• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.2 no.2
• /
• pp.82-102
• /
• 2008

Packet losses tend to occur during short error bursts separated by long periods of relatively error-free transmission. There is also a significant spatial correlation in loss among the receiver nodes in a multicast session. To recover packet transmission errors at the transport layer, tree-based protocols construct a logical tree for error recovery before data transmission is started. The current tree construction scheme does not scale well because it overloads the sender node. We propose a scalable recovery tree construction scheme considering these properties. Unlike the existing tree construction schemes, our scheme distributes some tasks normally handled by the sender node to specific nodes acting as repair node distributors. It also allows receiver nodes to adaptively re-select their repair node when they experience unacceptable error recovery delay. Simulation results show that our scheme constructs the logical tree with reduced message and time overhead. Our analysis also indicates that it provides fast error recovery, since it can reduce the number of additional retransmissions from its upstream repair nodes or sender node.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.4 no.4
• /
• pp.275-279
• /
• 2004

A new burst mode clock and data recovery circuit is realized that improves the previousldy-known gated-oscilletor technique with half rate clock recovery, The circuit was fabricated with 0.25um CMOS technology, and its functions were confirmed up to 1 Gbps.

• Journal of Communications and Networks
• /
• v.6 no.3
• /
• pp.235-244
• /
• 2004

There have been a lot of approaches to evaluate and predict transmission control protocol (TCP) performance in a numerical way. Especially, under the recent advance in wireless transmission technology, the issue of TCP performance over wireless links has come to surface. It is because TCP responds to all packet losses by invoking congestion control and avoidance algorithms, resulting in degraded end-to-end performance in wireless and lossy systems. By several previous works, although it has been already proved that overall TCP performance is largely dependent on its loss recovery performance, there have been few works to try to analyze TCP loss recovery performance with thoroughness. In this paper, therefore, we focus on analyzing TCP's loss recovery performance and have developed a simple model that facilitates to capture the TCP sender's behaviors during loss recovery period. Based on the developed model, we can derive the conditions that packet losses may be recovered without retransmission timeout (RTO). Especially, we have found that TCP Reno can retransmit three packet losses by fast retransmits in a specific situation. In addition, we have proved that successive three packet losses and more than four packet losses in a window always invoke RTO easily, which is not considered or approximated in the previous works. Through probabilistic works with the conditions derived, the loss recovery performance of TCP Reno can be quantified in terms of the number of packet losses in a window.

• Nuclear Engineering and Technology
• /
• v.56 no.2
• /
• pp.685-687
• /
• 2024

Fiber optic cables are used extensively for remote monitoring in applications under extreme conditions, such as at high temperatures or in ionizing radiation fields. When high temperature fiber optic cables were subjected to gamma irradiations, there was a significant loss in transmission at wavelengths < 350 nm after only 1 minute of irradiation. Negligible recovery of the fiber optic transmission with time was observed over 2 years, but the irradiation damage was almost completely reversed by high temperature annealing at 400 ℃.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.6B
• /
• pp.867-874
• /
• 2010

Since high packet losses occur in multi-hop transmission of wireless sensor networks, reliable data transmission is required. Especially, in case of event-driven data, a loss recovery mechanism should be provided for lost packets. Because retransmission for lost packets is requested to a node that caches the packets, the caching node should maintains all of data for transmission in its buffer. However, nodes of wireless sensor networks have limited resources. Thus, both a loss recovery mechanism and a buffer management technique are provided for reliable data transmission in wireless sensor networks. In this paper, we propose a buffer management technique at a caching position determined by a loss recovery mechanism. The caching position of data is determined according to desirable reliability for the data. In addition, we validate the performance of the proposed method through computer simulations.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.7B
• /
• pp.650-659
• /
• 2004

