• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.11a
• /
• pp.127-134
• /
• 2000

Soil nailing is in-situ ground improvement technique of reinforcing soils using passive inclusions for the purpose of slope stability. Also soil nailing, in general, was used and studied as a reinforcement technique at cut slope, but this paper presents the results of study for soil nailing application as a reinforcement technique at the banking over slided slope. In-situ pull-out tests of nails, instrumented with strain gauges, were performed to investigate the maximum pull-out load and to calculate the unit side resistance in each different layer. And the apparent average unit side resistance of this study was compared with that of other sites installed at cut slope.

• The Journal of Engineering Geology
• /
• v.15 no.2 s.42
• /
• pp.105-121
• /
• 2005

Most of the landslides triggered by intensive rainfall on natural slope occur serious damages of human beings and properties. There have been many landslides since 1991 in Gyeonggi province. The influential factors are rainfall, topography, geology and soil properties. There were 660 landslides occurred by intensive rainfall as much as 250mm at Yongin and Anseong area from Tuly 19th to luly 21st,1991 This study surveyed location, topography, geology, geometry of the landslide and rainfall at the area and analyzed occurrence characteristics of the landslides. Most of the landslides occurred on the soil layer above the bed rock. They showed changes of landslide types from translational slides at the head part to flow at the central part. The landslides have relatively small magnitude of which length is shorter than 50m. In order to identify characteristics of landslides dependent on soil conditions, geotechnical properties of soil were evaluated by laboratory tests using soil samples which were collected on slided area and not-slided area. Soil properties of the slided area show high percentage of coarse material such as gravel and sand. However, soil of the not-slided area is mainly composed of fine material such as silt and clay. Permeability coefficients of the slided area are higher than those of the not-slided area.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2006.03a
• /
• pp.51-60
• /
• 2006

At new constructing national road, a cutting slope was surveyed and gotten face mapping for three months. The slope is composed of gray phyllite and coaly slate which is the Chang-ri Formation, Okcheon system. The slope angle is 40 degree and the direction is NNE. The attitude of schistosity is $260^{\circ}/45^{\circ}$. So the slope direction is nearly parallel to the schistosity. This is the reason that the slope is very unstable. On the other hand, the very unstable slope is caused by the direction of the schistosity and the slope. First month the coaly slate was slided through the schistosity plane about 10cm. However, three months late the displacement was 2m maximum.

• Journal of the Korean Professional Engineers Association
• /
• v.17 no.3
• /
• pp.6-21
• /
• 1984

A rock slide in amount of 100 tons in weight happened at 7: 10 a.m., 4th October 1982, on the southwestern ridge of Mt. Seunghag, Busan City. The original rock mass of the rock slide is located 850m west from the Dangri Crushed Stone Quarry. The geology of the area consists of agglomerate, andesite, andesitic tuff, and shale hornfels of the Cretaceous Yucheon Group. The rock blocks were first shifted along the steep joint plane on an andesite outcrop at the site and then to the eastern foot of the mountain slope where some private houses are placed. The mountain slope is covered with thick superficial soil. A slided monolithic-block with 83 tons in weight from the rock slide met with an accident of striking against a house with a tremendous force, to which much damage was done as much as its half was destroyed. The rock-slided block pierced the board-floored room only posited at the center and by the bedroom of the house making a pass like a bullet hole, and hence cut a big pine tree with 24 centimeters in diameter at a distance of 26 meters down the house. However nobody was killed or injured in the stricken house, though seven family members were stayed therein at the very time of accident. They really met a rare opportunity in an unhappy disaster. Measurements of the rock slide were made in the course of the field survey. The monolithic mass was transported by way of saltation, rolling, and sliding to a distance of 300 meters down along the slope dipping 30$^{\circ}$ east. It took about 16 seconds front tile outcrop to the terminal. The acceleration value of the monolithic rock slide is 2.35m/sec$^2$.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2009.09a
• /
• pp.677-694
• /
• 2009

While the budget has been allocated more for repairs and reinforcements, casualties are gradually increased due to slope disaster. Slope disaster causes road damaged as well as casualties. It also causes significant social and economic loss. The measurement device, which is installed inside ground of slope like inclinometer, has the high loss rate when slope is being slided. The electric type and the vibrating wire type have low durability because of corrosion. To cover the demerit of the present slope monitoring, the measurement method using the Multi-Antenna GPS has been developed. The Multi-Antenna GPS has been installed in the local slope as the regular monitoring system for slope. Although the initial cost of the Multi-Antenna GPS for installation is high, the additional cost is low. So it is the suitable method for large slope. The regular monitoring system using the Multi-Antenna GPS is the suitable measurement method for watching slope collapse, which is occurred widely, because it is economical, has high durability, and collects data with high resolution.

• Journal of the Korean Geotechnical Society
• /
• v.22 no.5
• /
• pp.83-91
• /
• 2006

Recently, the intensive rainstorm possibly induced by global warming plays a key role on the instability of railway adjacent slopes. The instability of slopes results as covering and loss of railway lines induced by slided soil mass. According to the site investigation on the failed slopes triggered by rainfall, low types of slope failure were observed: shallow, intermediate, gully erosion, and soil-rock interface failures. The observation reveals the different characteristics of slope failure depending on the thickness of soil layer, morphological features of slope, etc. Based upon the observations, flume tests were conducted to analyze the sliding mechanism of each failure. The variables of flume test are soil layer thickness, rainfall intensity, and morphology of slope under the constant condition of the percentage of fine, initial soil moisture content, slope angle and compaction energy. Test results show that shallow failure was mostly observed from the surface of the slope and caused by the soil erosion; in addition, compared to the other types of failure, the occurrence of initial erosion is late, however, the development of erosion is fast. In gully erosion failure, the collected water from the water catchment area helps erosion of the upper soil layer and transfer of residual corestone, which impedes the erosion process once the upper soil layers are eroded and corestone are exposed. The soil-rock interface failure shows the most fast initial erosion process among the failure types. Interestingly, the common feature observed from the different types of failure was the occurrence of the initial deformation near the toe of slopes which implies the existence of surbsurface flow along the downslope direction.

• Journal of Korean Society of Forest Science
• /
• v.89 no.3
• /
• pp.323-334
• /
• 2000

This study was carried out to investigate the effects of geological and topographical features on landslide and land-creep at the twenty four surveyed sites of Kyungpook province. According to the results obtained, it was concluded that continuous heavy rainfall was one of the primary factors to occur landslide and land-creep. Most of the landslides occurred in the past were concentrated in the granite and granitic gneiss zones, while land-creeps were mainly occurred in the mud-stone zones. Therefore, it was thought that the physical properties such as soil texture, solid phase, moisture contents, density, hardness and porosity rate of weathered granite and granitic gneiss could affect the occurrence of landslide and land-creep. Due to the holding of sand contents in the upper soil layers of weathered granite and granitic gneiss, rainfall could infiltrate into the soil easily. While lower soil layers contained much quantity of clay and silt contents, those soils saturated with rainfall cause to lose viscosity and shear strength. Therefore, it was seemed that landslide was occurred more easily and the saturation of those soils was made much easily by bed rocks under those soils. Landslide and land-creep are slided into lower place by gravitation and slope degree factors. Therefore, prediction of landslide occurrence is very difficult because landslide is occurred abruptly, and physical properties of the soil have to be understood and checking the existence of bed rocks under the soils is not easy, on the other hand, land-creep is progressed very slowly. Therefore, it was suggested that in a degree creeping could be protected by removing of several causing factors.