• Geophysics and Geophysical Exploration
• /
• v.6 no.3
• /
• pp.119-125
• /
• 2003

The small-loop electromagnetic (EM) technique has been used successfully for many geophysical investigations, particularly for shallow engineering and environmental surveys. In conventional small loop EM operating at small induction numbers, geometric sounding has been widely used because the depth of penetration of EM energy depends only on the source-receiver separation. Recently developed small loop EM system, however, measures the secondary magnetic field, $H^S$, at multiple frequencies with a fixed source-receiver separation and frequency sounding is tried actively. In this study, we analyzed the behavior of in-phase and quadrature components of ${H^S}_z$, for horizonal coplanar (HCP) configuration over two-layer models. Through this theoretical analysis, it was found that the in-phase component of ${H^S}_z$ is more suitable for frequency sounding than the quadrature component. But, the in-phase component of ${H^S}_z$ is too small to measure, especially in resistive and noisy environment like Korea. Using the fact that the quadrature component is much greater than the in-phase component and the difference of quadrature component of ${H^S}_z$ measured at two frequencies shows the same behavoir as the in-phase component, we suggested an alternative frequency sounding technique. Also, we defined an apparent conductivity, which reflects well the conductivity of subsurface layers.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.4
• /
• pp.564-581
• /
• 1999

This paper introduces a new, small, low cost, robust and quick replaceable pavement-based vehicle detector using CW radar, magnetometer, and UHF small antennal techniques. The detector has been developed for a replacement of loop detectors having wide surface areas, for a more accurate operation under all weather conditions, and for no algorithmic change of the existing traffic information system. The detected vehicle information is sent by a small helical antenna embedded in a plastic material and received by a 5/8 $\lambda$ long GP antenna for signal processing. In a relatively good weather condition, the detector operates at 24 GHz. But in a heavy rain condition, magnetometer is activated by automatic switching.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.2
• /
• pp.163-169
• /
• 2016

In this paper, we miniaturized the loop and coil in magnetic resonance wireless power transfer(MR-WPT) system for application to the small mobile device. The proposed disk type double coil resonator was designed to cause resonance at 6.87 MHz. It is composed of thin copper on both-side of acrylic substrate structured 2 mm width, 1 mm pitch and 8 turns. The outer radius of spiral coil pattern is 9 cm. And the proposed loop was made of the copper wire 5 mm diameter of cross-section. The size of loop is 10 cm diameter. For resonance at 6.87 MHz, the capacitor with 3,300 pF was connected in series on the loop. We rearranged the resonators and organized several WPT systems which is rearranged by resonators. The highest transfer efficiency of miniaturized WPT system was 35.67 %. This proposed design of spiral double coil will contribute to make resonator smaller for appling small and thin mobile device.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2001.11a
• /
• pp.239-242
• /
• 2001

본 논문에서는 self-bias 구조를 갖는 소 신호 증폭기에 대해 논의된다 주파수 영역은 ISM band (Industria1/Scientific/Medical band) 인 무선 랜 (WLL : Wireless Local Loop) 대역 5.8GHz 에서 설계하였다. 제시된 self-bias 구조는 단일 전원만을 사용한다는 장점을 가지고 있으며 입력 단에서 RFC (λ/4 전송선로)를 제거하고 매칭 회로에서 단락 스터브를 사용함으로 구조를 간단히 하였다. 이러한 bias조건에서 FET의 이득은 11dB이고 회로 설계 후 측정 결과는 입력 반사 손실 -16.455dB, 이득은 8.095dB이다. 이 소 신호 증폭기는 간단한 구조로 구현된 장점 뿐 만 아니라 무선 랜 분야에서도 충분히 응용 될 수 있으리라 기대된다.

• Journal of electromagnetic engineering and science
• /
• v.14 no.3
• /
• pp.317-319
• /
• 2014

In this letter, a small-loop antenna for a mobile UHF RFID device is proposed. To achieve size reduction, a ferrite sheet optimized for a 900 MHz band is applied. The overall dimensions of the antenna are $46mm{\times}35mm{\times}0.24mm$, and it has a bandwidth of 45 MHz with a return loss of less than -6 dB. The proposed antenna satisfies near and far field UHF EPC global frequency band communications (902-928 MHz).

