• Journal of Life Science
• /
• v.22 no.2
• /
• pp.148-155
• /
• 2012

A cross-sectional analysis of blood pressure (BP) changes and the current prevalence and distribution of hypertension among age groups in Korea were conducted. Systolic (SBP), diastolic (DBP), and pulse (PP) pressures were evaluated. Residents visiting a local Community Health Center for a health check-up and/or participating in the Health Promotion Program were included for the analyses. A total of 6,570 subjects (2,809 men, 3,761 women) were divided into five age groups: 30-39, 40-49, 50-59, 60-69, and $70\leq$ years. Comparisons were made between sex and among age groups. SBP and DBP were continuously elevated, while men showed higher levels than women until their mid-60s; then, the trend was reversed. DBP in men became elevated from their 30s, reaching the highest in the 40s then slowly decreasing. DBP in women increased up to their 40s and 50s, then reached a plateau. PP increased rapidly from the 50s in both sexes. The major contributor of age-related BP elevation may be large artery stiffness in men, particularly from their 50s, while the blood pressure elevation of women may relate to diverse factors including large artery stiffness, stroke volume, and ventricular ejection rate. The rapid elevation of PP after the 50s in both men and women could represent a risk of cardiovascular or coronary mortality, particularly with increasing age. The current data showed a higher rate of hypertension in both sexes compared to previous reports. When those with both high-normal BP and hypertension are looked at in combination, BP management of the target population should be drastically elevated.

• Korean Journal of Microbiology
• /
• v.49 no.4
• /
• pp.353-359
• /
• 2013

The objectives of this study were to investigate effectiveness of the Compressed Air Jet (CAJ) System for cleaning up shorelines contaminated with crude oils and to examine effects of the system on total petroleum hydrocarbon (TPH) removal and microbial community changes before and after remediation of the oil-contaminated shorelines. These data will lead to better understanding of optimized remediation process. About 66% of TPH reduction was observed when the contaminated site was treated with the CAJ System 2, 3, 4, and 5 times. This treatment system was more efficient than the seawater pumping system under similar treatment conditions (by 40%). By the way, little oil degrader communities were observed despite a potential function of the air jet system to stimulate aerobic oil degraders. The apparent low population density of the oil degraders might be as a result of low concentration of TPH as a carbon source and limiting nutrients such as nitrogen and phosphorus. It was proposed that the CAJ System would contribute significantly to removal of residual oils on the shorelines in combination with addition of these limiting nutrients.

• Journal of Internet Computing and Services
• /
• v.12 no.4
• /
• pp.157-172
• /
• 2011

The latest active studies on distributed OLAP to adopt a distributed environment are mainly focused on DHT P2P OLAP and Grid OLAP. However, these approaches have its weak points, the P2P OLAP has limitations to multidimensional range queries in the cloud computing environment due to the nature of structured P2P. On the other hand, the Grid OLAP has no regard for adjacency and time series. It focused on its own sub set lookup algorithm. To overcome the above limits, this paper proposes an efficient central managed P2P approach for a cloud computing environment. When a multi-level hybrid P2P method is combined with an index load distribution scheme, the performance of a multi-dimensional range query is enhanced. The proposed scheme makes the OLAP query results of a user to be able to reused by other users' volatile cube search. For this purpose, this paper examines the combination of an aggregation cube hierarchy tree, a quad-tree, and an interval-tree as an efficient index structure. As a result, the proposed cloud P2P OLAP scheme can manage the adjacency and time series factor of an OLAP query. The performance of the proposed scheme is analyzed by a series of experiments to identify its various characteristics.

• The Journal of the Korea Contents Association
• /
• v.16 no.6
• /
• pp.135-150
• /
• 2016

This study aims to investigate how perceived interactivity between the mobile messenger application and its user gives rise to user's enjoyment and continuous usage intention. Perceived interactivity was assumed to be formed by the combination of control, share, and responsiveness in light of the previous studies. The relations between perceived interactivity, enjoyment, and usage intention are hypothesized on the basis of the pleasure-arousal-dominance emotional state model, the theory of reasoned action, and the theory of planned behavior. Survey data were collected from 481 mobile messenger users in Korea and China. In order to test hypotheses, structural equation modeling analyses were conducted. As a result, perceived interactivity concerning connectedness and responsiveness not only positively affected enjoyment, but also had a significant effect on usage intention. However, while control positively influenced usage intention, it was not significantly related to enjoyment. In addition, there was a positive relation between enjoyment and usage intention. Incidentally, multi-group analysis was conducted to explore the differences between Korean and Chinese users. The findings would provide managerial implications for mobile messenger corporations on causal effects of perceived interactivity and the differences of the path coefficients between in Korea and China.

• KSCI Review
• /
• v.14 no.2
• /
• pp.185-197
• /
• 2006

A star schema consists of a central fact table, which is surrounded by one or more dimension tables. Each row int the fact table contains a multi-part primary key(or a composite foreign key) along with one or more columns containing various facts about the data stored in the row Each of the composit foreign key components is related to a dimensional table. The combination of keys in the fact table creates a composite foreign key that is unique to the fact table record. The composite foreign key, however, is rarely unique to the fact table record in real-world applications, particularly in financial applications. In order to make the composite foreign key be the determinant in real-world application, some precalculation might be performed in the SQL relational database, and cached in the OLAP database. However, there are many drawbacks to this approach. In some cases, this approach might give users the wrong results. In this paper, an approach to fact table modeling and related MDX query composing, which can be used in real-world applications without performing any precalculation and gives users the correct results, is proposed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.12A
• /
• pp.1319-1332
• /
• 2004

