• Journal of the Korean Society of Food Science and Nutrition
• /
• v.34 no.4
• /
• pp.567-571
• /
• 2005

In this study, the effects of varying the amount of water, soaking time at $25^{\circ}C$ and drying time after soaking at $45^{\circ}C$ on the induction of resveratrol were evaluated to optimize the soaking treatment by response surface methodology (RSM). After response surface regression (RSREG), the second-order polynomial equation was fitted to the experimental data. The analysis of variance showed that the model appeared to be adequate $(R^2=0.9547)$ with no significant lack of fit (p>0.1). From statistical analysis, amount of water and soaking time were found to be significant factors. On the other hand, drying time was not significant. Ridge analysis showed that the optimized parameters were $67.15\%$ for amount of water, 19.58 hr for soaking time, 65.56 hr for drying time. It was confirmed that resveratrol content was increased from $0.1\;{\mu}g/g$ to $4.55\;{\mu}g/g$ under the optimized conditions. In addition, the experimental values at the optimized condition agreed with values predicted by ridge analysis. The analytical method validation parameters such as accuracy, precision, and specificity were calculated to ensure the method's validity.

• Analytical Science and Technology
• /
• v.25 no.1
• /
• pp.83-90
• /
• 2012

The objective of the study was to estimate the measurement uncertainty associated with determination of creatinine (Cr) in urine samples by liquid chromatography-tandem mass spectrometry (LC-MS/MS). Centrifuged urine samples (10 ${\mu}L$) were diluted with 390 ${\mu}L$ of distilled water. To 20 ${\mu}L$ aliquots of diluted urine samples, 30 ${\mu}L$ of internal standard solution (Cr-$d_3$, 5 ${\mu}g/mL$) and 10 ${\mu}L$ of acetonitrile were added and filtered. The samples (1 ${\mu}L$) were introduced into LC-MS/MS with no further pretreatment. Cr was separated on a multi-mode ODS column (Scherzo SM-C18, 75 ${\times}$ 2.0 mm I.D., 3 ${\mu}m$) and quantified by LC-MS/MS operating in MRM mode (Cr, m/z 114.0${\rightarrow}$ 86.0; Cr-$d_3$, m/z 117.0${\rightarrow}$ 89.1). The four factors that contribute uncertainty to the final result were extracted and evaluated. The principal factors of contribution to combined standard uncertainty were sample dilution, calibration curve and repeatability, while the preparation of standard solution was only a minor factor. Relative extended uncertainty of the measured concentration was 14.2% in a real urine sample.

• Journal of Korean Society of Transportation
• /
• v.27 no.4
• /
• pp.167-173
• /
• 2009

It is important to study on the traffic accident severity reduction because traffic accident is an issue that is directly related to human life. Therefore, this research developed countermeasure to reduce traffic accident severity considering various factors that affect the accident severity. This research developed the Accident Severity Prediction Model using the collected accident data from Seohaean Expressway in 2004~2006. Through this model, we can find the influence factors and methodology to reduce accident severity. The results show that speed limit violation, vehicle defects, vehicle to vehicle accident, vehicle to person accident, traffic volume, curve radius CV(Coefficient of variation) and vertical slope CV were selected to compose the accident severity model. These are certain causes of the severe accident. The accidents by these certain causes present specific sections of Seohaean Expressway. The results indicate that we can prevent severe accidents by providing selected traffic information and facilities to drivers at specific sections of the Expressway.

