• Korean Journal of Food Science and Technology
• /
• v.47 no.6
• /
• pp.725-732
• /
• 2015

This study was conducted to compare the physicochemical and sensory characteristics of beef-bone broths prepared under atmospheric pressure (BBAP) and overpressure (BBOP). Beef-bone was boiled in water (bone/water=1:2, w/w) for 1, 2, 4, 6, and 12 h under atmospheric pressure and overpressure ($121^{\circ}C$, 1.25 atm). The BBOP broth samples were found to contain significantly higher amounts of solid, crude protein, crude ash, collagen, and chondroitin sulfate than the BBAP broth samples for a given boiling time (p<0.05). In addition, the Ca and Mg contents in the BBAP samples were higher than those in the BBOP samples, whereas the P, Na, and K contents were higher in BBOP than BBAP. The L value of BBAP was also significantly higher than that of BBOP (p<0.05). Further, as the boiling time increased, turbidity increased in the BBAP samples. In the quantitative descriptive analysis, the BBOP samples exhibited stronger brownness, transparency, meaty off-odor, meaty off-flavor, and sulfuric odor than the BBAP samples.

• The korean journal of orthodontics
• /
• v.26 no.4
• /
• pp.449-454
• /
• 1996

The propose of this study was to evaluate the difference of cellular activity dependent on intermittent compressive force by determining the alkaline phosphatase activity. Alkaline phosphatase activity was measured on control and experimental groups every 24, 48, 72hours. Experimental groups consisted of continous and intermittent compressive group which were compressed by $300gm/cm^2$ of diaphram pump. The intermittent compressive group was connected by timer which was worked on 10 minutes an off 10 minutes. The results were as follows; 1. The alkaline phosphatase activity between control and experimental groups showed not significant difference at compressed 24 hours. 2. The alkaline phosphatase activity of experimental groups were more increased than control group at compressed 48 hours. 3. The alkaline phosphatase activity of intermittent compressive group showed significant increased to control group. Whereby continuous compressive group showed not significant difference to control at 72 hours. 4. The alkaline phosphatase activity of intermittent compressive group were stringly increased than continuous compressive groups. 5. Between experimental groups and control group no other morphologic changes were detected by microscopic findings.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1996.05a
• /
• pp.594-601
• /
• 1996

가압기고압력 원자로정지여유도(high pressurizer pressure trip margin)에 영향을 주는 요인들에 대한 민감도 분석을 울진 3,4호기 성능해석코드인 LTCUCN computer code틀 이용하여 수행하였다. 그 결과, 초기 가압기압력, 증기우회제어계통의 quick open지연시간, 터빈우회밸브의 quick opening시간, 원자로출력 감발계통의 용량, 원자로출력감발 제어붕 낙하시간, 가압기 살수작동 설정치 둥이 완전부하상실시 가압기압력을 상승시키는 주요인자임을 알 수 있었으며, 증기우회제어계통 및 가압기살수계통의 용량은 최대 가압기 압력에 미치는 영향이 미미한 것으로 판명되었다. 울진 3,4호기의 참조발전소인 영광 3,4호기의 as-built 자료를 토대로 울진 3,4호기의 원자로정지여유도를 계산한 결과 울진 3,4호기는 완전부하상실사건시 37 psi의 정지여유도를 가질 수 있는 것으로 판단된다. 그러나, 원자로출력감발계통이 있는 ABB-CE type의 울진 3,4호기에서는 완전부하상실사건보다 원자로출력감발계통이 동작하지 않는 부하감발사건이 최대 가압기 압력치를 유발하는 사건이고, 다양한 부하상실사건중에도 운전여유도는 확보하고 있음을 알 수 있었다.

