• Korean Journal of Organic Agriculture
• /
• v.16 no.4
• /
• pp.455-469
• /
• 2008

A research was conducted to investigate the effect of treatment of woody charred materials such as wood vinegar, charcoal, and mixture of wood vinegar and charcoal on the growth and components of tomato and chinese cabbage. The effect of treatment of woody charred materials on the growth and components of tomato the research findings are as follows. The total number of soil microorganisms increased in the groups treated with woody charred materials compared with the control. The fruit number, fruit length, fruit diameter, fruit weight, hardness and sugar contents of tomato did not show significant difference in all plots treated with woody charred materials, but the plot treated with wood vinegar + charcoal showed relatively higher values in general. Vitamin C contents were shown higher in the plots treated with woody charred materials than the control, and among the treatment plots. The effect of treatment of woody charred materials on the growth and components of chinese cabbage the research findings are as follows. The soil chemical components did not change before and after the treatment of woody charred materials. The total number of soil microorganisms increased in the treatment plots compared with the control, The leaf length, leaf width, inner leaf number, plant weight, and head weight of Chinese cabbage treated with woody charred materials were in general larger than the control. Among the treatment plots, the plot treated with wood vinegar + charcoal showed slightly higher values. The contents of minerals in chinese cabbage such as Ca, Fe, K, Mg and Mn were higher in the treatment plots than the control.

• Journal of the Korean Wood Science and Technology
• /
• v.33 no.3 s.131
• /
• pp.45-52
• /
• 2005

This research was performed to evaluate adsorption behavior of woody charcoals obtained from wood powder, fiber and bark of spruce (Abies sibirica Ledeb). The wood materials were carbonized at various temperatures for 1 hour using experimental rotary kiln without any inert gas. The adsorption capacity of iodine and toluene, specific surface area and removal efficiency of acetic acid and ammonia gas of those charcoals were measured. The higher was the temperature for carbonization, the lower yields of charcoals were. Ash content of bark charcoal was higher than that of wood powder charcoal or fiber charcoal. Elemental analysis of woody charcoal revealed that the content of carbon was gradually lincreased as carbonization temperature was higher. When carbonization temperature was higher, adsorption capacity of woody charcoals for iodine was much improved. Wood powder charcoal and fiber charcoal were more effective for iodine adsorption rather than bark charcoal. Capacity of toluene adsorption was the highest in the charcoal of $600^{\circ}C$. Charcoals produced at high temperature efficiently removed acetic acid gas, while charcoals carbonized at low temperature such as $400^{\circ}C$ were proper to remove ammonia gas. This difference may be explained that the acidity of charcoals depends on the carbonization temperature: charcoals of low temperature indicate acidic property, while those of high temperature turned to alkaline.

• Journal of the Korean Wood Science and Technology
• /
• v.36 no.6
• /
• pp.69-76
• /
• 2008

To estimate removal ability of harmful gas by charcoal, we carbonized Red oak (Quercus mongolica Fischer) wood and Larch (Larix leptoepis) bark at $300^{\circ}C$, $600^{\circ}C$ and $900^{\circ}C$ for 1 hour. Gas removal ratios was increased with carbonization temperature but there is no difference between wood and bark charcoal. In the case of bad smell and VOC gas, woody charcoal including bark charcoal carbonized at $300^{\circ}C$ showed low removal ratio, less than 50%, whereas woody charcoals which was carbonized at more than $600^{\circ}C$ reached almost 100% removal ratio to bad smell gas such as trimethylamine, methymercaptan, hydrogen sulfide, and to VOC such as benzene, toluene, xylene in $5{\ell}$ tedler bag with each gas of 100 ppm. It was thought that because charcoals carbonized at high temperature, for example, $600^{\circ}C$ or $900^{\circ}C$ have enough specific surface area to adsorb gas of 100 ppm. Moreover these charcoals rapidly removed almost gas in 10 minutes. However, acetylene, $SO_2$ and $NO_2$, charcoals which was carbonized more than $600^{\circ}C$ and which showed high removal ratio had low gas removal ratio of 40% at even 4 hours adsorption. It was concluded that adsorptive ability of woody charcoal was mainly influenced with carbonizing temperature, so that different charcoals carbonized at different temperature brings different gas removal ratio because these charcoals have not only different physical factor such as specific surface area but different chemical characteristic such as functional group, expected.

