• 소음진동
• /
• 제4권3호
• /
• pp.337-343
• /
• 1994

A method of the leak detection from the pipe system by using accelerometer is proposed. The signal detected from accelerometer is proved experimentally to be a dispersive wave. Based on the experiments, a method using the narrow band pass filter and the unit impulse response function is analyzed. The method uses the characteristics of the unit impulse response function, that the function is available evenin the narrow band signal because, unlike the cross correlation, it is normalized by the auto spectrum. The accelerometer is quite easier to use than the hydrophone in adapting to the pipe system.

• Smart Structures and Systems
• /
• 제20권3호
• /
• pp.263-272
• /
• 2017

This paper presents the time response of a mixed vibration system with the viscous damping and the hysteretic damping. There are two ways to derive the time response of such a vibration system. One is an analytical method, using the contour integral of complex functions to compute the inverse Fourier transforms. The other is an approximate method in which the analytic functions derived by Hilbert transform are expressed in the state space representation, and only the effective eigenvalues are used to efficiently compute the transient response. The unit impulse responses of the two methods are compared and the change in the damping properties which depend on the viscous and hysteretic damping values is investigated. The results showed that the damping properties of a mixed damping vibration system do not present themselves as a linear combination of damping properties.

• Journal of Biosystems Engineering
• /
• 제22권1호
• /
• pp.41-48
• /
• 1997

A nondestructive quality inspection technique using acoustic impulse response method was studied to investigate the feasibility of egg shell inspection. An experimental system was built to generate impact force, to measure the response signal and to analyze the frequency spectrum. This system includes an impulse generating unit, an egg holding seat, a microphone with preamplifier, and a digital oscilloscope connected to Personal Computer by RS-232C interface. The factors such as impulse generating method, egg holding method, and sensor location were evaluated by analyzing the power spectrum density of the measured signal. The results obtained are summarized as follows : 1. From the sampled eggs, the proper conditions for detecting damaged eggs were found as followings; ceramic for the impact ball material, rubber for egg seat material, 20 degrees for an impact angle of pendulum, 10mm for the distance between egg and sensor, the sharp side for impacting part, and 180 degrees for the location of sensor. 2. Examination of the Fourier transformed analysis in beth normal and damaged eggs revealed that those factors such as the resonant frequency, a number of peak frequencies and the magnitude of power spectrum were important to detect damaged eggs.

• 한국자동차공학회논문집
• /
• 제10권4호
• /
• pp.122-128
• /
• 2002

In this paper dynamic responses of an engine, which is supported by hydraulic mount, to throttle tip-in/Tip out are analyzed. Because the hydraulic mounts have non-linearity that the characteristics of stiffness and damping vary with frequencies, it is difficult to analyze the dynamic behavior of an engine using general integral algorithms. Convolution integral and relationship between unit impulse response functions and frequency response functions are therefore used to simulate the transient behaviors of an engine indirectly. In time domain, impulse response functions are calculated by two-side discrete inverse courier transform of frequency response function achieved by laplace transform of equations of motion. Considering the fact that the shapes of behavior of an engine simulated by the proposed method are in good agreement with test results, it is confirmed that the proposed method is very effective for the analysis of transient response to throttle tip-in/out of an engine with hydraulic mounts.

• Transactions on Control, Automation and Systems Engineering
• /
• 제4권4호
• /
• pp.283-288
• /
• 2002

This paper has shown that the impulse and the unit step responses of 2nd-order systems can be computed by an analytic method. Three different 2nd-order systems are investigated: the prototype system, the system with one LHP(left half plane) real zero and the system with one RHP(right half plane) real zero. It has also shown that the effects of the LHP or the RHP zero are very serious when the zero is getting closer to the origin on the complex plane. Based on these analytic results, this paper has presented two sufficient and necessary conditions for 2nd-order linear SISO(single-input/single-output) stable systems to have the nonovershooting and the monotone nondecreasing step response, respectively. The latter condition can be extended to the sufficient conditions for the monotone nondecreasing step response of high-order systems.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 춘계학술대회논문집B
• /
• pp.540-545
• /
• 2001

