• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.8 no.4
• /
• pp.53-64
• /
• 2009

Inter-vehicular communication that propagates information without infrastructures has drawn a lot of interest. However, it is difficult to apply conventional ad-hoc routing protocols directly in inter-vehicular communication due to frequent changes in the network topology caused by high mobility of the vehicles. MMFP(Multi-hop MAC Forwarding) is a unicast forwarding protocol that transport packets based on the reachability information instead of path selection or position information. However, delivering public safety messages informing road conditions such as collision, obstacles and fog through inter-vehicular communication requires broadcast rather than unicast since these messages contain information valuable to most drivers within a close proximity. Flooding is one of the simplest methods for multi-hop broadcast, but it suffers from reduced packet delivery-ratio and high transmission delay due to an excessive number of duplicated packets. This paper presents two multi-hop broadcast protocols for inter-vehicular communication that extend the MMFP. UMHB(Unreliable Multi-Hop Broadcast) mitigates the duplicated packets of MMFP by limiting the number of nodes to rebroadcast packets. UMHB, however, still suffers from low delivery ratio. RMHB(Reliable Multi-Hop Broadcast) uses acknowledgement and retransmission in order to improve the reliability of UMHB at the cost of increase in transmission delay, which we show through simulation is within an acceptable range for collision avoidance application.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.4A
• /
• pp.352-360
• /
• 2008

Recently Task Group (TG) 4 of the Institute of Electrical and Electronics Engineers (IEEE) 802.15a has been recommended a system with ranging capability in existence of multiple Simultaneous operating piconets (SOPs) as well as low-cost, low-power. According to the ranging service, coherent and non-coherent based ranging schemes using ternary code have been adopted as a standard. However it is hard to estimate an accurate time of arrival (TOA) in case of using direct sequence based TOA estimation method because pulse repetition interval (PRI) offered by TG is more limited than the maximum excess delay (MED) of channel. To mitigate inter pulse interference (IPI) problem, this paper proposes a non-coherent TOA estimation scheme using non-periodic transmission (NPT) pattern. The proposed receiver is based on a non-coherent energy detection considering with motivation of low rate wireless personal area network (LR-WPAN). TOA information is estimated via proper comparison with a prescribed threshold after the sliding correlation and search back window (SBW) process for reducing TOA error. To verify the performance of proposed ranging scheme, two distinct channel models approved by IEEE 802.15.4a TG are considered. According to the simulation results, we could conclude that the proposed scheme have performed better performance than the conventional method on the existence of multiple SOPs.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.49 no.1
• /
• pp.29-38
• /
• 2012

Due to the rapid development of network environment and wireless communication technology, the distribution of digital video has made easily and the importance of the protection for digital video has been increased. This paper proposes the digital video encryption system based on multiple chaos maps for MPEG-2 video encoding process. The proposed method generates secret hash key of having 128-bit characteristics from hash chain using Tent map as a basic block and generates $8{\times}8$ lattice cipher by applying this hash key to Logistic map and Henon map. The method can reduce the encryption overhead by doing selective XOR operations between $8{\times}8$ lattice cipher and some coefficient of low frequency in DCT block and it provides simple and randomness characteristic because it uses the architecture of combining chaos maps. Experimental results show that PSNR of the proposed method is less than or equal to 12 dB with respect to encrypted video, the time change ratio, compression ratio of the proposed method are 2%, 0.4%, respectively so that it provides good performance in visual security and can be applied in real time.

• Spatial Information Research
• /
• v.9 no.1
• /
• pp.51-72
• /
• 2001

It is frequently pointed out that the conventional field survey for natural environment has may limitations in terms of positional accuracy, real-time GIS data acquisition, and economic efficiency. The aim of this research was to develop an on site real-time mapping technique that enables the surveyor to input data in the field. The idea is based upon the recent trends in the field of Telecommunication and Information Technology that uses a GPS, wireless network computing, moving computing, etc. A virtual office approach has been adopted, in which a portable computer is linked to a GPS and field workers record data on the computer at the site and analyse data on site. This field mapping system has shown to be much less susceptible to the positional accuracy than that of th conventional approach. The Graphic User Interface, in particular, were ideally suited to combining positional information with attribute data which changes with every survey points. This interface allows users to interactively display and query GIS layers reproduced from the past survey results. The GIS database stored in the virtual office will serve to carry out a highly reliable survey since it could play a crucial role in identifying temporal and spatial changes occurred in the site. It is expected that integrated utilization of field data among the related agencies would be increased much more than before since the virtual office survey would be a powerful tool to ensure geometric fidelity in GIS database creation process. This paper also discusses the limitations and future direction of the present prototype research.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.5
• /
• pp.473-479
• /
• 2004

In this paper, power density in near field is calculated about analytic object which has comparatively large volume in considering used wavelength such as cellular base station antenna. Panel sector antenna which is used widespreadly in domestic cellular wireless communication system is modeled and electromagnetic field distribution in reactive near field region is calculated by FDTD (Finite Difference Time Domain) method. After that, antenna gain in far field region is obtain by near to far transformation. Power spectral density in radiated near field is calculated in applying to gain-based model with antenna gain in far field. Finally, compliance distance is obtained in considering the result from radiated near field calculation and basic restrictions on occupational and general public exposure limits in ICNIRP guideline. In the center of main radiating position, the result from gain-based model is -14.55 ㏈m and the result from surface scanning method is -15.75 ㏈m. When the losses from cables and connectors used in measurement are considered, the results from gain-based model and surface scanning method are nearly coincident.

