• Journal of Digital Contents Society
• /
• v.19 no.8
• /
• pp.1603-1615
• /
• 2018

In order to achieve the low complexity and area, power in the design of Optical Image Stabilization (OIS) suitable for the smart phone, this paper presents the following design explorations, such as; optimization of gyroscope sampling rate, simple and accurate gyroscope filters, and reduced operating frequency of motion compensation, optimized bit width in ADC and DAC, evaluation of noise effects due to PWM driving. In experiments of gyroscope sampling frequencies, it is found that error values are unvaried in the frequency above 5KHz. The gyroscope filter is efficiently designed by combining the Fuzzy algorithm, to illustrate the reasonable compensation for the angle and phase errors. Further, in the PWM design, the power consumption of 2MHz driving is shown to decrease up to 50% with respect to the linear driving, and the imaging noises are reduced in the driving frequency above 2MHz driving frequency. The operating frequency could be reduced to 5KHz in controller and 10KHz in driver, respectively, in the motion compensation. For ADC and DAC, the optimized exploration experiments verify the minimum bit width of 11bits in ADC as well as 10bits in DAC without the performance degradation.

• Journal of Korean Society of Transportation
• /
• v.25 no.5
• /
• pp.91-100
• /
• 2007

This study suggests direct connection service which has advantage of high-speed operation of KTX and access convenience of general train, and Pre-feasibility studies on the direct connection service. And analyze transportation demand change by the method as follows; It is to analyze the demand change of before and after KTX operation by previous transport data of Gyeongbu line, and calculate the coefficient of utilization using triggering demand by opening the 2nd phase of Gyeongbu line (Dongdaegu${\sim}$Busan). Through Pre-feasibility analysis, reduction $70{\sim}100$ minutes of train travel time and total revenue will increase about $100 thousand per day. Also, there will be environment-friendly effects of decreasing $CO_2$ emissions. But, Direct connection service need to highly cost ; Buying and Operation cost of KTX train. Therefore, we will be get more correct result of Pre-feasibility study on direct connection service, if there are concrete on buying the KTX action plans.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2018.06a
• /
• pp.62-62
• /
• 2018

Pt is still considered as one of the most active electrocatalysts for ORR in alkaline fuel cells. However, the high cost and scarcity of Pt hamper the widespread commercialization of fuel cells. As a strong candidate for the replacement of Pt catalyst, silver (Ag) has been extensively studied due to its high activity, abundance, and low cost. Ag is more stable than Pt in the pH range of 8~14 as the equilibrium potential of Ag/Ag+ being ${\approx}200mV$ higher than that of Pt/PtO. However, Ag is the overall catalytic activity of Ag for oxygen reduction reaction(ORR) is still not comparable to Pt catalyst since the surface Ag atoms are approximately 10 times less active than Pt atoms. Therefore, further enhancement in the ORR activity of Ag catalysts is necessary to be competitive with current cutting-edge Pt-based catalysts. We demonstrate the architectural design of Ag catalysts, synthesized using plasma discharge in liquid phase, for enhanced ORR kinetics in alkaline media. An attractive feature of this work is that the plasma status controlled via electric-field could form the Ag nanowires or dendrites without any chemical agents. The plasma reactor was made of a Teflon vessel with an inner diameter of 80 mm and a height of 80 mm, where a pair of tungsten(W) electrodes with a diameter of 2 mm was placed horizontally. The stock solutions were made by dissolving the 5-mM AgNO3 in DI water. For the synthesis of Agnanowires, the electricfield of 3.6kVcm-1 in a 200-ml AgNO3 aqueous solution was applied across the electrodes using a bipolar pulsed power supply(Kurita, Seisakusyo Co. Ltd). The repetition rate and pulse width were fixed at 30kHz and 2.0 us, respectively. The plasma discharge was carried out for a fixed reaction time of 60 min. In case of Ag nanodendrites, the electric field of 32kVcm-1 in a 200-ml AgNO3 aqueous solution was applied and other conditions were identical to the plasma discharge in water in terms of electrode configuration, repetition rate and discharge time. Using SEM and STEM, morphology of Ag nanowires and dendrites were investigated. With 3.6 kV/cm, Ag nanowire was obtained, while Ag dendrite was constructed with 32 kV/cm. The average diameter and legth of Ag nanowireses were 50 nm and 3.5 um, and thoes values of Ag dendrites were 40 nm and 3.0 um. As a results of XPS analysis, the surface defects in the Ag nanowires facilitated O2 incorporation into the surface region via the interaction between the oxygen and the electron cloud of the adjacent Ag atoms. The catalytic activity of Ag for oxygen reduction reaction(ORR) showed that the catalytic ORR activity of Ag nanowires are much better than Ag nanodendrites, and electron transfer number of Ag nanowires is similar to that of Pt (${\approx}4$).

