• Applied Chemistry for Engineering
• /
• v.35 no.1
• /
• pp.42-47
• /
• 2024

Limonene was separated from waste citrus peels by a vacuum drying process with a venturi, and bioethanol was produced from dried citrus peels. Vacuum drying using venturi was very effective in removing moisture and limonene compared to hot air drying and natural drying. Citrus peels prepared by venturi vacuum drying were the most suitable for ethanol fermentation. The moisture and limonene content of the citrus peels dried for 15 hours were 17.0% and 3.2%, respectively. By venturi vacuum drying, essential oil containing limonene and floral water were obtained, respectively. The amount of essential oil separated by venturi vacuum drying was 4.21 mL essential oil/kg citrus peel, 79.9% of the separated essential oil was limonene.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.6
• /
• pp.1055-1061
• /
• 2000

The kinetics of tar formation has been studied experimentally and modeled mathematically for waste lubricating oil after pyrolyzed at batch reactor. And stabilization of pyrolyzed oil has been studied. A combination of series and parallel reaction was assumed for the mechanism of tar formation. From the proposed kinetic model, pyrolyzed oil to tar was found to be rate limiting step for tar formation. It was found that the fly ash and coke had the ability to remove materials of tar formation and to protect oxidation of pyrolyzed oil.

• Journal of ILASS-Korea
• /
• v.18 no.4
• /
• pp.182-187
• /
• 2013

This study was performed to investigate the effect of biodiesel derived from waste cooking oil on the spray behavior and macroscopic spray characteristics. To analyze quantitative characteristics of test fuels, injection quantity was measured at various injection pressures and the spray images of injected fuels in the pressurized chamber were obtained by using a high speed camera and image analysis system. Based on the measured spray images, the spray tip penetration and spray cone angle were investigated at various energizing timings and injection pressures. In this work, the experimental results showed that the injection quantity of waste cooking biodiesel indicated the higher quantities than diesel at high injection pressure. As the injection pressure was increased, the spray tip penetrations of biodiesel were higher value than diesel. The difference of penetration between biodiesel and conventional diesel fuel was reduced in accordance with the increase of injection pressure. Also, the spray angles of diesel were larger than that of biodiesel because diesel fuel has lower viscosity than biodiesel. In addition, the spray evolution processes of biodiesel fuel at various injection pressures and the elapsed time after the injection were compared to the conventional diesel fuel.

• Journal of Microbiology and Biotechnology
• /
• v.22 no.3
• /
• pp.371-377
• /
• 2012

The present study describes medium-chain-length polyhydroxyalkanoates (mcl-PHAs) production by the Pseudomonas Gl01 strain isolated from mixed microbial communities utilized for PHAs synthesis. A two-step fed-batch fermentation was conducted with glucose and waste rapeseed oil as the main carbon source for obtaining cell growth and mcl-PHAs accumulation, respectively. The results show that the Pseudomonas Gl01 strain is capable of growing and accumulating mcl-PHAs using a waste oily carbon source. The biomass value reached 3.0 g/l of CDW with 20% of PHAs content within 48 h of cultivation. The polymer was purified from lyophilized cells and analyzed by gas chromatography (GC). The results revealed that the monomeric composition of the obtained polyesters depended on the available substrate. When glucose was used in the growth phase, 3-hydroxyundecanoate and 3-hydroxydodecanoate were found in the polymer composition, whereas in the PHAs-accumulating stage, the Pseudomonas Gl01 strain synthesized mcl-PHAs consisting mainly of 3-hydroxyoctanoate and 3-hydroxydecanoate. The transcriptional analysis using reverse-transcription real-time PCR reaction revealed that the phaC1 gene could be transcribed simultaneously to the phaZ gene.

