• 전기학회논문지
• /
• 제65권4호
• /
• pp.601-610
• /
• 2016

The light-emitting diode (LED) has been used in a variety of industrial fields and for general 0lighting purposes on account of its high efficiency, low power consumption and long lifespan. The LED is driven by direct current; therefore, an AC/DC converter is typically required for its use. An electrolytic capacitor is generally used for stabilizing DC voltage during use of the AC/DC converter. However, this capacitor has a short lifespan, which makes it a limiting factor in LED lighting. Furthermore, LED lighting requires a dimmable control to enable energy savings and fulfil a growing consumer demand. In this paper, the dimmable single-stage power factor correction (PFC) continuous conduction mode (CCM) flyback converter that employs no electrolytic capacitor is presented. The LC resonant filter is alternatively applied to reduce the 120[Hz] ripple on the output. And the optimum value of the LC resonant filter parameters considering both efficient and performance is analysed. Simulation and experimental results verify the satisfactory operation of the converter.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2000년도 전력전자학술대회 논문집
• /
• pp.299-304
• /
• 2000

In this paper we investigate accurately the input-output characteristic of single-phase diode rectifier. The diode rectifier has some advantages of simplicity cost and high-efficiency. But it has some defects which THD of input current low PF and voltage drop of output side. In order to compensate it we analyzed using the parameter variation and introduced capacitor insertion method for reducing the distortion and increasing the PF.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2000년도 전력전자학술대회 논문집
• /
• pp.384-387
• /
• 2000

In this paper Power factor correction circuit of single-phase three-level boost converter is proposed. The advantage of the proposed control scheme for three-level boost converter are low blocking voltage of each power device low THD(Total Harmonic Distortion) and high power factor. The control scheme is based on the current comparator capacitor compensator and region detector, In simulations the proposed system is validated.

• Carbon letters
• /
• 제10권2호
• /
• pp.90-93
• /
• 2009

The excellent and characteristic capacitor performance of pure single-walled carbon nanotubes (SWNTs), which differ from conventional activated carbon electrodes, is reported. SWNTs with little bundling showed higher specific capacitance than activated carbons. High operating voltage can be expected for pure SWNTs without metal contamination and graphene edge structure.

• Journal of Power Electronics
• /
• 제11권4호
• /
• pp.507-511
• /
• 2011

This paper presents a single-switch buck converter with a ripple-free inductor current. In the proposed converter, the filter inductor current ripple is completely removed by utilizing an auxiliary circuit consisting of an additional winding of the filter inductor, an auxiliary inductor, and an auxiliary capacitor. Moreover, the ripple-free current characteristic is maintained under both light load and full load conditions. The theoretical analysis and performance of the proposed converter were verified with a 110W experimental prototype operating at a 107 kHz switching frequency.

• Journal of Electrical Engineering and Technology
• /
• 제11권5호
• /
• pp.1242-1252
• /
• 2016

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 제38회 하계학술대회
• /
• pp.1053-1054
• /
• 2007

This paper represents technique of optimum efficiency calculation for condenser run type single phase induction motor considering utilization rate. The material cost and loss expense are major factor of proposed algorithm. The simulation results are compared with experimental ones. And they are agreement with each other.

• 전력전자학회논문지
• /
• 제18권4호
• /
• pp.305-311
• /
• 2013

This paper proposes a performance improvement of existing single-phase current-fed qZ-Source inverter. Voltage gain of the traditional voltage-fed full-bridge inverter and single-phase current-fed qZ-source inverter is only equal to or smaller than input voltage. The proposed inverter can obtain twice higher voltage gain than the single-phase current-fed qZ-Source inverter by adding an extra switch and a capacitor in the circuit. In addition, the proposed inverter shares the common ground between dc input and ac output voltage. Therefore, the proposed inverter can eliminate the possible ground leakage current problem when it is used for grid-tied photovoltaic inverter system. A 120 W prototype inverter is built and tested to verify performances of the proposed inverter.

• 전기학회논문지
• /
• 제58권8호
• /
• pp.1519-1525
• /
• 2009

This paper presents a novel passive converter for single phase SRM. The proposed passive converter has additional passive power circuit which is consisted by three diodes and one capacitor in the front-end of conventional asymmetric converter to supply a high negative bias during demagnetization. The high negative bias can reduce the demagnetization time and negative torque from tail current in single phase SRM. So, It can extend positive torque region by the extended turn-off position. In this paper, the structure and operating modes of a novel passive converter are introduced with mathematical model. The proposed single phase SRM using passive converter is verified by the computer simulation and experimental results.

• 전자공학회논문지D
• /
• 제34D권10호
• /
• pp.14-23
• /
• 1997

An MMIC downconverting mixer for cellular phone application has been successfully developed using an MMIC process including $1 \mu\textrm{m}$ ion implanted gaAs MESFET and passive lumped elements consisting of spiral inductor, $Si_3N_4$ MIM capacitor and NiCr resistor. The configuration of the mixer presented in this paper is single-ended dual-gate FET mixer with common-source self-bias circuits for single power supply operation. The dimension of the fabricated circuit is $1.4 mm \times 1.03 mm $ including all input matching circuits and a mixing circuit. The conversion gian and noise figure of the mixer at LO powr of 0 dBm are 5.5dB and 19dB, respectively. The two-tone IM3 characteristics are also measured, showing -60dBc at RF power of -30dBm. Allisolations between each port show better than 20dB.