DOI QR코드

DOI QR Code

다양한 피복두께를 가진 RC 보의 부식 거동 및 초음파 속도

Corrosion Behavior and Ultrasonic Velocity in RC Beams with Various Cover Depth

  • 남진원 (인하공업전문대학 건설환경공학과) ;
  • 양현민 (한양대학교 에리카 캠퍼스 스마트융합공학부 지속가능건축융합전공) ;
  • 권성준 (한남대학교 토목환경공학과)
  • Jin-Won Nam (Department of Civil and Environmental Engineering, Inha Techincal College) ;
  • Hyun-Min Yang (Division of Smart Convergence Engineering, Hanyang University ERICA) ;
  • Seung-Jun Kwon (Department of Civil and Environmental Engineering, Hannam University)
  • 투고 : 2023.07.05
  • 심사 : 2023.07.28
  • 발행 : 2023.09.30

초록

철근 콘크리트 구조물은 부식이 증가함에 따라 부식생성물로 인한 균열이 발생하고 하중저항 능력이 감소한다. 본 연구에서는 140시간 동안 촉진염해시험(ICM)을 적용하여 부식을 유도하였으며 부식 전후의 초음파속도 변화, 휨파괴 하중, 부식생성물량을 평가하였다. 피복두께를 3수준(20 mm, 30 mm. 40 mm)으로 고려하였는데, 피복두께가 증가할수록 균열발생시기 및 부식생성량이 증가하였다. 또한 초음파 속도는 피복두께의 감소 및 부식생성량의 증가에 따라 뚜렷한 선형관계를 가지고 감소하였다. 휨파괴 하중의 경우 부식에 따라 10 % 이상 휨하중이 감소하였으나, 명확한 상관성을 도출할 수 없었는데, 이는 부식률이 작으므로 철근단면적의 감소 영향보다 슬립에 의한 영향이 크기 때문이다. 피복두께가 증가함에 따라 부식생성량 및 초음파 속도는 뚜렷한 선형관계를 가지고 변화하였으며, 부식으로 인한 균열발생 시간은 평가된 전류의 기울기를 분석하여 추측할 수 있었다.

With increasing corrosion in RC (Reinforced Concrete) structures, cracks occurred due to corrosion products and bearing load resistance decreased. In this study, corrosion was induced through an accelerated corrosion test (ICM: Impressed Current Method) with 140 hours of duration, and changes in USV (Ultra-Sonic Velocity), flexural failure load, and corrosion weight were evaluated before and after corrosion test. Three levels of cover depth (20 mm, 30 mm, and 40 mm) were considered, and the initial cracking period increased and the rust around steel decreased with increasing cover depth. In addition, the USV linearly decreased with decreasing cover depth and increasing amount of corrosion. In the flexural loading test, the bending capacity decreased by more than 10% due to corrosion, but a clear correlation could not be obtained since the corrosion ratio was small, so that the effect of slip was greater than that of reduced cross-sectional area of steel due to corrosion. As cover depth increased, the produced corrosion amount and USV changed with a clear linear relationship, and the cracking period due to corrosion could be estimated by the gradient of the measured corrosion current.

키워드

과제정보

본 연구는 한남대학교 연구년(2022)에 대한 연구 결과로 저자는 이에 감사드립니다.

