• Tuberculosis and Respiratory Diseases
• /
• v.43 no.3
• /
• pp.339-347
• /
• 1996

Background : Transthoracic fine needle aspiration and biopsy(TNAB) has become a frequently used technique in the investigation of the intrathoracic lesions because of its safety, reliability, and accuracy. Method : Data on 125 patients who underwent TNAB from 1990 through 1994 were studied to determine the diagnostic sensitivity, accuracy and complications of this procedure as related to lesion type and location. Results : 1. The over-all diagnostic sensitivity of TNAB was 61.6%(77 of 125 patients). 2. The diagnostic yields were as high as 89.9% for malignant lesions, but a specific diagnosis of benign lesions were obtained only in 30% of benign lung lesions. 3. The correlation between results of TNAB cytology and of final histology was as high as 88.2%. 4. Lung lesions that were greater than 3cm in size had a higher proportion of correct diagnosis(73.3%) as compared with lesions 3cm or less in size(38.1%). But there was no significant difference between the central and peripheral lung lesions. 5. There were no serious complications to TNAB. In 12.8% of the procedures a pneumothorax developed, indicating a chest tube in 1.6% of the procedures. In 2 cases, minimal hemoptysis developed which did not require treatment. Conclusion : In our experience, TNAB represents a minor and safe procedure, which permits a direct approach to localized malignant lung lesions with a high degree of accuracy.

• Journal of Environmental Health Sciences
• /
• v.41 no.4
• /
• pp.241-248
• /
• 2015

Objectives: This study was conducted to provide scientific and effective information on phytoncides, which are associated with forest healing, and to activate recreational forests. Methods: The target sites were natural recreation forests, a forest park and an arboretum, and the control sites were three urban parks. The samples were collected at a volume of 6.0 L and a flow rate of 0.1 L/min for one hour using a low volume pump and the solid adsorbent sampling method. The phytoncide compounds adsorbed in the Tenax TA tube were analyzed by a automatic heat desorption unit and GC-MS. Results: By type of recreational forest, the annual concentrations of phytoncide (monoterpene) for the forest park showed the highest concentration with $1.450{\mu}g/m^3$, while those for the arboretum showed the lowest concentration at $0.892{\mu}g/m^3$, and thus the concentration of the forest park was approximately 1.6 times higher than the arboretum. The season showing the highest concentration of phytoncides was summer (June) and the forest park was the highest among the recreational forests. The concentrations of major components for phytoncide showed in descending order: ${\alpha}-pinene$, ${\beta}-pinene$, camphene, 3-carene and limonene. The seasonal concentration of ${\alpha}-pinene$, camphene and ${\beta}-pinene$ by type of recreational forest increased in April, which is characterized by low temperature and humidity, and the seasonal concentration of camphene decreased with higher humidity. The meteorological factors which had the high correlation with the concentration of total terpene were temperature and humidity. $CO_2$ and $O_2$ showed an inverse correlation. Conclusion: The major components of phytoncide were ${\alpha}-pinene$, ${\beta}-pinene$, camphene, 3-carene and limonene in descending order of concentration. Further and systematic study on the chemical nature of individual phytoncides, and on the effect of phytoncides on humans needs to be performed.

• Clean Technology
• /
• v.20 no.4
• /
• pp.425-432
• /
• 2014

The effect of two important parameters of a catalytic membrane reactor (CMR), hydrogen selectivity and hydrogen permeance, coupled with an Ar sweep flow and an operating pressure on the performance of a water gas shift reaction in a CMR has been extensively studied using a one-dimensional reactor model and reaction kinetics. As an alternative pre-combustion $CO_2$ capture method, the feasibility of capturing a pressurized and concentrated $CO_2$ in a retentate (a shell side of a CMR) and separating a purified $H_2$ in a permeate (a tube side of a CMR) simultaneously in a CMR was examined and a guideline for a hydrogen permeance, a hydrogen selectivity, an Ar sweep flow rate, and an operating pressure to achieve a simultaneous capture of a concentrate $CO_2$ in a retentate and production of a purified $H_2$ in a permeate is presented. For example, with an operating pressure of 8 atm and Ar sweep gas for rate of $6.7{\times}10^{-4}mols^{-1}$, a concentrated $CO_2$ in a retentate (~90%) and a purified $H_2$ in a permeate (~100%) was simultaneously obtained in a CMR fitted with a membrane with hydrogen permeance of $1{\times}10^{-8}molm^{-2}s^{-1}Pa^{-1}$ and a hydrogen selectivity of 10000.

