI) in Saccharomyces cerevisiae, four episomal expression systems employing GAPDH, ADHI, PGK and ENOI promoters were constructed as p YIGP aADHI -INU, pPGK-INU, and pENOI- INU plasmids respectively, When S cereviais transformants harboring each plasmid were batchwisely cultivated in the fermentor containing 5% glucose medium no significant differences in the cell growth are observed How- ever the experession level of exoinulinase and plasmid stability showed a strong dependency on the promoter employed. The expression levels of exoinulinase were about 1.70 unit/ml for GAPDH promoter 1.67 unit/ml for PGK promoter, 1.29 unit /ml for ADH1 promoter, and 0.80 unit/ml for ENOl promoter. The plasmid stabilites were maintaines above 80% in all experession systems. except the GAPDH promoter system of 55%, Based on the plas- mid stability and expression level of exoinulinase the ADHl and PGK promoter system were selected for the fed - batch culture to overproduce exoinulinase By the intermittent feeding of yeast extract and glucose, both promoter systems gave the cell concentration of about 30 g-dry cell weight/1 byt the maximal exoinulinase activity of 3.70 unit/ml and plasmid stability of 96% in the ADH1 promoter were higher than those (2.70 unit/ml, 80%) of PGK sys- tem Taking into account the plasmid stability and extended culture time the ADH1 promoter systems would be the most feasible expression systems for the constitutive overproduction of exoinulinase through high cell-density fed- batch cultures using non-selective rich medium.

• Korean Journal of Remote Sensing
• /
• v.22 no.6
• /
• pp.469-483
• /
• 2006

An algorithm was developed to estimate stability indices (SI) over the Korean peninsula using Terra Moderate Resolution Imaging Spectroradiometer (MODIS) infrared brightness temperatures (TBs). The SI is defined as the stability of the atmosphere in the hydrostatic equilibrium with respect to the vertical displacements and is used as an index for the potential severe storm development. Using atmosphere temperature and moisture profiles from Regional Data Assimilation and Prediction System (RDAPS) as initial guess data for a nonlinear physical relaxation method, K index (KI), KO Index (KO), lifted index (LI), and maximum buoyancy (MB) were estimated. A fast radiative transfer model, RTTOV-7, is utilized for reducing the computational burden related to the physical relaxation method. The estimated TBs from the radiative transfer simulation are in good agreement with observed MODIS TBs. To test usefulness for the short-term forecast of severe storms, the algorithm is applied to the rapidly developed convective storms. Compared with the SIs from the RDAPS forecasts and NASA products, the MODIS SI obtained in this research predicts the instability better over the pre-convection areas. Thus, it is expected that the nowcasting and short-term forecast can be improved by utilizing the algorithms developed in this study.

• Journal of Yeungnam Medical Science
• /
• v.23 no.1
• /
• pp.19-25
• /
• 2006

Background: There is limited data on comparisons between the effect of histidin-etryptophan-ketoglutarate (HTK) solution and cold blood cardioplegic (CBC) solution in pediatric cardiac surgery. The purpose of this study was to compare the myocardial protective effect of HTK solution and CBC solution in patients undergoing pediatric cardiac surgery. Materials and Methods: We selected 49 patients with ventricular septal defect and atrial septal defect. HTK solution was used in 21 patients and CBC solution was used in 28 patents. HTK solution was given as a single dose, whereas CBC solution was used in the usual multi-dose method. The incidence of EKG change and concentration of Troponin T and CK-MB were compared for the evaluation of myocardial damage. Results: There were no significant differences in the incidence of ST, T segment change by EKG and serial cardiac enzyme levels between two groups. Conclusion: These results suggested that the myocardial protective effect of HTK solution was similar to CBC solution in simple pediatric cardiac surgery.

• Microbiology and Biotechnology Letters
• /
• v.15 no.2
• /
• pp.122-128
• /
• 1987

Lipases from Candida rogosa and Rhizopus arrhizus were immobilized by entrapment with photo-crosslinkable resin prepolymer for the study of fat splitting and interesterification in isooctane-two phase system. Dioctylsulfosuccinate was selected as the most suitable surfactant during the immobilization. Lipase entrapped with hydrophobic photo-crosslinkable resin prepolymer(ENTP-3000) exhibited the highest activity, whereas lipase entrapped with hydrophilic gel(ENT-4000) was more stable in organic solvent. As the degree of hydrophobicity of the immobilization matrix was increased, Vm(app) of the lipase entrapped was increased, but Km(app) was approximately constant. While the optimum pH of the lipases entrapped on hydrophilic gel (ENT-4000) were around pH 7.0 for Candida lipase and Rhizopus lipase, the reaction rate of the lipases entrapped on hydrophobic gel were less dependent on pH variations for short reaction time. However, for longer reaction time, the lipnses from C. rugosa and R. arrhizus entrapped on hydrophobic gel yielded maximum rate at pH 6.0 and 6.5, respectively, Entrapment method endowed the lipase with thermal stability.

• Journal of Wetlands Research
• /
• v.22 no.2
• /
• pp.161-170
• /
• 2020

Constructed wetlands (CWs) are widely used to solve water quality problems caused by diffuse pollution from agricultural areas; however, phytoplankton blooms in CW systems can occur due to long hydraulic retention time (HRT), high nutrient loading, and exposure to sunlight. This study was conducted to evaluate the efficiency of a CW designed to treat agricultural diffuse pollution and develop a design concept to improve the nature-based capabilities of the system. Monitoring was conducted to assess contribution of individual wetland components (i.e. water, sediments, and plants) in the treatment performance of the system. During dry days, the turbidity and particulates concentration in the CW increased by 80 to 197% and 10 to 87%, respectively, due to the excessive growth of phytoplankton. On storm events, the concentration of particulates, organics, and nutrients were reduced by 43% to 70%, 22% to 49%, and 15% to 69% due to adequate water circulation and constant flushing of pollutants in the system. Based on the results, adequate water circulation is necessary to improve the performance of the CW. Free water surface CWs are usually designed to have a constant water level; however, the climate in South Korea is characterized by distinct dry and rainy seasons, which may not be suitable for this conventional design. This study presented a concept of multifunctional design in order to solve current CW design problems and improve the flood control, water quality management, and environmental functions of the facility.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.19 no.6
• /
• pp.959-972
• /
• 2017

In evaluation of blast-induced vibration, peak particle velocity (PPV) is generally calculated by using attenuation relation curve. Calculated velocity is compared with the value in legal requirements or the standards to determine the stability. Attenuation relation curve varies depending on frequency of test blasting, geological structure of the site and blasting condition, so it is difficult to predict accurately using such an equation. Since PPV is response value from the ground, direct evaluation of the structure is impractical. Because of such a limit, engineers tend to use the commercial numerical analysis program in evaluating the stability of the structure more accurately. However, when simulate the explosion process using existing numerical analysis program, it's never easy to accurately simulate the complex conditions (fracture, crushing, cracks and plastic deformation) around blasting hole. For simulating such a process, the range for modelling will be limited due to the maximum node count and it requires extended calculation time as well. Thus, this study is intended to simulate the elastic energy after fractured zone only, instead of simulating the complex conditions of the rock that results from the blast, and the analysis of response characteristics of the velocity depending on shape and size of the fractured zone was conducted. As a result, difference in velocity and attenuation character were calculated depending on fractured zone around the blast source appeared. Propagation of vibration tended to spread spherically as it is distanced farther from the blast source.