In this paper dynamic responses of an engine, which is supported by hydraulic mount, to throttle tip-in/tip out are analyzed. Because the hydraulic mounts have non-linearity which the characteristics of stiffness and damping vary with frequencies, it is difficult to analyze the dynamic behavior of an engine using general integral algorithms. Convolution integrals and relationships between unit impulse response functions and frequency response functions are therefore used to simulate the transient behavior of an engine indirectly. In time domain, impulse response functions are calculated by two-side discrete inverse Fourier transform of frequency response function achieved by Laplace transform of equations of motion. Considering the fact that the shapes of behavior of an engine simulated by the proposed method are in good agreement with test results, it is confirmed that the proposed method is very effective for the analysis of transient response to throttle tip-in/out of an engine with hydraulic mounts.

• Communications for Statistical Applications and Methods
• /
• 제17권2호
• /
• pp.241-253
• /
• 2010

표준 단위근 검정이 실제 시계열자료의 단위근 귀무가설을 기각하지 못하는 경우가 많아지고 검정력에 문제점을 드러내면서 이와는 반대로 정상성 귀무가설을 단위근 대립가설에 대해 검정하는 방안이 제기되어 왔다. 본 연구는 국내 광역지역의 주택가격 시계열자료에 귀무가설과 대립가설이 바뀐 두 가지 종류의 단위근 검정법을 모두 적용시켜 보았다. 그리고 지역 자료간 통계적 역학관계를 검정하기 위한 인과관계, 교차상관관계 또 충격반응 및 분산분해 등에 대한 분석 결과는 대체로 일관된 성향을 보이는 것으로 나타났다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2008년도 춘계학술대회논문집
• /
• pp.714-720
• /
• 2008

This research presents a laboratory study about an subjective response of impulsive sound caused by leisure shooting. The sources are sampled from outdoor noise and their levels range from 40 to 75 dB at the interval of 5dB. The noise unit is based on A-weighted sound exposure level (ASEL; $L_{AE}$). To make equal ASEL of outdoor noise, finite impulse response (FIR) filter is applied to the originally sampled source to include the effect of distance attenuation. The evaluation method of the jury test adopted a Semantic Difference(SD) Method. In the result of the jury test for impulsive noise, the mean response rating expressed a linear relation and %HA(percent highly annoyed) displayed a exponential growth relation.

• Ocean and Polar Research
• /
• 제40권1호
• /
• pp.49-58
• /
• 2018

This study aimed to analyze the causality of hairtail prices among import and domestic distribution channels using a Vector Error Correction Model(VECM). The results are as follows. First, since the ADF unit-root test suggests that each of the price variables, apart from retail price, has a unit root, the price variables should be 1st-differenced to secure the stability of the prices. Next, through the Johansen co-integration test, it was discovered that there are long-term relationships among the price variables. On the basis of the co-integration test, VECM analysis shows that the producer price has a long-run balance with the import and wholesale prices. In particular, when the prices deviate from the balance, the producer price dynamically adjusts to return to the long-term relationship among prices. It also indicates that the producer price has an impact on the import, wholesale, and retail prices in the short-term, and the import price has an influence on the producer and wholesale prices. In addition, the impulse response analysis demonstrates that the impulse of import and producer prices has a lasting impact on each of the prices.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 하계학술대회 논문집 E
• /
• pp.1773-1775
• /
• 1997

The accuracy of impulse voltage measurement has been discussed and revised the IEC Publication 60-2 "High-voltage test techniques Part 2: Measuring Systems". Along with those activity, reference measuring systems have been experimentally investigated on their characteristics by step response method for lightning impulse voltage in our country. In this paper, using EMTP, we enable to clarify dominant factors affecting the unit step response, and to evaluate the construction of measuring system.