• Journal of the Korean Geotechnical Society
• /
• v.23 no.8
• /
• pp.87-95
• /
• 2007

This study analyzed ground settlement and ground stress depending on tunnel excavation and the ground reinforcing grouting methods for double line road tunnel through deep weathered zone. Diameter of double line road tunnel was approximately 12m and umbrella arch method and side wall reinforcing grouting were applied. The ring-cut split excavation method and CD-cut excavation method for excavation method were applied. Analyses of failure rate and vertical stress ratio show that the tunnel for which the height of the cover (H) was higher than four times the diameter, can be considered a deep tunnel. Comparisons of various excavation and ground reinforcement methods showed that CD-cut method results in lower surface and crown settlement, and lower failure rate than that obtained by Ring-cut split method. In addition, the side wall reinforcing grouting resulted in reduction of tunnel displacement and settlement.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.3 no.2
• /
• pp.25-30
• /
• 2010

In this paper, a novel notch resonator is proposed based on Rectanglar Split Ring Resonator (R-RSS) element. We represented the electrical characteristics for R-SRR elements coupled with microstrip line, and measured result is compared with electromagnetic simulation (HFSS) result. We also solved equivalent circuit for R-SRR element, and also discussed influences of change structural parameters of R-SRR. the size of R-SRR is the most important parameters for frequency tuning. Also we can make tunable resonator form the basic structure. This novel resonator can apply to design of tunable bandpass filter and voltage control oscillator.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.62 no.8
• /
• pp.1053-1058
• /
• 2013

Because of computational burden and complex topology of substation, a transmission overload relief using circuit-breaker switching was very complex and difficult. However, a on-line algorithm for reducing the overloads in transmission lines has made progress due to the advance of IT technology. This paper describes the methodology for alleviating the overloads in transmission lines by circuit-breaker switching. First, the severe contingency lists and substations were selected from the results of contingency analysis. Then the switch combinations are determined using circuit-breakers of the selected substation. The topology changes are limited to equipment outage, bus split, island split, bus merge and island merge. Finally, the fast screening and full analysis methods are used to analyze the overload in transmission lines. To verify the performance of the proposed methodology, we performed a comprehensive test for both test system and large-scale power systems. The results of these tests showed that the proposed methodology can accurately alleviate the overloads in transmission lines from online data and can be applied to on-line applications.

• The Journal of the Acoustical Society of Korea
• /
• v.21 no.2
• /
• pp.167-172
• /
• 2002

The EVRC (Enhanced Variable Rate Codec) is currently in service as a speech cosec in digital cellular systems in North America and Korea. In the EVRC, the LSP (Line Spectral Pairs) related to energy distribution of speech signals in the frequency domain are coded by weighted split vector quantization. Considering that the LSP codebooks might be trained with the language of the develop country of the codebooks or English, it is expected that codebooks trained with Korean provide the performance improvements in the communication in Korean. In this paper, the EVRC LSP codebooks are designed with korean adopting the LBG algorithm based vector quantization, and the performance improvement of the vector quantization and the accompanying speech quality improvement are demonstrated by spectral distortion, SNR and SegSNR measurements, respectively.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.26 no.3
• /
• pp.43-53
• /
• 2022

In this study, analysis of the flow characteristics of pintle-controlled nozzle with split-line TVC system and the thrust performance prediction was performed. The numerical computation was verified by comparing the thrust coefficient derived from the analysis results with the experimental data. By applying the same numerical analysis technique, the flow characteristics of nozzle were confirmed according to operating altitude, pintle stroke position and TVC angle with the 1/10 scale. As the TVC angle increased, thrust loss occurred and the tendency of AF was different depending on the position of the pintle stroke. Based on the analysis results, the relation of thrust coefficient was derived by applying the response surface methods. The thrust performance model with a slight difference of 1.2% on average from the analysis result was generated.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.35 no.6
• /
• pp.1329-1338
• /
• 2015