• The korean journal of orthodontics
• /
• v.27 no.4 s.63
• /
• pp.599-605
• /
• 1997

The propose of this study was to evaluate the effect of cellular activity on PDL cells dependent on intermittent and continuous compressive force by determining the alkaline phosphatase activity. An intermittent and continuous compressive forces were applied on PDL cells at the confluent stage. The alkaline phosphatase activity was measured on control and experimental groups every 24, 48, 72hours. The experimental group were consist of continuous and intermittent compressive group which were compressed by $300g/cm^2$ of diaphram pump. The intermittent compressive group was connected by timer which was worked on 10 minutes and off 10minutes. The results were as follows ; 1. The alkaline phosphatase activity of intermittent compressive group was lower than control group at 24 hours(P<0.05). 2. The alkaline phosphatase activity between each groups showed no significant differences at 48hours. 3. The alkaline phosphatase activity of continuous compresssive group was significantly higher than control group at 72 hours(P<0.01).

• Electrical & Electronic Materials
• /
• v.6 no.5
• /
• pp.446-453
• /
• 1993

초기충진압력이 서로 다른 시편에 가한 가압횟수와 열처리시간의 혼합공정이 임계전류밀도 특성에 미치는 영향을 관찰하기 위하여 power-in-tube방법으로 초전도 선재를 제조하였다. 일정 초기충진압력에서 테이프화를 위한 열처리 및 가압이 혼합공정횟수가 증가할수록 임계전류밀도가 증가하였다. 초기충진압력이 1000kg/$cm^{2}$에서 Bi-2223 고온상 체적비가 가장 높게 나타났고 결정립이 판상으로 성장되었을 뿐만 아니라 C축과 직각방향으로 잘 배양되어 있음을 관찰할 수 있었다. 특히 초기충진압력 1000kg/$cm^{2}$의 시편을 두께를 줄이기 위하여 3회 가압하고 450시간 열처리하였을때 임계전류밀도가 5800A/$cm^{2}$를 나타내었으며 이를 중심으로 500, 2500kg/$cm^{2}$이 양측단으로 가우시안분포를 보였다. 결론적으로 시편의 임계특성은 적정 초기충진압력, Bi-2223 고온상 체적비, 테이프화를 위한 가압횟수, 결정의 일방향배열, 결정립의 성장등에 강하게 의존함을 알 수 있었다.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.16 no.6
• /
• pp.79-84
• /
• 2012

An experiment of rapid pressurization-induced crack propagation of solid propellant was conducted by using a windowed test chamber. A pre-cracked specimen of solid propellant is installed in the chamber, and highly compressed nitrogen gas in an accumulator pressurizes the chamber until the chamber pressure reaches set-up pressure to make the chamber depressurization. Pressure-time trace was obtained from the experimental result, and pressurization rate was defined from the trace. In this study, three pressurization rates (64.34, 73.86 and 85.44 MPa/s) are considered, and propagation lengths are measured. Also, a progression of the crack propagation recorded by a high-speed digital camera is presented.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2018.05a
• /
• pp.290-290
• /
• 2018

본 연구에서는 수충격으로 발생할 수 있는 실제 상수도관망의 피해율을 신뢰성해석을 통해 정량적으로 비교분석하였다. 이를 위해서 먼저 실제 상수관망에 대한 수충격해석을 수행하였는데 기존의 가압장 운영조건을 적용하였고 가압장의 선택운영조건을 변경하여 수충격해석을 수행하였다. 이 결과물을 토대로 신뢰성해석을 수행하였고 두 조건에 대하여 정량적인 파괴확률을 산정할 수 있었다. 본 연구에서 사용된 실제 상수관망은 가압장의 운영조건으로 24시간 75m 수두를 유지하고 있으며 관말단부의 수용가에 충분한 유량이 전달되고 있다. 가압장의 고압유지는 관말부에는 적정할 수 있으나 상수도관망에서 누수와 시설물에 대한 많은 피해를 유발할 수 있다. 따라서 본 연구에서는 가압장의 펌프압력수두를 75m와 65m로 선택적 운영을 가정하였다. 이로 인한 관말부의 압력이 수도압력으로 충분한 15m를 계속 유지하는 것을 확인하였으며 수돗물 사용량이 적은 야간에는 가압장의 수두를 낮추는 방법으로 선택적 운영조건을 사용하였다. 기존 가압장의 운영조건과 선택적 운영조건을 사용하여 수충격해석을 수행하였고 신뢰성 해석모형을 사용하여 파괴확률을 정량적으로 산정할 수 있었다. 가압장의 운영조건을 최적화하여 효율은 증대하고 피해율을 저감할 수 있는 방법을 찾을 수 있었다, 이를 위해서 가압장의 인버터 설치는 물론이고 펌프의 최적운영을 위한 프로그램을 장착하여 가압장을 운영한다면 보다 경제적인 운영이 될 수 있을 뿐만 아니라 실제 상수관망에서 발생할 수 있는 여러 가지 피해를 최소화할 수 있을 것으로 판단된다.