Multicarrier direct sequence code-division multiple access CDMA(MC DS-CDMA) is an attractive technique for achieving high data rate transmission even if the potentially large peak-to-average power ratio(PAPR) is an important factor for its application. On the other hand, code select CDMA(CS-CDMA) is an attractive technique with constant amplitude transmission of multicode signal irregardless of subchannels by introducing code selection method. In this paper we propose a new multiple access scheme based on the combination of MC DS-CDMA and CS-CDMA. Proposed scheme, which we called MC CS-CDMA, includes the sutclasses of MC DS-CDMA and CS-CDMA as special cases. The performance of this system is investigated for multipath Sequency selective fading channel and maximal ratio combining with rake receiver. In addition the PAPR of proposed system is compare with that of both MC BS-CDMA and CS-CDMA. Simulation results show that proposed system improves PAPR reduction than MC DS-CDMA at the expense of the complexity of receiver and the number of available non. Also, the numerical result shows that the proposed system is better performance than MC DS-CDMA due to the increasing processing gain and the number of time diversity gain.

• 한국해양학회지
• /
• v.27 no.2
• /
• pp.123-136
• /
• 1992

As a result of faunal analysis on 50 bottom samples bearing a total of 183 species of the Recent benthonic foraminifers from the West and South Sea of korea, five bioassociations (groups of species) and five biotopes (groups of samples) were discriminated. From the areal distribution of biotopes in combination with bioassociations and the available ecological data of foraminiferal species, five biofacies are recognized: (1) Southern Inner Shelf Biofacies; (2) Southern Coast Biofacies; (3) Northern Middle Shelf Biofacies; (4) Central Middle Shelf Biofacies; and (5) Southern Outer Shelf and Upper Slope Biofacies. The biofacies are defined by a group of sampling stations containing a diagnostic species association and can be related to the major current pasterns and water masses in the West and South Sea of Korea: Southern Inner Shelf Biofacies is related to the Coastal Waters and drainage from China; Southern Coast Biofacies is related to the Coastal Waters and drainage from Korea; Northern Middle Shelf Biofacies is related to the Coastal Waters and Yellow Sea Cold Water, Central Middle Shelf Biofacies is related to the Yellow Sea Warm Current; and Southern Outer Shelf and Upper Slope Biofacies is related to the Tsushima Warm Current.

• Proceedings of the KACD Conference
• /
• 2008.05a
• /
• pp.184-197
• /
• 2008

This study was to investigate the influence of combining composite resins with different elastic modulus, and occlusal loading condition on the stress distribution of restored notch-shaped non-carious cervical lesion using 3D finite element (FE) analysis. The extracted maxillary second premolar was scanned serially with Micro-CT. The 3D images were processed by 3D-DOCTOR. ANSYS was used to mesh and analyze 3D FE model. A notch-shaped cavity was modeled and filled with hybrid, flowable resin or a combination of both. After restoration, a static load of 500N was applied in a point-load condition at buccal cusp and palatal cusp. The stress data were analyzed using analysis of principal stress. Results showed that combining method such that apex was restored by material with high elastic modulus and the occlusal and cervical cavosurface margin by small amount of material with low elastic modulus was the most profitable method in the view of tensile stress that was considered as the dominant factor jeopardizing the restoration durability and promoting the lesion progression.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.8 no.1
• /
• pp.19-32
• /
• 2010

Electrolytic reduction technology is essential for the purpose of adopting pyroprocessing into spent oxide fuel as an alternative option in a back-end fuel cycle. Spent fuel consists of various metal oxides, and each metal oxide releases an oxygen element depending on its chemical characteristic during the electrolytic reduction process. In the present work, an electrolytic reduction behavior was estimated for voloxidized spent fuel based on the assumption that each metal-oxygen system is independent and behaves as an ideal solid solution. The electrolytic reduction was considered as a combination of a Li recovery and chemical reactions between the metal oxides such as uranium oxide and the produced Li metal. The calculated result revealed that most of the metal oxides were reduced by the process. It was evaluated that a reduced fraction of lanthanide oxides increased with a decreasing $Li_2O$ concentration. However, most of the lanthanides were expected to be stable in their oxide forms. In addition, a semi-empirical model for describing $U_3O_8$ electrolytic reduction behavior was proposed by considering Li diffusion and a chemical reaction between $U_3O_8$ and Li. Experimental data was used to determine model parameters and, then, the model was applied to calculate the reduction yield with time and to estimate the required time for a 99.9% reduction.

• Journal of Korean Society of Disaster and Security
• /
• v.14 no.1
• /
• pp.9-21
• /
• 2021

Recently, the importance of eco-friendly power generation facility using renewable energy has newly appeared. Hydropower plant is a very important source of electricity generation and supply which is very important to secure safety because it is commonly connected with multi facility and operated on a large scale. In this study, a scenario-based analysis method was suggested to assess vulnerability of a penstock system caused by water hammer commonly occurred in the operation of hydropower plants. A hypothetical hydropower plant was used to demonstrate the applicability of a transient analysis model. In order to verify reliability of the model, the prediction of pressure behaviors were compared with the results of commercial model (SIMSEN) and measured data, then a real hydroelectric power plant was applied to develop all potential water hammer scenarios during the actual operation. The scenario-based simulation and vulnerability assessment for water hammer in the penstock system were performed with internal and external load conditions. The simulation results indicated that the vulnerability of a penstock system was varied with the operating conditions of hydropower facilities and significantly affected by load combination consisting of different load scenarios. The proposed numerical method could be an useful tool for the vulnerabilityty assessment of the hydropower plants due to water hammer.