• Proceedings of the Korea Water Resources Association Conference
• /
• 2004.05b
• /
• pp.424-428
• /
• 2004

본 연구는 장기하상변동, 단면축소세굴, 국부세굴로 일반적으로 분류되는 세굴형태 중 국부세굴의 방지를 위하여 교자 전면에서 발생하는 하강류를 차단함으로써 교각 및 교각기초를 세굴로부터 보호하여 세굴심을 감소시키기 위한 실험적 인구로서, 동시에 경제성을 확보하는 것을 목적으로 한다. 교각의 기초부의 전면에 유수방향과 대응되도록 세굴방지구조물을 설치하여 세굴방지구조물의 상부 끝단에 하강류를 방지하기 위하여 차단각을 주었고 세굴방지구조물의 폭은 교자의 폭을 고려하여 설계하였다. 이러한 세굴방지구조물은 기초에 하강류 차단 방지시설을 설치하여 세굴심의 방지효과가 약 $20\~40\%$로 나타났으며 기존의 교자기초에 설치하던 매트 및 사석보호공에 비해 경제적 시공이 가능하며, 지속적인 효과를 볼 수 있었다.

• Proceedings of the Computational Structural Engineering Institute Conference
• /
• 2010.04a
• /
• pp.183-186
• /
• 2010

교각에서의 기초세굴 단계 및 상부구조물의 영향에 따른 진동특성을 파악하기 위해 교각 시험체를 이용하여 충격진동실험과 Midas FEA ver.2.0를 이용한 유한요소해석을 수행하였다. 기초세굴 모의는 교각시험체 기초 주위의 지반을 단계별로 굴착하였으며, 상부구조물의 영향은 철근콘크리트 블록을 제작하여 교각 시험체 위에 재하하였다. 충격진동실험과 수치해석결과, 강성이 작아지거나 질량이 커질수록 1차 모드 고유진동수도 작아지는 등 유사한 경향을 나타내었다. 대체적으로 충격진동실험으로 구한 1차모드 고유진동수는 수치해석으로 구한 값보다 작은 경향을 나타내었으며, 이는 지반의 강성변화를 수치해석 모델에서 연속적으로 반영하지 못하는 한계로 인해 발생한 오차로 판단된다. 따라서 1차 모드 고유진동수의 변화를 이용한 교각 세굴 건전성 평가를 위한 유한요소해석을 위해서는 지반물성을 보다 잘 모의할 수 있는 기법의 개발이 필요하였다.

• 한국방재학회:학술대회논문집
• /
• 2009.02b
• /
• pp.132.1-132.1
• /
• 2009

• Journal of the Earthquake Engineering Society of Korea
• /
• v.5 no.4
• /
• pp.83-95
• /
• 2001

Scale model tests were performed to investigate the seismic behavior and capacity of reinforced concrete piers that were not detailed for seismic load. The prototype pier is of solid circular section. Additional lateral reinforcing bars were not provided that might be required for the confinement. Two kinds of reinforcement details are considered for the vertical longitudinal reinforcing bars: lap spliced and continuous. In the case of lap spliced model all the longitudinal bars were lap spliced at the same height in the bottom plastic hinge zone. Three specimens were constructed and subjected to quasi-static cyclic lateral loading while the vertical load held constant. Non-ductile failure modes were observed in the test of lap spliced models but limited ductile behavior was observed in the test of a continuous longitudinal reinforcement model.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.11a
• /
• pp.109-112
• /
• 2008

It has better seismic performance and construction performance in precast column than in conventional RC column. In this research, seismic performances of precast column are analyzed by OpenSEES. Main variables of analysis are concrete strength, jacking ratio of tendon, amount of tendon and size of segment. As the amount of tendon and jacking ratio are increased, the flexural strength is also increased. And there is very little effect as it varies concrete strength and size of segment. But high initial jacking ratio leads to early yielding of tendon. And it is considered that a size of segment is related on construction problem. And also, strain in core concrete is less than ultimate strain. Consequently, it is considered that the amount of transverse steel will be reduced.

