초록
액체로켓엔진은 연소기, 터보펌프, 가스발생기, 각종 밸브 및 배관, 조인트, 오리피스, 튜브, 하니스, 센서 등이 결합되어있는 매우 복잡한 시스템이다. 대부분의 액체로켓엔진 부품은 IT(ISO Tolerance) 기준으로 6등급 이상의 높은 정밀도를 요구하며 정상운용 전후 시동과 종료 등과 같은 비정상 시의 응답에도 대응해야한다. 따라서 엔진 시스템 및 부품은 넓은 영역에서 안정적으로 동작할 수 있도록 설계되어야하며 조립은 이러한 설계철학을 충실히 반영하여야 한다. 엔진 설계 시에는 부품 간에 물리적 혹은 기능적 간섭이 없도록 공간배치를 해야 하며 조립 중 조립성과 조립 후 유지보수의 효율성까지도 고려되어야 한다. 특히 양산품이 아닌 개발 단계에서는 조립 중 부품 간 공차의 누적, 각종 구성품의 비정렬, 부품 인터페이스 간의 불일치 등이 발생할 수 있다. 즉, 엔진조립공정은 개발 중 내재되어있는 각종 위험이 현실화 되는 위기 혹은 예상치 못한 사건(incident)이 발생하기 쉬운 작업이다. 그러므로 조립 중 사건이 발생했을 경우를 대비한 신속한 대응시스템이 구비되어야한다. 이 연구에서는 위에서 언급한 사항들의 기본적 대응방법과 한국형발사체에 탑재되는 7 tonf 급 엔진의 실제 조립공정을 다루었다.
Liquid rocket engines (LREs) are very complex systems that include combustion chambers, turbopumps, gas generators, ducts and tubes, valves and etc. Most components of the LREs require higher than or equal to level 6 IT (ISO Tolerance). The components along with pipe line and/or tubing must dispose not to interfere each other. In addition, effectiveness of maintenance and service after assembling should be considered when the allocation of the components are determined. Especially at the stage of the development, tolerance accumulations or unpredictable errors may result in misalignment and/or mismatches at interfaces of the parts. Namely, it is the engine assembling process that many inherent risks are realized and crises or incidents occur. Therefore, a rapid reaction system should be prepared. In this research, 7 tonf class liquid rocket assembling process was studied and actual building steps were introduced.