• Bulletin of the Korean Chemical Society
• /
• v.35 no.7
• /
• pp.2109-2113
• /
• 2014

Solvent extraction of Fe(III) from chloride solution by using a mixture of D2EHPA (Di-(2-ethylhexyl)-phosphoric acid) and TBP (Tri-butyl phosphate) and the reductive stripping of Fe(III) from the loaded organic were investigated. Quantitative extraction of Fe(III) from the solution (Fe concentration = 90 g/L) was accomplished in two cross-current extraction stages by using the mixture of D2EHPA and TBP. In order to facilitate the stripping efficiency, a reductive stripping method was employed by using $H_2SO_3$ or $Na_2SO_3$ as a reducing agent. The addition of $H_2SO_4$ into reducing agents led to improvement in the stripping efficiency while high concentration acid would suppress it. Both of the mixtures of $H_2SO_4+H_2SO_3$ and $H_2SO_4+Na_2SO_3$ showed good efficiency for the stripping of Fe(III), while the latter was recommended as the stripping solution based on the economics and experimental condition.

• Membrane and Water Treatment
• /
• v.10 no.2
• /
• pp.127-137
• /
• 2019

The D2EHPA/TBP co-extractants immobilized PolyHIPE membrane can be used for the selective separation of Mn (II) from Co (II). By solvent-nonsolvent method, D2EHPA/TBP co-extractants can be effectively immobilized into PolyHIPE membrane. The pore structure of PolyHIPE membrane and the presence of TBP enhance the stability of immobilized co-extractants. The optimal operating conditions for the separation of Mn (II) and Co (II) are feeding phase at pH 5.5, sulfuric acid concentration in the stripping phase of about 50 g/L and stirring speed at 400 rpm. The D2EHPA/TBP co-extractants ratio of 5:1 shows synergetic effect on Mn/Co separation factor about 22.74. The removal rate and recovery rate of Mn (II) is about 98.4 and 97.1%, respectively, while for Co (II) the transport efficiency is insignificant. The kinetic study of Mn (II) transport shows that high initial flux, $J_f^o=80.1({\mu}mol/m^2s)$, and maxima stripping flux, $J_s^{max}=20.8({\mu}mol/m^2s)$, can be achieved with D2EHPA/TBP co-extractants immobilized PolyHIPE membrane. The stability and reusability study shows that the membrane can maintain a long term performance with high efficiency. High purity of Co (II) and Mn (II) can be recovered from the feeding phase and stripping phase, respectively.

• Resources Recycling
• /
• v.23 no.5
• /
• pp.21-27
• /
• 2014

A study on the solvent extraction for the recovery of Li from lithium-containing waste solution was investigated using $D_2EHPA$ as an extractant. The experimental parameters, such as the pH of the aqueous solution, concentration of extractant and phase ratio were observed. Experimental results showed that the extraction percentage of Li was increased with increasing the equilibrium pH. More than 50% of Li was extracted in eq. pH 6.0 by 20% $D_2EHPA$. From the analysis of McCabe-Thiele diagram, 95% of Li was extracted by four extraction stage at phase ratio(O/A) of 3.0. Stripping of Li from the loaded organic phases can be accomplished by sulfuric acid as a stripping reagent and 90 ~ 120 g/L of $H_2SO_4$ was effective for the stripping of Li. Finially, Li was concentrated about 11.85 g/L by continuous stripping process, and then lithium carbonate was prepared by precipitation method.

• Korean Journal of Metals and Materials
• /
• v.48 no.1
• /
• pp.62-70
• /
• 2010

Leaching and solvent extraction experiments have been performed to develop a hydrometallurgical process for the recovery of nickel and cobalt from nickel laterite ore with high magnesium content. Most of the nickel and magnesium in the laterite ore dissolved at leaching conditions of $80^{\circ}C$ and 100 g/L sulfuric acid concentration. while half of the cobalt and iron were leached at the same conditions. Solvent extraction experiments were carried out with D2EHPA and saponifed D2EHPA from a synthetic solution containing Ni, Co, and Mg. The extraction percentage of Co, Mg. and Ni by D2EHPA was very low in a pH range of 4.4 to 7.3. while the extraction percentage sharply increased by using saponified D2EHPA. The stripping percentage of the metals from the saponified D2EHPA increased with sulfuric acid concentration and reached 99.9% at 1 M $H_2SO_4$ solution.

• Membrane and Water Treatment
• /
• v.9 no.1
• /
• pp.23-31
• /
• 2018

In this study, a new method called as multi-dropped liquid membrane (MDLM) which is more practical and more effective than other liquid membrane techniques is applied for transport of Zn(II) has been studied. HCl as the stripping solution and D2EHPA dissolved in kerosene as the membrane solution, has been examined. The effects of stripping solution concentration, carrier concentration, temperature and pH in the feed phase on the transport of Zn(II) have also been investigated. As a result, the optimum transport conditions of Zn(II) were obtained, i.e., the concentration of HCl solution was 0.25 M, the concentration of D2EHPA was $8{\times}10^{-3}M$, and pH value in the donor phase was 5.00. Under the optimum conditions, the transport percentage of Zn(II) was up to >99% during the transport time of 80 min when the initial concentration of Zn(II) was $120mgL^{-1}$. The activation energy is calculated as $5.30kcalmol^{-1}$. The value of calculated activation energy indicates that the process is diffusionally controlled by Zn(II) ions. The experiments have demonstrated that D2EHPA derivative is a good carrier for Zn(II) transport through MDLM in the study.

