초록
ALINEA는 램프의 하류부에 설치된 검지기를 이용하여 최적의 차량점유율 상태를 유지하도록 유입램프의 교통량을 조절하는 방안으로 검지기를 이용한 차량의 점유율을 제어 변수로 이용하고 있다. 하지만, 현재 가장 널리 사용되고 있는 루프제어기 점유율의 정확도가 비교적 낮다는 점과 점유율은 검지기 길이의 함수로서 ALINEA의 적용 시 설치 지점마다, 그리고 검지기 길이마다 최적 점유율 보정과정이 필요한 점을 감안할 때 현재 사용 중인 ALINEA를 보완할 필요가 있다. 관리자와 이용자 측면에서 점유율이 사실상 인지하기 어려운 변수임을 감안할 때 쉽고 간편한 변수의 사용을 통한 모형개발이 의미를 가질 수 있을 것이다. 본 연구에서는 ALINEA 알고리즘의 기본 개념을 이용하되 제어변수인 점유율을 이용할 때의 불편한 점 및 단점을 일부 개선시킬 수 있는 속도 변수를 이용하여 ALINEA 모델을 보완하고자 한다.
ALINEA algorithm, which is one of the best on-ramp metering algorithms, was designed to control the traffic volume from on-ramp in order to maintain the optimal occupancy rate of the detectors installed downstream of the merge area. But, the reliability of occupancy rate estimated from the loop detectors, which are used most commonly in Korea, is relatively lower than other parameters such as speed and volume. Moreover, because occupancy rate depends on the length of loop detectors and site, lots of calibration work is required whenever they are installed in order to estimate the occupancy rate. Therefore, there exists room for improvement of ALINEA algorithm because only occupancy rate having some problems is considered as a control parameter in ALINEA algorithm. Practically it is difficult to measure or perceive the occupancy rate for traffic engineers and drivers. On the other hand, speed can be good alternative which can overcome the defect induced by using occupancy. In this study, occupancy based ALINEA algorithm is converted to speed based ALINEA assuming the linear relationship between density and speed.