Domestic wireless network environment is changing rapidly while adapting to meet service requirements of users and growth of market. As a result, reliable data transmission using TCP is also expected to increase. Since TCP assumes that it is used in wired networt TCP suffers significant performance degradation over wireless network where packet losses are not always result of network congestion. Especially RTO imposes a great performance degradation of TCP. In this paper, we propose DAC$^{＋}$ and EFR in order to prevent performance degradation by quickly detecting and recovering loss without RTO during fast recovery. Compared with TCP NewReno, proposed scheme shows improvements in steady-state in terms of higher fast recovery Probability and reduced response time.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.14 no.6
• /
• pp.1043-1048
• /
• 2011

In this paper, a newsynchronization technique applied to burst-mode communication is proposed. A synchronization technique is to estimate carrier frequency and phase offsets in a noisy channel environment. A fundamental problem for estimating the parameters(carrier phase and frequency offsets) in burst-mode transmission is that the ways of pursuing estimation accuracy and transmission efficiency are always trade-off. To solve this problem, a new carrier recovery technique is proposed to improve the transmission efficiency with reliable performance especially at low S/N. In the proposed technique, the synchronization parameters are first estimated based on a data-aided feed-forward estimation scheme. Then, a phase tracker using decision-directed DPLL estimates the phase offset for the data portion of the burst data. From simulation results, it shows fast synchronization with shorter preamble maintaining reasonable BER performance at low S/N.

• Proceedings of the IEEK Conference
• /
• 2002.07a
• /
• pp.429-432
• /
• 2002

The existing recovery technique using the logging technique in the client/sewer database system only administers the log as a whole in a server. This contains the logging record transmission cost on the transaction that is executed in each client potentially and increases network traffic. In this paper, the logging technique for redo-only log is suggested, which removes the redundant before-image and supports the client-based logging to eliminate the transmission cost of the logging record. Also, in case of a client crash, redo recovery through a backward client analysis log is performed in a self-recovering way. In case of a server crash, the after-image of the pages which needs recovery through simultaneous backward analysis log is only transmitted and redo recovery is done through the received after-image and backward analysis log. Also, we select the comparing model to estimate the performance about the proposed recovery technique. And we analyzed the redo and recovery time about the change of the number of client and the rate of updating operation.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.7 no.4
• /
• pp.741-746
• /
• 2012

Transmission control protocol(TCP) widely used as a transport protocol in the Internet includes a loss recovery function that detects and recovers packet losses by retransmissions. The loss recovery function consists of the two algorithms; fast retransmit and fast recovery. There have been researches to avoid nonnecessary retransmission timeouts (RTOs), which leads to selective acknowledgement (SACK) option and limited transmit scheme that are standardized by IETF (Internet Engineering Task Force). Recently, a method that covers the case in which a retransmitted packet is lost again has been propsed. The method, however, is not proved in terms of the additive increase multiplicative decrease (AIMD) principle of TCP congestion control. In this paper, therefore, we analyzed the method in terms of the principle by ns-simulations.

• Proceedings of the KIEE Conference
• /
• 2007.07a
• /
• pp.107-108
• /
• 2007

Overhead transmission lines are completely exposed to the environment. This causes faults in transmission lines due to natural environmental conditions. In some cases, transmission towers are damaged by typhoons and snow, as well as sleet on the transmission lines. It takes a lot of time to repair the damaged towers. For emergency restoration purposes, steel poles are installed to temporarily supply power. Before 2003, emergency restoration steel poles were made of angled steel, which required a large number of beams, bolts, etc. In addition, the foundation of the steel pole and ground wire was constructed using excavation and burial methods, therefore it required a lot of manpower and time to construct temporary transmission lines. In September 2003, typhoon Maemi, whose maximum wind speed was 60m/s, hit Korea. 'Maemi' destroyed transmission lines in the Busan and Geojea area, causing long blackouts. To reduce the recovery time to the damaged transmission lines, self-build based emergency towers were developed. self-build based emergency towers reduced recovery time from 24 hours to 4 hours or less. However, the self-build based emergency tower had no arms, so the temporary transmission lines could only be constructed without curves in line routes. In this paper, solving these self-build based emergency tower limitations, using insulated arms(designed for use with the self-build based emergency tower), shall be explained.