• 한국정보디스플레이학회:학술대회논문집
• /
• 2009.10a
• /
• pp.385-388
• /
• 2009

We have investigated the effect of the device structure on the performance of polycrystalline ZnO TFT and amorphous AZTO TFT with top gate and bottom gate structure. While the mobility of both TFTs showed relatively similar value in a top and bottom gate structure, bias stability was quite different depending on the device structure. Top gate TFT showed much less Vth shift under positive bias stress compared to that of bottom gate TFT. We attributed this different behavior to the defects formation on the gate insulator induced by energetic bombardment during the active layer deposition in a bottom gate TFT. We suggest the top gate oxide TFT would show more stable behavior under the Vgs bias.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.276-276
• /
• 2014

High-performance, fully-transparent, and top-gated oxide thin-film transistor (TFT) was successfully fabricated with Ta2O5 high-k gate dielectric on a glass substrate. Through a self-passivation with the gate dielectric and top electrode, the top-gated oxide TFT was not affected from H2O and O2 causing the electrical instability. Heat-treated InSnO (ITO) was used as the top and source/drain electrode with a low resistance and a transparent property in visible region. A InGaZnO (IGZO) thin-film was used as a active channel with a broad optical bandgap of 3.72 eV and transparent property. In addition, using a X-ray diffraction, amorphous phase of IGZO thin-film was observed until it was heat-treated at 500 oC. The fabricated device was demonstrated that an applied electric field efficiently controlled electron transfer in the IGZO active channel using the Ta2O5 gate dielectric. With the transparent ITO electrodes and IGZO active channel, the fabricated oxide TFT on a glass substrate showed optical transparency and high carrier mobility. These results expected that the top-gated oxide TFT with the high-k gate dielectric accelerates the realization of presence of fully-transparent electronics.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.1101-1104
• /
• 2008

We have fabricated the transparent TFTs using new oxide material (AZTO: Al-doped zinc tin oxide) as an active layer. The AZTO TFT showed good performance without post-annealing. The electrical characteristics were improved by the post-annealing up to $300^{\circ}C$. The AZTO TFTs exhibited a mobility of $8{\sim}12\;cm^2/Vs$, a sub-threshold swing of 0.2~0.6 V/dec, and an on/off ratio of more than $10^9$.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2009.05a
• /
• pp.13.1-13.1
• /
• 2009

Transparent electronics has attracted many interests, for it can open new applications for consumer electronics, transportation, business, and military. Among them, display backplane, thin film transistor (TFT) array would be the most attractive application. Many researchers have been investigating oxide semiconductors for transparent channel material of TFT since the report for transparent amorphous oxide semiconductor (TAOS) TFT by Hosono group and ZnO TFT by Wager group. Especially, oxide TFTs have been intensively investigated during a couple of years since the first demonstration of ZnO-TFT driving AM-OLED. Many papers regarding the fabrication and performance of oxide TFTs, and active matrix display driven by oxide TFTs have been reported. Now lots of people have confidence in the competitiveness of oxide TFTs for the backplane of AM-Display. Especially, high mobility, uniformity, fairly good stability, and low cost process make oxide TFTs applied even to a large size AM-OLED. Last year, Samsung mobile display, former SID, reported 12" AM-OLED driven by IZGO-TFT and it seems that the remained issue for the mass production is the bias temperature stability. Here, we will introduce the application of oxide TFT and important issue for oxide TFT to be used for the direct printing.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.620-621
• /
• 2008

Transparent electronics has been one of the key terminologies forecasting the ubiquitous technology era. Several researchers have thus extensively developed transparent oxide-based thin-film transistors (TFTs) on glass and plastic substrates although in general high voltage operating devices have been mainly studied considering transparent display drivers. However, low voltage operating oxide TFTs with transparent electrodes are very necessary if we are aiming at logic circuit applications, for which transparent complementary or one-type channel inverters are required. The most effective and low power consuming inverter should be a form of complementary p-channel and n-channel transistors but real application of those complementary TFT inverters also requires electrical- and even photo-stabilities. Since p-type oxide TFTs have not been developed yet, we previously adopted organic pentacene TFTs for the p-channel while ZnO TFTs were chosen for n-channel on sputter-deposited $AlO_x$ film. As a result, decent inverting behavior was achieved but some electrical gate instability was unavoidable at the ZnO/$AlO_x$ channel interface. Here, considering such gate instability issues we have designed a unique transparent complementary TFT (CTFTs) inverter structure with top n-ZnO channel and bottom p-pentacene channel based on 12 nm-thin nano-oxide/self assembled monolayer laminated dielectric, which has a large dielectric strength comparable to that of thin film amorphous $Al_2O_3$. Our transparent CTFT inverter well operate under 3 V, demonstrating a maximum voltage gain of ~20, good electrical and even photoelectric stabilities. The device transmittance was over 60 % and this type of transparent inverter has never been reported, to the best of our limited knowledge.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2009.10a
• /
• pp.464-465
• /
• 2009

A new level shifter using n-channel aluminum-doped zinc tin oxide (AZTO) thin film transistors (TFTs) was proposed to integrate driving circuits on qVGA panels for mobile display applications. The circuit used positive feedback loop to overcome limitations of circuits designed with oxide TFTs which is depletion mode n-channel TFTs. The measured results shows that the proposed circuit shifts 10 V input voltage to 20 V output voltage and its power consumption is 0.46 mW when the supply voltage is 20 V and the operating frequency is 10 kHz.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2007.08b
• /
• pp.1273-1276
• /
• 2007

We provide a newly developed dry etching process for the fabrication of ZnO-based oxide TFTs. The etching characteristics of ZnO (active layer) and $Al_2O_3$ (gate insulator) thin films were systematically investigated when the etching gas mixtures and their mixing ratios were varied in the heliconplasma etching system.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.06a
• /
• pp.10-10
• /
• 2009

We have fabricated transparent and flexible thin film transistor(TFT) on polyethylene terephthalate(PET) substrate using Zinc Oxide (ZnO) and Indium Tin Oxide (ITO) film as active layer and electrode. The transfer printing method was used for printing the device layer on target plastic substrate at room temperature. This approach have an advantage to separate the high temperature annealing process to improve the electrical properties of ZnO TFT from the device process on plastic substrate. The resulting devices on plastic substrate presented mechanical and electrical properties similar with those on rigid substrate.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.222-225
• /
• 2008

We proposed the dry etching process recipe for the fabrication of In-Ga-Zn-O (IGZO)-based oxide TFTs, in which the etching behaviors of IGZO films were systematically investigated when the etching gas mixtures and their mixing ratios were varied. Good device characteristics of the fabricated TFT were successfully confirmed.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.28 no.6
• /
• pp.351-359
• /
• 2015

Next-generation displays should be transparent and flexible as well as having high resolution and frame number. The main factor for active matrix organic light emitting diode and next-generation displays is the development of TFTs (thin-film transistors) with high mobility and large area uniformity. The TFTs used for transparent displays are mainly oxide TFT that has oxide semiconductor as channel layer. Zinc-oxide based substances such as indium-gallium-zinc-oxide has attracted attention in the display industry. In this paper, the mobility improvement of low cost oxide TFT is studied for fast operating next-generation displays by overcoming disadvantages of amorphous silicon TFT that has low mobility and poly silicon TFT that requires expensive equipment for complex process and doping process.