• Electrical & Electronic Materials
• /
• v.7 no.3
• /
• pp.187-199
• /
• 1994

In order to find an effect of structural changes due to variation of addition ratio of anhydride hardener and postcuring herat-treatments upon electrical properties of epoxy composites, the dielectric properties over a frequency range from 30[Hz] to l[MHz] were investigated in the temperature range of 20-180[.deg. C]. From the dielectric properties, the a peaks related with glass-transition phenomena of epoxy network appeared near 130[.deg. C], the conduction loss in high temperature region above 150[.deg. C] due to thermal dissociation of hardener started off with the low frequency side and the .betha. peak concerned with contribution of movable unreacted terminal epoxy groups and curing agents in the glass states concurred with the high-frequency side below 20[.deg. C]. And an effect of an hydride hardener upon structural changes and of postcuring heat treatments upon structural stability in epoxy composites would be explained through the estimation of the distribution of relaxation times and the activation energy for a .alpha. peak according to the WLF equations.

• The Korean Journal of Ceramics
• /
• v.4 no.3
• /
• pp.183-188
• /
• 1998

Gas sensitizations of tin oxide film were investigated by measuring the change of film resistance in various gas atmospheres such as $N_2,\; O_2,\; H_2O$. The main test sample, polycrystalline $SnO_2$ film containing small Sb as a dopant was prepared by a sputtering technique and showed a long term stability in base resistance and thus, in gas sensitivity. The adsorption of oxygen on the film surface as a type of $(O_{ads})$ at the temperature of around $300^{\circ}C$ played important roles in sensor operating mechanism. The roles were ⅰ) the increase of base resistance in ambient air, which consequently lead to high sensitivity and ⅱ) the promotion of fast recovery. The reaction of hydrogen gas with the already adsorbed $(O_{ads})$ ions was considered as a decisive sensitization mechanism of tin oxide film. However, the dissociation of hydrogen molecules on film surface, by direct donation of electron to film also took a major part in the sensitization. The effect of humidity on gas sensitization was found to be negligible at the sensor operating temperature of around $300^{\circ}C$.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.1
• /
• pp.41-46
• /
• 2009

The low dielectric SiOCH films were deposited on p-type Si(100) substrates through the dissociation of BTMSM $(((CH_3)_3Si)_2CH_2)$ precursors with oxygen gas by using PECVD method. BTMSM precursor was introduced with the flow rates from 42 to 60 sccm by 2 sccm step into reaction chamber but with the constant flow rate of 60 sccm $O_2$. SiOCH thin films were annealed at $450^{\circ}C$ for 30 minutes. The electrical property of SiOCH thin films was studied by MIS, Al/SiOCH/p-Si(100), structure. Annealed samples showed large reduction of the maximum capacitance yielding low dielectric constant owing to reductions of surface charge density. After exposure at room temperature and atmospheric pressure, dielectric constant of SiOCH films was totally increased. However, annealed SiOCH thin films were more stable than as-deposited SiOCH thin films for natural oxidation.

• Bulletin of the Korean Chemical Society
• /
• v.31 no.5
• /
• pp.1349-1354
• /
• 2010

The geometries and isomerization of the alkylidene silylenoid $H_2C$ = SiLiF as well as its insertion reactions with R-H (R = F, OH, $NH_2$) have been systematically investigated at the B3LYP/6-311+$G^*$ level of theory. The potential barriers of the three insertion reactions are 97.5, 103.3, and 126.1 kJ/mol, respectively. Here, all the mechanisms of the three reactions are identical to each other, i.e., an intermediate has been formed first during the insertion reaction. Then, the intermediate could dissociate into the substituted silylene ($H_2C$ = SiHR) and LiF with a barrier corresponding to their respective dissociation energies. Correspondingly, the reaction energies for the three reactions are -36.4, -24.3, and 3.7 kJ/mol, respectively. Compared with the insertion reaction of $H_2C$ = Si: and R-H (R = F, OH and $NH_2$), the introduction of LiF makes the insertion reaction occur more easily. Furthermore, the effects of halogen (F, Cl, Br) substitution and inorganic salts employed on the reaction activity have also been discussed. As a result, the relative reactivity among the three insertion reactions should be as follows: H-F > H-OH > H-$NH_2$.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.163.2-163.2
• /
• 2014

We report catalytic decomposition of few-layer graphene on an $Au/SiO_x/Si$ surface wherein oxygen is supplied by dissociation of the native $SiO_x$ layer at a relatively low temperature of $400^{\circ}C$. The detailed chemical evolution of the graphene covered $SiO_x/Si$ surface with and without gold during the catalytic process is investigated using a spatially resolved photoelectron emission method. The oxygen atoms from the native $SiO_x$ layer activate the gold-mediated catalytic decomposition of the entire graphene layer, resulting in the formation of direct contact between the Au and the Si substrate. The notably low contact resistivity found in this system suggests that the catalytic depletion of a $SiO_x$ layer could realize a new way to micromanufacture high-quality electrical contact.

• Bulletin of the Korean Chemical Society
• /
• v.12 no.6
• /
• pp.629-632
• /
• 1991

The rate constants for the formation and dissociation of nickel(II) and cobalt(II) complexes with mandelate have been determined by the pressure-jump relaxation study. The forward and reverse rate constants for the mandelate complex formation reactions were obtained to be $k_f=3.60{\times}10^4\;M^{-1}s^{-1}$ and $k_r=1.73{\times}10^2\;s^{-1}$ for the nickel(II), and $k_f=1.75{\times}10^5\;M^{-1}s{-1}$ and $2.33{\times}10^3\;s^{-1}$ for the cobalt(II) in aqueous solution of zero ionic strength ($(\mu{\to}0)\;at\;25^{\circ}C$. The results were interpreted by the use of the multistep complex formation mechanism. The rate constants evaluated for each individual steps in the multistep mechanism draw a conclusion that the rate of the reaction would be controlled by the chelate ring closure step in concert with the solvent exchange step in the nickel(II) complexation, while solely by the chelate ring closure step for the cobalt(II) complex.

