• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.11 no.6
• /
• pp.295-302
• /
• 2011

In this paper we consider technological requirements to broadcast digital television signals using single frequency networks(SFN) in the Advanced Television Systems Committee(ATSC) transmission systems and propose Interference Cancellation Digital On Channel Regenerative Repeater(IC-DOCR) thar overcomes the limitation of EDOCR(Equalization Digital On Channel Repeater) proposed by ETRI. The proposed IC-DOCR maintains the benefits of EDOCR that have good output signal quality removing multi-path, additive white Gaussian noise(AWGN). In additional, since the Interference Cancellation algorithm using the 8-VSB symbol demodulation of received signal removes the Interference of feedback signal, IC-DOCR improve the weakness of EDOCR that have low isolation between receive and transmit antenna so that can overcome the limitation of output signal power. we did analysis and verification of the proposed system performance using computational simulation.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.14 no.3
• /
• pp.7-12
• /
• 2014

The data forwarding transmission is an important function of the relay in cooperative communication in wireless communication systems. However, additional relay cause the waste of power consumption and cost. Therefore, in this paper, we consider how to use the user mobile devices in stead of relays to deal with this problem. In this paper, we proposed the protocol that divide each relay into two states of idle and non-idle. The receiver has two functions of base station and user mobile device. In this case, it is possible that no additional cost, and improve the spectral efficiency and network capacity. We verified BER performance for the proposed protocol over Rayleigh fading through Monte-Carlo simulation.

• Spatial Information Research
• /
• v.18 no.4
• /
• pp.75-88
• /
• 2010

Recent development in wireless communication and mobile positioning technologies make geosensor networks widely used in the various fields of real world. As a result, much research has been done on the middleware that uses limited energy resources efficiently. However, because traditional middleware does not consider the characteristics of sensor node, such as computing power and specification, the existing middleware call not support the sensor nodes with only the restricted system resource. Therefore, in this paper, we design and implement a new Bytecode based Data Service Middleware supporting energy efficiency in geosensor networks. At first, the proposed middleware provides the optimized functions for sensor nodes by using minimum by tee ode instruction set and data manager supporting hardware abstraction. Secondly, the proposed middleware increases the energy efficiency of sensor node through both data aggregation query processing and data filtering that minimize data transmission by eliminating unnecessary data. Finally, we show from our performance analysis that the proposed middleware is more energy efficient than the existing SwissQM.

• Journal of the Korea Society of Computer and Information
• /
• v.17 no.10
• /
• pp.99-105
• /
• 2012

ZigBee is the low power, low cost and low data rate wireless personal area network(LR-WPAN) standard. The Directed-Messaging is the protocol which improves the energy efficiency through reducing the redundant message transmission by transmitting messages with directional information toward the specified sub-network area in wireless sensor network using broadcasting. In this paper, we design and implement the experimental grid sensor network using ZigBee modified by the Directed-Messaging for the energy efficiency improvement. The experimental sensor network in this paper is configured with Nano24 supporting the ADV message and the routing management module modified to use the directional information. The energy efficiency improvement of the experimental sensor-network by evaluating the experimental results according to transmitting ADV message.

• Journal of the Korea Society for Simulation
• /
• v.21 no.2
• /
• pp.51-58
• /
• 2012

In IEEE 802.16j MMR protocol, two modes about usage of RS are proposed; one is transparent mode to enhance data throughput and the other is non-transparent mode to extend coverage. In this paper, we focus on non-transparent mode and find that the mode can also improve data throughput. Therefore, we analyze data throughput on various RS topology and their extended coverage area by simulation in IEEE 802.16j non-transparent mode. We also compare the simulation results with the single MR-BS system of which coverage is extended by higher transmission power. From the comparisons of simulation results, we see that higher throughput can be obtained in the proposed non-transparent mode.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.3
• /
• pp.950-975
• /
• 2016

Device-to-Device (D2D) communication underlaying cellular networks is a promising add-on component for future radio communication systems. It provides more access opportunities for local device pairs and enhances system throughput (ST), especially when mobile relays (MR) are further enabled to facilitate D2D links when the channel condition of their desired links is unfavorable. However, mutual interference is inevitable due to spectral reuse, and moreover, selecting a suitable transmission mode to benefit the correlated resource allocation (RA) is another difficult problem. We aim to optimize ST of the hybrid system via joint consideration of mode selection (MS) and RA, which includes admission control (AC), power control (PC), channel assignment (CA) and relay selection (RS). However, the original problem is generally NP-hard; therefore, we decompose it into two parts where a hierarchical structure exists: (i) PC is mode-dependent, but its optimality can be perfectly addressed for any given mode with additional AC design to achieve individual quality-of-service requirements. (ii) Based on that optimality, the joint design of MS, CA and RS can be viewed from the graph perspective and transferred into the maximum weighted independent set problem, which is then approximated by our greedy algorithm in polynomial-time. Thanks to the numerical results, we elucidate the efficacy of our mechanism and observe a resulting gain in MR-aided D2D communication.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.8 no.5
• /
• pp.113-119
• /
• 2008