• 한국지구물리탐사학회:학술대회논문집
• /
• 2008.10a
• /
• pp.37-40
• /
• 2008

We have measured resistivities for undisturbed soil samples collected from dredged bank with sea sand, and analyzed with one-dimensional inversion results from small-loop electromagnetic survey data. From the relationship between the two resistivities, it appeared that calculated resistivities were remarkably consistent with measured resistivities. Correlation relationships between resistivity values and cone resistance were analyzed after comparing inversion results with cone resistance. It turns out that the region with below 1 ohm-m is correspondent to that of with less than $50\;kgf/cm^2$ in dredged bank with sea sand. From the study result, resistivity monitoring of small-loop EM periodically is proved to be more effective to maintain the stability of embankment dike.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.5
• /
• pp.551-558
• /
• 2012

This paper presents a dual band loop-type ground antenna using lumped-elements that control the impedance bandwidth and resonant frequency. The dual-band operation of the proposed antenna is realized by inserting an additional resonated loop feed structure into the reference ground antenna. As the proper value of the capacitor and the inductor are chosen, the impedance bandwidth of our antenna with voltage standing wave ratio(VSWR) equal to 3 is 85 MHz and 725 MHz at the 2.45 and 5.5 GHz frequency band, respectively. Its validity is demonstrated via both the computed and measured results. Good antenna patterns and efficiencies are achieved at the dual frequency bands, as well as the physically small antenna element size($10{\times}5mm^2$).

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.12
• /
• pp.1325-1332
• /
• 2009

In this paper, we design a 2.4 GHz bio-radar system that can detect human heartbeat and respiration signals with small size and improved noise performance using single circular-polarized antenna and phase-locked loop. The demonstrated bio-radar system consists of single circular-polarized antenna with $90^{\circ}$ hybrid, low-noise amplifier, power amplifier, voltage-controlled oscillator with phase-locked loop circuits, quadrature demodulator and analog circuits. To realize compact size, the printed annular ring stacked microstrip antenna is integrated on the transceiver circuits, so its dimension is just $40\times40mm^2$. Also, to improve signal-to-noise-ratio performance by phase noise due to transmitter leakage signal, the phase-locked loop circuit is used. The measured results show that the heart rate and respiration accuracy was found to be very high for the distance of 50 cm without the additional digital signal processing.

• Journal of the Korea Convergence Society
• /
• v.6 no.5
• /
• pp.9-14
• /
• 2015

In this paper, we analysis the electromagnetic scattering of an arbitrary shape dielectric cube subjected to plane wave incidence in three dimensions. MoM(Method of Moments)in which a surface of a body is divided with small triangular patches and equivalence principle are used to fuse the PMCHW(Poggio, Miller, Chang, Harrington, and Wu) Integral Equations with respect to equivalent currents on a dielectric body. Triangular patch and loop-patch basis functions that is robust in wide frequency ranges are used for MoM formulations. Proposed method is very useful to analysis the induced current of arbitrary dielectric bodies and numerical results for a dielectric cube are presented.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.4
• /
• pp.285-289
• /
• 2009

Small RFID tag antenna were fabricated on Si substrate and their physical and electrical properties were evaluated. With decreasing the size of tag antenna on Si substrate, small SMD-type RFID tags could be fabricated, which is very useful for various applications including PCB tracking. Firstly, electromagnetic properties on tag antenna pattern were simulated with HFSS. The setup frequency was 13.56 MHz of HF-band RFID. The line-width and line-gap were modeled in the range of $50{\sim}200{\mu}m$. S parameters, SRF, and Q value were calculated from the model. When the line-width and line-gap were 100 urn and the loop-turn was 10, the SRF was 80 MHz and the Q value was ca. 9. When the microstrip antenna pattern of aluminum was fabricated by using DC sputtering, Vpp of ca. 1.6 V was obtained when the reader-tag distance was 40 mm.