• Journal of IKEEE
• /
• v.24 no.1
• /
• pp.81-89
• /
• 2020

This paper describes the design and fabrication of a LNB(Low Noise Block downd-converter) which is a component of a FST(Flyaway Satellite Terminal), one of the ET(Earth Terminal) of the military satellite. LNB is physically composed of an down-converter module, a low noise amplifier module, a transmit band suppression filter, a isolator, a housing, and a cable assembly. It was designed using simulator (AWR) to satisfy the electrical characteristics of LNB's such as gain, noise figure and unwanted signal. The gain and noise figure characteristics were measured at 61.4dBm and 1.37dB, respectively. The unwanted wave was measured at -66.79dBc. Of the electrical requirements of Table 1, not only the above three but also all other items were confirmed to be satisfied.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.12
• /
• pp.91-96
• /
• 2011

In this paper, a low-power direct-conversion transmitter based on current-mode operation, which satisfies the IEEE 802.15.4 standard, is proposed and implemented in a $0.13{\mu}m$ CMOS technology. The proposed transmitter consists of DACs, LPFs, variable gain I/Q up-conversion mixer, a divide-by-two circuit with LO buffer, and a drive amplifier. By combining DAC, LPF, and variable gain I/Q up-conversion mixer with a simple current mirror configuration, the transmitter's power consumption is reduced and its linearity is improved. The drive amplifier is a cascode amplifier with gain controls and the 2.4GHz I/Q differential LO signals are generated by a divide-by-two current-mode-logic (CML) circuit with an external 4.8GHz input signal. The implemented transmitter has 30dB of gain control range, 0dBm of maximum transmit output power, 33dBc of local oscillator leakage, and 40dBc of the transmit third harmonic component. The transmitter dissipates 10.2mW from a 1.2V supply and the die area of the transmitter is $1.76mm{\times}1.26mm$.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.32 no.4
• /
• pp.88-94
• /
• 2004

The electrical design of the Ka-band antenna for the domestic Communications and Broadcasting Satellite (CBS) is described. The antenna has the offset Gregorian structure and is installed on the Earth-facing panel of the satellite. The electrical performance specifications for the antenna were determined from the required EIRP and G/T through the payload level performance analysis. This paper utilized the reflector shaping technology for the trade-off among the major performance parameters, resulting in compliance of all the parameters. The designed antenna shows 37.95 dBi EOC (End of Coverage) gain and 28.7 dB sidelobe isolation for transmit band, and 37.49 dBi EOC gain and 31.1 dB sidelobe isolation for receive band, The electrical performances of the antenna have been verified via the electrical testing of a manufactured EQM (Engineering Qualification Model) antenna.

• The Journal of the Acoustical Society of Korea
• /
• v.18 no.6
• /
• pp.77-83
• /
• 1999

H.263 is an international standard of ITU-T that can makes the service such as video phone, video conference in the transmission line less than 64Kbps. This recommendation draft has used motion estimation/compensation, transform coding and quantizing methods. TMN5 used for the performance estimation of H.263 has fundamentally used DCT in transform coding method and presented quantizer for quantizing the DCT transform coefficient. This paper is presenting adaptive quantizer effectively able to quantize DCT coefficient considering the human visual sensitivity while the structure of TMN5 is maintaining. As quantizer that proposed DCT-based H.263 could make transmit more frame than TMN5 in a same transfer speed, it could lower the frame drop effect. And the luminance signal appeared the difference of -0.3 ～ +0.7dB in the average PSNR for the estimation of objective image quality and the chrominance signal appeared the improvement in about 1.5dB in comparision with TMN5. As a result it can attain the better image quality compared to TMN5 in the estimation of subjective image quality.

