• 대한의용생체공학회:의공학회지
• /
• 제16권3호
• /
• pp.325-330
• /
• 1995

혈압에 의한 안쪽벽의 변형을 집중현상으로 인한 동백 전단부의 변형율 gradient의 심각성은 잔유 변형율에 의해 감소되거나 없을 수 있다는 가정을 실험적으로 시도했다. 잔유변형율과 압력에 의한 변형율을 측정하여 잔유변형율이 원주변형율에 끼치는 영향을 알아 보았다. 결과로서 변형율 gradient를 줄이거나 없을수도 있으나 negative gardient가 평균적으로 나타났다. 즉 전체변형율(원주변형율+잔유변형율)은 안쪽벽이 낮고 바깥쪽이 높은 것으로 나타났다.

• 한국구조물진단유지관리공학회 논문집
• /
• 제4권4호
• /
• pp.109-119
• /
• 2000

PVDF film sensor was applied to measure the stress concentration for monitoring the structural integrity. The strain calibration of this film sensor was performed by the bending test of aluminum beam. The PVDF sensor and the electrical strain gage were bonded on the beam. When the beam was loaded, the output of electrical strain gage was compared with the output of the PVDF sensor. The waveform of PVDF sensor output was shown as the same form of the output of electrical strain gage. The gain was determined as 1.7 by comparing these two signals to determine the exact value of the strain. In order to experiment the stress concentration, the stress field was analyzed by finite element analysis. The tensile test of notched steel specimens was conducted to develop the measurement technique of stress concentration. The output voltage ratio between the PVDF sensor near the notch and the PVDF sensor far from the notch could give the information about the load bearing capacity of steel specimen.

• Journal of Ginseng Research
• /
• 제17권2호
• /
• pp.148-152
• /
• 1993

One kind of microorganism was isolated and identified from Korean fresh, white and red ginseng, and the effect of a preservative, sodium benzoate on the microorganism and its thermal resistant propertues were studied. The results obtained were as follows. The predominant strain on ginseng and ginseng products was identified as Penicillium sp. The strain showed perithecium structure producing ascospores. The growth of the strain was slightly inhibited at 0.0571 concentration of sodium benzoate. The minimal inhibitory concentration (MIC) of sodium benzoate against the strain was 0.26%. The D value of the strain at 56, 59, $62^{\circ}C$ were 9.9, 5.0 and 4.5 min, respectively.

• 한국토양동물학회지
• /
• 제2권2호
• /
• pp.76-82
• /
• 1997

Mortality of some agro-forest insect pests, Agrotis segetum, Blitopertha orientalis, Agerastica coerulea, Glyphodes perspectalis and Acantholyda parki caused by entomopathogenic nematodes was investigated in laboratory and in pot. Steinernema carpocapsae All and Pocheon strain were effective against 2nd of 3rd instar larvae of A. segetum showing 100% mortalities at the concentration of 10Ijs/larva but not effective against 4th inster larvae. Mortality of B. orientalis was 100% after 26 days in H. bacteriopora NC 1, H. bacteriophora Hamyang and S. glageri NC strain treatment. S. monticulum also showed 100% mortalities against A. coerulea andd G. perspectalis at the concentration of 80 and 40 Ijs/larva. However, H. bacteriophora Cheju and S. glaseri Cheju strain were not effective against A. parki, i.e., showing 23.3 and 20.0% mortalities, respectively at the concentration of 160Ijs/larva. S. glaseri Hanrim strain was more effective than H. bacteriophora Cheju strain against Pryeria sinica.

• 한국자동차공학회논문집
• /
• 제4권2호
• /
• pp.80-89
• /
• 1996

Fatigue life of a notched shaft was evaluated in order to estimate the durability and integrity of the notched shaft in design stage. Cumulative fatigue dama- ge analysis was performed using local strain approach based on the assumption that the fatigue life of a notched component is approximately same as that of a smooth specimen is subjected to the same strain at the notched component. In this paper, shafts with different notch root radius of 1, 2㎜ resulting in different values of stress concentration factors were tested under||rotating bending fatigue loading condition. Theoretical stress concentration factor for each notch type was calculated using finite element method. Fatigue life prediction program, FALIPS, written in C language was developed using the strain-life curve, and the local strain approach integrating Neuber's rule, cyclic stress-strain, and hysteresis loop equations. The fatigue life evaluated using the fatigue notch factor obtained from the experimentally determined fatigue strength showed very large scattering with nonconservatism, but the fatigue notch factors derived from the stress concentration factors and Peterson's equation reduced the considerablely accurate fatigue life evaluation within a factor of three.

• Biotechnology and Bioprocess Engineering:BBE
• /
• 제8권1호
• /
• pp.37-40
• /
• 2003

The antibacterial action of violet pigment, a mixture of violacein and deoxyviolacein, isolated from phychrotrophic bacterium RT102 strain was examined, and the operational conditions for the effective production of violet pigment were studied. The antibacterial activity of the violet pigment was confirmed for several bacteria such as Bacillus licheniformis, Bacillus subtilis, Bacillus megaterium, Staphylococcus aureus, and Pseudomonas aeruginosa, and the high concentration of violet pigment, above about 15mg/L, caused not only growth inhibition but also death of cells. The growth properties of RT102 strain were clarified under various incubation conditions such as pH, temperature, and dissolved oxygen concentration. The maximum violet pigment concentration, i.e. 3.7 g/L, and the maximum productivity of violet pigment, i.e. 0.12 g .L$\^$-1/H$\^$-1/, were obtained in a batch culture of pH 6, 20$^{\circ}C$, and 1 mg/L of dissolved oxygen concentration.