• Korean Journal of Agricultural Science
• /
• v.14 no.1
• /
• pp.16-25
• /
• 1987

Colletotrichum acutatum, C. coccodes, C. dematium and C. gloeosporioides were detected in seed samples of red pepper (Capsicum annuum). C. dematium and C. gloeosporioides were the predominant species, maximum seed infection of the species in some samples were 84% and 28%, respectively. C. acutatum and C. coccodes were recorded only in low percentages of 1-2. The blotter method proved more suitable for detecting Colletotricum spp. than the deep freezing blotter or agar plate methods. Plating of seed components showed that C. dematium and C. gloeosporioides were recovered more frequently from seed coat, and decreasing amounts of infection were observed in the endosperm and cotyledon. Seed-borne C. dematium and C. gloeosporioides caused seed rot, damping-off, seedling blight and brown discoloration of cotyledon and hypocotyl when infected seeds were sown in agar of test tube or in soil. Inoculation experiments showed that C. acutatum was pathogenic to red fruit of red pepper and C. coccodes was highly pathogenic to red fruit and weakly pathogenic to leaf of the plant. C. dematium was highly pathogenic to leaf and green fruit and C. gloeosporioides was pathogenic to not only leaf but also green and red fruits. Host range of the four seed-borne species of Colletotrichum was also investigated.

• The Journal of the Acoustical Society of Korea
• /
• v.39 no.4
• /
• pp.351-363
• /
• 2020

Launch vehicles are subject to airborne acoustic loads during atmospheric flight and these effects become pronounced especially in transonic region. As the vibration due to the acoustic loads can cause malfunction of payloads, it is essential to predict and reduce the acoustic loads. In this study, a complete process has been developed for predicting airborne vibro-acoustic environment inside the payload pairing and subsequent noise reduction procedure employing acoustic blankets and Helmholtz resonators. Acoustic loads were predicted by Reynolds-Averaged Navier-Stokes (RANS) analysis and a semi-empirical model for pressure fluctuation inside turbulent boundary layer. Coupled vibro-acoustic analysis was performed using VA One SEA's Finite Element Statistical Energy Analysis (FE-SEA) hybrid module and ANSYS APDL. The process has been applied to a hammerhead launch vehicle to evaluate the effect of acoustic load reduction and accordingly to verify the effectiveness of the process. The presently developed process enables to obtain quick analysis result with reasonable accuracy and thus is expected to be useful in the initial design phase of a launch vehicle.

• Korean Journal of Optics and Photonics
• /
• v.10 no.3
• /
• pp.195-200
• /
• 1999

We made sharp optical fiber tips with less than 100 nm diameter by using the heating and pulling method with a good repetition and fabricated the photon scanning tunneling microscope (PSTM) using constant intensity mode. The 3-dimensional PZT (Piezoelctric transducer) scanner made of a long PZT tube is consisted of three divided parts, that is, a pair of $\pm$ x and a pair of $\pm$y scanning parts and a z scanning part for the fine approach and scanning. The scanning dimension is 1.43 $\mu\textrm{m}$$\times$1.76 $\mu\textrm{m}$. The height of a optical tip to maintain a constant height within $1/{\lambda}_0$ (${\lambda}_0$ is the incident wavelength) from surface of a specimen to a optical tip is controlled automatically by using the electric feedback circuit. The 3-dimensional shape of standing evanescent waves generated on the surface of a dove prism was measured successfully by using the constant intensity mode PSTM.