• Journal of Korean Society for Geospatial Information Science
• /
• v.9 no.2 s.18
• /
• pp.29-36
• /
• 2001

The purpose of this paper is to describe the Disaster Management System Development of Enterprise GIS at the Kangwon Province in Korea. This project is included into 'the Kangwon Enterprise GIS 21 plan'. The Division of Disaster Management is in the middle of the 2-year project of the Disaster Management System development, appropriate for business performed at the Departments of Forestry, Culture, Environment, Tourism, etc. At the 1st phase of CIS implementation, for more than half a year we focused on the necessity of management of disasters. In the planning process, we needed long-term information on the whole area of Kangwon. In the assessment and response processes, we needed real-time data from Korean Meteorological Administration and other agencies. All the above information was carefully studied and referred to. ESRI's new GIS technologies solve the natural hazard/disaster problems. For example, hazardous materials routing often needs to be found the least expensive path through a roadway network. In the circumstances given, we can choose the departure point and destination of the vehicle, which carries the materials. It's also possible to minimize overall risk and costs of disaster problems by making a plan of people and possessions evacuation from the disaster area in short time limits. We can meet all the above goals using the latest ESRI's technologies.

• Korean Journal of Veterinary Research
• /
• v.60 no.1
• /
• pp.25-32
• /
• 2020

Natural killer (NK) cells play have a crucial role in the early phase of immune responses against various pathogens. We compared characteristics of canine NK cells against two canine mammary carcinoma cell lines, REM134 and CF41.Mg. REM134 showed higher expression of progesterone receptor, proliferative cell nuclear antigen, Ki67, multiple drug resistance, Bmi-1, c-myc, E-cadherin, and human epidermal growth factor receptor type-2 than that of CF41.Mg. For specific expansion and activation of NK cells, we isolated CD5 negative cells from canine peripheral blood mononuclear cells and co-cultured K562 cells in the presence of interleukin (IL)-2, IL-15, and IL-21 for 21 days. As a result, we found that expression markers of activated NK cells such as NKp30, NKp44, NKp46, NKG2D, CD244, perforin, granzyme B, and tumor necrosis factor alpha were highly upregulated. In addition, we found there was upregulated production of interferon gamma of activated NK cells against target cells such as REM134 and CF41.Mg. Specifically, we observed that cytotoxicity of NK cells against target cells was more sensitively reacted to CF41.Mg than REM134. Based on the results of this study, we recommend the development of an experimental application of CF41Mg, which has not been reported in canine mammary carcinoma research.

• Korean Journal of Food Science and Technology
• /
• v.38 no.1
• /
• pp.1-4
• /
• 2006

Method of analyzing sodium alginate in foods was developed using high performance liquid chromatography (HPLC). HPLC conditions for sodium alginate were: column, MCI GEL $(8\;mm\;i.d{\times}300\;mm)$; mobile phase, deionized water; detector, refractive index detection (sensitivity = 16). Separation of sodium alginate was achieved within 15 min. Sodium alginate showed good linear relationship at 0.1-2.0% range. Correlation coefficient of calibration curve for sodium alginate exceeded 0.999, and detection limit was 0.005%. Recovery rate of sodium alginate in wheat flour dough was 106.67%. This method was successfully applied to analyses of cereals, saccharides, and ice cream, etc. Sodium alginate was detected in chocolate, noodles, and kelp at 0-44.8% range.

• Resources Recycling
• /
• v.27 no.4
• /
• pp.16-22
• /
• 2018

Inconel713C which of a commercial Ni super alloy have the compositions of 70 wt.% Ni, 12 wt.% Cr, 6 wt.% Al and 4 wt.% Mo. In this study, solvent extraction has been performed to separate Mo from the synthetic leaching solution, formation of Inconel713C alloy similarly and is found the optimum conditions of recovery of Mo from the leaching solution. The effects of some variables, such as the nature and concentration of the extractants, $H_2SO_4$ concentrations, and the presence of impurities were investigated. The extraction percentage of Mo by Cyanex272 is 96% in the condition of pH 1 and 4% of concentration of Cyanex272 but Alamine336 is 99% in the condition of the range of pH 1 to 4 and 1 wt.% of concentration of Alamine336. In the case of Alamine336, the extraction percentage of Mo is increased by increasing of the concentration of Alamine336. The optimum condition of this experiment is pH 1 in aqueous phase, 1% concentration of Alamine336 and activation ratio of $H_2SO_4$ 1:0.5.

