• Journal of the Korean Geosynthetics Society
• /
• v.15 no.1
• /
• pp.21-35
• /
• 2016

It is a current trend that the concrete track is applied for high speed railway. In the case of the railway embankment constructed on soft ground, the damage to concrete track which is sensitive to settlement such as distortion and deflection could be caused by very small amount of long term settlement. Pile Supported Embankment method can be considered as the effective method to control the residual settlement of the railway embankment on soft ground. The Geosynthetics is used inside of the embankment to maximize the arching effect transmitting the load of the embankment to the top of the piles. But, PHC piles that are generally used for bridge structures are also applied as the pile supporting the load of embankment concentrated by the effect of the Geosynthetics. That is very low efficiency in respect of pile material. So, in this study, the cast in place concrete pile was selected as the most suitable pile type for supporting the embankment by a case study and the optimum mixing condition of concrete using a by-product of industry was induced by performing the mixing designs and the compressive strength designs. And it is shown that the cast in place pile with the optimum mixing condition using the by-product of industry is 2.8 times more efficient than the PHC pile for the purpose of Pile Supported Embankment by the finite element analysis method.

• Asian Journal of Turfgrass Science
• /
• v.23 no.1
• /
• pp.61-76
• /
• 2009

The purpose of this study are to investigate the reasonable maintenance expense of golf course according to the size and management system of each golf course. The maintenance cost per hole per golfer of 29 golf courses and the maintenance cost for items and locations of 8 golf courses were analyzed. 1. As golfers per hole increased, maintenance cost per hole per golfer decreased. 2. The decisive cost factors for maintenance cost of golf course are the number of annual golfers, the total course size, the management system, and automation of course facilities. 3. Maintenance cost of golf courses contained the landscaping areas except for building and parking lots is $869^{\}/_{m^2}$ Korean won. 4. Average maintenance cost of 8 golf courses is $44,325,000^{\}/_{hole}$. 5. Labor cost marked the largest portion in the total cost. Among the items of labor cost, repair cost for green ball mark was the highest with the ratio of 26%(\4,163,000). 6. Material cost for Fairways which reaches 30% of the total area was composed of $22%{\sim}44%$ of the total cost of materials. Cost of imported fertilizers, pestcides for insects and diseases, and sands for top dressing was the highest. 7. Material cost for Green which reaches 2% of the total area was composed of $28%{\sim}36%$ of the total cost. Cost of imported products such as particle-shaped fertilizers, micro mineral fertilizers, and soil conditioners was the highest. 8. There is no difference in cost between chemical fertilizers and the environmentally friendly fertilizers even if environmentally friendly fertilizers using microorganism or chitosan materials are also expensive.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2017.06a
• /
• pp.201-201
• /
• 2017

Delayed stem senescence of soybean is a phenomenon of retarded leaf and stem yellowing, where plants maintain a high stem water content and remain chlorophyll in leaf and stem at maturity stage. This phenomenon was one of the most important physiological disease in Japanese soybean cultivation. The occurrence of delayed stem senescence was affected by sowing time. And the most of Japanese field, soybean seeds were sowed in June. June is the rainy season in Japan, and the soil water content of field become higher in this season. In this study, the effects of late sowing (July sowing) on the yield and the occurrence of delayed stem senescence in soybean cultivars Enrei, Tachinagaha and Ayakogane were examined from 2013 to 2015, in the experimental farm at Nihon University (Fujisawa-city, Kanagawa, Japan). The seeds of all cultivars were sowed in June (June-normal density plot) or July (July-normal density plot, July-high density plot and July-super high density plot) in field experiment. The pot experiments were carried out in 2014. In all cultivars, the yield of July-high density plot and July-super high density were higher than that of June normal density plot. And the yield of June-normal density plot was the same as that of July-normal density plot. In all cultivars, the occurrence of delayed stem senescence was increased by seeding in June sowing. And in July sowing plots, no significance difference in the occurrence of delayed stem senescence was observed among density plots. One of reason about the increasing the occurrence of delayed stem senescence in June-normal plot was the increasing of the damaged seeds by bean bugs. Add one of reason about the decreasing of the occurrence of delayed stem senescence of July plots was the decreasing of the amount of cytokinin supplied from root to top and water stress after the flowering time was improved compared with the June plot. In conclusion, the yield of Enrei, Tachinagaha and Ayakogane were not changed by changing the sowing time from June to July. In all cultivars, the occurrence of delayed stem senescence were decreasing by seeding in July.

