• Journal of the Korean Ceramic Society
• /
• v.40 no.8
• /
• pp.746-750
• /
• 2003

Using the Czochralski method, Er$_2$O$_3$ doped near stoichiometric LiNbO$_3$ single crystals were grown 15~20 mm in diameter and 30-35 mm in length for Z-axis. Lattice constants were inspected by the X-Ray Diffractometer (XRD) and through Fourier Transform-Infrared Spectrophotometer (FT-IR), it observed absorption band. Also, the distributions of Er concentration were confirmed by the Electron Probe Micro Analysis (EPMA).

• Journal of the Korean Applied Science and Technology
• /
• v.28 no.1
• /
• pp.6-9
• /
• 2011

Step feed process was analyzed stoichiometrically for the optimal operation conditions in this study. In case of optimal operation conditions, minimum R (sludge recycling) value, r (internal recycling ratio) value, and n (influent allocation ratio) value for the step feed process to acquire the maximum TN removal efficiency were identified by theoretical analysis. Maximum TN removal efficiency, based on stoichiometric reaction, can be obtained by controlling n value for the step feed process.

• Korean Journal of Materials Research
• /
• v.9 no.6
• /
• pp.551-555
• /
• 1999

The deposition condition to obtain stoichiometric $Ta_2$O\ulcorner films, which is still controversial, using magnetron reactive sputtering was studied. The films were deposited by varying $O_2$gas flow rate with sputtering power and Ar gas flow rate of 200W and 60 sccm fixed. At the conditions of $O_2$ gas flow rate over 20 sccm, amorphous Tantalum oxide films with the refractive index of 2.1 and dielectric constant of 25 were deposited. Among those films, the capacitors dielectric properties of the film deposited at the condition of $O_2$ gas flow rate 50 sccm was best, the leakage current was 1$\times$10\ulcornerA/$\textrm{cm}^2$ at the electric field strength of 0.5 MC/cm and the breakdown field strength was over 2.0 MV/cm. This result could be explained from the analysis comparing with a standard sample using RBS because the composition of the film deposited at this condition was closest to the stoichiometric $Ta_2$O\ulcorner. The result of XPS analysis convinced that this film was stoichiometric $Ta_2$O\ulcorner film. A maximum cathode voltage was observed when $O_2$gas flow rate was 30 sccm. This shows that the Schiller's proposition that one can obtain stoichiometric films at the condition of maximum cathode voltage is not correct and more oxygen than that of the maximum voltage condition is necessary to deposit the stoichiometric Ta$_2$O\ulcorner films.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.16 no.6
• /
• pp.235-239
• /
• 2006

ZnO-doped near-stoichiometric $LiNbO_3$ single crystals of $0.8{\sim}1.0mm$ diameter and $30{\sim}35mm$ length were grown by the micro-pulling down (U-PD) method. The structure of the grown crystals was confirmed by powder x-ray diffraction (XRD) patterns. Electron probe micro analysis (EPMA) showed that Zn ions were homogeneously incorporated In grown crystals. The threshold in ZnO doping level was confirmed that an abrupt change in the features of $OH^-$ absorption band as doping level reaching about 2 mol%.

• Journal of Microbiology and Biotechnology
• /
• v.4 no.2
• /
• pp.95-101
• /
• 1994

The effects of glycine on cell growth and L-omithine production were investigated in shake-flask and jar fermentor cultures of a citrulline auxotrophic mutant, Brevibacterium ketoglutamicum BK 1046. In the shake-flask culture, the optimal concentration of glycine for L-ornithine production was found to be 20 g/l. In the jar fermentor culture with the glycine at an initial concentration of 20 g/l, L-ornithine production increased by 28%, compared to that of the culture with no glycine added. 37 g/l of L-ornithine was produced when additional feeding of glycine (5 g/l) was made. This was a significant improvement in L-ornithine production compared to that (ca. 24 g/l) of the corresponding batch culture conducted without glycine. According to the stoichiometric analysis with the batch fermentation results, the experimental and theoretical L-ornithine yields based on the glucose consumption were 0.24 and 0.59, respectively. This indicates that the performance of L-ornithine fermentation can further be improved by the supplementation of glycine and the development of a mutant strain possessing a higher growth yield.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.33 no.3
• /
• pp.207-214
• /
• 2009