• ANNALS OF ANIMAL RESOURCE SCIENCES
• /
• v.28 no.3
• /
• pp.97-107
• /
• 2017

The present study was conducted to investigate the effects on growth performance, nutrient digestibility, and gut health of broiler chickens when a dietary supplementation of multienzymes was added to diets, containing different energy levels. A total of 480 broiler chickens of similar body weight (Ross 308, 1-day-old) were randomly subjected to four treatments. The dietary treatments included a corn-soybean meal-based diet supplemented with: multienzyme (amylase+protease+ mannanase+xylanase+phytase), 0.05% enzyme, and different energy levels (3010 and 3060 kcal/kg). The experimental diets were fed to the chicks in a mash form for 35 days in two phases (1-21 d, phase I; and 22-35 d, phase II). During the overall period, chicks fed with diets supplemented with multienzymes had a better weight gain (p<0.05) and feed conversion ratio (FCR) than those fed with diets without enzymes. There was no difference in the growth rate and FCR among the chicks fed with diets supplemented with enzymes, even though the dietary energy levels were different. The apparent fecal and ileal digestibility of dry matter, gross, crude protein, calcium, and phosphorus were significantly enhanced (p<0.05). The population of cecal and ileal Lactobacillus spp. was significantly increased (p<0.05), and Clostridium spp. and coliforms were significantly decreased (p<0.05) in diets supplemented with enzymes. Villus height and villus height to crypt depth ratio in the small intestine was also significantly enhanced (p<0.05) in diets supplemented with enzymes. In conclusion, multienzyme supplementation had positive effects on the weight gain of broilers, FCR, digestibility of nutrients, and on the growth of intestinal microbiota.

• Journal of Periodontal and Implant Science
• /
• v.23 no.1
• /
• pp.97-108
• /
• 1993

One of the important initial events required for periodontal regeneration is the attachment and subsequent spreading of periodontal ligament cells on the root surface. The purposes of this study is to investigate the attachment and spreading pattern of human periodontal ligament cell on the surface of glass slides. After establishment of a cell line of the primary cell culture from the periodontal ligament of 1st premolar teeth which were extracted for the purpose of orthodontic treatment, author dispersed the cells at $5{\times}10^3\;cells/ml$ into the each 35mm culture petri-dish containing 2 glass slides. To observe the morphological changes of the cells which attached to the surfaces of glasses at every designed time schedule, author used the inverted phase contrast microscope and scanning electron microscope. During the whole experiment culture condition was at $37^{\circ}C$, 100% Humidity, 5% $CO_2$ gas incubator. The following results were obtained. Periodontal ligament cells showed spherical outline and started to attach to glass surface by basal sytoplasmic extension after 10min in culture. After 30min in culture, periodontal ligament cells were attached to glass surface by well - developed filopodia which protruded from the lamellipodia. The cell surface is covered with bubble-like structures and occasional microvillus can be seen with diffculty among these structures. After 1.5hr in culture, peridontal ligament cells shhowed radially well-spread cytoplasm and the nucleus was centered on its cytoplasm. Unspread central region of the cell was covered with numerous microvilli. The change of cell attachment and spreading pattern was manifest at 6hr in culture. At this time, periodontal ligament cell showed elongated outline and an oval-shaped nucleus. After 12hr in culture, periodontal ligament cells showed more stretched fibroblast-like appearance with polarity. Two long lamellipodia can be seen around the both terminal ends of cells. After 24hr in culture, periodontal ligament cells showed spindle shapes and an oval-shaped nucleus was slanted toward one side of the cell.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.2
• /
• pp.151-158
• /
• 2012

This paper proposes a H-plane 8-way rectangular waveguide power divider using Y-junction. A general N-way power divider can be composed of multi-stage T-junctions. However, if the distances of output ports are close, the matching characteristic is not improved by using only T-junctions because of space limitation. In this case, since other types of 3-port junctions should be used to final output stage, Y-junctions are used with T-junctions in this paper. The proposed Y-junction uses the tapered-line impedance transformer and inductive irises to improve impedance matching characteristic. The 8-way power divider using Y-junction is fabricated and measured. The measured return loss and insertion loss from input port to output port are -30.8 dB and -9.3 dB at operating frequency, respectively. The measured maximum phase difference is about $1^{\circ}$. Therefore, the proposed power divider will be useful to apply to various microwave systems, which need to divide the input power equally, such as feed networks for array antennas.