Conventional 1-1-1 cooperative protocol offers path-loss gain as advantage of multi-hop and spatial diversity which is equivalent to MIMO system. This protocol is enable to get higher reliability and reduction of power consumption than those of the single-hop or multi-hop. But the 1-1-1 cooperative protocol get only the diversity order 2 and limited path-loss reduction gain because this protocol has a single cooperative relay. We propose 1-2-1 cooperative protocol using two cooperative relays R1, R2. The 1-2-1 cooperative protocol can improve path-loss reduction and increase diversity order 3. Moreover, the cooperative relay R2 attains diversity order 2. The signaling method in transmission uses DF (Decode and Forward) or DR (Decode and Reencode) and 1-2-1 DF/DR cooperative protocol are applied to clustering based wireless sensor networks (WSNs). Simulations are performed to evaluate the performance of the protocols under Rayleigh fading channel plus AWGN (Additive White Gaussian Noise).

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.32A no.3
• /
• pp.1-9
• /
• 1995

In the B-ISDN using satellite between geo-satellites and earth stations, the laser having high security and broad band width has to be used as a carrier for transmitting massive information of visual, vocal, and high rate data. In this paper, by computer simulation we analyzed the number of optical detector array of optical satellite communication downlink in case of using channel coding and no channel coding for BISDN between geo-satelites and earth stations under clear weather condition. It was supposed that 1 watt semiconductor laser was used and as modulation method, the binary FSK was used. The data rate of 10Gbps was used for B-ISDN. Also, hardly affected by atmospheric absorption 1.55$\mu$m wave-length was used to reduce influence of dispersion and chirp generated at a high speed transmission. We analyzed the received power, SNR and BER. The number of optical detector array was determined to satisfy for the BER less than 10$^{-7}$. Also, we ananlyzed the possibility of reducting the number of optical detector array in case of using channel coding. the number of optical detector array is one in the region where the elevation nangle is between 38$^{\circ}$ and 90$^{\circ}$ and two where the elevation angle is between 33$^{\circ}$ and 37$^{\circ}$ and three where the elevation angle is between 30$^{\circ}$ and 32$^{\circ}$ and increases per one as the elevation angle decreases per 1.deg.. So in the region where the elevation angle is 25$^{\circ}$, the number of optical detector arrays is eight. In case of using channel coding, the number of optical detector arrays decreases to five in the region where the elevation angle is 25$^{\circ}$. Therefore, we remaark the advantage of the channelcoding to decrease the size of received antenna and the number ob optical detector arrays.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.1
• /
• pp.11-18
• /
• 2012

In this paper, we propose a novel equal-gain differential precoding scheme utilizing temporal correlation of channels. The conventional differential precoding schemes only quantize a part of channel space not the whole channel space, so that it virtually increases codebook size which enhances the system capacity. But the conventional differential schemes increase peak-to-average power ratio (PAPR) without preserving equal-gain transmission. This paper proposes the design method of equal-gain differential precoding scheme and analyzes the performances of the proposed equal-gain precoding scheme. Monte-Carlo simulations verify that the proposed scheme has an advantage of 1dB to obtain the same system capacity with the same amount of feedback information compared with the conventional LTE schemes, with showing very low PAPR property.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.2
• /
• pp.9-16
• /
• 2012

In this paper, the beamforming and user scheduling scheme for device-to-device (D2D) underlaying celullar networks with partial channel state information is investigated. In the proposed scheme, cellular users whose channels are nearly orthogonal to the channel between base station and D2D receiver are selected for unitary beamforming so as to minimize the interference to the D2D receiver. The interference caused by underlaying D2D communication can be minimized by reducing the D2D transmitter's transmission power. To enhance the cellular users' throughput further, we also investigate codebook generation method in which each code vector belongs to multiple unitary code matrices. From simulation results, we show that the proposed beamforming and user scheduling scheme mitigates D2D interference to the cellular networks and the codebook generation method improves cellular users' throughput.