Crossover of nitrogen from cathode to anode is inevitable in typical membranes used in PEM fuel cells. This crossovered nitrogen normally accumulates in the hydrogen recirculation system at anode side channels. Excessive buildup of nitrogen in the anode side lowers the relative hydrogen concentration and finally affects the performance of fuel cell stack. So it is very important to analysis the nitrogen gas crossover at various operating conditions. In this study, characterization of nitrogen gas crossover in PEM fuel cell stack was investigated. The mass spectroscopy (MS) has been applied to measure the amount of the crossovered nitrogen gas at the anode exit. Results show that nitrogen gas crossover rate was affected by current density, anode and cathode stoichiometric ratio and operating pressure. Current density, anode stoichiometric ratio and anode operating pressure do not affect nitrogen crossover rate but anode exit concentration of nitrogen. Cathode pressure and stoichiometric ratio largely affect the nitrogen crossover rate.

• Carbon letters
• /
• v.4 no.4
• /
• pp.175-179
• /
• 2003

It is well established that halogenated fullerene derivatives act as synthetic intermediates for further substitution via replacement with nucleophlies. In the present work, systematic studies were carried out on the synthesis of bromofullerenes under different experimental conditions. The effect of reaction time on the product formed was observed. We observed the formation of new compound of bromofullerenes in a different stoichiometric ratio i.e., $C_{60}Br_{14}$; in addition to previous reported bromofullerenes in the stoichiometric ratio of $C_{60}Br_6$, $C_{60}Br_8$, and $C_{60}Br_{24}$. The new derivative of bromofullerene was isolated and well characterized by various analytical techniques like FT-IR, TGA, DSC, and elemental analysis. In this paper, detail of the synthesis and characterization of the bromofullerene prepared are described. The yields obtained were better than those reported previously.

• Journal of the Korean Ceramic Society
• /
• v.39 no.10
• /
• pp.977-980
• /
• 2002

Using the micro-pulling down method, $Nd_2O_3$ doped crack-free stoichiometric $LiNbO_3$ single crystals were grown in 1 mm diameter and 30∼35 mm length. The homogeneous distributions of $Nd_2O_3$ concentration were confirmed by the electron probe micro analysis. The absorption and photoluminescence spectra were measured with respect to the $Nd_2O_3$ doping.

• Korean Journal of Materials Research
• /
• v.11 no.9
• /
• pp.797-801
• /
• 2001

In this study, the solution combustion method was employed to synthesize stoichiometric mullite, and hence the attrition process was employed to prepare ultrafine mullite particles with nano size. The thermal decomposition behavior and partial pressure of equilibrium species of both oxidizer and fuel were considered during solution combustion process. The synthesized product was mullite phase with 40 nm crystalline size, and the alumina contents of the product by TEM/EDS quantity analysis was 3.12$\pm$04 mole. The result showed that the synthesized mullite was almost close to the it's stoichiometric composition. For attrition process, the dispersion behavior of the mullite suspension was controlled and was comminuted with the condition of 800 rpm for 4 hours using 0.3 mm zirconia ball media. As a result of comminution, the mean particle size was 80 nm.

• ETRI Journal
• /
• v.34 no.2
• /
• pp.226-234
• /
• 2012

The novelty of this study resides in the fabrication of stoichiometric and stress-reduced $Si_3N_4/SiO_2/Si_3N_4$ triple-layer membrane sieves. The membrane sieves were designed to be very flat and thin, mechanically stress-reduced, and stable in their electrical and chemical properties. All insulating materials are deposited stoichiometrically by a low-pressure chemical vapor deposition system. The membranes with a thickness of 0.4 ${\mu}m$ have pores with a diameter of about 1 ${\mu}m$. The device is fabricated on a 6" silicon wafer with the semiconductor processes. We utilized the membrane sieves for plasma separations from human whole blood. To enhance the separation ability of blood plasma, an agarose gel matrix was attached to the membrane sieves. We could separate about 1 ${\mu}L$ of blood plasma from 5 ${\mu}L$ of human whole blood. Our device can be used in the cell-based biosensors or analysis systems in analytical chemistry.