• Journal of Environmental Health Sciences
• /
• v.34 no.3
• /
• pp.226-232
• /
• 2008

A feasibility study for the application of the photoelectrocatalytic decolorization of Rhodamine B (RhB) was performed in a photoelectrochemical reactor with immobilized $TiO_2$ particle. The effects of operating conditions, such as current, electrolyte and pH were evaluated. The experimental results showed that optimum $TiO_2$ dosage and current in the photoelectrocatalytic process were 83.3 g/l and 0.5 A, respectively. It was found that the RhB could be degraded more efficiently by this photoelectrocatalytic process than the sum of the two individual oxidation processes (photocatalytic and electrolytic process). The addition of NaCl increased the initial decolorization rate and reduced reaction time. The optimum dosage of NaCl was 0.15 g/l. The decolorization rate of the photoelectrocatalytic process increased sharply with a decrease in pH value. However when the NaCl was added, the pH effect was not high.

• Journal of the Korean Ceramic Society
• /
• v.39 no.11
• /
• pp.1017-1022
• /
• 2002

$(Ba_{1-x}Ca_x)(Ti_{1-y}Zr_y)O_3(BCTZ)$ powders for the Ni-electrode Multilayer Ceramic Capacitor(MLCC) were synthesized via hydrothermal treatment using mixed aqueous solutions of $BaCl_2{\cdot}2H_2O,\Ca(NO_3)2{\cdot}4H_2O,\ ZrOCl_2{\cdot}8H_2O$ and $TiCl_4$. Two component and three component systems were also extensively studied for basic data. BT, CT and BZ powders were crystalline but CZ was determined to be amorphous under the same synthetic condition. In BTZ system, Zr and Ti were completely soluble and Ca would be substituted for Ba up to ∼6 mol% in BCT. The submicron-sized $(Ba_{0.95}Ca_{0.05})(Ti_{0.80}Zr_{0.20})O_3$ powder of the target composition was successfully synthesized at $150{\circ}$ for 12h.

• Corrosion Science and Technology
• /
• v.11 no.6
• /
• pp.232-241
• /
• 2012

This work focused on corrosion of carbon steel bolted GECM/Al parts in tap water and NaCl solutions. In tap water and NaCl solutions, open circuit potential of GECM and its potentials in a series of carbon steel bolt>Ti>Al became active. Regardless of test materials, open circuit potentials in tap water were noble, and increasing NaCl concentration, its potentials became active. Immersion test of single specimen showed that no corrosion occur in Ti and GECM. In tap water, carbon steel bolt didn't show red corrosion product and in chloride solutions, corrosion rate in 1% NaCl solution was greater than its rate in 3.5% NaCl solution and red corrosion product in 1% NaCl solution was earlier observed than that in 3.5% NaCl solution. It seems that this behavior would be related to zinc-coatings on the surface of carbon stee l bolt. On the other hand, aluminium was corroded in tap water and chloride solutions. Corrosion of aluminium in tap water was due to the presence of chloride ion in tap water by sterilizing process.

• Journal of the Korean Chemical Society
• /
• v.25 no.2
• /
• pp.61-66
• /
• 1981

A method for calculation of the contribution of $\pi$ bonding molecular orbitals to the dipole moments for octahedral [M(III)$A_3B_3$] type complexes has been developed [M(III) = Ti(III), V(III), Cr(III), Fe(III) or Co(III); A = O or N; B = N, S or Cl]. The contribution of ${\pi}$ bonding molecular orbitals to the dipole moments is found to be smaller than that of ${\sigma}$ bonding molecular orbitals but this contribution may not be negligible even for chelate complexes in which delocalization of ${\pi}$ electron is assumed. The calculated dipole moments (u = $u_{\sigma}$ + $u_{\pi}$) are closer to the experimental values than those for the case where only ${\sigma}$ bonds are assumed to be formed.

