• Bulletin of the Korean Chemical Society
• /
• v.12 no.6
• /
• pp.705-708
• /
• 1991

Novel polysilamethylenosilanes (PSMS) were prepared by Wurtz type co-condensation of various mixtures of 2,4,4,6-tetrachloro-2,6-dimethyl-2,4,6-trisilahept ane (TSH) and dimethyldichlorosilane (D). When TSH was incorporated more than 25 mole%, PSMS polymers were soluble in common organic solvents probably due to the polycarbosilane linkage brought from TSH. The molecular weights of the polymer were measured by gel permeation chromatography and showed higher molecular weight with high TSH content. The thermal gravimetric residues increased as TSH contents increased. These properties suggested that PSMS polymers could be useful as ceramic precursors for silicon carbide.

• Journal of Integrative Natural Science
• /
• v.2 no.4
• /
• pp.289-292
• /
• 2009

Perchlorosilanes are useful precursors for the synthesis of hydrosilanes for the fabrication of electronic devices such as silicon thin-film transistors and silicon nanoparticles. For this solution process, requirements of precursors applicable to solution process are relatively low volatile and soluble in common organic solvents. In this work, the decaphenylcyclopentasilane has been obtained from the reaction of the lithium wire and dichlorodiphenylsilane. The reaction of decaphenylcyclopentasilane with lewis acid catalyst, HCl/$AlCl_3$, gives the perchlorocyclopentasilane. Decaphenylcyclopentasilane exhibits an unusual optical property. Its optical property was characterized by UV-vis and fluorescence spectroscopy. Absorption wavelength maxima for the decaphenylcyclopentasilane was 272 nm. Decaphenylcyclopentasilane displayed an emission band at 741 nm with excitation wavelength of 272 nm.

• Journal of Environmental Science International
• /
• v.15 no.3
• /
• pp.211-219
• /
• 2006

An experimental study on the removal of VOCs gas using a biomembrane reactor were carried out at various inlet gas concentration, specific loading rate, retention time and gas flow rate of volume. The variations of efficiency and various parameters, which are relevant to gas removal, with mixing of soluble gas and without have been discussed. More than 95% of the toluene and methanol present in the feed was successfully removed in each study. The elimination of methanol with mixture of soluble compound of about 300 mg/h corresponds to a portion of 21% if there is a feed stream of 1400 mg/h. On the contrary the maximum efficiency of about 72% of toluene was reached. This is to be rated as a treatment of sorption that the limiting factor of the dismantling speed could be represented by this difficult degradable component. Nevertheless the elimination capacities for this reactor for toluene were on a very high level. For substances which show a very high solubility in silicon rubber an advantage of a bio membrane is clearly shown. Therefore a similarly good result is expected for n-hexane, because of its relatively good permeability which was distinguished during permeation experiments.

• Applied Chemistry for Engineering
• /
• v.26 no.6
• /
• pp.674-680
• /
• 2015

A solvent-soluble polyimide (PI) polymeric binder was synthesized by a two-step reaction for silicon (Si) anodes for lithium-ion batteries. Polyamic acid was first prepared through ring opening between two monomers, bicyclo[2,2,2]oct-7-ene-2,3,5,6-tetracarboxylic dianhydride (BCDA) and 4,4-oxydianiline (ODA), followed by condensation reaction. Using the synthesized PI polymeric binder (molecular weight = ~10,945), the coating slurry was then prepared and Si anode was fabricated. For the control system, Si anode based on polyvinylidene fluoride (PVDF, molecular weight = ~350,000) having the same constituent ratio was prepared. During precycling, PI polymeric binder revealed much improved discharge capacity ($2,167mAh\;g^{-1}$) compared to that of using PVDF polymeric binder ($1,740mAh\;g^{-1}$), while the Coulombic efficiency of two systems were similar. PI polymeric binder improved the cycle retention ability during cycles compared to that of using PVDF, which is attributed to an improved adhesion property inside Si anode diminishing the dimensional stress during Si volume changes. The adhesion property of each polymeric binder in Si anode was confirmed by surface and interfacial cutting analysis system (SAICAS) (Si anode based on PI polymeric binder = $0.217kN\;m^{-1}$ and Si anode based on PVDF polymeric binder = $0.185kN\;m^{-1}$).

• Journal of Marine Bioscience and Biotechnology
• /
• v.10 no.2
• /
• pp.34-43
• /
• 2018

Silicon has become of increasing importance as the basic element of many high-technology products. Its synthesis is very difficult requiring high temperature solid-state reactions (> $1000^{\circ}C$) or lower temperature methods ($100-200^{\circ}C$) involving hydrothermal and solvothermal reactions under extreme pH conditions. In nature, on the other hand, a wide range of living organisms have collectively evolved the means of biosilicification at the astounding rate of gigatons/year. This is impressive because biosilicification in these organisms occurs under mild physiological conditions. Marine sponges possess the ability to sequester soluble silicon sources from their environments and assemble them into intricate 3D architecture. The advent of molecular biology has recently made it possible to glean molecular information about biosilicification from these systems and it turned out that enzyme silicatein is the core of biosilicification. In this review, biosilicification regulated by silicatein and its mechanism are described. Also, production of silicatein through recombinant technology and several applications of recombinant silicatein are described including immobilization of silicatein, formation of Au or Ag nanoparticles on nanowires, nanolithography approaches, core-shell materials, encapsulation, bone replacement materials, and microstructured optical fibers.