• The Korean Journal of Ecology
• /
• v.27 no.2
• /
• pp.99-106
• /
• 2004

We developed the estimation model for the vegetation developmental processes on the severely burned slope areas after forest fire in the east coastal region, Korea. And we calculated the vegetation indices as a useful parameter for the development of land management technique in the burned area and suggested the changes of the vegetation indices after forest fire. In order to estimate the woody standing biomass in the burned area, allometric equations of the 17 woody species regenerated by sprouter were investigated. According to the our results, twenty year after forest fire need for the development to the normal forest formed by 4 stratum structure, tree, sub-tree, shrub and herb layer. The height of top vegetation layer, basal area and standing biomass of woody species show a tendency to increase linearly, and the ground vegetation coverage and litter layer show a tendency to increase logarithmically after forest fire. Among vegetation indices, Ive and Ivcd show a tendency to increase logarithmically, and Hcl and Hcdl show a tendency to increase linearly after forest fire. The spatial variation of the most vegetation factors was observed in the developmental stages less than the first 5 years which were estimated secondary disaster by soil erosion after forest fire. Among vegetation indices, Ivc and Ivcd were the good indices for the representation of the spatial heterogeneity in the earlier developmental stages, and Hcl and Hcdl were the useful indices for the long-term estimation of the vegetation development after forest fire.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.9
• /
• pp.626-633
• /
• 2020

This study examined the behavior of the ground by comparing the methods using the results of the Terzaghi formula and the ground investigation data and method considering the dilatancy effect for a circular tunnel using the finite element method. In the case of the Terzaghi formula, the tunnel load can be overestimated and cause overdesign. The method using the results of the ground investigation data cannot be applied when a reasonable coefficient of earth pressure is not determined. This is because it behaves completely differently from the actual behavior, and unexpected problems can occur. In the case of the method considering the dilatancy effect, however, both the strength enhancement effect can be considered through the dilatancy angle and relative density. Therefore, the tunnel load was calculated most reasonably using the method considering dilatancy. Finite element analysis using the geotechnical survey results showed that the tensile stress acts at the top of the tunnel when the upper soil of the tunnel is shallow. On the other hand, additional verification is necessary, such as a comparison with the field measurement results. Through additional research, if normalized, the tunnel load can be calculated reasonably at the time of tunnel design, and safe and economical design is possible.

• Journal of the Mineralogical Society of Korea
• /
• v.5 no.1
• /
• pp.14-21
• /
• 1992

Allanite crystals rich in rare-earth elements(REE) occur in soil developed on top of anorthositic rocks in the Jungsu-ri area of Okjong-myun, Hadong-run, where large Ti orebodies are embedded in the bed rock. In this study allanite is investigated mainly by transmitted light microscopy, electron microprobe analysis, atomic absoption spectrophotometry, X-ray diffraction, infrared spectrocopy. In addition, its specific gravity and micro=indentation hardness value are measured. Allanite occurs with max. dimension of $3cm{\times}6cm$ and coexists with quartz, epidote, zircon, biotite and muscovite. It shows nearly nonmetamict crystallinity, although ${\alpha}$-particles bombardment from the disintegration of the radioactive element Th is detected by an autoradiography. The allanite is particularly enriched in REE(19.88-23.99 wt.%), but is deficient in CaO(8.35-10.29wt.%). Genesis of the allanite in this area is not understood yet. It is, however, assumed to have been formed from magmatic fluid rich in REE and Ti, based on the facts that it ocexists with zircon and that it has high $TiO_2$(0.89-1.13 wt.%) whose concentration is significant in the country rocks.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.42 no.5
• /
• pp.503-514
• /
• 1997

The morphogenesis of panicle and spikelet in paddy rice has been studied in high yielding Indica$\times$Japonica hybrid cultivar, Milyang 23 and a Japonica type cultivar, Koshihikari. Germinated seeds planted in $5000^{-1}$ a pots filled with submerged soil and cultured under natural conditions. The young panicle of main stem were continuously dissected and observered by Cryo-SEM from the panicle initiation stage until heading stage. Although the date of panicle differentiation and heading in Koshihikari earlier than those of Milyang 23. the sequence of panicle development in two cultivars begins when first bract primordium at opposite side of flag-leaf primordium differentiated, synchronously followed by growth of the primary branch primordia (PBPs) and secondary branch primordia (SBPs), spikelet primordia(SPs), glumes as lateral organs on rachilla and organs composing single floret, and successive sporogenesis in the young spikelets continue after the enclosure by lemma and palea. The PBPs are acropetally initiated from the base of the panicle primordium, and the SBPs alternately differentiate from the base of upper PBP which differentiate later than the lower PBP. Spikelet development starts at the top of upper side PBP of the young panicle and continue basipetally even though SBPs continue to develop at the lower primary branch. Each PBP, SBP and SP differentiate with differentiation bract or bract hair cell around the base of each their primordia. The observation could confirm that Milyang 23 has not only 2~3 more defferentiated PBPs, but also more SBPs and SPs especially from middle-lower primary branch, at end of their differentiation stages, as compared to those of Koshihikari.