참고문헌

  1. Abo-Qudais, S.A. (2005). Effect of concrete mixing parameters on propagation of ultrasonic waves, Construction and Building Materials, 19(4), 257-263.  https://doi.org/10.1016/j.conbuildmat.2004.07.022
  2. Ali, H., Assih, J., Li, A. (2021). Flexural capacity of continuous reinforced concrete beams strengthened or repaired by CFRP/GFRP sheets, International Journal of Adhesion and Adhesives, 104, 102759. 
  3. Alonso, C., Castellote, M., Andrade, C. (2002). Chloride threshold dependence of pitting potential of reinforcements, Electrochimica Acta, 47(21), 3469-3481.  https://doi.org/10.1016/S0013-4686(02)00283-9
  4. American Concrete Institute (2002). ACI Committee-362, Guide for the Design of Durable Parking Structures; ACI 362, 1R-97; American Concrete Institute (ACI): Detroit, MI, USA. 
  5. Baek, S., Xue, W., Feng, M.Q., Kwon, S. (2012). Nondestructive corrosion detection in RC through integrated heat induction and IR thermography, Journal of Nondestructive Evaluation, 31, 181-190.  https://doi.org/10.1007/s10921-012-0133-0
  6. Bentz, E.C. (2003). Probabilistic modeling of service life for structures subjected to chlorides, Materials Journal, 100(5), 391-397.  https://doi.org/10.14359/12814
  7. BS 1881 (1986). Part 203, Recommendations for Measurement of Velocity of Ultrasonic Pulses in Concrete, British Standards Institution, 56-58. 
  8. Elsener, B. (2005). Corrosion rate of steel in concrete-measurements beyond the tafel law, Corrosion Science, 47(12), 3019-3033.  https://doi.org/10.1016/j.corsci.2005.06.021
  9. European Committee for Standardization (2000). Eurocode 1: Basis of Design and Actions on Structures, EN-1991, Brussels, Belgium, 2-27. 
  10. Japan Society of Civil Engineering (2007). Standard Specification for Concrete Structures-Design: JSCE Guidelines for Concrete 15, Tokyo, Japan, 3-38. 
  11. Karaiskos, G., Deraemaeker, A., Aggelis, D.G., Van Hemelrijck, D. (2015). Monitoring of concrete structures using the ultrasonic pulse velocity method, Smart Materials and Structures, 24(11), 113001. 
  12. Kim, Y.Y., Oh, K.C., Park, K.T., Kwon, S.J. (2015). Modeling on ultrasonic velocity in concrete considering micro pore structure and loading conditions, The Journal of the Korea Contents Association, 15(3), 415-426. [in Korean]  https://doi.org/10.5392/JKCA.2015.15.03.415
  13. Kohl, C., Streicher, D. (2006). Results of reconstructed and fused NDT-data measured in the laboratory and on-site at bridges, Cement and Concrete Composites, 28(4), 402-413.  https://doi.org/10.1016/j.cemconcomp.2006.02.005
  14. Krause M., Mielentz F., Milman B., Muller W., Schmitz V., Wiggenhauser, H. (2001). Ultrasonic imaging of concrete members using an array system, NDT & E International, 34(6), 403-408.  https://doi.org/10.1016/S0963-8695(01)00007-X
  15. Kwon, S.J., Na, U.J., Park, S.S., Jung, S.H. (2009). Service life prediction of concrete wharves with early-aged crack: probabilistic approach for chloride diffusion, Structural Safety, 31(1), 75-83.  https://doi.org/10.1016/j.strusafe.2008.03.004
  16. Kwon, S.J., Park, S.S. (2012). Non destructive technique for steel corrosion detection using heat induction and IR thermography, Journal of the Korea Institute for Structural Maintenance and Inspection, 16(2), 40-48 [in Korean].  https://doi.org/10.11112/jksmi.2012.16.2.040
  17. Lee, B.Y., Koh, K.T., Ismail, M.A., Ryu, H.S., Kwon, S.J. (2017). Corrosion and strength behaviors in prestressed tendon under various tensile stress and impressed current conditions, Advances in Materials Science and Engineering, 2017. 
  18. Lee, S.K. Zielske, J. (2014). An FHWA Special Study: Post-Tensioning Tendon Grout Chloride Thresholds, Federal Highwat Administration, FHWA-HRT-14-039. 
  19. Olsen, K.R. (2009). Ultrasonic Detection of Simulated Corrosion in 1 inch Diameter Steel Ttieback Rods, Washington State University. 
  20. RILEM (1994). Durability Design of Concrete Structures, Report of RILEM Technical Committee 130-CSL, E&FN, London, 28-52. 
  21. Sakurada, S., Irie, H., Yoshida, Y. (2008). Development of reinforced concrete corrosion amount presumption method by ultrasonic method, 17th World Conference on Nondestructive Testing, Shanghai, China, 1-6. 
  22. Stewart, M.G., Rosowsky, D.V. (2004). Time-dependent reliability of deteriorating reinforced concrete bridge decks. Structural Safety. 20(1), 91-109.  https://doi.org/10.1016/S0167-4730(97)00021-0
  23. Yeih, W., Huang, R. (1998). Detection of the corrosion damage in reinforced concrete members by ultrasonic testing, Cement and Concrete Research, 28(7), 1071-1083.  https://doi.org/10.1016/S0008-8846(98)00060-X
  24. Zhou, Z., He, J., Chen, G., Ou, J. (2009). A smart steel strand for the evaluation of prestress loss distribution in post-tensioned concrete structures, Journal of Intelligent Material Systems and Structures, 20(16), 1901-1912. https://doi.org/10.1177/1045389X09347021