• Clean Technology
• /
• v.29 no.2
• /
• pp.95-101
• /
• 2023

An experiment was conducted to produce vaterite-type precipitated calcium carbonate from waste oyster shells in order to use them as recyclable resources. Calcined oyster shells containing calcium oxide as their main component were prepared at a temperature of 800℃ for 24 h. The oyster shells were dissolved in nitric acid or hydrochloric acid solution to make 0.1 M calcium nitrate or calcium chloride aqueous solution, and a carbonation reaction was performed using a 0.1 M sodium carbonate aqueous solution under various experimental conditions, which included varying the amount of aspatic acid additive, the amount of NH₄OH added, the reaction time, the reaction temperature, the stirring speed, and the type of dissolved acid. The XRD, SEM, and size distributions were analyzed and the vaterite content was calculated. Spherical precipitated calcium carbonate with a vaterite content of 95.9% was synthesized by adding 0.1 mol aspatic acid/1 mol CaO and 2 cm³ of NH₄OH, and reacting for 1 h at 25℃ while stirring at 600 rpm. The average particle diameter was found to be 12.11 ㎛. Calcium carbonate contatining high vaterite is used as high value added calcium carbonate for medical, food, inke additiver, etc.

• Journal of the Korean Ceramic Society
• /
• v.39 no.6
• /
• pp.550-557
• /
• 2002

TiO$_2$ particles coated on fly ash composites for use in photocatalyst were synthesized by the precipitation dropping method and heated at $700^{\circ}C$ for 2 h. The pH of reaction solution, the addition rate of NH$_4$HCO$_3$, the stirring speed, the reaction temperature and the concentration of TiC1$_4$ had a pronounced effect on the nature of precipitated TiO$_2$ particles on the surface off fly ash and the crystal structure of precipitated TiO$_2$ particles. At an addition rate of NH$_4$HCO$_3$; 1.0 ml/min, the pH of the reaction solution; 6, the stirring speed; 1,000 rpm and the reaction temperature; 8$0^{\circ}C$, about 10 nm of TiO$_2$ particle size and homogeneous precipitated layer on the surface of a fly ash was achieved. On the contrary, at an addition rate of NH$_4$HCO$_3$; 0.3,0.5 ml/min, the pH of the reaction solution; 2 and 11, the stirring speed; 300~500 rpm and the reaction temperature; lower than 5$0^{\circ}C$:, Inhomogeneous precipitated layer was developed on a fly ash. TiO$_2$ particles with anatase phase was formed as-dried precipitation at the low concentration of Tic14, the high addition rate of NH$_4$HCO$_3$ and the high reaction temperature, the crystalline fraction of anatase increased with raising heat-treatment temperature and rutile phase began to formation at 80$0^{\circ}C$. The crystal size of TiO$_2$ particles increased with raising the heat-treatment temperature, the crystal size was showed about 21 m at $700^{\circ}C$. Anatase type of TiO$_2$ coated on the fly ash heated at $700^{\circ}C$ for 2 h showed 1.25 g/cm$^3$of particle density, 82.8% of strength and 69.5 Lab of whiteness and can be used as a photocatalyst.

• Journal of Korea Foundry Society
• /
• v.14 no.3
• /
• pp.240-247
• /
• 1994

TiC particulate reinforced magnesium matrix composites were fabricated by melt stirring method. The effect of alloying elements on TiC particulate dispersion into molten magnesium and mechanical properties were investigated. The incorporation time is defined as the time required for dispersion of solid particles into molten metal. The incorporation time of TiC particles into molten pure magnesium was remarkably shorter and the particulated dispersion was more uniform than that of pure aluminum which was reported previously. The incorporation time was, prolonged by the addition of Al, Bi, Ca, Ce, Pb, Sn or Zn. The tensile strength increased and elongation decreased by the addition of Cu or Sn into the matrices and composites. Although, the tensile strength of the matrices and composites increased by alloying with Ca or Ce, the maximum elongation was observed at a content of about 1% for the matrices. By alloying with Zn, the tensile strength increased for the matrices and composites, but the elongation of the matrices increased. The pure magnesium and its alloy matrix composites reinforced with 20vol% TiC have the tensile strength of about 400MPa. This value is compared with the tensile strength of SiC whisker reinforced magnesium matrix composites fabricated by liquid infiltration method at the same volume fraction. There fore, the melt strirring method which has the advantages of simple process is considered to be efficient in fabricating magnesium matrix composites.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.36 no.10
• /
• pp.1033-1041
• /
• 2012

Performance evaluation of a direct carbon fuel cell (DCFC) was conducted according to coals and a graphite particle. Several fuel properties such as thermal reactivity, textural structure, gas adsorption characteristic, and functional groups on the surface of fuels were investigated and their effects on electrochemistry were discussed. The strong carbon structure inside of fuels led the rapid potential decreasing in high current density region, because it caused small surface area and low pore volume. The functional groups on the surface were related to the low current density region. The maximum current density and power density of fuels were affected by the total carbon content in fuels. The effect of operating conditions such as stirring rate and operating temperature was investigated in this study.

