• Ocean and Polar Research
• /
• v.35 no.2
• /
• pp.127-134
• /
• 2013

In this study we investigated changes in the Tsushima Warm Current (TWC) under the global warming scenario RCP 4.5 by analysing the results from the World Climate Research Program's (WCRP) Coupled Model Intercomparison Project Phase 5 (CMIP5). Among the four models that had been employed to analyse the Tsushima Warm Current during the 20th Century, in the CSIRO-Mk3.6.0 and HadGEM2-CC models the transports of the Tsushima Warm Current were 2.8 Sv and 2.1 Sv, respectively, and comparable to observed transport, which is between 2.4 and 2.77 Sv. In the other two models the transports were much greater or smaller than the observed estimates. Using the two models that properly reproduced the transport of the Tsushima Warm Current we investigated the response of the current under the global warming scenario. In both models the volume transports and the temperature were greater in the future climate scenario. Warm advection into the East Sea was intensified to raise the temperature and consequently the heat loss to the air.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.3B
• /
• pp.85-94
• /
• 2005

In this paper, we propose a reliable high-speed UDP-based media transport with an adaptive error control. The proposed adaptive transport scheme controls the amount of redundancy by monitoring the network in order to adapt to network fluctuations efficiently. The feedback of receiver enables the sender to be aware of current reception status (i.e., rate and type of packet loss) and to estimate the expected network status. Based on this, the proposed transport attempts to enable reliable transport by adaptively controlling the amount of both whole sending rate and the ratio for adaptive FEC code. Experiment with high-speed network has been conducted to verify the performance of the proposed system that demonstrates the enhanced reliability of the proposed transport at the speed of up to several hundred Mbps.

• Proceedings of the KIEE Conference
• /
• 1996.07a
• /
• pp.101-103
• /
• 1996

Multiply-twist cable is used for a large capacity superconducting cable because it is helpful to reduce AC losses and to increase transport current. In a multiply-twisted cable, the axis of a strand does not coincide with that of cable. Therefore, the longitudinal field is generated by the transport current. The longitudinal field changes the current distribution in the strand and generates additional AC loss. This paper calculates the longitudinal field that is applied to a strand in the multiply-twisted cable. Current distribution of a strand in the cable is also presented. 2nd level superconducting cable is chosen as an analysis model, whose current capacity is 2000A. Calculation result shows the longitudinal field cannot be neglected in low field machines such as superconducting transformer.

• Journal of Communications and Networks
• /
• v.12 no.3
• /
• pp.275-284
• /
• 2010

The current multihome-aware protocols (like stream control transmission protocol (SCTP) or parallel TCP for concurrent multipath data transfer (CMT) are not designed for high-capacity and large-latency networks; they often have performance problems transferring large data files over shared long-distance wide area networks. It has been shown that SCTP-CMT is more sensitive to receive buffer (rbuf) constraints, and this rbuf-blocking problem causes considerable throughput loss when multiple paths are used simultaneously. In this research paper, we demonstrate the weakness of SCTP-CMT rbuf constraints, and we then identify that rbuf-blocking problem in SCTP multihoming is mostly due to its loss-based nature for detecting network congestion. We present a simulation-based performance comparison of FAST TCP versus SCTP in high-speed networks for solving a number of throughput issues. This work proposes an end-to-end transport layer protocol (i.e., FAST TCP multihoming as a reliable, delaybased, multihome-aware, and selective ACK-based transport protocol), which can transfer data between a multihomed source and destination hosts through multiple paths simultaneously. Through extensive ns-2 simulations, we show that FAST TCP multihoming achieves the desired goals under a variety of network conditions. The experimental results and survey presented in this research also provide an insight on design decisions for the future high-speed multihomed transport layer protocols.

