• Journal of Positioning, Navigation, and Timing
• /
• v.12 no.2
• /
• pp.157-166
• /
• 2023

Several experiments were carried out to analyze the impact of the modernized Global Positioning System (GPS) L2C signal on pseudorange-based point positioning. Three dual-frequency positioning algorithms, ionosphere-free linear combination, ionospheric error estimation, and simple integration, were used, and the results were compared with those of Standard Point Positioning (SPP). An analysis was conducted to determine the characteristics of each dual-frequency positioning method, the impact of the magnitude of ionospheric error, and receiver grade. Ionosphere-free and ionospheric error estimation methods can provide improved positioning accuracy relative to SPP because they are able to significantly reduce the ionospheric error. However, this result was possible only when the ionospheric error reduction effect was greater than the disadvantage of these dual-frequency positioning algorithms such as the increment of multipath and noise, impact of uncertainty of unknown parameter estimation. The RMSE of the simple integration algorithm was larger than that of SPP, because of the remaining ionospheric error. Even though the receiver grade was different, similar results were observed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.4B
• /
• pp.237-244
• /
• 2003

This paper presents the design of a QPSK/16-QAM downstreams receiver chip. The proposed chip consists of a blind equalizer, a timing recovery block and a carrier recovery block. The blind equalizer uses a DFE sturucture using CMA(Constant Module Algorithm). The symbol timing recovery uses the modified parabolic interpolator. The decision-directed carrier recovery is used to remove the carrier frequency offset, phase offset and phase jitter. The implemented LMDS receiver can support four data rates, 10, 20, 30 and 40 Mbps and can accommodate the symbol rate up to 10 Mbaud. This symbol rate is faster than existing QAM receivers.

• Journal of Positioning, Navigation, and Timing
• /
• v.11 no.4
• /
• pp.317-325
• /
• 2022

In this paper, we developed a single frequency-based RRAIM to monitor integrity of the UAM landing vertically in urban area with only low-cost single-frequency GPS receiver. Conventional dual-frequency RRAIM eliminates ionospheric delay through a combination of frequencies. In this study, ionospheric delay was directly modeled. Drift error of residual ionospheric delay is modeled using the previously studied result on ionospheric rates of change. To verify the performance of the proposed RRAIM algorithm, a simulation of vertical landing UAM in urban area was conducted. It was assumed that the protection level at the initial position was calculated through SBAS correction data. During vertical landing, integrity monitored by receiver alone without external correction data. In the 60 sec simulation, the protection level of the proposed RRAIM compared to the conventional RRAIM was calculated to be 140% due to the accumulated ionospheric delay error. Nevertheless, it was confirmed that the final vertical protection level meeting the requirements of LPV-200, which cannot be achieved with single frequency GPS receiver alone.

• Journal of Positioning, Navigation, and Timing
• /
• v.12 no.2
• /
• pp.121-128
• /
• 2023

When calculating the user's position using satellite signals, the signals originating from the satellite pass through the ionosphere and troposphere to the user. In particular, the ionosphere delay error that occurs when passing through the ionosphere delays when the signal is transmitted, generating a pseudorange error and position error at a large rate. Therefore, to improve position accuracy, it is essential to correct the ionosphere layer error. In a receiver capable of receiving dual frequency, the ionosphere error can be eliminated through a double difference, but in a single frequency receiver, an ionosphere correction model transmitted from a Global Navigation Satellite System (GNSS) satellite is used. The popularly used Klobuchar model is designed to improve performance globally. As such, it does not perform perfectly in the Korea region. In this paper, the characteristics of the delay in the ionosphere in the Korean region are identified through an analysis of 10 years of data, and an improved ionosphere correction model for the Korean region is presented using the widely employed Klobuchar model. Through the proposed model, vertical position error can be improved by up to 40% relative to the original Klobuchar model in the Korea region.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.49 no.9
• /
• pp.244-250
• /
• 2012

This paper describes a 4-Gb/s receiver circuit for a low-swing ground-referenced differential signaling system. The receiver employs a common-gate level-shifter and a continuous linear equalizer which compensates inter-symbol-interference (ISI) and improves voltage and timing margins. A bias circuit maintains the bias current of the level-shifter when the common level of the input signal changes. The receiver is implemented with a low-power 65-nm CMOS technology. When 4-Gb/s 400mVp-p signals are transmitted to the receiver through the channel with the attenuation of -19.7dB, the timing margin based on bit error rate (BER) of $10^{-11}$ is 0.48UI and the power consumption is as low as 0.30mW/Gb/s.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.6 s.360
• /
• pp.24-30
• /
• 2007