• Journal of the Korean Ceramic Society
• /
• v.29 no.12
• /
• pp.963-969
• /
• 1992

This paper describes the feasibility for a direct production of zinc oxalate powders from zinc-loaded D2EHPA solutions combining the purification and the precipitation in one operation unit. This process has the potential as an alternative to conventional method for the synthesis of zinc oxide precursor particles from the hydrometal-lurgical processes. Zinc was extracted into D2EHPA in kerosene and then zinc-loaded D2EHPA solution was emulsified with oxalic acid-HCl solution to precipitate zinc oxalate powder, which was readily calcined to zinc oxide. The precipitation kinetics and yield were sensitive to experimental conditions. The morphology, size and size distribution of the zinc oxalate powders varied with zinc/oxalate ion riatio, temperature, and the presence of SPAN 60, which affected nucleation, growth, and the emulsion characteristics.

• Journal of Environmental Science International
• /
• v.9 no.6
• /
• pp.517-522
• /
• 2000

Separation of strontium ion from synthetic seawater in the contained liquid membrane permeator with two micro-porous films was performed. The permeator consisted of a liquid membrane and two cells for aqueous solutions. The liquid membrane consisted of $D_2EHPA(di-2-ethylhexy1-phosphoric acid)$ and DCH18C6 (dicyclohexano-18-crown-6),diluted to 30 vol% with kerosine and was trapped between two micro-porous hydrophilic films. This liquid membrane separated two aqueous solutions, one of which was synthetic seawater and the other of which was the stripping solutions consisting of 1mol/L $H_2SO_4$ solution. The effects of various operating parameters on the extraction rate and equilibrium extraction ratio of strontium ion from synthetic seawater were experimentally examined. The addition of DCH18C6 to the $D_2EHPA$ solution caused synergy effect on the extraction of strontium ion. The permeator extracted strontium ion from synthetic seawater effectively with high membrane life time.

• Resources Recycling
• /
• v.31 no.1
• /
• pp.12-20
• /
• 2022

The smelting reduction of spent lithium-ion batteries results in metallic alloys containing Co, Cu, Fe, Mn, Ni, and Si. A process to separate metal ions from the sulfuric acid leaching solution of these metallic alloys has been reported. In this process, ionic liquids are employed to separate Fe(III) and Cu(II). In this study, D2EHPA and Cyanex 301 were employed to replace these ionic liquids. Fe(III) and Cu(II) from the sulfate solution were sequentially extracted using 0.5 M D2EHPA with three stages of cross-current and 0.3 M Cyanex 301. The stripping of Fe(III) and Cu(II) from the loaded phases was performed using 50% (v/v) and 60% (v/v) aqua regia solutions, respectively. The mass balance results from this process indicated that the recovery and purity percentages of the metals were greater than 99%.

• Resources Recycling
• /
• v.25 no.1
• /
• pp.16-23
• /
• 2016

The separation behaviour of Mo and W from sulfuric acid solution by solvent extraction with Alamine 336 was investigated as a function of solution pH and extractant concentration. Selective extraction of Mo over W by Alamine 336 was obtained in the pH range of 3-5 with low amine concentration. The mixture of Alamine 336 and acidic extractants improved the separation factor between Mo and W and was in the following order: D2EPHA > PC88A > Decanol > Versatic acid. The stripping efficiency of Mo and W from the loaded mixture of Alamine 336 and D2EHPA was very poor, while complete stripping of Mo and W was possible from the mixture of Alamine 336 and Decanol by using a mixture of $NH_4OH$ and $NH_4Cl$.

• Resources Recycling
• /
• v.1 no.1
• /
• pp.58-68
• /
• 1992

A process development for direct synthesis of high pure ZnO powders from zinc-bearing waste was investigated. This waste contains a 55% of zinc and it was extracted by the sulfuric acid(leaching). After removal of iron ion by precipitation from the zinc solution, the purification through a solvent extraction by the use of D2EHPA as an extractant was carried out. Then, loaded zinc in organic solution was stripped and precipitated simultaneously using a precipitant such as oxalic acid. Then, loaded zinc in organic solution was stripped and precipitated simulataneously using a precipitant such as oxalic acid. The synthesized $ZnC_2O_4$ powders by the precipitation stripping method was calcined to obtain more than 99.9% of ZnO powders. The effect of sulfuric acid concentration, leaching time, pulp density on the extraction of zinc was studied and the optimum conditions for the solvent extraction were obtained through the investigation of purification of zinc solution. The size, morphology and size distribution of synthesized $ZnC_2O_4$ powders were studied in terms of oxalic acid concentration, temperature, surfactant added, precipitation time, etc.