• The Journal of Engineering Geology
• /
• v.30 no.2
• /
• pp.185-198
• /
• 2020

High-density rapid expansion material is a method that increases the solid volume of injection materials due to hydration and foam reactions at the same time as spraying. It is an effective method for securing ground stability, restoring subsidence, and loading during construction of structures. In this regard, through the mechanical experiments of injection materials, the stability of the foundation ground of the structure and the effect of increasing the endurance using site construction were analyzed. The results of the experiment showed that the unit weight of soil decreased by 10.5% after injection of the filling material, and the allowable support for the structure was deemed safe, and the subsidence by each section after ground improvement was determined to be safe at 2.28, 1.55 and 0.46 cm, respectively, with an acceptable subsidence of less than 5 cm. After the field test, five inclinometers were installed on the top floor of the target building to measure the displacement of the X and Y axes. As a result of the measurement, no displacement related to the phenomenon of inequality or subsidence cracks of the structure was measured for about 16 months (509 days) after construction. This can be judged to be a sufficient increase in the stability of the ground after the injection of rapid expansion.

• Korean Journal of Plant Resources
• /
• v.23 no.4
• /
• pp.368-373
• /
• 2010

Juniperus chinensis var. sargentii Henry is a short and creeping evergreen shrub which reaches about 60 cm in height and only occurs in the northeast Asia and in the top of high mountains over the Korea. The Korea Forest Service protects it strictly by law since J. chinensis var. sargentii is an eccentric plant and possibly may be exterminated soon in Korea. This study was carried out to develop the propagation technique by cutting for conservation of genetic resources of J. chinensis var. sargentii. The rooting responses of branch cuttings, obtained from hard(May) and semi-hard wood shoots (August) to four growth regulators, namely, IAA, IBA, NAA and Rooton(exceptionally powder method) applied at various concentrations(0, 100, 200, 500, 1000 and 2000 $mgL^{-1}$) were examined in mixed soil media. Rooting rate showed significant difference between cutting times, among kinds and among concentrations of growth regulators. The optimum cutting time was April to May in hardwood cutting. The application of IBA 1000 $mgL^{-1}$(rooting rate : 36.4%) was most effective in callus formation and rooting of cutting. Relatively, rooting of cutting of the control taken in May was 30.4%. Root characteristics such as number, length and diameter of root were not significantly affected by kinds and concentrations of growth regulators in hardwood cutting.

• The Korean Journal of Ecology
• /
• v.28 no.1
• /
• pp.31-36
• /
• 2005

An important theme of this paper is to search for more genelalities of diversity and distribution pattern on the trampled plant communities in Daegu area. A total of 50 phytosociological releves were analyzed by the Zurich-Montpellier School's method and generalized habitat characteristics by using Euclidean coefficient and PCoA (Principal Coordinates Analysis). Five plant communities were classified and matched into largely two physiognomic types: grass-types such as Eragrostis ferruginea community, Eleusine indica community, Setaria viridis community, Digitaria ciliaris community, and forb-type of Plantage asiatica community only. These plant communities correspond to quite distinctive four habitat types, with both soil stability and moisture in microhabitat conditions: stable-moderate, unstable-moderate, stable-dry, and unstable-dry. Top-ten species showing the highest relative net contribution degree(r-NCD) were Digitaria ciliaris, Eleusine indica, Eragrostis ferruginea, Plantago asiatica, Echinochloa crus-galli, Trifolium repens, Polygonum aviculare, Setaria viridis, Setaria glauca and Artemisia princeps. The front three species showing more than 50% in percent r-NCD possess florescence after monsoon season. It is critically pointed out that the regional ecological differentiations i.e. the Daegu bioclimatic division, the $C_4$-plant dominant season(post-monsoon) of Korean peninsula, and species composition different from Japan's Plantaginetalia asiaticae, are the basis for deriving characteristics of the roadbed trampled plant communities of Daegu.