This article aims to develop model for the right policy Tools available from the cause analysis regarding the regional differences of subway modal split in Seoul metropolitan area. This allows two major factors of the most influential subway modal split to be proved and Portfolio Analysis is conducted. The results are as follows. Firstly, the two primary factors affecting subway modal split were shown as subway adjacent area and local line bus. It signifies that expansion of subway adjacent area, establishing the number of the subway stations and increase of local line bus are required in order to improve a diminishing subway modal split. Following that, pattern of the improvement to strengthen better subway connections are classified according to the two areas which are Concentration Area of Improvement in Subway Station Area (CAISSA) and Concentration Area of Improvement in Local Bus (CAILB). Our study revealed that Ganbukgu, Seodaemungu, Geumcheongu, and Gwanakgu were selected as the area of CAILB and Songpagu, and Junggu were selected as the area of CAISSA. As all things are considered, transportation policy makers should be taken into account in the two main factors driven by our study according to types in order to enhance the future subway share proportion.

• The Journal of Korea Robotics Society
• /
• v.9 no.3
• /
• pp.140-146
• /
• 2014

This paper introduces a dual-arm robot painter system which is capable of sketching a camera-captured image with short line segments. To express various curved edges in the image by combining line segments, we first apply edge detection algorithm to the entire image, split the edged image into small boxed pieces, and then apply Hough Transformation to each piece so that the edges inside the piece can be approximated with short line segments. To draw the picture within a reasonable time, we designed a simple dual-arm robot system and controlled both arms concurrently according to linear interpolation algorithm. From the experiments, we could verify that simple linear motions can describe various images effectively with a unique brush style.

• Proceedings of the IEEK Conference
• /
• 2003.11a
• /
• pp.31-34
• /
• 2003

In this paper, we describe a method for separating text lines in handwritten Korean address images. The most remarkable feature of the proposed method is to use a modified projection technique. named a partial projection technique. A projection based text line separation method which projects the whole address image in horizontal direction to find split points for text line separation cannot avoid failing separation in case of images with a little skew or overlap between vertically neighboring text lines. To overcome this problem, we have introduced a partial projection technique which splits an address image into a few partial address images to be equal width and then project them each horizontally. The experiment done with 989 handwritten Korean address images extracted from live mails shows the superiority of the proposed method. The correct text-line separation rate fir the testing images was about 91.5％.

• Current Optics and Photonics
• /
• v.4 no.6
• /
• pp.461-465
• /
• 2020

A dual-mode laser terahertz source consisting of two in-line distributed Bragg reflector (DBR) laser diodes (LD) is proposed. It is less susceptible to residual reflections from facets than an in-line dual-mode distributed feedback (DFB) LD. The characteristics of the proposed terahertz source are theoretically investigated using a split-step time-domain simulation. It is shown that terahertz waves of frequencies from 385 GHz to 1725 GHz can be generated by appropriate thermal tuning of two DBR LDs. The dual-mode DBR LD terahertz source exhibits good spectral quality for residual facet reflectivity below 0.02, but facet reflectivity of the in-line dual-mode DFB LD terahertz source should be below 0.002 to provide similar spectral quality.

• Journal of electromagnetic engineering and science
• /
• v.12 no.4
• /
• pp.240-246
• /
• 2012

This paper presents a novel modeling technique for traces that cross a defected ground structure. A simple and accurate equivalent circuit model provides clear insight into the coupling mechanism between a microstrip line and a slot or split. The circuit models consist of a transformer as the coupling mechanism and LC resonators as the ground with a slot or split structure. Resistors, capacitors, and inductors are added to the model to increase accuracy and equivalence at high frequency. Simulated and measured S-parameters are presented for defected ground structures. The accuracy and validity of the proposed equivalent circuit model is verified by evaluation of the S-parameter characteristics of the defected ground structures and comparison with measured results.