• Journal of the Korean Chemical Society
• /
• v.24 no.2
• /
• pp.91-100
• /
• 1980

A formula for calculation of the magnetic moments for octahedral $[Ti(III)A_3B_3]$ type complexes with axial symmetry has been developed and the magnetic moments for these complexes are calculated, using the experimental values of the distortion parameters$({\delta})$, spin-orbit coupling constants and orbital reduction factors. The calculated magnetic moments for axially distorted octahedral $[Ti(III)A_3B_3]$ type complexes are in resonable agreement with the experimental valuest It is found that the calculated magnetic moments decrease as the extent of axial distortion increases and the orbital reduction factor decreases. A calculation method of the magnetic moments for octahedral $[Ti(III)A_3B_3]$ type complexes which are in a ligand field of lower than axial symmetry has also been developed and the structure of distorted octahedral $[Ti(III)A_3B_3]$ type complexes are discussed on the basis of the of the calculated magnetic moments.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.9 no.5
• /
• pp.510-515
• /
• 1999

Synthesize of anatase type $TiO_2$ from $TiCl_4$ solution was studied. KOH was used on dehydration reaction of $TiCl_4$ solution. Products of dehydration reaction was calcined at 300, 500, 700, 900, $1000^{\circ}C$ during 1hour. Calcined products was studied by XRD, DTA, and FT-IR for effect of calcined temperature. The results are as follow. \circled1 Product pf dehydration reaction at$ 90^{\circ}C$ was semicrystalline anatase type $TiO_2$ because it has a peak vary broad and low at the position of anatase crysral XRD pattern. \circled2 Pure titanium oxide semi-crystalline products were produced at acid pH condition which convert to anatase crystal at $300^{\circ}C$ and to rutile crystal at $700^{\circ}C$. \circled3 The chemical composition of semicrystalline products which was produce at alkali pH conditions, were potasium titante. Potasium-titanate semi-crystalline products crystallized at 630~$640^{\circ}C$ \circled4 The transition temperature of potassium dopped titanium oxide semi-crystalline products was increased with the contents of potasium. \circled5 The optimum synthesise condition of anatase $TiO_2$ products from $TiCl_4$ and KOH are pH 3~5 and $300^{\circ}C$ calcination.

• Transactions of the Korean hydrogen and new energy society
• /
• v.13 no.3
• /
• pp.224-232
• /
• 2002

CdS-$TiO_2$ nano-composite sol was prepared by the sol-gel method in organic solvents at room temperature and further hydrothermal treatment at various temperatures to control the physical properties of the primary particles. Again, CdS-$TiO_2$ composite particulate films were made by casting CdS-$TiO_2$ sols onto $F:SnO_2$ conducting glass and then heat-treatment at $400^{\circ}C$. Physical properties of these 61ms were further controlled by the surface treatment with $TiCl_4$, aqueous solution. The photo currents and hydrogen production rates measured under the experimental conditions varied according to the $CdS/[CdS+TiO_2]$ mole ratio and the mixed-sol preparation method. For $CdS-TiO_2$ composite sols prepared in IPA, CdS particles were homogeneously surrounded by $TiO_2$ particles. Also, the surface treatment with $TiCl_4$ aqueous solution caused a considerable improvement in the photocatalytic activity, probably as a result of close contacts between the primary particles by the etching effect of $TiCl_4$. It was found that the photoelectrochemical performance of these particulate films could be effectively enhanced by this approach.

• Proceedings of the Korean Environmental Sciences Society Conference
• /
• 2008.11a
• /
• pp.464-467
• /
• 2008

