• 정보학연구
• /
• 제7권1호
• /
• pp.155-161
• /
• 2004

정상적인 기계의 동작동안, 부분방전측정이 고전압전동기 고정자권선을 모의하여 터빈제너레이터 분석기(TGA)를 이용하여 실행하였다. 모의한 고정자권선에 인가된 전압은 4.47[kV]와 6.67[kV]을 인가하였다. 모의 고정자권선을 갖는 전동기들은 단자함에 80[pF]용량성 커풀러를 설치하였다. 인가전압 위상각을 고려한 부분방전패턴의 경우 2차원, 3차원적으로 보여주었다. TGA는 정규화된 펄스수(NGN)DHK 부분방전펄스크기(Qm)으로서 두개의 정량화된량을 나타내었다. 결론적으로, 우리는 모의한 고정자권선에 대한 내부방전과 표면방전의 차이를 TGA을 이용하여 식별할 수 있었다. 고정자권선의 결함에 대한 특징을 추출하기 위한 기법으로서 이산웨이블렛 변환기법 및 주파수분석법을 이용하여 결함신호에 대한 특징을 추출할 수 있었다.

• 센서학회지
• /
• 제25권6호
• /
• pp.383-387
• /
• 2016

Well-ordered nanocolumnar indium oxide ($In_2O_3$) thin films have been successfully fabricated by glancing angle deposition (GAD) using an e-beam evaporator. Nanocolumnar structures have a porous and large surface area with a narrow neck between nanocolumns, which allows them to detect minute amounts of gases. The nanocolumnar $In_2O_3$ thin films were fabricated by the GAD process at five different positions, viz. top, bottom, center, left, and right in a four inch substrate holder. There was a divergence in the thickness and the base resistance of each sensor. However, all the sensors exhibited extremely high sensitivity that was greater than $10^3$ times the change in electrical resistance after being exposed to 50 ppm of acetone gas at $300^{\circ}C$. Furthermore, the nanocolumnar $In_2O_3$ sensors displayed an extremely low detection limit (1.2 ppb) in dry atmosphere as well as in high humidity (80%). We demonstrated that the GAD nanocolumnar $In_2O_3$ sensors have an enormous potential for many applications owing to their particularly simple and reliable fabrication process.

• 한국의류학회지
• /
• 제23권2호
• /
• pp.307-313
• /
• 1999

This study investigated material the type(sewn-in stamped-on etc) of the label and its placement(location on the product) on children's clothing in order to survey consumer complaints to suggest the improvement. The data were collected from label-producing companies by surveying children's clothing displayed at department store as well as by questionnaire to 205 consumers who were mothers of preschool children. The results were as follows : 1. 100% polyester was the most used raw material for brand labels and nylon was for care labels. 2. Most brand labels were one piece labels and located inside the back of neck line by sewn-in either on the top on each sides or on all four sides, Care labels were usually sewn-in on the inside of left-side seam line. The texture of care label was softer than that of brand label and two pieces of care labels were widely used, 3. 67.3% of consumers complained of its stiffness while 36.1% of consumers complained of rough surface and edge 85.4% of consumers complained of an itch caused by brand labels and claimed to detach labels. For care labels 36.6% expressed displeasure of stiffness of labels while 39% complained of annoyance due to too many pieces of labels. 4. Major suggestions from the consumers were change of raw materials and relocation of brand labels. For the care labels changes of material form and type of labels were suggested and one piece of label and smaller size were preferable.

• Food Science and Biotechnology
• /
• 제17권4호
• /
• pp.705-712
• /
• 2008

Sweet potato starch was modified using Thermus aquaticus $\alpha$-1,4-glucanotransferase ($Ta{\alpha}GT$), and its structural and rheological properties were investigated. $Ta{\alpha}GT$-modified starch had a lower amylose level and molecular weight than raw starch. The chain length distribution showed an increased number of short and long branched chains and the formation of cycloamyloses. Compared with raw starch, $Ta{\alpha}GT$-modified starch displayed a lower gelatinization enthalpy and a wider melting temperature range. The X-ray diffraction of $Ta{\alpha}GT$-modified starch was a weak V-type pattern with distinct sharp peaks at 13 and $20^{\circ}$. Scanning electron micrographs of modified starch exhibited big holes on the surface and the loss of granular structure. The frequency sweep measurement revealed that the gel of $Ta{\alpha}GT$-modified starch was more rigid than raw starch gel. However, the structure of modified starch gel was destroyed by heating at $75^{\circ}C$, and a firm gel was re-formed by subsequent storage at $5^{\circ}C$, indicating thermoreversible property.

