The aim of this study was to investigate and identify the differences in lower extremity energy dissipation strategies between drop-landing and countermovement-jump maneuvers. Fourteen recreational athletes(Age : $23.3{\pm}2.1years$, Height : $172.3{\pm}4.0cm$, Weight : $69.2{\pm}4.7kg$) were recruited and instructed to perform drop-landing from 45 cm height and countermovement-jump from 45 cm to 20 cm height. The landing phase was taken as the time between initial contact and peak knee flexion. A motion-capture system consisting of eight infra-red cameras was employed to collect kinematics data at a sampling rate of 200 Hz and a force-plate was used to collect GRF data at a sampling rate of 2000 Hz. Paired t-test was performed to determine the difference in kinematics and kinetics variables between each task. During the countermovement-jump task, all of lower extremity joint ROM and the hip joint eccentric moment were decreased and the ankle joint plantarflexion moment was increased than drop-landing task. In the eccentric work during countermovement-jump task, the ankle joint displayed greater while knee and hip joint showed lesser than drop-landing. Therefore, the knee joint acted as the key energy dissipater during drop-landing while the ankle joint contributed the most energy dissipation during countermovement-jump. Our findings collectively indicated that different energy dissipation strategies were adopted for drop-landing and countermovement-jump.

The purpose of this study was to compare and analyze the finger pressure and kinematic variables in the forehand hairpin net shot between skilled elite players and less skilled recreational players. Eight elite players(age: $18.1{\pm}0.8yrs$, height: $176.8{\pm}1.5cm$, weight: $640.9{\pm}48.6N$) with minimum of 6 years of experience and eight recreational players(age: $27.9{\pm}1.6yrs$, height: $177.1{\pm}6.1cm$, weight: $820.5{\pm}62.8N$) with less than one year experience were recruited in this study. For each trial being analyzed, four critical instants were identified from the video recordings: Right heel contact1 (E1), Right toe-off (E2), Right heel contact2 (E3), and Shuttlecock Impact (E4). Each hairpin net shot was broken into consecutive phases: E1~E2 (Right Landing Phase: RLP), E2~E3 (Sliding Step Phase: SSP), and E3~E4 (Impact Phase: IP). Temporal parameters, shuttlecock speed, linear and angular kinematics of body segments, and finger pressures were computed for this study. The results showed that The finger pressure of the ring finger and the middle finger for the skilled group during an impact had significantly greater than those of unskilled group. It is possible that all fingers were not used in the same manner when the racket was gripped in forehand hairpin. The result also suggested that the ring finger and the middle finger pushed the racket from top to bottom while having the mid-phalanx and proximal phalanx of index finger as an axis.

This study was to perform the kinetic analysis of tucked backward salto on the balance beam. Eight women's gymnastics players(age: $15.88{\pm}2.45yrs$, career: $6.38{\pm}0.52yrs$, height: $152.38{\pm}7.35cm$, weight: $44.25{\pm}7.54kg$) of the I-region participated in this study. The kinematic variables were analyzed response time of motion, angle, velocity, acceleration and the kinetic variables were analyzed ground reaction force(GRF) of motion. For measure and analysis of kinematic and kinetic variables of this study, used to synchronized to 6 Eagle camera and 1 force plate, used to the Cortex(Ver. 1.0) for analyzed of variables. The results were as follows; To the kinematic variables of tucked backward salto on the balance beam, a time appeared longer landing than air rotation, changes of angle regulated segment of body smaller moment of inertia when air rotation, larger moment of inertia when releasing and landing. A velocity appeared fast motion when releasing and air rotation of body, but appeared more decelerations from landing and acceleration showed to be tended to velocity. A GRF appears jump more than twice the weight at the moment that showed the power of motion to all subject.

