• 대한조선학회논문집
• /
• 제36권3호
• /
• pp.60-70
• /
• 1999

해면효과를 받는 WIG선의 종방향 안정성 특성은 고도에 따른 힘과 모멘트의 변화량 때문에 일반 항공기와는 매우 다르게 나타나며, WIG선의 안전한 설계 및 성능에 큰 영향을 준다. 해면 효과를 고려한 WIG선의 종방향 운동방정식으로부터 정안정성 및 동안정성 조건을 유도하고 이를 분석하였다. 20인승 WIG선의 실험데이터로부터 정적 및 동적 안정성 해석을 수행하였으며, 몇가지 설계인자의 변화에 따른 동적 운동특성도 조사하였다. 마지막으로 순항조건에서 비행성능(flying quality)을 군용 항공규정에 의해 분석하였다.

• 대한기계학회논문집B
• /
• 제28권2호
• /
• pp.146-153
• /
• 2004

A Promising new approach to achieve low pollutant emissions and improvement of flame stability is tested experimentally using a cyclone jet hybrid combustor employing both premixed and diffusion combustion mode. Three kinds of nozzle are tested for mixing enhancement of fuel and air. The LNG (Liquified Natural Gas) is used as a fuel. The combustor is operated by two methods. One is DC (Diffusion Combustion) mode generated swirl flow by air as general swirl combustor, and the other is HC (Hybrid Combustion) mode. The HC mode consists of diffusion jet flame of axial direction and premixed cyclone flame of tangential direction in order to stabilized the diffusion jet flame. The results showed that the flame stability of HC mode is significantly enhanced than that of DC mode through the change of mixing characteristics by modifications of fuel nozzle. In addition, the reductions of CO and NOx emission in HC mode, as compared with that for the DC mode, is large than about 50% in stable region. Also, even using the low calorific fuel as $CO_2$-blended gas, it is identified that the cyclone jet hybrid combustor has the high performance of flame stability.

• 한국축산식품학회지
• /
• 제37권3호
• /
• pp.376-384
• /
• 2017

The objective of this study was to investigate the effect of using gelled emulsion (olive oil 46%, inulin 9%, gelatin 3%) as fat replacer on some quality parameters of chicken patties. For this purpose GE, prepared with olive oil, gelatin and inulin was replaced with beef fat at a level of 0%, 25%, 50%, 100% (C, G25, G50, G100). In this study syneresis, thermal stability, centrifuge and creaming stability of gelled emulsion were analyzed. Chemical composition, technological paramerers (cooking yield, water holding capacity, diameter reduction, fat and moisture retention) and textural and sensory properites were evaluated in comparision to control patties. High thermal stability was recorded in GE (93%), also creaming stability results showed that GE protected its stability without any turbidity and separation of the layer. The complete replacement of beef fat with GE showed detrimental effect on all investigated cooking characteristics except fat retention. Replacement of beef fat with GE at a level of 50% resulted similar cooking characteristics with C samples. Color parameters of samples were affected by GE addition, higher CIE $b^*$ values observed with respect to GE concentration. The presence of GE significantly affected textural behaviors of samples (p<0.05). Our results showed that GE prepared with inulin and olive oil is a viable fat replacer for the manufacture of chicken patty.

• 대한의용생체공학회:의공학회지
• /
• 제30권6호
• /
• pp.521-528
• /
• 2009

This study is about to evaluation of postural stability according to characteristics of electrical stimulation on the ankle muscles. We measured body sway(center of pressure, COP) when various parameters of electrical stimulation was applied to ankle muscles in stable and unstable posture. Subjects consisted of 10 young adults, and electrical stimulation was delivered on right and left of tibialis anterior and Achilles tendon. The body sway was measured during electrical stimulation of three duty cycle and frequencies in stable posture and three amplitudes of sensory threshold in unstable posture. Consequently, the COP Shift is higher during electrical stimulation of 1/30(duty ratio) and 100Hz(frequency) in stable posture. In unstable posture, 100% amplitude of sensory threshold induced postural stability. These findings are important for the rehabilitation system of postural stability and the use of electrical stimulation as somatosensory information.

• Journal of Mechanical Science and Technology
• /
• 제20권6호
• /
• pp.874-881
• /
• 2006

Combustion stability characteristics in actual full-scale combustion chamber of a rocket engine are investigated by experimental tests with the model (sub-scale) chamber. The present hot-fire tests adopt the combustion chamber with three configurations of triplet impinging-jet injectors such as F-O-O-F, F-O-F, and O-F-O configurations. Combustion stability bound-aries are obtained and presented by the parameters of combustion-chamber pressure and mixture (oxidizer/fuel) ratio. From the experimental tests, two instability regions are observed and the pressure oscillations have the similar patterns irrespective of injector configuration. But, the O-F-O injector configuration shows broader upper-instability region than the other configurations. To verify the instability mechanism for the lower and upper instability regions, air-purge acoustic test is conducted and the photograph or the flames is taken. As a result, it is found that the pressure oscillations in the two regions can be characterized by the first impinging point of hydraulic jets and pre-blowout combustion, respectively.