• Journal of the Korean Applied Science and Technology
• /
• v.27 no.4
• /
• pp.437-444
• /
• 2010

Dry Process(natural drying, hot-air drying, oil fry drying), optimized mixture ratio and the condition of carbonization was carried out in order to improve the product durability develop eco-friendly solid fuel mixing food waste and paper sludge. As a result of the experiment, oil fry drying process was the fastest method for drying food waste and paper sludge mixture that contains 80% water inside, and the optimized mixture ratio to minimize the generating concentration of chlorine gas against caloric value of mixture ratio was 7:3. Additionally proper temperature of product carbonization was about $200^{\circ}C$ and shown increasing product durability through the carbonization. Therefore, the pelletized solid fuel be shaped diameter around 0.5cm, length 2cm under which was pulverized and molded using 7:3 mixture of food waste, and paper sludge was the eco-friendly solid fuel possible to be industrialized which is consist of chlorine concentration of below 2.0wt% and the lowest caloric value of over 5,000kcal/kg. In conclusion, this developing manufacturing process of the solid fuel can be interpreted to contribute alternative energy development in accordance with low carbon and green growth era.

• Textile Coloration and Finishing
• /
• v.18 no.6 s.91
• /
• pp.31-36
• /
• 2006

Study has been made for producing anionic surfactant using waste fleshing scraps from the leather making process through refining, esterification, sulfonation and blending processes. As a most optimum lard oil refining method, refining was carried out for 4 hours under temperature of $120^{\circ}C$ and approximately 200 mbar vacuum, which gave a recovery of more than 80% lard oil. Refined lard oil obtained thus was undergone methlyl-esterification, then sulfonated to make a degreasing agent. By methyl-esterification using lard oil, more than 85% of fatty acid and $12{\sim}13%$ of glycerine were extracted from the oil. Sulfonation of the extracted fatty acid ester lard oil has shown most optimum at $15{\sim}20%$ chlorosulfonic acid content, and the content of bonding sulfate at this time was higher than 3.5%. Finally the followed anionic surfactant having degreasing force of 80% and higher could be made by blending process.

• Journal of Energy Engineering
• /
• v.12 no.3
• /
• pp.216-222
• /
• 2003

An experimental study on the characteristics of a dewatering due to vacuum evaporation in the waste lubrication oil were performed using a lab scale system. Evaporation characteristics were investigated for various performance factors. Results of evaporation characteristics as a function of vacuum pressure, oil temperature, initial water concentration, and nozzle type were obtained. Increasing the oil temperature and altering the nozzle type were found to increase the evaporation rate without increasing vacuum pressure requirement. The best performance is achieved for the nozzle which made porous material.

• Journal of environmental and Sanitary engineering
• /
• v.18 no.3 s.49
• /
• pp.21-26
• /
• 2003

The generation of waste cable has been continuously increased as a production of electrical and communication media are extended. The current recovery methods, such as mechanical peeling, incineration, solvent extraction and pyrolysis, seems inadequate because they are either hard to apply in some cases or environmentally unacceptable. It has been shown that copper can be effectively separated from the jelly filled type cables using a soybean oil treatment method. As a result, jelly compound is vanished from the wire by soybean oil bath and waste wires are separated copper and PE by the mechanical chipper. This is a more environmentally friendly method than burning, and considerably faster than Stripping.

• Journal of the Korean Society of Industry Convergence
• /
• v.7 no.4
• /
• pp.341-348
• /
• 2004

This study experimented dividing compaction load by dynamic compaction test and an oil pressure hammer compaction test for consolidation strength characteristics experimental feedback about soil change aspect of waste landfill ground and revelation of compaction effect as underground research about consolidation behavior of waste landfill ground by compaction load, foot weight and percussion number of times were adapted differently each other with uniformity drop head when dynamic compaction test, and hammer scale and percussion number of times were adapted differently also when oil pressure hammer compaction test.

• Transactions of the Korean hydrogen and new energy society
• /
• v.28 no.5
• /
• pp.577-583
• /
• 2017

A series of microwave waste tire pyrolysis experiments were conducted using a lab-scale batch reactor to delineate the effects of microwave ouput power on the pyrolysis behavior of waste tire. As results of experiments, it was found that as the microwave output power was increased from 1.22 kW/kg to 2.26 kW/kg, the reaction temperature and oil yield increased significantly and the required time and microwave power consumption decreased remarkably, respectively. With increased power consumption, the content of the fixed carbon of pyrolysis residue increased.