• Journal of the Institute of Convergence Signal Processing
• /
• v.9 no.3
• /
• pp.195-200
• /
• 2008

To compress the moving picture data effectively, it is needed to reduce spatial and temporal redundancy of input image data. While motion estimation! compensation methods is effectively able to reduce temporal redundancy but it is increased computation complexity because of the prediction between frames. So, the study of algorithm for computation reduction and real time processing is needed. This paper is presenting quantizer effectively able to quantize DCT coefficient considering the human visual sensitivity. As quantizer that proposed DCT-based H.263 could make transmit more frame than TMN5 at a same transfer speed, and it could decrease the frame drop effect. And the luminance signal appeared the difference of $-0.3{\sim}+0.65dB$ in the average PSNR for the estimation of objective image quality and the chrominance signal appeared the improvement in about 1.73dB in comparision with TMN5. The proposed method reduces $30{\sim}31%$ compared with NTSS and $20{\sim}21%$ compared to 4SS in comparition of calculation quantity.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.6
• /
• pp.871-881
• /
• 2001

In this paper, the effect of soft handoff technique on CDMA cell coverage is analyzed in a lognormally shadowed channel, which uses the Hata propagation model, Also, the rate of increase for the cell coverage is analyzed by calculating the hard and soft handoff margin. When the outage probability is 0.02 and the standard deviation of the received signal is 2.5 dB in a lognormally shadowed channel, the transmit power of the mobile station which is located in the cell boundary is increased by the hard handoff margin of 5.13 dB and by the soft handoff margin of 3.68 dB, respectively. So, the rate of increase for the cell coverage is 1.39 in case of using the soft handoff technique. It is shown that if the (E$\_$b//N$\_$0/)$\_$req/ value is 7 dB, the cell coverage of the CDMA cellular system with soft handoff technique in city area is 3.33 km in case of the 850 MHz frequency and 1.36 km in case of the 1900 MHz frequency. Also, the accurate cell coverage with soft handoff technique is supported that could be serviced by the base-station in CDMA cellular system.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.5
• /
• pp.672-683
• /
• 1990

The line code for ISDN subscriber loops is a critical choice in designing U-interface transceiver, since it affects system performance in a crucial way. This paper provides the performance analysis of U-interface transceiver systems employing four different line codes AMI, MMS43, VMDB5, and 2B1Q. The codes are compared using computer simulation studies, and three performance parameters of the four codes such as power spectrum, eye width, and error probability are used for the comparison. The simulation model consists of the encoder, transmit filter (root-raised cosine filter), channel, receive filter, zero-forcing equalizer, sampler, and decoder. The near-end crosstalk and addive white gaussian noise are considered as teh principal impediments.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.4 no.1
• /
• pp.74-81
• /
• 2004

We propose a novel scheme to transmit high center frequency RF signals using electroabsorption devices (EADs) as frequency converters at the transmitter and the receiver. In this approach frequency heterodyning is employed for obtaining high center frequency. With the EAD as a detector/mixer at the receiver we demonstrated a smaller conversion loss than that of the conventional modulator/mixer. With EAD as a modulator/mixer at the transmitter and with two heterodyned lasers to generate an optical local oscillator (LO), we demonstrated a large reduction (${\sim}23dB$) in conversion loss, and the transmission is not limited by the optical saturation of the EAD. This transmission scheme has optical single-side-band transmission feature which greatly relieves the fiber dispersion effect.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.1
• /
• pp.35-42
• /
• 2003

Differential signaling has become a popular choice for high-speed interconnection schemes on Printed Circuit Boards (PCBs), offering superior immunity to external noise. However, conventional differential transmission lines on PCBs have problems, such as crosstalk and radiated emission. To overcome these, we propose a Twisted Differential Line (TDL) structure on a multi-layer PCB. Its improved immunity to crosstalk noise and the reduced radiated emission has been successfully demonstrated by measurement. The proposed structure is proven to transmit 3 Gbps digital signals with a clear eye-pattern. Furthermore, it is subject to much less crosstalk noise and achieves a 13 dB suppression of radiated emission. Index Terms - Twisted Differential Line, Differential Signaling, Crosstalk, Radiated Emission, Transmission Line, Twisted Pair

• Journal of Internet Computing and Services
• /
• v.12 no.3
• /
• pp.111-117
• /
• 2011

In this paper, the BER(Bit Error Rate) performance of a DVB-T2(Second Generation Digital Terrestrial Television Broadcasting System) in MISO(Multiple Input Single Output) transmission mode is evaluated by the computer simulation. In the DVB-T2 receiver, an IDD(Iterative Demapping and Decoder) technique is employed that exchanges extrinsic information between the demapper and the LDPC decoder. Simulation results show that the IDD-based DVB-T2 receiver in MISO transmission mode provides 2dB gain at BER of $10^{-4}$ but suffer from the frequency offsets between transmit antennas.