• 한국광물학회지
• /
• 제9권2호
• /
• pp.82-92
• /
• 1996

The coarse-grained (0.05∼0.2mm) zeolites occur as the single-crystal cement in the sandstones of the Chunbuk Formation in the Pohang area. The zeolite cements unusually consist of the composite phases of heulandite and clinoptilolite and in a crystal. The zeolite crystals show chemical zoning ranging from 3.56 to 4.10 in Si/(Al+Fe), and tend to become continuously more silicic and alkalic from the margin toward inside of the crystal. The DTA and high-temperature XRD analyses also show complex patterns of both zeolites. Such a composite crystal showing chemical zoning and complex thermo-chemical behaviors indicates that heulandite and clinoptilolite are constituting a solid solution resulted from the coupled substitution of K+Si4+=Ca2+Al3+.

• 한국광물학회지
• /
• 제1권1호
• /
• pp.63-69
• /
• 1988

Chondrodite form the Wondong mine, Korea, which is the first occurrence from the southern Korea, has been studied for its mineralogical characterization. It occurs in close association with penninite, phlogopite, diopside and garnet within the magnetite ore bodies, which are debeloped along the contact of the Hwajeol Formation and rhyolite. Two kinds of chondrodites are recognized by their different optical properties; the high birefringent untwinned one and the low birefringent twinned one. The former has slightly higher Mn content than the latter. Twinning in chondrodite has been formed in close relation to substitution Mg (Fe, Mn) in the humite solid solution, as evidenced by the chemical variation across the twin lamallae.

• E2M - 전기 전자와 첨단 소재
• /
• 제9권10호
• /
• pp.1040-1046
• /
• 1996

Low voltage phosphor, ZnGa$_{2}$O$_{4}$:Mn, was synthesized and sintered at the high temperature in Ar or vacuum. By XRD analysis, it is confirmed that poly crystalline ZnGa$_{2}$O$_{4}$:Mn solid solution was formed. From EPMA analysis of the samples prepared in Ar and vacuum, the change of oxygen content was investigated and as a result, it was observed that the oxygen amounts were reduced in ZnGa$_{2}$O$_{4}$:Mn prepared in vacuum. It caused the deficiency in oxygen amounts in the phosphor and then consequently, it results in the formation of the energy level near 513 nm. It contributes to the improvement of the brightness of ZnGa$_{2}$O$_{4}$:Mn.

• The Korean Journal of Ceramics
• /
• 제6권4호
• /
• pp.370-379
• /
• 2000

Simple ways to build up mixed-metal molecules which can act as potential single-source precursors to multimetallic oxides are reviewed. Emphasis is given to Lewis acid-base reactions between metal alkoxides M(OR)/sub n/, and between metal alkoxides and more accessible oxide precursors, carboxylates M(O₂CR)/sub n/ and β-diketonates M(β-dik)/sub n/. Characterization of the precursors is achieved in the solid state (single crystal X-ray diffraction, FT-IR) and by multinuclear NMR in solution. The reactions proceed toward the formation of aggregates in which the different metals display their usual coordinations numbers, often six for transition metals, as shown. Strategies for fixing the stoichiometry between the metals are developed. The reactivity of the MM species (dissociation, effects of chemical modifiers, of other metallic species, hydrolytic or non-hydrolytic condensation, etc.) will be indicated. Transformations into oxides are illustrated on precursors for titanates or niobates.

• Bulletin of the Korean Chemical Society
• /
• 제18권1호
• /
• pp.44-50
• /
• 1997

A method of dual-signal generation from two different enzymes was developed and utilized to simultaneously perform dual immunoassays in a single microwell. Two enzymes selected as tracers were horseradish peroxidase (HRP) and β-galactosidase (GAL). 3, 3', 5, 5'-Tetramethylbenzidine (TMB) and chlorophenolred-β-galactopyranoside (CPRG) as chromogenic substrates for the respective enzyme were used. Although the two enzymes showed their maximum activities at distinct pH conditions (pH 5.1 for HRP and 7.5 for GAL), the enzyme reactions were able to be concurrently carried out at pH 5.75 in a dual-substrate solution without signal loss. This performance was achieved by increasing TMB concentration two-fold, introducing potassium salt as activator of GAL reaction, and extending total reaction time 50%. The signal generation method was then used for dual-enzyme immunoassays to detect antibodies with co-immobilized Hepatitis C virus antigens (core and NS5) and a Hepatitis B virus antigen (PreS(2)) in a microwell. Dose-response curves of the assays revealed cooperativity between different antigen-antibody complex formation, which suggested that dual immunoassays can only be used for qualitative screening tests unless the antigens immobilized were spatially separated.

• Bulletin of the Korean Chemical Society
• /
• 제7권5호
• /
• pp.353-357
• /
• 1986

Mutual miscibility between thermotropic, nematic compounds with two terminal mesogenic units and a central spacer was studied by differential scanning calorimetry (DSC) and on a polarizing microscope. It was found that the isomorphous, nematic dimesogenic compounds with wide variety of structures are miscible in mesophases with each other over the whole range of composition and that Schroder-van Laar equation almost correctly predicts the melting temperature and composition of eutectic mixtures. There was a pair of compounds which were exceptional and did not form a eutectic mixture and, instead, revealed a monotonous change in melting (T$_{m}$) and isotropic transition temperatures (T$_{i}$) as the composition of the mixture was varied. The compounds were of almost same structure in shape and seemed to undergo formation of solid solution.