• Journal of the Korean Applied Science and Technology
• /
• v.32 no.1
• /
• pp.157-164
• /
• 2015

Oleanolic acid is known as which anti-cancer, anti-sinhaeng angiogenic, anti-inflammatory, antioxidant and anti-wrinkle effects. We focused on the antioxidant activity of oleanolic acid was separated from the natural plant and It was confirmed that the whitening effect. In this study, oleanolic acid was stabilized by polyglyceryl surfactant which from natural origin with only a simple stirring operation, and compared with lecithin liposome that was manufactured with high cost facility. The transdermal transition rate of 0.4% oleanolic acid polyglyceryl nanoemulsion was 95%, and it was simillar with lecithin liposome of 92%. 65% of 3hr transdermal transition rate of polyglyceryl nanoemulsion indicate charistiristcs of quick release, compared with 45% of lecithin liposome's 3hr transdermal transition rate. In the in-vivo clinical trial test, polyglyceryl nanoemulsion of 0.4% oleanolic acid was higher 25% in 2nd week, 58% in 4th and 8th weeks than non-added oleanolic acid emulsion.

• Analytical Science and Technology
• /
• v.8 no.4
• /
• pp.611-615
• /
• 1995

The design of appropriate chemically modified electrodes should allow development of new voltammetric measurement schemes with enhanced selectivity and sensitivity. Microorganism like algae has high ability to trap toxic and heavy metal ions and different affinities for metal ions. A copper(II) ion-selective carbon paste electrode was constructed by incorporating alga Anabaena into a conventional carbon paste mixture, and then the film of 10% Nafion was coated to avoid the swelling of the electrode surface. Copper ion could be deposited at the 25% algamodified electrode for 15 min without the applied potential while stirring the solution by only immersing the electrode in a buffer (pH 4.0) cot1taining copper(II). Temperature was controlled at $35^{\circ}C$. After preconcentration was carried out the electrode was transferred to a 0.1 M potassium chloride solution and was reduced at -0.6 volt at $25^{\circ}C$. The differential pulse anodic stripping voltammetry was employed. A well-defined oxidation peak could be obtained at -0.1 volt (vs SCE). In five deposition / measurement / regeneration cycles, the responses were reproducible and relative standard deviations were 3.3% for $8.0{\times}10^{-4}M$ copper(II). Calibration curve for copper was linear over the range from $2.0{\times}10^{-4}M$ to $1.0{\times}10^{-3}M$. The detection limit was $7.5{\times}10^{-5}M$. Studies of the effect of diverse ions showed that the coexisting metal ions had little or no effect for the determination of copper. But anions such as cyanide. oxalate and EDTA seriously interfered.

• Korean Journal of Environmental Agriculture
• /
• v.27 no.4
• /
• pp.435-440
• /
• 2008

Bovine mastitis is an important disease causing serious economic loss in dairy production and food poison in public health. The major causative agents of bovine mastitis include Escherichia coli (E. coli), Streptococcus agalactiae (S. agalactiae), Staphylococcus aureus (S. aureus). These bacteria were found in milk and environmental condition such as feces, water, soil and so on. Recently, many cases of mastitis are derived from environmental contamination of micro-organisms, which important factors for the spread of this disease in farm. Ultraviolet irradiation (UV) has been used as disinfection for waste and water in clinical and industrial facilities. Moreover the UV irradiation has been used as useful bactericidal agents to remove bacterial biofilms in environmental condition. In this study, we determined the bacterial replication in different percentage of water content (PWC) in sterilized saw dust and feces complexes from farm, and results showed that slightly decreased growth pattern of E. coli and S. agalactiae but increased growth pattern of S. aureus in various PWC (200, 400 and 600%) until 144 h incubation. In the bacteriocidal effect of UV irradiation to bacteria in saw dust and feces complex, the results showed that bacteriocidal effect was depended on the UV irradiation time, irradiation distance and PWC. Especially the antibacterial activity of UV irratiation is stronger in low PWC (50%), long time irradiation (50 sec), and short distance (5 cm) than other condition of this study. Furthermore UV irradiation with stirring showed increased the bactericidal effect compared without stirring. These results suggested that bovine mastitis causing agents may survive long time in environmental condition especially saw dust and feces complexes in farm and can cause a various disease including mastitis. Moreover, these data can be used as basis for application and development of UV disinfection to control of bovine mastitis from environmental contaminated bacteria in dairy farm.

