• The KIPS Transactions:PartB
• /
• v.9B no.1
• /
• pp.83-90
• /
• 2002

In this work, an improved method of EZW is suggested for efficient compression and transmission of image data. Here, coding efficiency is accomplished by embedded coding of significant coefficients using lower-level insignificant coefficients, and coding time is decreased by pre-coding of lower-level coefficients in coefficient detection. In simulation of designed architecture, the performance improvement of 1dB PSNR is confirmed compared with the results by the original En method.

• Proceedings of the KIEE Conference
• /
• 2005.07a
• /
• pp.283-285
• /
• 2005

Wavelet transforms provide basis functions for time-frequency analysis and have properties that are particularly useful for the compression of analogue point on wave transient and disturbance power system signals. This paper evaluates the compression properties of the discrete wavelet transform using actual power system data. The results presented in the paper indicate that reduction ratios up to 10:1 with acceptable distortion are achievable. This paper discussed the application of the reduction method for fault analysis and protection assessment.

• Tribology and Lubricants
• /
• v.17 no.1
• /
• pp.56-63
• /
• 2001

The dynamic behavior of rotor-bearing system used in swash plate compressor has been investigated using the combined methodologies of finite elements and transfer matrices. The finite element is formulated including the field element for a shaft section and the point element for swash plate, disk pulley and bearings. The Houbolt method is used to consider the time march for the integration of the system equations. The transient whirl response of rotating shaft supported on roller bearings is obtained, considering compression forces and unbalance forces at swash plate and driving pulley. And, the steady state displacements of the rotor are compared with a variation in unbalance mass. Results show that the loci of rotating shaft considering unbalance forces and external compression forces are more severe in flutter motion than with only unbalance forces.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.28B no.11
• /
• pp.866-875
• /
• 1991

In this paper, multi pulse excited-linear predictive coding (MPE-LPC), where the correlation eliminated residual signal is modeled by a few pules, is shown to be effective for the compression of electrocardiogram (ECG) data, and a more efficient scheme for a faithful reconstruction of ECG is proposed. The reconstruction charateristic of QRS's and P.T waves is improved using the adaptive pulse allocation (APA), and the compression ratio (CR) can be changed by controlling the mumber of modeling pulses. The performance of the proposed method was evaluated using 10 normal and 10 abnormal ECG data. The proposed method had a better performance than the variable threshold amplitude zone time epoch coding (AZTEC) algorithm and the scan-along polygonal approximation (SAPA) algorithm with the same CR. With the CR in kthe range of 8:1 to 14:1, we could compress ECG data efficiently.

• Proceedings of the IEEK Conference
• /
• 2002.07c
• /
• pp.1602-1605
• /
• 2002

Communication schemes are currently changing from circuit switched towards packet switched. These changes enable access to Internet and multimedia services in wireless network. Provision of real-time IP services in air interface introduces relatively large overhead in RTP/UDP/IP headers. To reduce the overhead, the header compression schemes are required. There exist two header compression schemes (CRTP, ROHC) which are IETF standards. We propose Context-ID detection method which reduces more efficiently the packet loss rate than two existing schemes. Its performance in WCDMA system environment is evaluated for CRTP and ROHC schemes.

• The Korean Journal of Emergency Medical Services
• /
• v.24 no.3
• /
• pp.107-116
• /
• 2020

Purpose: We compared three chest compression methods to find an efficient method for performing infant cardiopulmonary resuscitation (CPR) for single rescuers and improving chest compressions quality. Methods: Thirty new marine police trainees at the Korea Coast Guard Education Institute were tested for five sessions using three methods of single rescuer infant CPR: two-finger chest compression, two-thumb encircling chest compression, and two-finger support chest compression. Results: The depth, accuracy, and number of compressions per minute of resuscitation were analyzed for the above three methods. The depth of two-finger chest compression, two-thumb encircling chest compression, and two-finger support chest compression was 3.53±0.20cm, 4.10±0.13cm, and 4.22±0.15cm, respectively. Accuracy was 23.86±12.59%, 54.11±10.8%, 71.55±18.81%, respectively, while the time for one cycle of 30 chest compression was 16.01±10.5 seconds, 16.45±0.85 seconds, and 16.56±0.91 seconds, respectively. Chest compression interruptions were 6.59±0.78 seconds, 7.17±0.37 seconds, and 6.97±0.35 seconds, respectively. The interruptions were consistent with the range of 5-10 seconds suggested by the American Heart Association. Conclusion: When one rescuer performs CPR for an infant in cardiac arrest, a comparative analysis of three methods showed that two-thumb encircling chest compression is the best for accuracy and efficiency of chest compressions.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.15 no.1
• /
• pp.1-10
• /
• 1991