• Journal of Broadcast Engineering
• /
• v.18 no.4
• /
• pp.572-588
• /
• 2013

In this paper, 4K-UHDTV or 8K-UHDTV and UHD-3DTV that the next generation broadcasting implementation and the possibility of direct receiving environment construction is analyzed on the terrestrial broadcasting. Particularly, we investigated the possibility by analyzing the previous and related works with regard to UHDTV transmission by DVB-T2 that is one of the best commercialized transmission mode. In order that the UHDTV broadcasting succeeds once again after completion of digital terrestrial switch over at the end of 2012, the ultra high resolution image transfer is important. However, the direct, the indoor and ubiquitous receiving environment is important in not only TV but also the personal type multimedia terminal in the sense of UHDTV service penetration. Therefore, in this paper, by using SFN and high error-correcting mode in DVB-T2 standard, the efficient frequency utilization and effective reception environment construction is illustrated. Particularly, SFN network constitution by 2 mutually different frequencies including the VHF bandwidth and UHF band, and etc. is shown. And the method that builds the free wireless receive environment by using SFN low power radio repeater and for home use gap filler is proposed. And the effect and frequency amount required are presented, when UHDTV broadcasting use 10MHz bandwidth.

• Journal of Korea Spatial Information System Society
• /
• v.11 no.3
• /
• pp.9-18
• /
• 2009

Recently, due to the advanced technologies of mobile devices and wireless communication, there are many studies on telematics and LBS(location-based service) applications. because moving objects usually move on spatial networks, their locations are updated frequently, leading to the degradation of retrieval performance. To manage the frequent updates of moving objects' locations in an efficient way, a new distributed grid scheme, called DS-GRID (distributed S-GRID), and k-NN(k-nearest neighbor) query processing algorithm was proposed[1]. However, the result of k-NN query processing technique may be invalidated as the location of query and moving objects are changed. Therefore, it is necessary to study on continuous k-NN query processing algorithm. In this paper, we propose both MCE-CKNN and MBP(Monitoring in Border Point)-CKNN algorithmss are S-GRID. The MCE-CKNN algorithm splits a query route into sub-routes based on cell and seproves retrieval performance by processing query in parallel way by. In addition, the MBP-CKNN algorithm stores POIs from the border points of each grid cells and seproves retrieval performance by decreasing the number of accesses to the adjacent cells. Finally, it is shown from the performance analysis that our CKNN algorithms achieves 15-53% better retrieval performance than the Kolahdouzan's algorithm.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.4
• /
• pp.3-11
• /
• 2016

In the environment of Internet of Things (IoT), IoT devices are limited by physical components such as power supply and memory, and also limited to their network performance in bandwidth, wireless channel, throughput, payload, etc. Despite these limitations, resources of IoT devices are shared with other IoT devices. Especially, remote management of the information of devices and patients are very important for the IoT healthcare service, moreover, providing the interoperability between the healthcare device and healthcare platform is essential. To meet these requirements, format of the message and the expressions for the data information and data transmission need to comply with suitable international standards for the IoT environment. However, the ISO/IEEE 11073 PHD (Personal Healthcare Device) standards, the existing international standards for the transmission of health informatics, does not consider the IoT environment, and therefore it is difficult to be applied for the IoT healthcare service. For this matter, we have designed and implemented the IoT healthcare system by applying the oneM2M, standards for the Internet of Things, and ISO/IEEE 11073 DIM (Domain Information Model), standards for the transmission of health informatics. For the implementation, the OM2M platform, which is based on the oneM2M standards, has been used. To evaluate the efficiency of transfer syntaxes between the healthcare device and OM2M platform, we have implemented comparative performance evaluation between HTTP and CoAP, and also between XML and JSON by comparing the packet size and number of packets in one transaction.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.48 no.12
• /
• pp.17-27
• /
• 2011

Most of the previous mobility management protocols such as IETF MIPv4/6 and its variants standardized by the IETF do not support global seamless handover because they require partially changes of the existing network infrastructure. In this article, we propose a simple mobility management protocol (SMMP) which can support global seamless handover between homogeneous or heterogeneous wireless networks. To do this, the SMMP employs separate location management function as DMMS to support global user and service mobility and the bidirectional tunnels are dynamically constructed to support seamless IP mobility by using the IEEE MIH extension server, which is extended the IEEE 802.21 MIH standards. The detailed architecture and functions of the SMMP have been designed. Finally, the mathematical analysis and the simulation have been done. The performance results show the proposed SMMP outperforms the existing MIPv6 and HMIPv6 in terms of handover latency, packet loss, pear signal noise ratio (PSNR).

• Journal of Internet Computing and Services
• /
• v.15 no.1
• /
• pp.179-191
• /
• 2014

In this paper, a frame transmission method to make IEEE 802.15.4 nodes run at a new channel and its characteristics are studied when they experience difficulties in transmission of frames due to WiFi traffic. The researches on evaluating the interference from WiFi traffic, searching for a new channel with little interference or not, and changing the operating channel are analyzed. In an wireless channel overlapped with IEEE 802.11 network, the transmission delay of IEEE 802.15.4 frames, the collision of frames in sending IEEE 802.15.4 frames without applying CSMA-CA algorithm, and the operation of IEEE 802.11 nodes are explained. A transmission method of frames including frame-formated code blocks in order to use the rest part of collided IEEE 802.15.4 frame is proposed. In the experiments of the proposed method, it is observed that frame-formated code blocks are synchronized and received by receivers in case of collision, and then the collided positions in IEEE 802.15.4 frame and the characteristics of frame reception rate are analyzed. The experimental results show that the performance of the proposed method is improved in comparison to an existing method when we measure the time taken to send a channel change command and get the response in order to avoid the interference from WiFi traffic.