• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.12
• /
• pp.1265-1273
• /
• 2006

The environmental capacity and watershed pollution load reduction of Yongdam reservoir were estimated by the simulation of water quality variation process with the target water quality establishment, pollution load estimation and flow analysis. The potable raw water $I{\sim}II$, COD $1.0{\sim}3.0$ mg/L and TP $0.01{\sim}0.03$ mg/L were selected as the target water quality Yongdam reservoir water quality model was constructed with WASP5 contained 42 segments and the correlation of calibrated results were BOD 0.73, $PO_4-P$ 0.98. The environmental capacity for target quality COD 2.0 mg/L and TP 0.02 mg/L were BOD $131,880{\sim}4,694$ kg/d, TP $7,855 {\sim}167$ kg/d which were less than exists, and the related reduction ratios were BOD $51{\sim}62%$, TP $47{\sim}67%$ which were middle amount in exists. The load reduction ratios to meet the potable raw water $I{\sim}II$ were BOD $72{\sim}16%$, TP $78{\sim}36%$ in existing conditions and BOD $81{\sim}44%$, TP $84{\sim}52%$ in new conditions. BOD was the least one and TP was the second least in 4 results. The effects of the load reduction assignment to subbasin were dominant in TP but little in COD.

• Journal of Wetlands Research
• /
• v.10 no.3
• /
• pp.57-68
• /
• 2008

For improving water quality and hish habitat environment the targeted instream flows added to the field measurement of low flow at each reach along Wonju Cheon are calculated by depth, velocity, and the present lower channel width with considering the landscape, aquatic environment, and natural ecological function. Target instream flow increasing ranged from $0.03m^3/s$ of upstream to $0.90m^3/s$ of downstream according to the proposed depths of 0.10m to 0.30m and velocity of 0.2m/s. The methods for target instream flow increasing are base flow increasing by watershed management, non polluted discharge inflow from valley and combined sewer by sewerage system modification, and discharges from upstream reservoirs and detention basins near-by stream. The possible increasing flow rates are $0.19m^3/s$ to $3.42m^3/s$ which are 1.4 to 2.5 times of low flow to be measured which are the equivalent targeted instream flows along Wonju Cheon. The BOD-based water quality improvement are analyzed by QUAL2E. The habitat suitability indices by PHABSIM of Zacco temmincki as target species at middle stream of Wonju Cheon improve significantly by low flow increasing, which is very important to improve water quality and fish habitat.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.38 no.4
• /
• pp.317-325
• /
• 2020

UAV (Unmanned Aerial Vehicle) photogrammetry has recently emerged as a means of obtaining highly precise and rapid spatial information due to its cost-effectiveness and high efficiency. However, current procedures or regulations for quantitative quality verification methods and certification processes for UAV-images are insufficient. In addition, the current verification method for image quality is not evaluated by an MTF (Modulation Transfer Function) analysis or edge response analysis, which can analyze the degree of contrast including image resolution, and only relies on the GSD (Ground Sample Distance) analysis. Therefore, in this study, the edge response analysis using a Slanted edge target was performed along with GSD analysis to confirm the necessity of analyzing edge response analysis in UAV-images quality analysis. Furthermore, a Matlab GUI-based software tool was developed to help streamline the edge response analysis. As a result, we confirmed the need for edge response analysis since the outputs of the edge response analysis from the same GSD had significantly different outcomes. Additionally, we found that the quality of the edge response analysis of UAV-images is proportional to the performance of the camera mounted on the UAV.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.2
• /
• pp.221-228
• /
• 2020

A sonobuoy is dropped onto the surface of water to estimate the bearing of an underwater target. A Directional Frequency Analysis and Recording (DIFAR) sonobuoy has an error in the specific angular section due to the method of estimating bearing and noise, which causes an error in target localization using multiple sonobuoys. In addition, the position of the sonobuoy continues to move, but since a sonobuoy with a GPS is intermittently arranged, it is difficult to estimate the exact position of the sonobuoy. This also causes target localization performance degradation. In this paper, we propose a technique to improve the target localization performance by compensating for bearing errors using characteristics of the DIFAR sonobuoy and multiple-sonobuoy position errors based on the intermittently arranged active sonobuoy with a GPS.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.12 s.115
• /
• pp.1249-1258
• /
• 2006

Two-dimensional(2-D) radar images, namely, ISAR images from a maneuvering target include unwanted phase errors due to the target's motion. These phase errors make ISAR images to be blurred. The ISAR autofocus technique is required in order to remove these unwanted phase errors. Unless those unwanted phase errors produced by the target's motion are removed prior to target identification, we cannot expect a reliable target identification performance. In this paper, we use the entropy-based ISAR autofocus technique which consists of two steps: range alignment and phase adjustment. We analyze a relationship between the number of sampling point and a image quality in a range alignment algorithm and also analyze a technique for reducing computation time of the SSA(Stage-by-Stage Approachng) algorithm in a phase adjustment.