• Journal of the Korean Wood Science and Technology
• /
• v.35 no.3
• /
• pp.53-60
• /
• 2007

Carbon content, properties of micro-pore, and chemical properties of the charcoal prepared from wood powder, wood fiber, and bark of Abies sibirica Ledeb at different temperatures were investigated. The yield of charcoal decreased with increasing the carbonization temperature. The yield of bark charcoal was higher than those of wood and wood fiber charcoal. The content ratio of carbon atom in the charcoal increased with increasing the carbonization temperature, whereas those of hydrogen and oxygen atom were decreased. Ash content of bark charcoal was also higher than those of wood and wood fiber charcoal. The specific surface area of wood and wood fiber charcoal was greater than that of bark charcoal. In all charcoal, the specific surface area and the volume of micro-pore were highest when the carbonization temperature was $600^{\circ}C$, however they tended to decrease when the temperature was reached to $800^{\circ}C$. For the functionality test of chemical groups on the charcoal surface, adsorption test have performed against acidic (HCl) and basic chemicals (NaOH, $Na_2CO_3$, and $NaHCO_3$). As carbonization temperature increased, adsorption amount of HCl increased, while adsorption amounts of NaOH, $Na_2CO_3$, and $NaHCO_3$ were decreased. The charcoal prepared at higher temperature showed basic properties, while the charcoals manufactured at lower temperature presented acidic properties. Therefore, it was considered that the carbonization temperature affected the pH of charcoal.

• Korean Journal of Environmental Agriculture
• /
• v.12 no.1
• /
• pp.1-8
• /
• 1993

This study was conducted to investigate the effect of woody chared materials on the injuries and growth of plant, and chemical properties of soil in the continuous cropping field of red pepper. The field for the experiment was selected among districts, where have been taking place seriously injuries by continuous cropping of red pepper for above 20 years. The growth of red pepper was promoted and the growing period was prolonged about 2 weeks longer than that of control, and yield was increased with the increment of charcoal application amount. The occurrance rate of phytopthora blight disease was 9% lower at charcoal 500 kg/l0a application treatment than at control in the experiment of application amount of the first year, but was not significantly different between sizes of charcoal. The mix of charcoal and pyroligeous liquor had no effect on the growth of red pepper. In applicated soil of charcoal, pH was increased, EC was decreased, and Ca and Mg content was low somewhat. In all, charcoal granule was most effective type. The B/F value of soil was higher at the charcoal powder treatment on July 18 than other treatment, but was no difference between treatments in anytime else.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.48 no.3
• /
• pp.63-71
• /
• 2006

A downdraft gasifier was made of stainless steel for biomass gasification. Internal reactor had a 300 mm diameter and 8 air intakes. Three thermocouples were installed to measure the temperature inside the reactor. Three different biomass fuels were provided in the experiments to find out the effects of fuel conditions on gasification processes; charcoals, woodchips, and mixture of woodchip and charcoals. Two different experiments were conducted fer charcoal experiments, small and larger sizes of charcoal fuels. It took about 10 minutes after ignition to generate combustible producer gas when charcoal was f9d, but 20 or more minutes for woodchips. When the gasification was stabilized, the highest temperature was observed just below the combustion zone. The air flow rate for woodchip experiment was provided at 25% of a stoichiometric requirement of combustion, which was within the range of typical air flow rate fer woody biomass gasification. Carbon monoxide concentrations were also within the values reported in the previous studies, ranging 20 to 30% depending on fuel types. It could be seen that fuel size and heating value were very important parameters in biomass gasification. These parameters should be taken into account in operating and designing biomass gasifiers.

• Journal of Korea Foresty Energy
• /
• v.25 no.1
• /
• pp.9-17
• /
• 2006

Properties of wood charcoal made from the domestic wood species at $300-900^{\circ}C$ have investigated to understand the correlation between carbonization temperature and chemical and physical characteristics of wood charcoal. In terms of charcoal yield at particular carbonization temperatures, it was drastically decreased until the temperature reaches up to $600^{\circ}C$ and the decrease ratio of yield was reduced at higher temperatures. As the carbonization temperature increased, pH of the wood charcoal increased so that it became basic at last. The wood charcoal prepared at $600{\sim}700^{\circ}C$ showed the highest caloric value and those of wood charcoals made at higher temperature became plateau at a little lower level than the peak. The caloric value of Japanese larch charcoal was a bit higher than that of Red oak charcoal. The carbon content in the wood charcoal was increased as the carbonization temperature increased, whereas the hydrogen content was decreased. Specific surface area of the wood charcoal became larger with increase in temperature up to $600^{\circ}C$ but it was decreased or reduced in the increasing ratio after, and then it rose again at higher temperature than $800^{\circ}C$. Absorption capacity of the wood charcoal against iodine and gaseous acetic acid became greater as the carbonization temperature increased. Japanese larch charcoal presented higher absorption capacity than Red oak charcoal. As the above results, it is revealed that carbonization temperature affects the chemical and physical properties of wood charcoal. Therefore, to use wood charcoal with maximum effect it should be prepared at optimum temperature for proper use.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.35 no.1
• /
• pp.27-32
• /
• 2003

