• 한국지구물리탐사학회:학술대회논문집
• /
• 2003.11a
• /
• pp.557-560
• /
• 2003

Some well-known artificial weathering tests such as freezing-thawing, acid immersion, and salt crystallization are adopted to examine the change of rock properties during the processes of artificial weathering. Granites and other rock types of limestone, marble and basalt collected from different quarries in south Korea were sampled for this study. All tests were performed up to 30 cycles and physical properties were measured after experiencing every ten cycles of artificial weathering tests. During the tests, the variation trends of rock properties were too variable to draw generalized variation patterns but it can be concluded that weathering agents have different effect on rock properties depending on weathering circumstance and time. Even in short terms of salt crystallization tests, some rocks were severely deformed and then burst, and in the early stages of salt weathering, recrystallized salts filling pores and cracks in rocks could be a important factor affecting rock properties.

• Economic and Environmental Geology
• /
• v.32 no.2
• /
• pp.203-208
• /
• 1999

The main objective of this study is to suggest a new assessment method of the influence of weathering due to salt crystallization on the engineering property of rock. For this purpose, various sources of salt and salt crystallization were investigated, and artificially accelerated weathering tests were carried out. In natural envionment, weathering rate is very slow and weathering process involves complex mechanisms. Therefore artificial weathering test is essential for systematic analysis. Arificial weathering test is defined as test which controls weathering rate and agents by controlling arificial environmental condition. In this study, salt crystallization test was selected among various artificial weathering test methods, for its important role in weathering. Change of various stone properties were detexted. The change of physical properties by salt crystallization were observed as follows : 72% in Brazilian tensile strength and 72% in Slake durability. These results explain the importance of salt crystallization in the mechanical behaviour and properties of stone.

• Journal of Korean Society of Steel Construction
• /
• v.15 no.2
• /
• pp.147-157
• /
• 2003

The application in steel structures is increasing the mill sheet for the weathering steels by minimum maintenance cost in a life cycle cost. These have been collected and statistically analyzed to investigate chemical compositions, mechanical properties, weldability indices, weathering index and impact absorbed energy. From this study, although the band of dispersion in chernical compositions, mechanical properties and impact absorbed energy of the weathering steels appeared a little larger, the results revealed that these values have adequately satisfied the standard values of the Korean Standard. Furthermore, it was found that the weldability indices and the weathering index for the weathering steels have respectively satisfied the value prescribed by the Japanese Highway Specification and ASTM.

• Journal of the Korea Furniture Society
• /
• v.26 no.4
• /
• pp.392-397
• /
• 2015

This study was carried out to analyze the effects on mechanical properties of deteriorated wood member by outdoor condition. The surface color, mechanical properties and structural stability of traditional wooden structures, exposed in water and UV, could be changeable. For the purpose, accelerated weathering test based on outdoor condition was carried out. The weathering time levels were composed 0, 500, 1000, 1,500 and 2,000 hours and mechanical properties were evaluated on each specimen according to weathering time level. Bending properties were decreased on weathering but recovered after 1,000 hours. Fatigue and impact strength were decreased to 1,000 hours and did not changed since then. Abrasion resistance was minimized in 1,000 hours. This results could be utilized for effectively stability management of traditional wooden structures and members.

• Economic and Environmental Geology
• /
• v.23 no.2
• /
• pp.221-232
• /
• 1990

Upon the basis of the measurements of index properties and ultrasonic velocities as well as the determination of degree of weathering mainly based on microscopic observation, relatively fare correlation has been found between the degrees of weathering and the physical properties of rocks, particularly between degrees of weathering and maximun water content. A significantly better correlation has been obtained between degree of weathering and P wave velocity by grouping rock samples according to rock facies. This study presented the range of physical parameters corresponding to each degree of weathering in granites.

• Explosives and Blasting
• /
• v.22 no.2
• /
• pp.33-43
• /
• 2004

The six grades weathering system is normally used in weathered rock classification. In this study. fresh and weathered rock block of grade I to V were sampled in Jang-soo ana but samples of the grade VI was omitted from this study. The variation quantities of chemical weathering indices with weathering degree are smaller than those of physical and mechanical properties. Increase of Weathering degree is well indicated by physical and mechanical properties such as strength, hardness, ultrasonic velocity and slake durability result. Especially, absorption and porosity ratio is a good indicator. As weathering proceeds. a number of the cracks affect the rock deformation. Therefore, stress-strain curves of weathered rocks in unconfined state are quite different from ones of fresh rocks.

• Tunnel and Underground Space
• /
• v.15 no.6 s.59
• /
• pp.411-424
• /
• 2005

Weathering is defined as a process by which surface rock, once formed in the deep ground, is broken down and altered to keep the equilibrium with the ambient environment. In this study granitic rock samples of different weathering grades were collected in the field and the microscopic observation, X-ray diffraction analysis, electron microscopic observation, chemical analysis, and rock property tests were carried out. Formation of secondary minerals, especially clay minerals, by weathering was identified and the mechanism for the change of engineering properties such as rock strength degradation was analyzed. Tunnel model test, Failure behaviour, Shallow tunnel, Unsupproted tunnel length.

• Elastomers and Composites
• /
• v.51 no.4
• /
• pp.350-354
• /
• 2016

The surface properties of poly(methyl methacrylate) (PMMA) were investigated after accelerated weathering. Glossinesses, contact angles, surface free energies, thermal stability, and mechanical properties were investigated. The glossiness of the weathered PMMA was decreased with increasing exposure time. Contact angles and surface free energies were not overtly changed because the amount of oxygen on the surface was remained. PMMA was compounded with anti-block and antistatic agents using a co-rotating twin screw extruder to improve the durability. The PMMA composites showed better glossinesses after accelerated weathering while maintaining the contact angles, surface energy, thermal stability, and mechanical properties without significant changes.

• Journal of the Korean Geotechnical Society
• /
• v.15 no.1
• /
• pp.127-140
• /
• 1999

In this study, decomposed granite soil samples were taken from 16 different regions and their weathering properties were investigated by testing their physical and chemical properties. According to the results, the Chemical Weathering Index (CWI) ranges from 15.5 to 30 in general and 12 out of the 16 regions show over 20 in CWI. The 12 regions are categorized into complete granite soil areas by Sueoka's classification. CWI, Li. $SiO_2,\; \DeltaS/S$ and SAR are all correlated significantly and used as indicators by which the degree of weathering can be judged. The degree of weathering can be measured especially through Li or $SiO_2$ which is considered as an easy approach of geotechnical classification. Also, the relationship between the value of N and Li is regarded as a good indicator in estimating the degree of weathering.

• Journal of the Korean Geotechnical Society
• /
• v.33 no.12
• /
• pp.127-139
• /
• 2017

Site investigation including boring and various in-situ borehole test (Pressuremeter test, Borehole shear test, Downhole test, Suspension PS logging, Density logging) and X-ray fluorescence analysis for rock core sample were performed to estimate geotechnical properties and weathering degree of weathered granite rock in Goyang. Deformation modulus, shear strength parameter and shear wave velocity estimated through in-situ borehole test had a tendency to increase with depth. And several chemical weathering indices evaluated by X-ray fluorescence analysis had a general tendency of reducing weathering degree in accordance with depth. Also, relationship between VR determined as a representative weathering index and the geotechnical properties was analyzed.