• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 제36회 하계학술대회 논문집 B
• /
• pp.1153-1155
• /
• 2005

This paper deals with dynamic characteristics of LSRM according to drive condition. First, in experiment of LSRM, position of LSRM detected approximation sensor. Position choose mover of LSRM and inductance. When approved current in each phase by decided position, we made sure current and voltage according to turn-on, turn-off. Second, in dynamic characteristic of LSRM, through an experiment, we decided turn-on position of inductance profile. Also, we presented dynamic characteristic analysis model which is consisted at motor and sensor signal part, etc., and substitute circuit constant that get using magnetic equivalent circuit method, we confirmed current and voltage waveform.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 제36회 하계학술대회 논문집 B
• /
• pp.1717-1718
• /
• 2005

Zn/Air 전지는 방전하는 동안에 최종 방전 cut-off 전압에 이르기까지 평탄한 voltage profile의 전기화학적 특성을 보여준다. Air cathode 전극의 경우, 전극의 porosity에 따라 특성변화에 큰 영향을 가지는 것으로 보이며 이의 비교연구를 위해 사용되어지는 활성탄의 종류를 달리함으로써 이러한 인자의 영향을 이해하고자 하였다. 이러한 인자연구는 discharge voltage, specific capacity, 및 energy 등의 연구결과를 바탕으로 고찰되어졌으며 결과적으로 공기 유로를 통한 산소의 원활한 공급 여부가 주요 원인인 것으로 여겨진다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2004년도 추계학술대회논문집
• /
• pp.586-591
• /
• 2004

A load/unload mechanism is applied to most small form factor hard disk drives. Loading velocity is ones of the most important factors to ensure the reliability of the load/unload operations. Especially, the lower the flying height of the head becomes, the more important the accuracy of the loading velocity control becomes. Because there is no sensor during the load/unload operations, BEMF voltage is used to sense the head velocity. To measure BEMF voltage, a simple circuit is added to the load/unload HDD control system. Overall acceptable results are obtained by using the simple PI controller but the errors from the target velocity occur when the head moves along the ramp and then reaches the disk. Feedforward profile and disturbance observer are used to remove those errors effectively.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2004년도 하계학술대회 논문집 A
• /
• pp.168-170
• /
• 2004

현대의 전력회사들은 전력계통의 현재 운용상황을 파악하기 위하여 상태추정을 사용한다. 상태추정기는 계통 내 각 지점에서 측정된 전력이나 전압, 전류등의 데이터를 이용하여 반복연산을 수행함으로써 전력계통의 상태(voltage profile)를 추정한다. 이때, 모든 데이터는 동시에 측정이 되었다는 가정 하에 상태추정 연산에 이용되지만, 실제로 모든 데이터 측정의 동기성을 확보하는 것은 사실상 불가능하다. 최근 인공위성에 의해 동기화된 페이저 측정장치가 전력계통 운용에 사용되고 있으며 본 논문에서는 이렇게 이미 이용 가능한 페이저 측정 데이터를 상태추정에 이용하는 방법을 시도하였다. 위성에 의해 동기화된 페이저 측정데이터는 데이터 측정의 동기성 확보뿐만 아니라, 데이터의 정밀도 및 위상각의 직접적인 측정이라는 둥의 여러 가지 면에서 매우 효용성이 높은 데이터이다. 본 연구를 통해 개발된상태추정 프로그램은 IEEE 14모선 시험계통을 이용하여 그 타당성을 검증하였다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2019년도 전력전자학술대회
• /
• pp.142-144
• /
• 2019

Nowadays, multi-MHz wireless power transfer (WPT) system has received a great concern of study due to its desirable characteristics such as user convenience, system compact and better safety as compared to the conventional DC-DC with cord. This paper presents a solution for WPT Lithium Batteries charger with Constant Current (CC) and Constant Voltage (CV) charging process. The proposed system consists of a high frequency class D power amplifier, a pair of PCB coil, transformable high-order resonant network and a full-bridge rectifier. The charger can be implemented CC /CV charging profile thanks to automatic reconfigurable resonant compensator. Therefore, the battery can be fully charged without the help of an additional DC/DC converter. The simulation and 50W-6.78-MHz hardware experimental results are presented to verify the feasibility of the proposed method and to evaluate the performance of the proposed wireless battery charger.

• 한국정보처리학회:학술대회논문집
• /
• 한국정보처리학회 2011년도 춘계학술발표대회
• /
• pp.917-919
• /
• 2011

Recently, most network communication chips are powered; which causes power consumption a heavily constraint. Since, there are a lot of expectations on TPM to have a high performance in terms of authentication of its device. During the design process there is a need to estimate the security of the design but it always when the chip has already been manufactured. This paper designed a power consumption control monitor in TPM device which evaluate the voltage drop during processing of use. Therefore we will analyze the power consumption profile. The result shows that the voltage drop leads to vulnerability of the system to attackers during communication process.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2000년도 전력전자학술대회 논문집
• /
• pp.525-528
• /
• 2000

This paper presents a circuit analysis and cotnrol example of favored configuration 6/4 SRM. SRM modeling and analysis are necessary for experiment. Thus this paper proposes a SRM modeling with PI controller (of driving converter) input voltage chopping and inductance profile when rotor position transformed. Through this simulation the designer can predict operating states of systems over a broad range of operating conditions.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2004년도 전력전자학술대회 논문집(1)
• /
• pp.350-354
• /
• 2004

This paper presents theoretical and practical details about the design, implementation, and performance of a series resonant do-to-dc converter using planar magnetics. Result of sinusoidal analysis are used to predict the voltage gain and conversion efficiency. The performance of a prototype converter is presented including the efficiency measurement and theoretical loss breakdown.

• 대한전기학회논문지
• /
• 제41권4호
• /
• pp.346-354
• /
• 1992

In the power-system, the active and reactive power levels of load bus randomly vary over days, months, and years which are stochastic in nature. This paper presents an algorithm for optimal Var planning considering the uncertainties of loads. The optimization problem is solved by a stochastic linear programming technique which can handle stochastic constraints to evaluate optimal Var requirement at load bus to maintain the voltage profile which results in probabilistic density function by stochastic Load Flow analysis within admissible range. The effectiveness of the proposed algorithm has been verified by the test on the IEEE-30 bus system.

• 전기학회논문지
• /
• 제56권12호
• /
• pp.2173-2178
• /
• 2007

Dynamics of plasma sheath was analyzed using simple ion fluid model with poison equation. Incident ion current, energy, potential distribution and space charge density profile were calculated as a function of time. The effects of initial floating sheath on the evolution of biased sheath were compared with ideal matrix sheath. The effects of finite rising time of pulse bias voltage on the ion current and energy was studied. The influence of surface charging on the evolution of sheath was also investigated