• 전기의세계
• /
• 제25권5호
• /
• pp.75-78
• /
• 1976

The most difficult problem encountered in impulse test of transformer is the determination of exact fauly for coil layer short. This paper is to establish one of improved standards in the above case by means of wave form analysis, based on the equivalent circuits and experimental investigation. During the fault occurs, the local oscillation in fault circuit is applicable where as the reflection wave is utilized to the main circuit. The result current wave form at neutral impeadance point is similar to the wave form by impulse test and has the singular wave form respectively.

• 대한기관식도과학회:학술대회논문집
• /
• 대한기관식도과학회 1978년도 제12차 학술대회연제 순서 및 초록
• /
• pp.9.1-10
• /
• 1978

Action potential의 본체는 cochlear nerve의 섬유집합의 주기적 흥분을 보이는 전위변화(복합활동전위)를 말한다. 와우신경섬유의 흥분인 impulse wave-form은 음양(N.P,)의 bipolar wave-form을 나타내기 때문에 A.P.도 이상성 wave-form으로 나타난다. 기계적으로나 약물로 내외모세포를 파괴한 가묘의 고실계에 induction coil을 삽입하고 동시에 outer device를 통해서 준 음자극에 의하여 얻은 파형을 분석 보고한다.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2001년도 학술대회논문집
• /
• pp.163-166
• /
• 2001

In this paper, the superposition of ultrasonic signals which were generated by multi-source in a transformer was presented. For analysis of ultrasonic superposition, V$_{peak-peak}$ and pulse number of ultra-sonic signal were used. As a result, the wave form of ultrasonic superposition was classified into three types ; First type was the wave form whose V$_{peak-peak}$ was increased by the superposition of each signal's V$_{peak-peak}$. Second type was wave form whose V$_{peak-peak}$ was decreased by the superposition of each signal's V$_{peak-peak}$. And the other type was wave form whose peals were two or mere. And V$_{peak-peak}$ of superposed ultrasonic wave wads mostlv increased or decreased and pulse number of supe게osed u1trasonic wave was mostly increased.y increased.

• 한국의류산업학회지
• /
• 제7권6호
• /
• pp.641-649
• /
• 2005

This study is to make pH 9 reduction by adding NaOH to 1, 3, 5, 7, 9, 11% solution of thioglycollic acid, cysteine, cysteamin, to add it on helically winded natural hair and colored hair and leave them for 20, 40, 60 minutes, to add $NaBrO_3$ oxidant for 15 minutes and to compare and analyze the wave form. This study showed the results of permanent using thioglycollic acid, cysteine, cysteamin. In the permanent wave form according to the kind of reductant, concentration, and processing time, there were a little difference between thioglycollic acid and cysteine. But cysteamine not only showed apparent difference but also formed strong and elastic wave. The permanent wave is affected by the diagonosis of hair, the choice of permanent solution and the processing time. Therefore the scientific diagonosis of hair is to be considered first of all. By choosing the kind of solution, the concentration and the processing time according to the results of hair diagonosis and wave form, we can prevent the lengthening and damage of hair.

• 대한조선학회지
• /
• 제18권1호
• /
• pp.9-18
• /
• 1981

The wave-pattern analysis has been one of important research tools in the towing tank, and applied for hull form design. The longitudinal-cut method of Newman and Sharma is adopted in KRIS deep towing tank. Instrumentations and data acquisition systems are developed for that. Local effects and truncation effects are estimated by using calculated wave patterns of simple source distributions. Wigley model of 2m is used to check the accuracy of the whole system. Cut positions and truncation points are changed to investigate characteristics of the wave-pattern analysis. Coefficients of wave-pattern resistance are low-estimated in comparison with those of Maruo and Ikehata. The general quality of the system is very good, but some more efforts to increase the accuracy are required. Two full-form models(one basic form, the other with bulbous bow) are tested to show high application-possibilities of the wave-pattern analysis for the hull form design.

