Transactions of the Korean Society of Automotive Engineers (한국자동차공학회논문집)

The Korean Society of Automotive Engineers (한국자동차공학회)
권호 표지
DOI QR코드

DOI QR Code

Comparison in Braking Force Characteristics for the Static and Dynamic Braking Force Inspection System about Vehicles in Service

운행 자동차에 대한 정적 및 동적 제동력 검사 시스템의 제동력 특성 비교

  • Oh, Sangyeob (School of Automotive Engineering, Kyungpook National University)
  • Received : 2015.02.25
  • Accepted : 2015.03.30
  • Published : 2015.05.01
Download PDF
⟨ Previous Next ⟩

Abstract

Braking force inspection of vehicles in service is certainly one of the most important characteristics that affect vehicle safety. Up to now, in domestic country, the regular safety inspection of vehicles in service has been tested with a roller type brake test (a static braking force inspection system). But, in EU and USA etc. in recent years, it has been tested with a plate type brake test (a dynamic braking force inspection system). In this study, to compare the characteristics of above two test systems, the correlations for the results of braking force are evaluated statistically. As the results, in the case of main braking force, the range of the $R^2$ of the deviation for the left and right side is 0.5386 ~ 0.6231 in the rear axle and 0.0032 ~ 0.0052 in the front axle respectively, then the $R^2$ in the front axle is lower than that in the rear axle and the total variation is unexplained by the least-squares regression line statistically. Also, the p-value for the deviation of the left and right in the front axle is 0.4839 ~ 0.5755, then it has nonsignificant in the front axle. Therefore, the static braking force inspection system can not reflect the inertia force that there is a load transfer from the rear axle to the front axle during braking. Accordingly, it is necessary to adopt the dynamic braking force inspection system which can reflect the inertia force on the regular vehicle safety inspection in domestic country.

Keywords

References

  1. H. D. Kim and Y. C. Lim, "A Study on the Characteristics of Automotive Brake Pedal Force," Auto Journal, KSAE, Vol.15, No.2, pp.64-75, 1993.
  2. D. H. Shim, D. Y. Kim and S. H. Ko, "A Study on the Effect Driving Speed and Braking Power on Squeal Noise of Disk Brake," KSAE Spring Conference Proceedings, pp.2189-2194, 2006.
  3. S. D. Kim, N. H. Kim and H. M. Kim, "A Study on a Comparison between the Mechanical System and the Fuzzy Control Electronic System for Braking Force Distribution," KSAE Spring Conference Proceedings, pp.437-444, 2000.
  4. C. G. Ok, T. W. Park, S. P. Jung and J. H. Lee, "Integrative Analysis of Automotive Brake System to Estimate Braking Feeling," KSME Spring Conference Proceedings, pp.736-741, 2009.
  5. I. S. Choi, J. M. Ahn, K. S. Cho and S. W. Cho, "A Consideration on the Market Situation and the Safety Evaluation Method of the Motor Vehicle Equipped with Brake Assist System," KSAE Spring Conference Proceedings, pp.1933-1940, 2010.
  6. M. S. Pak and S. H. Kim, "The Development of Braking Ratio Measuring Technique Using Wheel-torque Meter," KSAE Fall Conference Proceedings, pp.601-607, 1996.
  7. U. S. Yeo, W. D. Park, Y. D. Jung and B. D. Kang, "A Study on Introduction to Dynamic Braking Inspection Equipment of a Vehicle in Service," KSAE Spring Conference Proceedings, pp.1266-1272, 2013.
  8. S. Y. Oh and W. D. Park, "Comparison in Emission Inspection System of a Gasoline Vehicle in Service," Transactions of KSAE, Vol.22, No.1, pp.1-7, 2014.
  9. U. S. Yeo, W. D. Park, Y. D. Jung and B. D. Kang, "A Study on Improvement to Underbody Inspection of a Vehicle in Service," KSAE Spring Conference Proceedings, pp.1254-1259, 2013.
  10. B. D. Kang, Y. D. Jung, C. D. Kim, W. D. Park, K. S. No, U. S. Yeo and Y. J. Lee, A Study for Inspection Standard by Advanced Vehicle Inspection System Technology, Final Report, Inspection Standard Office, Korea Transportation Safety Authority, 2012.
  11. J. J. Kwon and D. W. Lee, "Research on the Relation of the Exhaust Gas Concentration between Lug-Down3 Test Mode and D147 Test Mode on the Driving Car Using Diesel Fuel," Proceeding of the 47th Meeting of KOSAE, pp.62-65, 2008.
  12. H. S. Joo, J. E. Sim and J. R. Kim, "Quantitative Effectiveness Analysis of Vehicle Inspection," Journal of Korean Society of Transportation, Vol.25, No.3, pp.65-74, 2007.
  13. Y. H. Park, J. C. Kim, S. I. Kwon, T. W. Lee and J. T. Lee, "A Study on the Improvement In-use Vehicle Inspection & Maintenance Program By RSD (Remote Sensing Detector)," KSAE Fall Conference Proceedings, pp.159-164, 2005.
  14. S. Y. Oh, H. I. Lee, G. W. Kim and I. S. Che, A Study for High Technology Vehicle Inspection System, Final Report, School of Automotive Engineering, Kyungpook National University, 2012.
  15. S. Y. Oh, U. S. Yeo, W. D. Park, Y. D. Jung and B. D. Kang, "Improvement in Emission Inspection System of a Gasoline Vehicle in Service," KSAE Annual Conference Proceedings, pp.536-542, 2012.
  16. S. Y. Oh, "Effect on Dynamic Braking Force Inspection System for Entering Velocity Vehicles in Service," KSMT, in Press, Corrected Proof, 2015.
  17. MOLIT (Minister of Land, Infrastructure and Transport, https://stat.molit.go.kr/portal/main/portalMain.do, 2015.
  18. Y. M. Ha, "A Report on 4 Judicial Precedents of the Supreme Court of Korea Concerning Brake System Failure," KSAE Spring Conference Proceedings, pp.1018-1023, 2006.
  19. J. Y. Wong, Theory of Ground Vehicles, 3rd Edn., John Wiley & Sons, New York, pp.203-271, 2001.
  20. K. Newton, W. Steeds and T. K. Garrett, The Motor Vehicle, 12th Edn., SAE, Manchester, pp.804-829, 1996.