• The Korean Journal of Pesticide Science
• /
• v.4 no.2
• /
• pp.37-43
• /
• 2000

Effects of silicon application on development of colonies of Sphaerotheca fuliginea were examined. Cucumber plants were applied with nutrient solutions amended with different concentrations of soluble silicon and selected leaves were inoculated with known concentrations of conidia of the pathogen. Colony number per leaf, colony area per leaf, and germination rate of conidia of S. fuliginea collected from the inoculated leaves were reduced as silicate concentrations in the nutrient solutions increased from 0.05 to 4.10 mM. The increase in resistance of plants to mildew infection was apparently due to silicate accumulation in leaves, and there was no correlation between cation or ionic strength effects and the silicate treatments. Silicate treatment in growth medium remarkably suppressed powdery mildew development on cucumber. Colonies of mildew fungus were visible with over approx. 38.3% of the mature leaf surface, while that of the leaves in high Si plants was 2.3% observed at 51 days after transplanting. No significant differences were observed between 1.7 mM and 3.4mM silicate treatments. Conidial germination rates were significantly reduced by increasing Si amendments. Conidial germination ranged from 14.7 to 20.3% for plants grown in low Si solution(<1.40 mM), and from 9.0 to 12.4% for plants grown in high Si solution(>1.8 mM). Foliar applications of Si with ${\geq}$ 17.0 mM decreased the number of powdery mildew colonies. Persistence of Si foliar sprays effects on cucumber demonstrated that the 17 mM Si spray applied 4 days before inoculation with S. fuliginea reduced mildew colony formation. The relationship was positive and linear.

• The Korean Journal of Pesticide Science
• /
• v.4 no.2
• /
• pp.44-49
• /
• 2000

Objective of this study was to determine the Si distribution and extent of control of powdery mildew diseases of cucumber(Cucumis sativus L.). The distribution of silicon in the leaf epidermis of cucumber plants grown in hydroponic nutrient solutions supplemented with soluble silicates was examined using scanning electron microscopy and energy dispersive X-ray analysis. The silicate absorbed from nutrient solution was translocated into cucumber leaves, and accumulated mainly in the cells surrounding the base of trichome hairs. Base cells surrounding the trichomes also had high levels of Si, Ca, and K. Si levels in the epidermal cells for low Si treatment were not detectable except in the trichome bases. Hyphal lengths of powdery mildew occurring on cucumber leaves cultivated in medium with high concentration of silicate were remarkably shorter than those of cucumber leaves cultivated with low concentration of silicate. There was a negative correlation between hyphal length of S. fuliginea and silicate concentrations.

• Journal of Bio-Environment Control
• /
• v.15 no.4
• /
• pp.322-326
• /
• 2006

This experiment has investigated the effects of silicon on albinism of strawberry. Albino fruit appeared after a month of treatment of potasium silicate(Si) in nutrient solution. When $200mL{\cdot}L^{-1}$ of Si applied, number of albino fruit increased over 90% of total amount of fruit, and the symptom remained latest any other treatment. The fruit length of the strawberries in Si treatments were longer than control treatment. However, the diameter and weight of fruit decreased in treatment of Si. The soluble solids of fruits, numbers of fruit and yield per plant were no significant differences among treatments. The rate of albino fruit was significantly increased with increase of concentration of Si. The results of this experiment will be utilized for the cultivation in the new substrate application for strawberry hydroponics.

• Korean Journal of Food Science and Technology
• /
• v.47 no.2
• /
• pp.145-148
• /
• 2015

According to the Korea Food Additives Code, sodium metasilicate is permitted for use as a filtering agent for edible oils and fats. Sodium metasilicate is currently used as a food additives to increase the weight of shark fins. In this study, we developed an analytical method to quantify sodium metasilicate in food. Sodium metasilicate content was estimated by measuring the moisture content, pH and silicon content of shark fins. Silicon content was analyzed using inductively coupled plasma-optical emission spectrometry (ICP-OES) following microwave-assisted digestion with $HNO_3$ (65%) and $H_2O_2$ (30%). Shark fin total silicon content was $7.17{\pm}8.92mg/kg$, while the soluble silicon content was $2.34{\pm}3.80mg/kg$. After soaking raw shark fin in an aqueous solution of sodium metasilicate, fin weight, pH and silicon content were measured. These results would be used as the basic information for shark fins safety management.

• Journal of Bio-Environment Control
• /
• v.26 no.4
• /
• pp.310-316
• /
• 2017

This study was analyzed the effects of boron (B), calcium (Ca), silicon (Si) on quality and shelf life of 'Unicorn' cherry tomato at the light red maturity-stage. The storage conditions were modified atmosphere packaging (MAP) by oxygen transmission rate (OTR) packaging film at $5^{\circ}C$, $11^{\circ}C$, and $24^{\circ}C$. Respiration and ethylene production were the lowest in B + Ca + Si -treated tomato fruits. The lowest fresh weight loss and the longest shelf life resulted from the B + Ca + Si treatment. And the firmness was enhanced by B + Ca + Si treatment at harvest time, and it was retained after storage at $5^{\circ}C$, $11^{\circ}C$, and $24^{\circ}C$. Significantly lower soluble solids, lycopene, and color development were found at B + Ca + Si-treated tomato fruits compared with control after storage. Moreover, the highest titratable acidity and vitamin C content were observed in B + Ca + Si-treated tomato fruits after storage. From the above results, it was concluded that B + Ca + Si combined treatment can delay the maturity of cherry tomato after harvesting, and retained the firmness and prolong the shelf life.