• Korean Chemical Engineering Research
• /
• v.52 no.5
• /
• pp.678-687
• /
• 2014

The catalytic performance of silicon carbide supported nickel catalysts modified with or without second metal (Co, Cu and Zn) for the methanation of CO has been investigated in a fixed-bed reactor using a feed consisting of 25% CO and 75% $H_2$ without any diluent gas. It has been found that the introduction of Co species can clearly improve the catalytic activity of Ni/SiC catalyst, whereas the addition of Cu or Zn can result in a significant decrease in the catalytic activity. The characterizations by means of XRD, TEM, XPS, CO-TPD and $H_2$-TPR indicate that the addition of Co could decrease the particle size of active metal, increase active sites on the surface of methanation catalyst, improve the chemisorption of CO and enhance the reducibility of methanation catalysts. Additionally, the special interaction between Co species and Ni species is likely favorable for the dissociation of adsorbed CO on the surface of catalyst, and this may also contribute to the high activity of 5Co-Ni/SiC catalyst for CO methanation reaction. For 5Cu-Ni/SiC catalyst and 5Zn-Ni/SiC catalyst, Cu and Zn species could cover partial nickel particles and decrease the chemisorption amount of CO. These could be responsible for the low methanation activity. In addition, a 150h stability test under 2 MPa and $300^{\circ}C$ showed that 5Co-Ni/SiC catalyst was very stable for CO methanation reaction.

• Journal of the Korean Chemical Society
• /
• v.27 no.3
• /
• pp.178-182
• /
• 1983

The conductances of sodium, potassium, ammonium, tetramethylammonium, and tetraethylammonium iodides, picrates(Pic) of sodium and potassium, and tetrabutylammonium tetraphenyl-boride have been measured in ethylene carbonate-acetone mixtures at $25{\circ}C$. The limiting equivalent conductances of the electolytes were computed by Fuoss-Kraus equation and the order was $(C_4H_9)_4NB(ph)_4 at any composition of the mixtures. The dissociation constants of the salts showed that the mixtures are good ionizing solvents for the salts. The order of limiting ionic equivalent conductance, $Na^+, is consistent with exactly the reverse order found for solvation number. Effective solvated radii calibrated by the Nightingale method showed that picrate ion seems to be unsolvated and that iodide ion seems to be solvated to some extent in the mixtures.

• Journal of Electrochemical Science and Technology
• /
• v.1 no.2
• /
• pp.121-126
• /
• 2010

An amperometric ascorbic acid selective sensor utilizing the transfer reaction of proton liberated from the dissociation of ascorbic acid in aqueous solution across an elliptic micro-hole water/organic gel interface is demonstrated. This redox inactive sensing platform offers an alternative way for the detection of ascorbic acid to avoid a fouling effect which is one of the major concerns in redox based sensing systems. The detection principle is simply measuring the current change with respect to the assisted transfer of protons by a proton selective ionophore (e.g., ETH 1778) across the micro-hole interface between the water and the polyvinylchloride-2-nitrophenyloctylether gel phase. The assisted transfer reaction of protons generated from ascorbic acid across the polarized micro-hole interface was first characterized using cyclic voltammetry. An improved sensitivity for the quantitative analysis of ascorbic acid was achieved using differential pulse stripping voltammetry with a linear response ranging from 1 to $100\;{\mu}M$ concentrations of ascorbic acid. As a demonstration, the developed sensor was applied for analyzing the content of vitamin-C in different types of commercial pharmaceutical tablets and syrups, and a satisfactory recovery from these samples were also obtained.

• Journal of the Korean Chemical Society
• /
• v.33 no.1
• /
• pp.3-10
• /
• 1989

In order to obtain a clue in understanding enzymatic hydrolysis in which the His-Cys moieties of papain protease is involved, we prepared cationic peptide-sufactants bearing histidyl, cysteinyl, and both histydyl and cysteinyl residues. Their catalytic efficiency toward the hydrolysis of PNPL were investigated in comicellar phases formed with $N^{+}C_{2}CysC_{12}$, $N^{+}C_{2}HisC_{12}$, $N^{+}C_{2}HisCysC_{12}$ increased markedly in the same order compared with that of $N^{+}C_{2}AlaC_{12}$. The markedly increased catalytic effects are attributed to the imidazole groups of $N^{+}C_{2}HisC_{12}$ and the thiol groups of $N^{+}C_{2}CysC_{12}$, and the large catalytic efficiency of $N^{+}C_{2}HisCysC_{12}$, is considered due to the interaction of the imidazole and the thiol groups. In order to investigate catalytic activities, rate constants for the functional groups, km* and dissociation constants, pKa have been determined. The results showed that $k^{\ast}_m$ and pKa of the imidazole groups were $7.91{\times}10^{-4}S^{-1}$ and 6.49, and those of the thiol groups were $6.00{\times}10^{-4}S^{-1}$ and 10.50. The catalytic effects of comicellar systems on the hydrolysis of p-nitrophenyl esters has increased according to the increasing size of the alkyl carbon number. Therefore, the catalytic effects have been increasing by the interaction of micellar hydrophobic parts and substrates as well as action of the functional groups.