• 한국소음진동공학회논문집
• /
• 제21권6호
• /
• pp.562-569
• /
• 2011

In this study linear and nonlinear dynamic stability characteristics of a medium-size high-speed turbocharger, whose rotor is supported by two 3-lobe journal bearings, are analyzed to evaluate and identify the effects of its bearing design variables. The rotor has the rated speed of 40,500 rpm and maximum continuous speed of 45,000 rpm. At first, utilizing the linear stability analysis method, bearing designs of yielding stable or unstable LogDecs as small as possible are searched by manipulating with machined bearing clearances and preloads. As next, utilizing the nonlinear analysis method, limit cycles of the rotor responses at the rated and maximum continuous speeds are simulated to check their acceptances. Results have shown that for the turbocharger rotor-bearing system considered, the 3-lobe journal bearing design with a smaller machined clearance and a larger preload are preferred for the stable rotor responses. More importantly, since there exists a good correlation between the linear and nonlinear stability analysis results, it is concluded that firstly the linear stability analysis method may be applied to screen quickly the ranges of bearing designs for stable or least unstable solutions and then, lastly the nonlinear stability analysis method may be deployed to check an absolute motion stability in terms of the limit cycle.

• Ecology and Resilient Infrastructure
• /
• 제6권4호
• /
• pp.314-327
• /
• 2019

본 연구에서는 본 연구에서는 2차원 수치모형을 적용하여 수제설치에 의한 흐름특성을 분석하고, 하도의 안정성을 평가할 수 있는 평가방법을 개발하였다. 2차원 수치모형의 결과는 관측자료와 1차원 모형의 결과와 비교하여, 그 적용성을 검토하였다. 평가 지표는 대상구간의 수리 및 지형학적 특성을 고려하여 하폭 대 수심의 비, 사행도, 하상경사, 하안 부근에서 유속, Shields number 등 5가지 항목으로 구성하였다. 낙동강의 달성보~강정고령보 구간의 수제 설치 전·후에 대해 평가지표를 적용하여 하도 안정성을 평가하였다. 평가 항목 중에서 하폭 대 수심의 비, 사행도, 하상경사는 하도의 안정성에 영향을 크게 주지 않는 것으로 평가되었다. 양안 부근에서 유속과 유사의 이동 특성을 결정하는 무차원 소류력인 Shields Number는 수제에 의하여 영향을 받으며, 수제의 수가 증가할수록 평가 값은 감소하고, 하안의 안정성은 증가하였다.

• 한국항공우주학회지
• /
• 제37권11호
• /
• pp.1055-1065
• /
• 2009

경계층 안정성 방정식인 PSE를 이용하여 익형 표면에 형성되는 경계층의 안정성 해석을 수행하였다. 압축성 비점성 유동 해석으로 경계층 가장자리 조건을 얻고, 일반좌표계에서의 압축성 경계층 방정식을 4차 정확도로 계산하여 층류 경계층 유동장을 얻었다. 층류 경계층 데이터를 PSE의 입력으로 하여 안정성 해석을 수행하고 교란의 증폭률을 얻어 안정성 특성을 고찰 하였다. 마하수 0.5의 NACA0012 및 HSNLF(1)-0213 익형에 대한 해석을 수행하여 교란 주파수에 따른 증폭률 및 위치에 따른 교란의 진폭 분포 특성을 파악하였다. 익형의 윗면과 아랫면에서 받음각에 따른 안정성 특성을 각각 증폭률의 크기와 주파수 범위에 대해 분석하였다. 또한 중립안정성 곡선, 마하수에 따른 안정성 특성을 살펴보았으며 익형의 종류에 따른 안정성 특성 차이를 분석하였다.

• 대한원격탐사학회지
• /
• 제18권1호
• /
• pp.1-12
• /
• 2002

Landslide prediction modeling has been regarded as one of the important environmental applications in GIS. While, landslide stability in a certain area as collateral process for prediction modeling can be characterized by DEM-based hydrological features such as flow-direction, flow-accumulation, flow-length, wetness index, and so forth. In this study, Slope-Area plot methodology followed by stability index mapping with these hydrological variables is firstly performed for stability analysis with actual landslide occurrences at Boeun area, Korea, and then Landslide prediction modeling based on likelihood ratio model for landslide potential mapping is carried out; in addition, KOMPSAT EOC imagery is used to detect the locations and scalped scale of Landslide occurrences. These two tasks are independently processed for preparation of unbiased criteria, and then results of those are qualitatively compared. As results of this case study, land stability analysis based on DEM-based hydrological variables directly reflects terrain characteristics; however, the results in the form of land stability map by landslide prediction model are not fully matched with those of hydrologic landslide analysis due to the heuristic scheme based on location of existed landslide occurrences within prediction approach, especially zones of not-investigated occurrences. Therefore, it is expected that the resets on the space-robustness of landslide prediction models in conjunction with DEM-based landslide stability analysis can be effectively utilized to search out unrevealed or hidden landslide occurrences.

• 전력전자학회논문지
• /
• 제4권4호
• /
• pp.368-376
• /
• 1999

본 논문은, 대표적인 FACTS기기중의 하나인 싸이리스터제어 병렬보상기의 특성 연구를 수행한다. 이를 위하여 푸리에 공간에서 전력조류 조건을 만족하는 싸이리스터 점호각을 수치해석적으로 구하고, 그 계산 결과를 이용하여 정상상태 및 고조파 특성을 해석하였다. 그리고, Poincare Mapping 이론을 이용한 스위칭 주파수영역에서 안정도 해석과 EMTP 시뮬레이션을 이용한 시평면상에서 해석결과의 검증 및 여러 운전점에서 과도응답특성의 비교연구를 수행하였다.