• Journal of the Korean Vacuum Society
• /
• v.11 no.3
• /
• pp.183-188
• /
• 2002

In the present study AI$(CH_3)_3)$films were deposited by the ALD technique using trimethylaluminum(TMA) and ozone to improve the quality of the AI$(CH_3)_3)$ films, since the $OH^-$ radicals existing in the AI$(CH_3)_3)$ films deposited using TMA and $H_2O$ degrade the physical and the dielectric properties of the AI$(CH_3)_3)$ film. The XPS analysis results indicate that the $OH^-$ radical concentration in the AI$(CH_3)_3)$film deposited using $O_3$is lower than that using $H_2O$. The etch rate of the AI$(CH_3)_3)$film deposited using $O_3$is also lower than that using $H_2O$, suggesting that the chemical inertness of the former is better than the latter. The MIS capacitor fabricated with the TiN conductor and the $Al_2$O$_3$dielectrics formed using $O_3$offers lower leakage current, better insulating property and smaller flat band voltage shift $({\Delta}V_{FB})$.

• The Korean Journal of Nuclear Medicine Technology
• /
• v.12 no.1
• /
• pp.62-65
• /
• 2008

Purpose: Vitamin $B_{12}$ and folic acid are type of water-soluble vitamin and those work as a secondary vital enzyme, but especially those are involved in the nuclear DNA synthesis. Those are mainly measured in order to diagnose megaloblastic anemia and to assess the storage of folic acid during pregnancy. It is generally known that the hemolyzed serum is useless for folic acid and vitamin $B_{12}$, but it is not easy to abide by this information because our lab (Samkwang Medical Laboratories) is reference laboratory. We tested how much the extent of hemolyzed serum had influence on the results. Materials and Method: We performed the tests of vitamin $B_{12}$, folic acid. For the hemolysis effect study, we used 40 cases. According to the level of A, B and C groups, each group had 10 samples which were mechanically hemolyzed serum. Results: Hemolysis did not affect the vitamin $B_{12}$ results. However in case of folic acid, the value increased according to the degree of hemolysis. And severe hemolyzed cases had the highest value (greater than 20 ng/ml). Conclusions: Preventing the hemolysis, it has to be informed that blood-collecting, separation and storage are performed more carefully. As you see from the above results, hemolyzed serum is not proper for folic acid test, and hemolysis does not affect the results of vitamin $B_{12}$. However, for the more accurate results, it is necessary to avoid hemolysis.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.37 no.2
• /
• pp.78-84
• /
• 2001

Escape behaviour of the anchovy (Engralius japonica, total length 4-7cm) at the inside wing net and bag net in the anchovy boat seine was observed by underwater video camera in order to clarify the relationship between visual stimulus of the gear or relative water flow inside gear and reacting behaviour. The vertical attenuation coefficient of underwater illuminance in the offshore of Keoje island and Tongyoung was ranged from 0.24 to 1.03 and it could be affect visual range and visual contrast of the fishing gear. The relative water flow at the joint part between inside wing and bagnet while towing was 1.5 times higher than at the middle part of inside wing or fore part of bag net, but it was estimated under than maximum swimming speed of 4-7 cm anchovy. The mean escaping number of anchovy from end part of inside wing of 30 cm mesh to out side for a minute within visual range of video camera was 455 and anchovy swimming forward from bag net through flapper was 308. These results revealed anchovy could escape as voluntary response in spite of higher visual stimulus or higher water flow.

• Radiation Oncology Journal
• /
• v.17 no.3
• /
• pp.223-229
• /
• 1999

Purpose : The expression pattern of c-jun by ionizing radiation according to cell growth state (exponential growth vs. stationary phase) and its relationship with cell cycle redistribution were investigated. Materials and Methods : The exponential growth phase (day 4) and stationary phase (day 9) cells were determined from cell growth curve according to the elapse of days in CaSki. The cells were irradiated using 6 MV X-ray with a dose of 2 Gy at a fixed dose rate of 3 Gy/min. Northern blot analysis was peformed with total cellular RNA and cell cycle distribution was analyzed using flow cytometry according to time-course after irradiation. Results : The maximum expression of c-jun occurred 1 hour after irradiation in both exponential growth and stationary phase cells. After then c-jun expression was elevated upto 6 hours in exponential growth phase cells, but the level decreased in stationary phase cells. Movements of cells from G0-G1 to S, G2-M phase after irradiation were higher in exponential growth phase than stationary phase. Conclusion : c-jun may be involved in the regulation of cellular proliferation according to the growth states after irradiation.