To understand the chemical structure of sewer sludge in comparison with commercial compost and charcoal used as a soil improver, it was carried out to analyse their ash contents and metal ions, and to elucidate the chemical structure of their residuals after a sequential treatment of alcohol-benzene(1:2) extraction in Soxhlet, 3% HCl reflux and 79% H₂SO₄ hydrolysis, using CHNS analyzer and solid C-13 NMR spectrometer. The results obtained were as follows: 1. Ash content of sludge was about 46% that is higher than those of compost (17%) and charcoal (4%). 2. The residual of sludge after a sequential treatment of HCl and H₂SO₄ hydrolyses had high ash content about 23%, too. 3. The sludge seems to be suitable to the soil improver because the content of heavy metal ions in sludge was near the compost and below the organic fertilizer standard. 4. Elemental composition of sludge residual after HCl-H₂SO₄ hydrolyes was C/sub 56/H/sub 91/O/sub 12/N₂S = (C/sub 6/H/sub 10/O/sub 5/)/sub 7/(C/sub 6/H₄)/sub 7/C₂H/sub 43/O₂N₂S, similar to C/sub 103/H/sub 122/O/sub 33/N/sub 6/S = (C/sub 6/H/sub 10/O/sub 5/)/sub 6/(C/sub 6/H₄)/sub 10/C/sub 7/H/sub 22/O₃N/sub 6/S of compost. 5. The sludge residual had proved to have both considerable aliphatic and aromatic groups, but the compost residual to have mainly aliphatic groups and the charcoal to have mainly aromatic groups, through the peak analysis of solid C-13 NMR charts. 6. So, the sewer sludge is proved to have a considerable amount of aromaticity like in woody biomass containing lignin.

• Journal of the Korean Wood Science and Technology
• /
• v.37 no.1
• /
• pp.87-93
• /
• 2009

Properties and chemical bonding of wood charcoal were investigated to understand the chemistry occurring in wood carbonization. From the pH changes of wood charcoal, it is revealed that it becomes acidic to weakly basic for charcoal carbonized at about $300^{\circ}C$, whereas it turns to basic at higher carbonization temperature higher than $600^{\circ}C$. Also, the ratio of carbon atoms in the charcoal was increased with increasing the carbonization temperature, while those of oxygen and hydrogen atoms. This tendency was significant when the carbonization temperature was increased up to $600^{\circ}C$ and the ratio changes of the atoms became stable at above $600^{\circ}C$. In the changes of chemical bonding, the ratio of C-C bonding was increased and those of C-O-H and C-O-R bonding was decreased significantly. It is considered that bondings connected to oxygen atoms tends to be broken, and the ratio of C-C bonding increased. Consequently, it is expected that this change may causes occurrence of new functional groups. In addition to that, it seems to be that the chemical bondings undergo the partial decomposition, formation, and recombination steps, Because ratio of C=O bonding tended to be increased or decreased by increasing the carbonization temperature. This understanding of chemical bond changes in charcoal can be a compensative consideration on the knowledges made only by physical parameters in the properties of micro-pore which has limited to explain the phenomenon. Also, it is considered that this can be treated as a basic knowledge for upgrading and development of use of wood charcoal.

• Journal of Plant Biotechnology
• /
• v.6 no.4
• /
• pp.213-219
• /
• 2004

Zygotic embryos were excised from immature and mature seeds of the Himalayan yew, Taxus wallichiana. The embryos germinated precociously when kept in darkness for 5 weeks and developed into full seedlings within 10-12 weeks. The highest rate of embryo germination ($81\%$) was obtained in modified Lloyd & McCown' s woody plant medium containing macro and micronutrients at half strength supplemented with $1\%$ activated charcoal, which supported both the best embryonic growth ($43\%$) and seedling development ($32\%$). However, the supplementation of basal media with kinetin, thidiazuron, 6-benzyl aminopurine or $GA_3$ had no effect on the germination of the embryos. The embryos derived from immature seeds germinated but the frequency of embryonic growth was better in mature seeds. Stratification of seeds effected precocious germination of embryos. Seeds kept at $4^{\circ}C$ for 1 week germinated earlier and at a higher frequency irrespective of the stage of seed maturity, while the germination rate declined with prolonged cold treatment for 1 month at that same temperature. Analysis of taxanes in germinating seedlings revealed that root tissues contained high levels of taxol, 10-deacetyl-baccatin ill and baccatin ill as compared to shoots. Thus embryo culture technique appears to overcome the lengthy dormancy requirement of T. wallichiana seeds.