• 대한의용생체공학회:의공학회지
• /
• 제27권4호
• /
• pp.154-163
• /
• 2006

A 64-channel magnetocardiogram (MCG) system using low-noise superconducting quantum interference device (SQUID) planar gradiometers was developed for the measurements of cardiac magnetic fields generated by the heart electric activity. Owing to high flux-to-voltage transfers of double relaxation oscillation SQUID (DROS) sensors, the flux-locked loop electronics for SQUID operation could be made simpler than that of conventional DC SQUIDs, and the SQUID control was done automatically through a fiber-optic cable. The pickup coils are first-order planar gradiometers with a baseline of 4 em. The insert has 64 planar gradiometers as the sensing channels and were arranged to measure MCG field components tangential to the chest surface. When the 64-channel insert was in operation everyday, the average boil-off rate of the dewar was 3.6 Lid. The noise spectrum of the SQUID planar gradiometer system was about 5 fT$_{rms}$/$\checkmark$Hz at 100 Hz, operated inside a moderately shielded room. The MCG measurements were done at a sampling rate of 500 Hz or 1 kHz, and realtime display of MCG traces and heart rate were displayed. After the acquisition, magnetic field mapping and current mapping could be done. From the magnetic and current information, parameters for the diagnosis of myocardial ischemia were evaluated to be compared with other diagnostic methods.

• 한국구조물진단유지관리공학회 논문집
• /
• 제13권5호통권57호
• /
• pp.169-179
• /
• 2009

본 논문의 목적은 열화상 비파괴 검사기법을 적용시 손상된 콘크리트 구조물의 표면온도를 증폭시키기 위해 사용되는 외부 열원의 효율성을 알아보기 위함이다. 원적외선램프와 할로겐램프의 적용성과 효율성을 서로 비교하였다. 이를 위해 전술한 두 개의 열원을 콘크리트의 내부공극과 FRP쉬트의 비부착 결함 시험체에 적용하였다. 본 연구결과, 원적외선램프가 할로겐램프보다 더 효율적인 것으로 파악되었다. 또한, 손상영역을 효과적으로 검출하기위해서 가우스 필터와 프리윗 마스크 화상처리기법을 혼합한 알고리즘을 제안하였다.

• 한국가스학회지
• /
• 제15권3호
• /
• pp.47-52
• /
• 2011

이 논문의 목적은 LPG 자동차의 전자제어에 대한 요소의 하나인 액추에이터에 대한 고장사례를 찾아 분석하고 연구하는 것이다. 차량의 연료를 저장하는 봄 내부의 LPG 긴급 차단 솔레노이드 밸브의 필터가 막혀 연료의 공급이 간헐적으로 차단되는 현상이 발생되어 엔진이 작동하는 동안 엔진의 초기시동불량이나 가속이 되지 않는 것을 확인하였다. 엔진 컨트럴 릴레이 부위의 접점부가 가공불량이나 조립불량에 의해 완전한 면접촉이 되지않아 접촉저항이 발생되어 초기 시동을 걸었을 때 시동이 걸렸으나 재시동을 걸 때 시동이 걸리지 않는 현상을 확인하였다. 공회전 조절장치의 내부에 카본이 퇴적되어 액추에이터가 고착되어 흡입공기의 공급이 감소되어 자동차의 시동이 걸려 공회전 상태일 때 엔진의 회전수가 규정 범위를 벗어나 상승과 하락을 반복하는 불안정 상태를 확인하였다.

