• 한국문화재보존과학회:학술대회논문집
• /
• 2004.10a
• /
• pp.66-71
• /
• 2004

When waterlogged wood dries up, it shrinks largely. And it is hard to recover original shape. Therefore it happens to lose the value of wood remains frequently. This paper studied how far dried waterlogged wood can recover original shape. Shape recovering course and extent are thoroughly investigated after waterlogged wood of Pinus densiflora, Quercus serrata and Styrax japonica oven-dries and instills varieties of test solution. At 1- step, oven-dried samples infiltrated by chlorous acid sodium or sodium hydroxide solution. At 2- step, wood tissues of samples were swelled by the fast decompression after infiltrating $CO_2-supercritical$ fluid at high pressure. The study investigated the possibility of shape recovering in waterlogged wood. Shape recovering rate is different with solution and wood species. Sample of sodium hydroxide solution doesn't swell anymore when using $CO_2-supercritical$ fluid. In general, the sample of sodium hydroxide solution has higher Shape recovering rate than $CO_2-supercritical$ fluid solution treated by chlorous acid sodium.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.16 no.12
• /
• pp.2261-2267
• /
• 1992

The equations are derived for the evaluation of the axial contact force. The contact forces for rubber seals are analyzed as a function of the ratio of real contact length, the thickness of seal lip, the inclined angle of seal lip, and the interference between the edge of seal lip and the rotating inner ring. The design data for rubber seals are presented in terms of the ratio of real contact length, initial inclined lip angle, lip thickness and the interference. The calculated results show that the deflected interference and the circumferential stress cause considerable change of contcat forces for the low sealed pressure.

• Membrane Journal
• /
• v.30 no.6
• /
• pp.385-394
• /
• 2020

In the gas separation process, the separation membranes have to not only show high gas transport and selectivity but also exhibit exceptional stability at high temperature and pressure. However, when the polymeric membranes (particularly, glassy polymers) are exposed to the condensable gases (i.e., CO2, H2S, hydrocarbon, etc.), the polymer chains are prone to swell, leading to low stability. As a result, the plasticization behavior reduces the gas selectivity in the separation of mixture gases at high pressures and thus results in limited applications to the separation processes. To address these issues, many strategies have been studied such as thermal treatment, polymer blending, thermally rearrangement, mixed-matrix membranes, cross-linking, etc. In this review, we will understand the plasticization behavior and suggest potential methods based on the previously reported studies.

• Nuclear Engineering and Technology
• /
• v.52 no.7
• /
• pp.1396-1408
• /
• 2020

Filtered containment venting system (FCVS) is one of the severe accident mitigation systems designed to release containment pressurization to maintain its integrity. The thermal-hydraulic behaviors in FCVSs are important since they affect the operation characteristics of the FCVS. In this study, a representative FCVS was modeled by RELAP5/Mod3.3 code, and the Station BlackOut (SBO) was chosen as an accident scenario. The thermal-hydraulic behaviors of an FCVS during long-term operation with two venting strategies (open-and-close strategy, open-and-non-close strategy) and the sensitivity analysis of important parameters were investigated. The results show that the FCVS can operate up to 250 h with a periodic open-and-close strategy during an SBO. Under the combined effects of steam condensation and water evaporation, the solution inventory in the FCVS increases during the venting phase and decreases during the intermission phase, showing a periodic pattern. Under this condition, the appropriate initial water level is 3-4 m; however, it should be adjusted according to the environment temperature. The FCVS can accommodate a decay heat power of 150-260 kW and may need to feed water for a higher decay heat power or drain water for a lower decay heat power during the late phase. The FCVS can function within an opening pressure range from 450 kPa to 500 kPa and a closing pressure range between 250 kPa and 350 kPa. When the open-and-non-close strategy is adopted, the solution inventory increases quickly in the early venting phase due to steam condensation and then decreases gradually due to the evaporation of water; drying-up may occur in the late venting phase. Decreasing the venting pipe diameter and increasing the initial water level can mitigate the evaporation of the scrubbing solution. These results are expected to provide useful references for the design and engineering application of FCVSs.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.25 no.2
• /
• pp.44-53
• /
• 1989

In order to grasp the characteristics of a fishing ground at yeosu bay, the fluctuation in condition of the coast and that in catch by pound nets in the coast were investigated respectively. The results obtained are summarized as follows: 1. The water temperature in spring and summer was higher at the coast side than off shore, but in autumn and winter took the reverse. 2. The salinity was higher in spring and winter than in summer and autumn. A lower salinity zone was found at the Dolsan Do coast and higher ones were made off shore. 3. A eddy current was found at the Dolsan Do coast and a thermocline were made at the depth of 30 to 40 m in summer. But in autumn and winter the water became homogeneous. 4. The annual catch by the pound net was highest in 1984 and then decreased gradually. The monthly catch was highest in June and then decreased gradually. 5. The catches seemed to increase with the sea water temperature and salinity, and great catch was shown in 21$^{\circ}C$ to 27$^{\circ}C$ and 33.80% to 34.00%. 6. The component rate of fishes was 28.4% in spanish mackerel, 17.9% in anchovy, 19.5% in horse mackerel, 21.0% in sardine, 7.2% in hairtail, and 1% in common mackerel. 7. The fishes appeared continuously on way of fishing operation were spanish mackerel, hairtail, Yellow talil, crab, etc. An anchovy and sardine were caught mainly from March to July or August, horese mackerel and common mackerel from May to November. but puffer, swell fish, saury and filefish were caught mainly from April to October. 8. The sum of catch was largest in June, at which the wind direction was NE to SSW, the speed below 3.2m/sec, the atmospheric pressure below 1008mb, and precipitation beyond 154mm.