In this paper, an energy detection-based low power, low complexity IR-UWB receiver in multipath impulse radio channel is presented. The proposed receiver has a simple 1-bit sampler for energy detection. Also, multipath signal received from multipath impulse radio channel is amplified and envelope of the signal is detected. Then, energy detection technique using integrator by summing multipath signals in certain period is adopted to minimize the BER loss by simple energy detection. In particular, in acquisition of a sample signal, SNR is additionally improved using a digital sampler. Symbol decision using several sampled signals is performed and thus the process of symbol synchronization is significantly simplified. Also, it is effectively designed to be compatible with influences of multipath and timing error. In addition, the proposed receiver complexity is reduced using pulse decision window. The performance of the proposed receiver is simulated based on IEEE 802.15.4a channel model and the algorithms are implemented on FPGA.

• Journal of Positioning, Navigation, and Timing
• /
• v.10 no.4
• /
• pp.315-333
• /
• 2021

Due to the Global Navigation Satellite System (GNSS) modernization, recently launched GNSS satellites transmit signals at various frequency bands such as L1, L2 and L5. Considering the Korean Positioning System (KPS) signal and other GNSS augmentation signals in the future, there is a high probability of applying more complex communication techniques to the new GNSS signals. For the reason, GNSS receivers based on flexible Software Defined Radio (SDR) concept needs to be developed to evaluate various experimental communication techniques by accessing each signal processing module in detail. This paper proposes a novel SDR-based A-GNSS receiver capable of processing multi-GNSS/RNSS signals at multi-frequency bands. Due to the modular structure, the proposed receiver has high flexibility and expandability. For real-time implementation, A-GNSS server software is designed to provide immediate delivery of satellite ephemeris data on demand. Due to the sampling bandwidth limitation of RF front-ends, multiple SDRs are considered to process the multi-GNSS/RNSS multi-frequency signals simultaneously. To avoid the overflow problem of sampled RF data, an efficient memory buffer management strategy was considered. To collect and process the multi-GNSS/RNSS multi-frequency signals in real-time, the proposed SDR A-GNSS receiver utilizes multiple threads implemented on a CPU and multiple NVIDIA CUDA GPGPUs for parallel processing. To evaluate the performance of the proposed SDR A-GNSS receiver, several experiments were performed with field collected data. By the experiments, it was shown that A-GNSS requirements can be satisfied sufficiently utilizing only milliseconds samples. The continuous signal tracking performance was also confirmed with the hundreds of milliseconds data for multi-GNSS/RNSS multi-frequency signals and with the ten-seconds data for multi-GNSS/RNSS single-frequency signals.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.3
• /
• pp.47-54
• /
• 1996

In this paper we propose a new timing recovery method by means of utilizing service data filling rate instead of timing information of transmitter. A proposed algorithm controls the phase locked loop in the opposite direction ot data filling rate of FIFO in receiver, and it is based on the fact that average of cell jitters is zero. The proposed method is simple compared with timing information method of transmitter. It can be utilized for timing recovery in synchronous digital hierarchy as well as in plesiochronous digial hierarchy without common reference clocks in end-to-end erminals. We implement the interactive video communication system and test the proposed algorithm. As a result, we hav econfirmed that it yields good perfomrnces in terms of jitters characteristics and hardware complexity.

• Proceedings of the IEEK Conference
• /
• 2007.07a
• /
• pp.123-124
• /
• 2007

In this paper a comparison of several coarse time synchronization(CTS) algorithms for OFDM is presented. The goal of a CTS is to achieve a timing estimate that avoids IST in the receiver. Five coarse timing estimation algorithms are examined and their performances are compared associated with hardware complexity. Simulations has been performed for DVB-T 2K system in thee different channels.

• Journal of the Korea Convergence Society
• /
• v.8 no.8
• /
• pp.325-332
• /
• 2017

This study was performed to investigate the effects of receiver's moving speed and pass types on anticipation timing response. Ten subjects were required to make a total of 24 passes in coincidence with an experimentally manipulated moving light signal in randomly three different conditions by performing chest and bound pass. Results of analyses revealed AE, CE, and VE increased as moving velocity became constant-acceleration condition. In addition, chest pass was more accuracy and consistency than bound pass on AE and CE. These findings indicated that moving velocity and pass type served as the major determination of coincident timing response on passing in basketball.