• KSBB Journal
• /
• v.15 no.1
• /
• pp.49-54
• /
• 2000

Bioluminescence of Photobacterium phosphoreum has been used for the detection of pollutants in the environment. Immobilization method was used to maintain the stability of bioluminescence of P. phosphoreum. The carboxymethylcellulose was investigated to find out whether it was suitable for the immobilization of P. phosphoreum as a matrix without disturbing the bioluminescence emission. A maintenance of bioluminescence was determined from the P. phosphoreum immobilized on the various concentrations of carboxymethylcellulose. A relatively high bioluminescence intensity was shown with immobilized cells on 1%(w/v) carboxymethylcellulose. The effect of carboxymethylcellulose concentrations on the sensitivity of Crcompounds including $Na_{2}CrO_{4}$, $K_{2}CrO_{4}$, $CrO_{3}$, CrK$(SO_4)_{2}$ and $CrCl_{3}$ to the bioluminescence intensity. The calculated $EC_{50}$ showed that the linear relations between such substances and bioluminesence intensity were established.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.16 no.2
• /
• pp.261-270
• /
• 2018

In this study, to replace the 'J-slot joint', a joint device between a disposal canister and an emplacement jig in Deep Borehole Disposal process, a novel joint device was designed and tested. The novel joint device was composed of a wedge on top of a disposal canister and a hook box at the end of a winch system. The designed joint device had merits in that it can recombine an emplaced canister freely without the replacement of the joint component. Moreover, it can be applied to various emplacement jigs such as drill pipes, wire-lines, and coiled tubing. To demonstrate the designed joint device, the joint device (${\Phi}110mm$, H 148 mm), a twin canister string (${\Phi}140mm$, H 1,105 mm), and a water tube (${\Phi}150mm$, H 1,500 mm) as a borehole model were manufactured at 1/3 scale. As deployment muds, Na-type bentonite (MX-80) and Ca-type (GJ II) bentonite muds were prepared at solid contents of 7wt% and 28wt%, respectively. The manufactured joint device showed good performance in pure water and viscous muds, with an operation speed of $10m{\cdot}min^{-1}$. It was concluded that the newly developed joint device can be used for the emplacement and retrieval of a deep disposal canister, below 3~5 km, in the future.

• Applied Biological Chemistry
• /
• v.22 no.3
• /
• pp.166-172
• /
• 1979

A series of experiments was planned for practical application of rhizobia in grass lands in Korea. This is the report for the studies mainly on the isolation and characterization of alfalfa nodule bacteria, and on the assessment of their nodulation abilities and nitrogen fixation capacities. 1. Total number of 47 strains was isolated from nodules which were taken from alfalfa grown in Daekwanyong, Cheju and other places. 2. Morphological and cultural characteristics of the strains were studied, and attempts. were also made to investigate their antigenic properties and to demonstrate lysogenic strains. The results were; i) the isolates varied in their cultural characteristics on yeast mannitol broth and agar, and in degree of congo red absorption; ii) similarities in their antigenic prorerties were found between the strains: SU 47/M-11, M-13/M-15, and M-3/M-5; iii) no lysogeny was found in the strains. 3. Plant infection test by test tube method in light room were carried out to elucidate the ability of the strains to nodulate Luna alfalfa and of the capacity of such nodules to fix atmospheric nitrogen. The isolates were grouped info non-invasive, ineffective, or effective to the legumes. Those strains which produced effective nodules, supporting similar/higher level of growth as nitrate control were: M-8, 9, 14, 20, 21, 25 and 34.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.10 no.6
• /
• pp.487-495
• /
• 2017

The thermal characteristics of the electrodeless lamp are one of the main factors that determine the design and performance of the lamp. The coupler changes the impedance characteristic by heat and its use temperature is usually within about $150^{\circ}C$. In this study, we observed the phenomenon when the coupler was exposed at a temperature of $150^{\circ}C$ or higher, which has not been discussed so far. Two types of coupler A and coupler B with different spacing between the inner tube and the coupler were analyzed for electrical, thermal and optical properties and deterioration characteristics with different heat and heat shielding conditions. First, the impedance of the system is obtained and used as a criterion for analyzing the electrical characteristics through it. The diameters of the two types of couplers are 1 mm, and the experimental result shows that the coupler diameter is 1 mm, which can cancel out the loss of the magnetic field strength. Therefore, based on these results, when the coupler is exposed to high temperature of about $200^{\circ}C$, the efficient design method corresponding thereto is proposed.