• Journal of the Korean Society of Radiology
• /
• v.10 no.4
• /
• pp.233-239
• /
• 2016

Comparison of the dose aspect that radiation therapy treatments using IMRT, tomotherapy, mArc (modulated arc therapy). The experimental subject is non-small cell lung cancer patient. The prescription dose is 58.0 Gy to the volume of PTV(planning target volume). and spinal cord, esophagus, and liver organ is the normal organ(OAR, organ at risk). Average PTV value is 57.60 Gy in mArc and 61.04 Gy in tomotherapy and 58.95 Gy in IMRT. The average dose of the Esophagus is 2.84 Gy in m-Arc, 5.14 Gy in tomotherapy, 1.84 Gy in IMRT. The average dose of the Liver is 19.44 Gy in m-Arc, 12.22 Gy in tomotherapy, 21.97 Gy in IMRT. The average dose of the Spinal cord is 5.72 Gy in m-Arc, 7.08 Gy in tomotherapy, 6.15 Gy in IMRT. Results of this study is no significant difference between mArc and tomotherapy and Linac based IMRT in dose study and also, mArc's dose coverage and dose volume histogram is better than IMRT and tomotherapy. but, This study is limited to a disease of cancer. in addition, fewer number of groups. The wide range the more research can be developed patient-specific treatment techniques and be applied to the patients

• Journal of the Korean Vacuum Society
• /
• v.22 no.1
• /
• pp.37-44
• /
• 2013

In order to investigate an influence of carrier trap by quantum dots (QDs) on the solar parameters, in this study, the $p^+-QD-n/n^+$ solar cells with InAs/GaAs QD active layers are fabricated, and their characteristics are investigated and compared with those of a GaAs matrix solar cell (MSC). Two different types of QD structures, the Stranski-Krastanow (SK) QD and the quasi-monolayer (QML) QD, have been introduced for the QD solar cells, and the parameters (open-circuit voltage ($V_{OC}$), short-cirucuit current ($I_{SC}$), fill factor (FF), conversion efficiency (CE)) are determined from the current-voltage characteristic curves under a standard solar illumination (AM1.5). In SK-QSC, while FF of 80.0% is similar to that of MSC (80.3%), $V_{OC}$ and $J_{SC}$ are reduced by 0.03 V and $2.6mA/cm^2$, respectively. CE is lowered by 2.6% as results of reduced $V_{OC}$ and $J_{SC}$, which is due to a carrier trap into QDs. Though another alternative structure of QML-QD to be expected to relieve the carrier trap have been firstly tried for QSC in this study, it shows negative results contrary to our expectations.

• Journal of Korea Water Resources Association
• /
• v.31 no.1
• /
• pp.3-12
• /
• 1998

Rainfall intensity under storms affects peak discharge or its time of occurrence in watershed runoff. Thus, it is reasonable to reflect the effect on the parameters of rainfall-runoff models or the governing equations of the models. This paper relates the change of the runoff coefficient of the first tank in tank model to rainfall intensity under storms. The standard four tanks have made the basic structure of the flood event model. and its modifications are as follows: it has two equal runoff coefficients in the first tank: the runoffs from first and second tanks produce delayed response through a simple delaying parameter. Applying the event simulation model to flood data from Naerinchon. runoff coefficients were estimated and their relation to rainfall intensity was analyzed. The results showed the Weak relation of the two factors. The trend of the two was fitted with the equation a1=kI$. where a1is the runoff coefficient of the first tank: I is rainfall intensity; k and m are fitting coefficients. In the verification. the model used moving averages for the calculation of I(t). If the value I(t) gave more greater value of a1(t) than that of previous time(t-1). the flood simulation was performed again from the beginning with the updated greater value of a1. The reflection of rainfall intensity on the runoff coefficient showed far better results than that of a fixed parameter.