• Korean Journal of Community Nutrition
• /
• v.20 no.2
• /
• pp.87-95
• /
• 2015

Objectives: Maintaining a balanced diet and thus health is crucial for adolescents, and the first step for balanced diet practice is meal planning. Adolescents, however, find it difficult to plan their meals. This study thus was set out to design an easier way of planning meals for adolescent girls. Methods: A dish-based target pattern for adolescent girls was tabulated, and validity of this was examined. Meal plan applying a dish-based target pattern was prepared by 150 female middle school students, and nutritional adequacies of those meal plans were examined. Validity and adequacy were tested by energy content, energy contribution ratio, nutrient adequacy ratio (NAR), probability of nutrient inadequacy, index of nutritional quality (INQ) calculation. Results: A dish-based target pattern with 11 dish groups was validated for nutritional adequacy. Though the NAR of calcium was 0.96, the INQ of calcium was 1.00. The average energy supply from the meal plans was 2,379 kcal, higher than the estimated energy requirement of a female middle school student, but the energy contribution ratio of carbohydrates, proteins, and fats were all adequate according to the acceptable macronutrient distribution range (AMDR). NAR of all nutrients examined were 1.0, except for calcium. The NAR and INQ of calcium were 0.87 and 0.75, respectively, and the meal plans at risk for calcium inadequacy was 19.30%. Conclusions: A dish-based target pattern proposed for adolescent girls was valid, but the meal plan prepared by female middle school students using this approach was high in energy and low in calcium supply. To cut down the energy supply from the meal plan, it is necessary to recommend dishes low in fat and use low fat cooking methods. To increase the calcium supply, it is important to recommend seaweed and legume group dishes with higher Ca INQ food items.

• International Journal of Reliability and Applications
• /
• v.2 no.3
• /
• pp.161-187
• /
• 2001

Starting with the meaning of the word quality, diverse concepts connoted by the term are examined. Instead of a bathtub curve, the desirable shape of a failure rate covering the entire life of a good product, which might be called hockey-stick line, is introduced. From the hockey-stick line and the definition of reliability, two measurements are extracted. The terms reliability, failure rate, product life, and durability are explained. From the customer's standpoint, the concept of product quality is classified in five factors, according to related technology: performance, reliability, conformance to specifications, customer perception, and fundamentals advantage. The correlation of the five factors for a first-class product is discussed, Since the market share of a company is determined as the competition result of its product value, defined as product quality and price, the market share increase is derived mathematically from the increment of product value. The market share increase, $\Delta$S, can be calculated from the present market share, S, and the oriented relative value increment of new product, R, to the current product in the same company for the same market target: $\Delta$S : $\Delta$(1-S). R/(1+S.R). Finally, the importance of separating warranty cost from the profit equation for the durables is explained.

• Journal of Digital Contents Society
• /
• v.13 no.4
• /
• pp.625-629
• /
• 2012

This paper is presented to prepare NGN quality assurance management process under the quality system test methodology. The process should be drawn for NGN quality measurement framework of multimedia traffic. NGN test bed management process model are QoS measurement metrics, measurement interval meter above, and measuring tools, measuring equipment, measurement methods and measurement results from a series of processes for the analysis and methodology. This model, NGN quality assurance activities should be utilized in the future. Quality target level only when themselves constantly measured and managed, does not guarantee the communication quality of service. It is sensitive to the importance of NGN network technology paradigm for research on quality management in the NGN.

• Journal of Korean Society on Water Environment
• /
• v.28 no.3
• /
• pp.426-435
• /
• 2012

The variation of stream flow is the one of the most important factors which influence on that of water quality in the unit watershed. The target water quality goal is established and permissible load is allotted in the base of the standard flow condition along with its water quality for the management of Total Maximum Daily Loads (TMDLs). A standard flow selected could cause problems in the load allotment if it was not properly arranged. This study reviewed the acquisition of water quality data, the self-variation and the retainability in water quality on the specific flow conditions. This study also proposed the median and the adjusted average flow condition out of general flow conditions as alternative standard flow conditions. It is considered that the alternatives can make the water quality data easily acquired and the water quality representativeness more enhanced on the standard flow conditions.

• Journal of the Korea Safety Management & Science
• /
• v.11 no.1
• /
• pp.115-120
• /
• 2009

Single PPM Quality Innovation Movement is originally developed quality program in Korea for supplier's quality level-up since 1995. The quality target is below the 10ppm(parts per million) in outgoing quality and delivered goods plus field claim. This Single PPM Quality Innovation Movement program was conducted to realize the anticipated results not only due to management result level's increasing, but also the company's confidence and competitiveness. This study attempted to find the mutual influences on the participation of the constituent members, satisfaction of the constituent members and results of the management from Single PPM Quality Innovation Movement. The reliance analysis for the measurement material on the questionnaire was verified by Cronbach's alpha coefficient. Participation of the constituent members, satisfaction of the constituent member and result of the management, the influences upon Single PPM improvement degree level were verified through the structural analysis by using SPSS statistic package. The influence evaluation among the groups was evaluated by the structure equation.