Two-dimensional explicit finite element code was developed. The transient dynamics code can analyse large deformations of non-linear materials subjected to extremely high strain rates. The Lagrangian finite element program uses an explicit time integration operator to integrate the equations of motion, thus the stiffness matrix is not introduced. Cylinder upsetting and ring compression problems are simulated to check the effects of friction and inertia force. It is shown that (1) calculated results agree very well with experimental results, (2) constant shear friction method overestimates the decrease of inner ring radius and then underestimates after on in comparison with the Coulomb friction method, and (3) the effect of the increase in initial strain rate is similar to the effect of higher frictional coefficient.

• Journal of Advanced Marine Engineering and Technology
• /
• v.33 no.8
• /
• pp.1100-1106
• /
• 2009

Recently, there are quite a lot of attention is drown on the researches related to of Miller method applied high expansion cycle. For this study, high expansion cycles are formed and analyzed with the base view point of thermodynamics, and the features of each factors are also investigated. As a result of analysis, the expansion-compression ratio is expected with a decrease of effective compression ratio as intake valve closing time retarded, however, the decrease of mean effective pressure and its output is accompanied with the counterflow of intake air. Accordingly, as the consequence of such failure, it is expected that an alternative is needed for the realization of high expansion cycles, and the improvement over thermal efficiency. To materialize such cycle, the control system to delay the closing time of intake valve was designed and VVT, the 3 S/B low speed diesel engine, is applied to evaluate the efficiency. The result of the trial shows that there was no significant errors.

• International Journal of Computer Science & Network Security
• /
• v.24 no.8
• /
• pp.85-104
• /
• 2024

The DNA (Deoxyribonucleic Acid) database size increases tremendously transmuting from millions to billions in a year. Ergo for storing, probing the DNA database requires efficient lossless compression and encryption algorithm for secure communication. The DNA short pattern repetitions are of paramount characteristics in biological sequences. This algorithm is predicated on probing exact reiterate, substring substitute by corresponding ASCII code and engender a Library file, as a result get cumulating of the data stream. In this technique the data is secured utilizing ASCII value and engendering Library file which acts as a signature. The security of information is the most challenging question with veneration to the communication perspective. The selective encryption method is used for security purpose, this technique is applied on compressed data or in the library file or in both files. The fractional part of a message is encrypted in the selective encryption method keeping the remaining part unchanged, this is very paramount with reference to selective encryption system. The Huffman's algorithm is applied in the output of the first phase reiterate technique, including transmuting the Huffman's tree level position and node position for encryption. The mass demand is the minimum storage requirement and computation cost. Time and space complexity of Repeat algorithm are O(N²) and O(N). Time and space complexity of Huffman algorithm are O(n log n) and O(n log n). The artificial data of equipollent length is additionally tested by this algorithm. This modified Huffman technique reduces the compression rate & ratio. The experimental result shows that only 58% to 100% encryption on actual file is done when above 99% modification is in actual file can be observed and compression rate is 1.97bits/base.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.16 no.11
• /
• pp.2011-2020
• /
• 1992

This paper discusses about real time control applying sliding mode to robot manipulators whose nonlinear terms, which are inertia term, Corilis term and centrifugal force mterm, are regarded as disturbances. We could simplify the dynamic equations of a manipulator and servo system, which are composed of linear elements and nonlinear elements, by assuming that non-linear terms are external disturbance. By simplifying that equation, we could easily obtain a control input which satisfy sliding mode. We proposed a new control input algorithm to decrease chattering in the application of sliding mode control of manipulator whose nonlinear elements are regarded as disturbances. We could take impulse response of linear elements of dynamic equations of a robot manipulator and servo system by Signal Compression Method. So then, we could obtain the unknown parametes of its linear lements, which are used to obtain switching parameter satisfying sliding mode, by Signal Compression Method. In this experiments, we used DSP(Digital Signal Processor) controller to suppress chattering by obtaining a switching speed and to carry out real time control.