The purpose of this study was to determine the effects of landing height information on landing strategy during a drop landing. Ten healthy male subjects(age: $22.1{\pm}1.9year$, height: $178.4{\pm}7.8cm$, mass: $75.3{\pm}9.4kg$) participated in this study. Each participant was asked to jump with both legs off a 40 cm high box on one of the three plates with different thickness (0 cm, 13 cm, 26 cm). In the first condition, subjects were given both cognitive and visual information about the jumping heights. In the second, they were given only cognitive information without visual one, and in the third, no information about the height was provided to subjects. (Only the data collected from the 40 cm height landing were analyzed and reported in the present study.) The results showed that landing strategies during a double-leg drop landing from 40 cm height were not significantly affected by visual and cognitive information blockages. Also, there were no statistically significant differences in landing strategies between the three conditions even though the mean differences attained in this study seemed to warrant further studies investigating the relationship between landing strategies and cognitive information.

The purpose of this study was to investigate the effects of increased saddle height on the length and activity pattern of vastus lateralis (VL) and biceps femoris (BF) muscle. To compare the effects of increased saddle height, Preferred (self-selected height of subject) and High saddle height (approximately 5% higher saddle height than self-selected) were used. Seven elite cyclists (career: $16.1{\pm}8.5years$) participated in 3 min. sub-maximal pedaling tests under the same cadence (90 RPM) and pedaling power (150 W). Hip and knee joint angles, and the length and activity of VL and BF were compared by measuring 3D motion and electromyography (EMG) data. Results showed that there were significant differences in peak extension timing of the hip joint angle and the range of motion of the hip and knee joint between different saddle heights. Although there were significant differences in muscle length of both muscles with increasing saddle height, the timing and amount of muscle activity differed only at the BF. These findings suggest that the timing and amount of bi-articular muscle activity (i.e. BF) can be altered by changing the saddle height. For practically applying these results, further study is necessary to evaluate the effects of various cadence and the pedaling power with various saddle heights.

The purpose of this study was to verify the effects of developed assisting wear which maximize trunk(back) muscle's stretch-shortening effect during backswing and downswing for increasing golf ball carrying distance. Design and fabrication of assistive wear were performed based on the results of analyzed data of trunk EMG activity from the golf drive swings of elite professional male golfers during back swing and downswing phases. After the prototype of wear was produced, surface EMG and Flight scope tests were conducted to verify the effectiveness of the wear for increasing distance to the professional golfers. Results indicated that wearing trial showed significant longer carry distance than the non-wearing trial(p<.001). The carry distance of wearing trial showed an average 229 m compared to the non-wearing trial, the average 225 m. The swing with wearing also produced significantly faster ball speed than the trial without wearing(p<.05). Average 245 Km/h and 244 Km/h were produced for the swing with and without wearing trails, respectively. EMG results also indicated that the muscle activity of left psoas was significantly increased for wearing trial during downswing and near the impact. Thus, this may affect positively to increase club head speed. The activity of the left latissimus dorsi was dramatically increased during the final stage of swing. This generates elongation effect for longer follow-through and increased impulse between club and ball so eventually valid assistance to increase carry distance. Therefore, the developed assisting wear was proved to be effective tool for increasing golf ball carry distance with maximizing trunk(back) muscle's stretch-shortening effect during backswing and downswing.

The purpose of this study was to determine the biomechanical effect of wearing carbon nanotube-based insole on cushioning and muscle tuning during drop landing. Twenty male university students(age: $21.2{\pm}1.5yrs$, height: $175.4{\pm}4.7cm$, weight: $70.2{\pm}5.8kg$) who have no musculoskeletal disorder were recruited as the subjects. Average axial strain, average shear strain, inversion angle, linear velocity, angular velocity, vertical GRF and loading rate were determined for each trial. For each dependent variable, a one-way analysis of variance(ANOVA) with repeated measures was performed to test if significant difference existed among different three conditions(p<.05). The results showed that Average axial strain of line 4 was significantly less in CNT compared with EVA and PU during IP phase. The average shear strain was less in CNT compared with EVA and PU during other phases. The inversion angle was increased in CNT compared with EVA and PU during all phase. In linear velocity, angular velocity, vertical GRF and loading rate, there were no significant difference between the three groups. This result seems that fine particle of carbon nanotube couldn't make geometric form which can absolve impact force by increasing density through eliminating voids of forms. Thus, searching for methods that keep voids of forms may play a pivotal role in developing of insole. This has led to suggestions of the need for further biomechanical analysis to these factors.