• 신재생에너지
• /
• 제19권1호
• /
• pp.1-11
• /
• 2023

A large amount of carbon monoxide (CO) is generated in circulating fluidized bed combustion, the process whereby a hot cyclone separates unburned fuel. However, calcium sulfate (CaSO₄), when combined with a high CO content, can cause fouling on the surface of the steam tube installed inside the integrated recycle heat exchangers (INTREX). In this study, CaSO₄ decomposition was investigated using 0.2-3.2 vol.% CO and 1-3 vol.% oxygen (O₂) at 850℃ for 20 min in a lab-scale fluidized bed reactor. The results show that CaSO₄ decomposes into CaS and CaO when CO gas is supplied, and SO₂ emissions increase from 135 ppm to 1021 ppm with increasing CO concentration. However, the O₂ supply delayed SO₂ emissions because the reaction between CO and O₂ is faster than that of CaSO₄; nevertheless, when supplied with CaCO₃, the intermediate product, SO₂ was significantly released, regardless of the CO and O₂ supply. In addition, agglomerated solids and yellow sulfur power were observed after solid recovery, and the reactor distributor was corroded. Consequently, a sufficient O₂ supply is important and can prevent fouling formation on the INTREX surface by suppressing CaSO₄ degradation.

• Journal of Magnetics
• /
• 제14권3호
• /
• pp.120-123
• /
• 2009

In this study, BiFe$O_3$-BaTi$O_3$ ceramics have been fabricated by a solid-state reaction method. The effects of BaTi$O_3$ content in the (1-x)BiFe$O_3$-xBaTi$O_3$ (x = 0.1, 0.2, 0.25, 0.3, 0.4, 0.5) system on crystal structure and magnetic, dielectric, and ferroelectric properties were investigated. Perovskite BiFe$O_3$ was stabilized through the formation of a solid solution with BaTi$O_3$. Rhombohedrally distorted structure (1-x)BiFe$O_3$-xBaTi$O_3$ ceramics showed strong ferromagnetism at x = 0.5. Dielectric and ferroelectric properties of the BiFe$O_3$-BaTi$O_3$ system also changed significantly upon addition of BaTi$O_3$. It was found that the maximum dielectric and ferroelectric properties were exhibited in the (1-x)BiFe$O_3$-xBaTi$O_3$ system at x = 0.25. This suggested the morphotropic phase boundary (MPB) with the coexistence of both rhombohedral and cubic phases of the (1-x)BiFe$O_3$-xBaTi$O_3$ system at x = 0.25.

• Macromolecular Research
• /
• 제17권11호
• /
• pp.856-862
• /
• 2009

This study examined the effects of liquid and solid additives on the morphological, mechanical and thermal insulating properties of rigid polyurethane foams (PUFs). The PUFs synthesized with tetramethylsilane (TEMS) as a liquid-type additive showed a smaller average cell size and lower thermal conductivity than those with the aerosil 200 and clay 30B as solid-type additives. When TEMS was added, the average cell size of the PUF became more uniform and finer due to the reduced surface tension of the polymer solution, which increased the nucleation rate and number of bubbles produced and reduced cell size. The PUFs with TEMS showed the highest closed cell contents among the PUFs prepared using TEMS, aerosil 200 and clay 30B. This suggests that the insulation properties of PUF can be determined by both the size of the cell structure and the amount of closed cell contents in the system. The compression and flexural strengths of the PUF increased slightly when the aerosil 200, clay 30B and TEMS were added compared those of the neat PUF. The reaction profiles of the PUFs showed a similar gel and tack tree time with the reaction time among the PUFs synthesized with three different additives and neat PUF. This suggests that the nucleating additives used in this study do not affect the bubble growth of the chemical reaction, and the additives may act as nucleating agents during the formation of PUF. From the above results of the cell size, thermal conductivity, closed cell contents and reaction profile of the PUFs, liquid-type nucleating agent, such as TEMS, is more effective in decreasing the thermal conductivity of the PUF than solid-type nucleating agent, such as aerosil 200 and clay 30B.

• Journal of Electrochemical Science and Technology
• /
• 제13권3호
• /
• pp.407-415
• /
• 2022

Surface coating of cathodes is an essential process for all-solid-state batteries (ASSBs) based on sulfide electrolytes as it efficiently suppresses interfacial reactions between oxide cathodes and sulfide electrolytes. Based on computational calculations, Li₃PO₄ has been suggested as a promising coating material because of its higher stability with sulfides and its optimal ionic conductivity. However, it has hardly been applied to the coating of ASSBs due to the absence of a suitable coating process, including the selection of source material that is compatible with ASSBs. In this study, polyphosphoric acid (PPA) and (NH₄)₂HPO₄ were used as source materials for preparing a Li₃PO₄ coating for ASSBs, and the properties of the coating layer and coated cathodes were compared. The Li₃PO₄ layer fabricated using the (NH₄)₂HPO₄ source was rough and inhomogeneous, which is not suitable for the protection of the cathodes. Moreover, the water-based coating solution with the (NH₄)₂HPO₄ source can deteriorate the electrochemical performance of high-Ni cathodes that are vulnerable to water. In contrast, when an alcohol-based solvent was used, the PPA source enabled the formation of a thin and homogeneous coating layer on the cathode surface. As a consequence, the ASSBs containing the Li₃PO₄-coated cathode prepared by the PPA source exhibited significantly enhanced discharge and rate capabilities compared to ASSBs containing a pristine cathode or Li₃PO₄-coated cathode prepared by the (NH₄)₂HPO₄ source.