• Proceedings of the KSME Conference
• /
• 2007.05b
• /
• pp.2250-2254
• /
• 2007

Comprehensive analytical models focusing on the anode water loss, the cathode flooding, water equilibrium, and water management strategy are developed for polymer electrolyte fuel cells. Analytical solutions presented in this study are compared with two-dimensional computational results and shows a good agreement in predicting those critical characteristics of water. General features of water concentration profile as a function of membrane thickness and current density are presented to illustrate the net effect of the back-diffusion of water from the cathode to anode and the water production by the cathode catalytic reaction on water transport over a fuel cell domain. As one of practical applications, the required humidity level of feed streams for full saturation at the channel outlets are investigated as a function of the physical operating condition. These analytical models can provide good understanding on the characteristic water

• Proceedings of the KIEE Conference
• /
• 1996.07a
• /
• pp.160-162
• /
• 1996

The estimation of AC losses is demanded for higher efficiency and stability in AC use of superconducting coils. Hysteresis loss occurred by a.c. transport current is called of self field loss, and it is major part of losses generated in a.c. superconducting wire in case of located in low external magnetic field as superconducting transformer with iron core, or in short twist pitch wire, multiply stacking cable. In this paper, we calculate self field loss of superconducting wire.

• Progress in Superconductivity and Cryogenics
• /
• v.6 no.2
• /
• pp.1-6
• /
• 2004

It is important to estimate the total AC loss which is the total energy, or power, dissipated in the superconductor in the simultaneous application of AC transport current and an AC external magnetic field. Experimental and numerical works on AC loss estimation of high $T_c$ superconductors in the author's group are reviewed. The method and the set-up for total AC loss measurements are described. The experimental results for a twisted Bi-2223 multifilamentary tape and a Y-123 mm conductor are given. A general theory for numerical electromagnetic field analysis of superconductor by the finite element method is explained. The numerical results for twisted Bi-2223 multifilamentary tapes and a rectangular superconductor simulating coated conductors are presented.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.06a
• /
• pp.367-368
• /
• 2009

BSCCO HTS(High Temperature Superconductor) could be applied to superconducting cable, magnet and motor, using its hight critical properties. Especially, superconducting cable has a hight possibility of practical use due to the possibility of low voltage and high capacity transmission caused by its lower power loss than copper cable. In this paper, the transport characteristics of BSCCO superconducting cable, according to the change of BSCCO superconducting cable's accident point at phase $0^{\circ}$ and $45^{\circ}C$, were analyzed and compared each other. Consequently, when the accident was occur the resistance of the HTS was higher at the point phase $0^{\circ}$ than $45^{\circ}$ which means it will cause much higher load on the HTS.

• 한국HCI학회:학술대회논문집
• /
• 2009.02a
• /
• pp.45-51
• /
• 2009

In this paper, a transparency analysis and network-adaptive transport scheme are proposed in order to improve transparency of EBA-based force-reflecting teleoperation. EBA guarantees stability of force-reflecting teleoperation over network delay and loss but has limitation that it cannot overcome transparency deterioration of haptic interactions. The proposed transparency analysis quantifies the force feedback distortion caused by network delay and loss. Based on the analysis, the proposed haptic data synchronization and transmission rate control schemes adapt synchronization delay and transmission rate to current network state for more transparent haptic interaction. Through Matlab/Simulink simulations, it is confirmed that the proposed analysis provides an acceptable quantification method about haptic interaction quality and that the proposed haptic data transport scheme effectively improves haptic interaction quality with respect to network delays and losses.

• Proceedings of the Korea Institute of Applied Superconductivity and Cryogenics Conference
• /
• 2000.02a
• /
• pp.97-100
• /
• 2000

Superconducting power cable is one of the most promising energy application of high-Tc superconductors (HTS). Thus, we investigated previously the characteristics on electrical and mechanical Bi-2223 Ag sheathed tape. And a prototype HTS cable have been designed, constructed and tested. The result shows that the transport current of HTS cable (1, 19-filament) in LN2 was 116[A], 240[A], respectively. And AC loss of HTS cable(19-filament) was 1.7 [W/m] in 240 [A] loading.