• Journal of the Korea Concrete Institute
• /
• v.18 no.6 s.96
• /
• pp.711-720
• /
• 2006

The structural behavior of concrete girder in bridges constructed by free cantilever method is time-dependent due to creep and shrinkage of concrete. The constraint effects of longitudinal movement of concrete girders can introduce unfavourable moment into piers. This study is aimed at proposing a method to reduce the moment of piers in bridge constructed by free cantilever method. The method are systematically composed of time-dependent structural analysis of bridges and loading of control force during construction of bridge. Numerical analyses are carried out depending on the parameters such as amount of control force and flexibility of pier. Time-dependent structural behavior shows that moment of pier increases according as pier height decreases. Also, moment of pier decreases when control method are applied. Numerical result of the study represents that time-dependent moment of piers can be controlled effectively by employing the proposed method.

• Journal of Korea Water Resources Association
• /
• v.33 no.4
• /
• pp.385-392
• /
• 2000

An experimental investigation was conducted to determine the effect of a nonuniform pier on the stability of riprap placed around bridge piers. A nonuniform pier is one of which the cross-sectional dimension varies over the length of the pier and comprises a cylinder of diameter bp placed on a larger diameter of foundation bf. and the stability of riprap are significantly influenced by the height of foundation z. The critical height of foundation is defined as the height of foundation which has the same critical velocity to that of uniform pier without foundation, and it was found to be zc=0.8bf. For z

• Journal of the Korean Society of Hazard Mitigation
• /
• v.3 no.2 s.9
• /
• pp.147-154
• /
• 2003

In this study, hydraulic characteristics around bridge piers were analyzed with and without collar through a hydraulic model experiment. The analysis of stage variation in front and back side of pier showed that collar installation did not function as obstacle to the stream flow. Little variation of water level between front and back sides of pier was observed before and after collar installation(0.2cm in front side and 0.1cm in back side of pier). Also, result that analyze velocity variation in front and back side of pier, lateral velocity(u) and transverse(v) before and after collar installation exhibited no alteration in the front and back side of pier. About 16.72% and 15.83% of vertical velocities(w) were reduced for the condition of y/d=0.33 in the front side of pier and y/d=0.67 in the back side of pier, respectively. This experimental results suggest that the collar installation around pier can minimize the local scouring depth by preventing the downflow that cause the pier scour.

• Journal of the Korean Geotechnical Society
• /
• v.35 no.7
• /
• pp.5-14
• /
• 2019

In this study, a prototype abutment was constructed to establish a safety assessment technique of pier and a series of non-destructive tests using impact load. The surcharge load was loaded from 0 tonf to 2.5 tonf on the prototype abutment, and maximum surcharge load was up to 25 tonf. To analyze the behavior of the piers according to the direction of impact, a total of three types of analysis were performed: the direction of the pier, the direction perpendicular to the pier, and the outer direction of the pier. The height of the impact was also tested at each top and bottom. The measuring instrument used an accelerometer to measure the acceleration response when impacted. Based on the series of experimental results, specific values were calculated according to the direction of an impact and the surcharge load using the Fast Fourier Transform (FFT). In addition, the phase difference was used to analyze the pier from the primary 1st mode to the 4th mode.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.25 no.6
• /
• pp.143-153
• /
• 2021

The corroded pier that has corrosion of the tranverse steel, main steel and lapsplice directly affects the seismic performance. The corrosion of the tranvese and main steel directly reduce the shear strength and bendig strength. If steel corrosion occurs in lap splice, the flexural strength and flexibility of existing corroded pier that are not seismic design are significantly reduced. In addition, as the axial force acting on the pier increase the shear strength. Considering these effects. In this stuydy, we cosidered steel corrosion, lap splice and axial force, for a reasonable evaluation of seismic-performance. It is confirmed that flexular failure occurs at pies where shear failure is expected to occur due to corrosion of reinforcement. These failure modes and their reason are analyzed, and necessary considerations are presented for seismic reinforcement.