성능이 우수한 다성분계 전극을 개발하기 위하여 Pt, Ru, Sn, Sb 및 Gd의 5 종류 금속을 이용하여 1성분계 전극의 성능과 산화제 생성량 및 2성분계 전극의 성능과 산화제 생성 경향을 고찰하여 다음의 결과를 얻었다. 1. RhB 농도 감소는 Ru/Ti > Sb/Ti > Pt/Ti > Sn/Ti > Gd/Ti 전극의 순서로 나타났으나 단위 전력당 2분간 제거된 RhB 농도 감소는 Ru/Ti > Sb/Ti > Pt/Ti > Gd/Ti > Sn/Ti 전극의 순서로 나타났다. 생성된 산화제 농도는 ClO$_2$ > free Cl > H$_2$O$_2$ > O$_3$의 순서였으며 Gd/Ti 전극의 경우 산화제가 거의 생성되지 않는 것으로 나타났다. 모든 전극에서 OH 라디칼이 거의 생성되지 않는 것으로 나타났다. Ru/Ti와 Sb/Ti 전극의 높은 RhB 분해와 산화제 생성 농도는 정확하지는 않지만 상관관계가 있는 것으로 나타났다. 2. Ru계 2성분 전극(Ru-Gd/Ti, Ru-Pt/Ti, Ru-Sn/Ti 및 Ru-Sb/Ti)은 모두 1성분계 전극보다 RhB 분해성능이 높아지는 것으로 나타났으며, Ru계 2성분 전극 중 가장 성능이 우수하였던 전극은 Ru:Sn=9:1 전극으로 나타났다. Sn-Sb/Ti 전극은 Sn:Sb=1:9의 전극 성능이 우수한 것으로 나타났으나 Sb/Ti 전극과의 차이는 크지 않은 것으로 나타났다. Pt계 전극(Pt-Gd/Ti, Pt-Sn/Ti, Pt-Sb/Ti)은 대체로 두 성분 혼합에 따른 RhB 분해효과 상승은 없는 것으로 나타났다. 2성분계 전극 중 RhB 제거 성능이 가장 우수하였던 Ru:Sn=9:1 전극에서 4종류의 산화제 생성 농도가 높은 것으로 나타났다. Ru:Pt=9:1 전극은 RhB 분해 성능이 5 전극 중 가장 낮았으며, 산화제도 생성량이 가장 적은 것으로 나타났다. Ru-Sn/Ti 계 전극의 RhB 분해 성능과 산화제 생성 농도가 실험한 모든 1, 2성분계 전극에서 높은 것으로 나타나 향후 3, 4성분계 전극 제조시 이를 바탕으로 제조하고 다른 물질들은 보조재료로서 사용할 필요성이 있는 것으로 사료되었다.

• Bulletin of the Korean Chemical Society
• /
• v.16 no.1
• /
• pp.58-62
• /
• 1995

Substituted 3-phenyl-1-silabutanes such as 3-phenyl-1-silabutane (1), 3-(2,5-dimethylphenyl)-1-silabutane (2), 3-(p-chlorotolyl)-1-silabutane (3), and 3-naphthyl-1-silabutane (4) were prepared in 62-96% yield by reduction of the corresponding substituted 3-phenyl-1,1-dichloro-1-silabutanes with LiAlH4. The dehydrogenative polymerization of the monomer silanes was carried out with Cp2MCl2/Red-Al (M=Ti, Hf) catalyst system. The molecular weight of the polymers produced ranged from 700 to 1300 (vs polystyrene) with degree of polymerization (DP) of 5 through 16 and with polydispersity index (PDI)=1.1-2.1. The dehydrogenative polymerization of the monomer silanes with Cp2TiCl2/Red-Al catalyst system occurred at a faster rate and produced somewhat higher molecular weights of polysilane than that with Cp2HfCl2/Red-Al catalyst system.

• Resources Recycling
• /
• v.30 no.2
• /
• pp.46-52
• /
• 2021

Off-grade Ti generated from smelting and mechanical processing has a high oxygen content. In this work, off-grade Ti was deoxidized using Mg and a chloride mixture as the reductant and flux, respectively. The experiments were conducted in the α-Ti temperature range (1,023~1,123 K) and the effects of the reaction time, reaction temperature, quantitiy of Mg and chloride ratio on deoxidation were investigated. Notably, when YCl3 is used as the flux to react with MgO, it is possible to reduce the activity of MgO. Therefore Ti can be deoxidized using Mg. In this study, the O content was decreased from 0.5 wt% to 0.1004 wt% at 1073 K, for 6 hours, with Mg=3.6 g and $X_{YCl_3}=0.22$.