• 한국안광학회지
• /
• 제5권2호
• /
• pp.5-9
• /
• 2000

시유발전위는 시피질 뇌파의 반응을 알 수 있는 전기 생리학적인 검사법이다. 이 검사는 눈의 기능을 타각적으로 검사하는 검사법이다. 본 연구는 색각에 대한 객관적인 검사를 위해 시유발전위를 사용하였다. 검사조건은 거리와 조명의 차이를 다르게 한 상태에서 실시하였다. 피검자는 한국인 성인으로 정상색각자를 대상으로 하였다. 수렴운동 상태에서 색각의 시표적에 따라서 시자극에 관계하는 시피질의 뇌파의 빈도는 델타파가 가장 많고, 다음으로 메타파, 세타파 그리고 알파파의 순으로 나타났다. 뇌파의 진폭에 대한 히스토그램은 거의 비정규분 포곡선을 가지며, 위상 분석에서는 대게 선형을 나타내었다. 시표의 종류에 따른 뇌파의 빈도는 비슷한 결과를 나타내었다.

• 대한조선학회지
• /
• 제17권1호
• /
• pp.19-24
• /
• 1980

From the singularity distribution which obtained by minimum wave resistance condition, optimum hull form is obtained by stream line trancing method as Inui and Pien did. Thus obtained hull form has a extruded bottom along a keel line. Therefore the hull form must be modified to have flat bottom. This modification process is conducted by putting a fictitious bottom. It is found out that the wave resistance does not significantly alter at design speed even though the hull form has remarkably changed at the bottom. Therefore flattening the bottom by the effect of depth may be more rational for practical hull form design than ordinary manual hull-form modification.

• 대한조선학회논문집
• /
• 제55권6호
• /
• pp.527-534
• /
• 2018

The segment of the piston type wave board has been expressed as a submerged vertical line segment in the two dimensional wave flume. Either end of vertical line segment representing wave board could be located in fluid domain from free surface to the bottom of the flume. Naturally the segment could be extended from the bottom to the free surface of the flume. It is assumed that the piston motion of the wave board could be defined by the sinusoidal oscillation in horizontal direction. Simplified analytic solution of the submerged segment of wave board has been derived through the first order perturbation method in water of finite depth. The analytic solution has been utilized in expressing the wave generated by the piston type wave board installed on the upper or lower half of the flume. The wave form derived by the analytic solution have been compared with the wave profile obtained through the CFD calculation for the either of the above cases. It is appeared that the wave length and the wave height are coincided each other between analytic solution and CFD calculation. However the wave form obtained by CFD calculations are more closer to real wave form than those from analytic calculation. It is appeared that the linear solutions could be not only superposed by segment but also integrated by finite elements without limitation. Finally it is proven that the wave generated by the oscillation of flap type wave board could be derived by integrating the wave generated by the sinusoidal motion of the finite segment of the piston type wave board.

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제9권5호
• /
• pp.499-508
• /
• 2017

This paper uses optimization techniques to obtain bow hull form of a 66,000 DWT bulk carrier in calm water and in waves. Parametric modification functions of SAC and section shape of DLWL are used for hull form variation. Multi-objective functions are applied to minimize the wave-making resistance in calm water and added resistance in regular head wave of ${\lambda}/L=0.5$. WAVIS version 1.3 is used to obtain wave-making resistance. The modified Fujii and Takahashi's formula is applied to obtain the added resistance in short wave. The PSO algorithm is employed for the optimization technique. The resistance and motion characteristics in calm water and regular and irregular head waves of the three hull forms are compared. It has been shown that the optimal brings 13.2% reduction in the wave-making resistance and 13.8% reduction in the added resistance at ${\lambda}/L=0.5$; and the mean added resistance reduces by 9.5% at sea state 5.

• 한국기계연구소 소보
• /
• 통권9호
• /
• pp.169-181
• /
• 1982

This paper presents three methods for ship hull form improvement on the basis of wave pattern analysis. These methods are primarily based on the assumption that a linear relation exists between the small difference of hull sections and the difference of the wave amplitude functions. The improved hull form of ship is made by superposing a thin hull form on that of a parent model. The first method use the simplification of framelines and Michell's Theory to the formula of wave resistance for superposed thin ship. The second method use tent functions and Michell's Theory to that. And the third is experimental method.