• 한국식품위생안전성학회지
• /
• 제10권4호
• /
• pp.205-211
• /
• 1995

To investigate the antimicrobial effect of polyphosphates as a food additive, the growth and structural change of Listeria monocytogentes Scott A were examined in relation to polyphosphates concentration and incubation temperature. Up to 10,000 ppm of polyphosphates, the growth rate of strain was gradually inhibited with increasing polyphosphates concentration and decreasting the incubation temperature. Minimal inhibitory concentration of polyphosphates to the growth of strain was about 12,000 ppm. It was observed , using both scanning electron microscopy(SEM) and transmission electron microscopy(TEM), that 0.9% polyphosphates treatment was resulted in the destruction of cell wall and outflow of cell ingredients. The antimicrobial effects of polyphosphates were more effective than those of dehydroacetate and potassium sorbate at 13$^{\circ}C$ and 4$^{\circ}C$. The growth rate the strain in beef was significantly inhibited by the treatment of 0.9% polyphosphates and storaged at cooling temperature.

• 소성∙가공
• /
• 제23권5호
• /
• pp.317-322
• /
• 2014

Bursting during tube hydroforming is preceded by localized necking. The retardation of the initiation of necking is a means to enhance hydroformability. Since high strain gradients occur at the necking sites, a decrease in local strain gradients is an effective way to retard the initiation of necking. In the current study, the expansion at potential necking sites was intentionally restricted in order to reduce the strain gradient at potential necking sites. From the strain distribution obtained from FEM, it is possible to determine strain concentrated zones, which are the potential necking sites. Prior to the hydroforming of a trailing arm, an incompressible material(such as lead) is attached to the tube where the strain-concentrated zone would contact the die. Due to the incompressibility of lead, the tube expansion is locally restricted, and the resultant strain extends to adjacent regions of the tube during hydroforming. After the first stage of hydroforming, the lead is removed from the tube, and the hydroforming continues to the final targeted shape without any local restriction. This method was successfully used to fabricate a complex shaped automotive trailing arm that had previously failed during traditional hydroforming fabrication.

• 한국건설순환자원학회논문집
• /
• 제11권4호
• /
• pp.381-390
• /
• 2023

본 연구에서는 염해를 받은 콘크리트의 역학적 성능 평가를 수행하고, 실험 결과를 바탕으로 염소이온 농도에 따른 압축응력변형률 모델을 제시하였다. 염해를 모사하기 위해 콘크리트 배합 시 CaCl₂ 용액을 첨가하였으며, 염소이온의 농도는 결합재의 중량 대비 0, 1, 2, 4 %가 되도록 하였다. 콘크리트의 최대 압축응력 이후의 응력-변형률 곡선을 조사하기 위해 변위 제어를 통해 압축강도를 측정하였다. 염소이온 농도가 1 %인 경우에는 최대 압축응력이 증가하였으나, 염소이온 농도가 2 % 이상인 경우에는 최대 압축응력이 감소하였다. 최대 압축응력에서의 변형률의 경우 재령 7일의 시편에서는 염소이온 농도에 따른 경향이 나타나지 않았다. 재령 28일의 시편에서는 염소이온 농도가 증가함에 따라 감소하였다. 재령 28일의 최대 압축응력와 변형률의 변화를 이용하여 Popovics model에 기반한 응력-변형률 곡선 모델을 제시하였다. 염소이온의 농도 증가에 따른 역학적 성능 저하의 원인을 조사하기 위해 수화생성물 분석을 수행하였다. 염소이온의 농도가 증가함에 따라 Friedel's salt가 증가하고, portlandite가 감소하는 것을 확인하였다.

• 한국미생물·생명공학회지
• /
• 제28권6호
• /
• pp.309-315
• /
• 2000

To isolate yeast strains producing high concentration of ethanol, 125 strains were subjected to screening. Initially 14 strains able to grow in a medium containing 15%(v/v) ethanol, 7 strains capable of growing in a medium containing 50%(v/v) glucose, 23 strains having relatively fast fermentation rates, 13 strains able to grow at $42^{\circ}C$ were selected. After secondary screening, 11 strains having relatively high ini-tial fermentation rate and producing high concentration of ethanol were selected. After tertiary screening 5 strains producing high concentration of ethanol were selected. These 5 strains were again for their ethanol produc-tion, residual sugar, and viability using fermentation medium containing 25% glucose. The strain producing the highest concentration of ethanol was 20-1 strain which produced 10.56%(v/v) ethanol in 4 days, and the highest viable strain was 11-1 which produced 10.35%(v/v) ethanol(13.1%. v/v) with the viability of 30.44% after 5 days of fermentation. Both of the 20-1 and 11-1 strains were identified as Saccharomyces cerevisiae.