• Electronic Materials Letters
• /
• 제14권6호
• /
• pp.678-688
• /
• 2018

The repeated-bending properties of Sn-0.7Cu, Sn-0.3Ag-0.7Cu (SAC0307), and Sn-3.0Ag-0.5Cu (SAC305) solders mounted on flexible substrates were studied using highly accelerated stress testing (HAST), followed by repeated-bending testing. In the Sn-0.7Cu joints, the $Cu_6Sn_5$ intermetallic compound (IMC) coarsened as the HAST time increased. For the SAC0307 and SAC305 joints, the $Ag_3Sn$ and $Cu_6Sn_5$ IMCs coarsened mainly along the grain boundary as the HAST time increased. The Sn-0.7Cu solder had a high contact angle, compared to the SAC0307 and SAC305 solders; consequently, the SAC0307 and SAC305 solder joints displayed smoother fillet shapes than the Sn-0.7Cu solder joint. The repeated-bending for the Sn-0.7Cu solder produced the crack initiated from the interface between the Cu lead wire and the solder, and that for the SAC solders indicated the cracks initiated at the surface, but away from the interface between the Cu lead wire and the solder. Furthermore, the oxide layer was thickest for Sn-0.7Cu and thinnest for SAC305, regardless of the HAST time. For the SAC solders, the crack initiation rate increased as the oxide layer thickened and roughened. $Cu_6Sn_5$ precipitated and grew along the grain and subgrain boundaries as the HAST time increased, embrittling the grain boundary at the crack propagation site.

• 한국토양비료학회지
• /
• 제48권6호
• /
• pp.593-601
• /
• 2015

The NDVI (Normalized difference vegetation index) is used as indicators of crop growth situation in remote sensing. To measure or validate the NDVI, reliable NDVI sensors have been needed. We tested new fixed-field NDVI sensor, "SRS (Spectral Reflectance Sensor)" developed by Decagon Devices, during Kimchi cabbage growing season at the cultivation area located in Gochang, Gangneung and Taebaek in Korea from 2014 to 2015. The diurnal variation of NDVI measured by SRS (SRS NDVI) showed a slight ${\cap}$-profile shape and was affected by water on the sensor surface. This means that SRS NDVI around noontime is resonable, except rainy day. Comparisons were made between the SRS NDVI and NDVI of used widely mobile sensor (Cropcircle NDVI). The comparisons indicate that SRS NDVI are close to Cropcircle NDVI (R=0.99). SRS NDVI time series displayed change of the plant height and leaf width of Kimchi cabbage. An obvious exponential relationship is found between SRS NDVI and the plant height ($R^2{\geq}0.92$) and leaf width ($R^2{\geq}0.92$) of Kimchi cabbage. Thus, SRS NDVI will be used as indicator of crop growth situation and a very powerful tool for evaluation of remote sensing NDVI estimates and associated corrections.

• Nano
• /
• 제13권12호
• /
• pp.1850147.1-1850147.14
• /
• 2018

In this work, water-soluble and blue-emitting carbon nanodots (CDs) were synthesized from apple peels for the first time via one-step hydrothermal method. The synthetic route is facile, green, economical and viable. The as-prepared CDs were characterized thoroughly by transmission electron microscopy (TEM), X-ray diffraction (XRD), Raman, Fourier transform infrared (FT-IR), X-ray photoelectron (XPS), fluorescence and UV-Vis absorption spectroscopy in terms of their morphology, surface functional groups and optical properties. The results show that these CDs possessed ultrasmall size, good dispersivity, and high tolerance to pH, ionic strength and continuous UV irradiation. Significantly, the CDs had fast and reversible response towards temperature, and the accurate linear relationship between fluorescence intensity and temperature was used to design a novel nanothermometer in a broad temperature range from 5 to $65^{\circ}C$ facilely. In addition, the fluorescence intensity of CDs was observed to be quenched immediately by Cr(VI) ions based on the inner filter effect. A low-cost Cr(VI) ions sensor was proposed employing CDs as fluorescent probe, and it displayed a wide linear range from 0.5 to $200{\mu}M$ with a detection limit of $0.73{\mu}M$. The practicability of the developed Cr(VI) sensor for real water sample assay was also validated with satisfactory recoveries.