DOI QR코드

DOI QR Code

Modified Similitude Law for Pseudodynamic Test on Small-scale Steel Models

철골 축소모헝의 유사동적실험을 위한 수정된 상사법칙

  • Kim, Nam-Sik (Technology Research Center of Hyundai Engineering and Construction) ;
  • Kwak, Young-Hak (Yooshin Engineering Corporation ) ;
  • Chang, Sung-Pil (Dept.of Earth Environment System Engineering, Seoul National University)
  • Published : 2003.12.01

Abstract

Although there are several experimental techniques to evaluate the seismic behavior and performance of civil structures, small-scale models in mast of physical tests, instead of prototypes or large-scale models, would be used due to a limitation on capacities of testing equipments. However, the inelastic seismic response prediction of small-scale models has some discrepancies inherently because the similitude law is generally derived in the elastic range. Thus, a special attention is required to regard the seismic behavior of small-scale models as one of prototypes. In this paper, differences between prototypes and small-scale models pseudodynamically tested on steel column specimens are investigated and an alternative to minimize them is suggested. In general, small-scale models could have the distorted stiffness induced from some experimental errors on test setup, steel fabrication and so on. Therefore, a modified similitude law considering both a scale factor for length and a stiffness ratio of small-scale model to prototype is proposed. Using the modified similitude law to compensate experimental errors, the pseudodynamic test results from modified small-scale model are much improved as compared with the results of prototype. According to the pseudodynamic test results of small-scale steel models, it can be concluded that the modified similitude law proposed could be effective in simulating the seismic response of prototype structures.

지진하중에 대한 구조물의 동적 거동과 내진성능을 평가하기 위하여 유사동적실험기법이 흔히 사용되고 있으나, 실험장비의 제약과 구조물의 규모 등으로 대부분 축소모형실험에 의존하고 있다. 그러나 일반적인 상사법칙은 탄성범위에서 유도된 것으로 지진거동과 같은 비탄성 거동을 예측하는 경우에는 한계가 있기 때문에 축소모형의 실험결과를 원형 구조물에 직접 적용하는 것은 많은 주의가 필요하다. 본 연구에서는 원형구조물과 축소모형에 대한 철골모형을 실험 대상으로 하여 실제 축소모형 실험결과로부터 원형구조물의 거동을 예측하는 경우의 문제점을 확인하고, 그 해결방법을 모색하고자 한다. 실제로 축소모형실험에서는 원형구조물의 경계조건을 정확히 재현하기 어려우며, 축소모형의 제작과정과 실험과정에서의 모든 오차가 강성의 변화로 반영되어 나타난다. 따라서 본 연구에서는 기하학적 상사율과 축소모형의 변화된 강성비를 함께 고려한 수정된 상사법칙을 제안하였으며, 수정된 상사법칙이 적용된 축소모형에 대하여 유사동적실험을 수행하여 지진응답결과를 원형구조물의 결과와 비교하였다. 축소모형에 대한 유사동적실험결과로부터 제안된 상사법칙을 적용함으로써 원형구조물의 지진응답 재현이 효과적임을 입증하였다.

Keywords

References

  1. Richards, C. W., “Size effect in the tension test of mild steel beams,” Proc. of ASTM, Vol. 54, 1954, pp. 995-1002.
  2. Zhang, M. Z., “Study on similitude laws for shaking table tests,” Chinese Earthquake Engineering and Engineering Vibration, Vol. 17, No. 2, 1997(in Chinese).
  3. Zhang, M. Z., Guo, X. and Dai, J. W., “Shaking table tests of a high-rise building model,” Proc. of the Fifth International Conference on Tall Buildings, Hong Kong, 1998.
  4. Meng, Q. L., “The dynamic simulation of nonlinear performance of R/C structures in the earthquake simulation shaking table test,” Master dissertation of Institute of Engineering Mechanics, China Seismological Bureau, Harbin, 2001.
  5. Kim, W., El-Attar, A., and White, R. N., “Small-scale modeling techniques for reinforced concrete structures subjected to seismic loads,” Technical report NCEER-88-0041, State University of New York at Buffalo, New York, 1988.
  6. Lu, Y., Vintzileou, E., Zhang, G. F., and Tassios, T. P., “Reinforced concrete scaled columns under cyclic actions,” Soil Dynamics and Earthquake Engineering, Vol. 18, 1999, pp. 151-167. https://doi.org/10.1016/S0267-7261(98)00037-2
  7. Mahin, S. A. and Shing, P. B., “Pseudodynamic test method-current status and future directions,” Journal of Structural Engineering, ASCE, Vol. 115, No. 8, 1989, pp. 2113-2128. https://doi.org/10.1061/(ASCE)0733-9445(1989)115:8(2113)
  8. Usami, T. and Kumar, S., “Damage evaluation in steel box columns by pseudodynamic tests,” Journal of Structural Engineering, ASCE, Vol. 122, No. 6, 1996, pp. 635-642. https://doi.org/10.1061/(ASCE)0733-9445(1996)122:6(635)
  9. Kumar, S., Itoh, Y., Saizuka, K. and Usami, T., “Pseudodynamic testing of scaled models,” Journal of Structural Engineering, ASCE, Vol. 123, No. 4, 1997, pp. 524-526. https://doi.org/10.1061/(ASCE)0733-9445(1997)123:4(524)
  10. Zung, Z. M., Chang, S. P., and In, S. B., “The seismic performance for concrete-filled steel piers,” Proceedings of Earthquake Engineering of Korea, Vol. 6, No. 2, 2002. 9, pp. 189-196(in Korean).
  11. Kim, N. S. and Lee, D. G., “Pseudodynamic test for evaluation of seismic performance of base-isolated liquid storage tanks,” International Journal of Engineering Structures, Vol. 17, No. 3, 1995, pp. 198-208. https://doi.org/10.1016/0141-0296(95)00076-J
  12. Chung, W. J., Yun, C. B., Kim, N. S., and Seo, J. W., “Shaking table and pseudodynamic tests for the evaluation of the seismic performance of base-isolated structures,” International Journal of Engineering Structures, Vol. 21, 1999, pp. 365-379. https://doi.org/10.1016/S0141-0296(97)00211-3
  13. Harris, H. G. and Sabnis, G. M., Structural modeling and experimental techniques, CRC Press, New York, 1999.
  14. Korean Standard Handbook, Steel(I), KSA, 2001.
  15. Annual book of ASTM standards, Section 1, Vol. 01.04, ASTM, 1992.

Cited by

  1. On similitude law of sub-systems vol.5, pp.1, 2006, https://doi.org/10.1007/s11803-006-0605-2