• Journal of the Korean Ceramic Society
• /
• v.37 no.12
• /
• pp.1146-1149
• /
• 2000

표면윤활층 처리와 540 MPa 까지의 진공가압성형을 통하여 나노 TiO$_2$과립 분말의 가압성형공정에서 나타나는 접합압력을 확인하였으며, 접합압력 상하에서 제조된 시편의 소결특성을 $700^{\circ}C$ 등온 소결을 통하여 분석하였다. 접합압력 이상에서 가압성형한 성형체를 $700^{\circ}C$에서 48시간 소결하여 96%의 높은 소결밀도와 112 nm의 평균 결정립 크기를 얻었다.

• Journal of the Korean Wood Science and Technology
• /
• v.28 no.1
• /
• pp.42-47
• /
• 2000

This study was designed to investigate the effect of treatment variables on CCA treatment of Japanese red pine (Pinus densiflora), Japanese larch (Larix leptolepis), and ezo spruce (Picea jezoensis) round posts. Variables included were duration of initial vacuum (30, 45, or 60 minutes) and maximum pressure applied (8.5, 10.5, or 14.0 kg/$cm^2$), and maximum pressure was maintained until refusal point was reached. Regardless of wood species, extending the duration of initial vacuum more than 30 minutes did not affect treatability. Increasing pressure did not affect preservative penetration; however, preservative retention was affected by pressure levels, particularly at higher level (14.0 kg/$cm^2$). Preservative penetration depth of Japanese red pine met a minimum requirement specified by Notification of Korean Forestry Administration (No. 1999-8) for hazard class H5 of CCA-treated wood. Penetration of preservative in both Japanese larch and ezo spruce was not deep because of shallow sapwood thickness of these species, so pretreatment such as incising should be considered if these species are treated with preservatives. Although retention in Japanese red pine was not significantly increased even with 14.0 kg/$cm^2$, that of refractory Japanese larch and ezo spruce was significantly increased with the application of 14.0 kg/$cm^2$. Effect of treatment variables on refusal time was unclear; however, it is cleared that the refusal time was shortened with the increase in sapwood thickness.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.04a
• /
• pp.809-812
• /
• 2008

Bleed test methods currently being specified in KS, ASTM and BS are the methods to read the height of bleed water and volume changes of mortar poured into transparent cylinder. Time for measuring of bleed are specified as 3, 20 hours in KS specification, while bleed is measured at 3 hour and change of volume is measured at 24 hour in ASTM and BS specification. Like these, bleed test takes a lot of time to conduct. Another method to measure the bleed is the pressure filter test. This method predict the bleed by measuring the passed water through the fiber glass filter under pressure. This pressure filter test developed by Schupack in 1971 has an advantage in predicting the bleed in shorter time. However, data correlating the pressure filter test results with amount of bleed are limited. Therefore, this study aims at verifying the availability of pressure filter test as a method to predict the bleed and deriving the relation between this test results and bleed.