• Korean Journal of Veterinary Service
• /
• v.45 no.2
• /
• pp.111-116
• /
• 2022

The purpose of this study is to evaluate the reduction effect of microbially activated peat on odor generated by livestock farms. The odor gas was measured by stirring the livestock manure sample with the existing litter and the microbially activated peat (Healtha Peat) was developed by this research team. In outdoor farm experiment, the measurements were performed by comparing broilers farm using rice husks and microbially activated peat as litter. The weight, mortality, shipment date, and odor levels (NH₃) were measured before and after experiment. The result showed that NH₃ levels were reduced by 100% in the Healtha Peat mixed group, Healtha Peat and rice husks mixed group. In the peat mixed group, Healtha Peat and saw dust mixed group showed reduce value at 99.6% and 99.1%, respectively. However the rice husks mixed group and saw dust mixed group showed a relatively weak NH₃ reduction effect with values of 57.5% and 84.8%, respectively. After 3 months, the Healtha Peat mixed group and Healtha Peat and rice husks mixed group showed the highest NH₃ reduction effect persistence. In the outdoor farm experiment, NH₃ was present in farms using rice husks, but not in farms using Healtha Peat. In farms using Healtha Peat, the mortality and NH₃ were reduced by 75% and >90%, respectively. The average body weight increased 18% and resulted to 10% decrease in the shipping date. These results implied that microbially activated peat has a clear effect on farm NH₃ reduction and affects the productivity of farm animals.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.1
• /
• pp.739-744
• /
• 2020

This study evaluates the erosive potential and effects of mixed alcohols by analyzing the pH, titratable acidity, and fluorescence loss degree (△F). Following alcohol groups were investigated: Soju, Calamansi+soju, Yakult+soju, Cola+soju, and Energy drink+soju. The ratio of soju:beverage in the alcohol mixtures was 7:3. Ed. Notes: The sentence lacks clarity. Please review if the edit correctly portrays the meaning. If not, please revise appropriately. Measurement of the pH and titratable acidity (the amount of 1M NaoH solution required to raise to pH 5.5 (TA5.5) and 7.0 (TA7.0)) of alcohols was achieved by stirring with pH meter. The erosive effect of the alcohol mixtures on bovine tooth (△F) after 1, 2, 4, and 6 hours exposure were analyzed by quantitative light-induced fluorescence (QLF-D). All the mixed alcohols in this study showed an acidic pH, lower than 4.5. The average pH of mixed alcohols was 3.17 ± 0.50 whereas the pH of Soju was 8.6 ± 0.01. The TA5.5 and TA7.0 values of the mixed alcohols were 0.5~18 and 0.5~23.5, respectively. △F of the three tested mixed alcohol groups (except yakult+soju group) were observed to increase in a time-dependent manner. The calamansi mixed alcohol had the highest acidity potential and erosive effect among the tested groups. Taken together, the results indicate that the mixed alcohols have a strong erosive effect and potential on dental enamel.

• Applied Chemistry for Engineering
• /
• v.17 no.2
• /
• pp.138-143
• /
• 2006

Ethosome is a liquid crystalline vesicle prepared by hydration of ethanol-dissolved lecithin with a solution containing hydrophilic components. Investigation of factors affecting the entrapment efficiency and particle size of ethosomes was carried out, because the high entrapment efficiency and small particle size are prerequisite in developing ethosomes as a drug delivery system. The variations of properties of ethosomes with constituent composition and preparation method were examined using a calcein as a hydrophilic marker. It was observed that the amount of ethanol and calcein solution, phosphatidyl choline content in lecithin, preparation temperature, stirring rate, and PBS addition method had a considerable effect on the properties of ethosome. Sonication treatment resulted in the reduction of entrapment efficiency of ethosome, which was due to the release of entrapped components in the vesicles by strong sonication vibration.