• Journal of Advanced Marine Engineering and Technology
• /
• 제37권1호
• /
• pp.47-52
• /
• 2013

The higher energy efficiency for ship and the lower pollution for global environment are required strictly. However the performance of marine diesel engine is gradually deteriorated with time. And also the operation condition is varied with sea conditions. Hence the optimization for operating condition of marine engines is needed for energy saving and environment kindly. In this paper, it was attempted to investigate the influence of aging for marine diesel engine. The deterioration of engine performance is assessed by the calculation results of the simulation program for two-stroke marine diesel engine developed by author which was reported before. And three parameters for deterioration of engine performance were considered such as lower efficiency of turbocharger by fouling, increase of blow-by gas due to wear of cylinder liner and getting worse of combustion by poor injection. By the results, it was shown that the influence of engine performance by aging was relatively not so small - 10.4 bar low in Pmax and 3.2% decrease in Pmi.

• Journal of Advanced Marine Engineering and Technology
• /
• 제37권1호
• /
• pp.91-98
• /
• 2013

The degradation of durability and increase of fatigue on the ship are mainly caused by vibration of the engine and rotating machineries. The damper to minimize the influence from vibration is usually attached between the machineries and its base. General damper applied on the vessel is passive damper which is designed to attenuate specified frequency signals, i.e, high frequency vibration signals. But it is hard to anticipate its performance for low frequency signals. In this research, active vibration isolator using VCM is developed to suppress wide band vibration signals. Routh-Huritz's stable condition, ultimate sensitivity method and parameter tuning are applied to derive PID parameters and 2 and 4 phase choppers are also adapted to drive VCM. Simulation and experiments are executed to confirm the effectiveness of the proposed control schemes.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• 제35권1호
• /
• pp.115-120
• /
• 2011

The dynamic responses of a 5 MW wind turbine lifted by a floating crane with two elastic booms are analyzed. Dynamic equations of motions of a multibody system that consists of a floating crane, two elastic booms, and a wind turbine are derived. The six-degree-of-freedom (DOF) motions for the floating crane and the wind turbine are considered in the equations of motions. The hydrostatic force, the hydrodynamic force due to a regular wave, the mooring force, the wire rope force, and the gravitational force are considered as external forces. By solving the equations numerically, the dynamic responses of cargo are simulated. The simulation results are compared with those in the case of one elastic boom. Finally, the dynamic responses of the wind turbine lifted by the floating crane are analyzed under regular wave condition.

• Proceedings of KOSOMES biannual meeting
• /
• 해양환경안전학회 2006년도 추계학술발표회
• /
• pp.217-219
• /
• 2006

This study focused an water quality response to land-based pollution loads and the appropriate pollutant load reduction in Chinhae Bay using an eco-hydrodynamic model. Land-based discharge foam urban areas, industrial complex and sewage treatment plant was the greatest contributor to cause red-tide blooms and summer hypoxia. Tidal currents velocity af the ebb tide was about 10 cm/s stronger than that of the flood tide. A residual current was simulated to. have a slightly complicated pattern with ranging from 0.1 to. 2.7 cm/s. In Masan Bay, pollutant materials cannot flaw from the inner to the outer bay easily because af residual currents flaw southward at surface and northward at the bottom. The simulation results of COD distribution showedhigh concentrations aver 3 mg/L in the inner part of Masan Bay related pollutant discharge, and charge, and lower levels less than 1.5mg/L in the central part of Chinhae Bay. For improvement water quality in Chinhae Bay, it is necessary to reduce the organic and inorganic loads from paint sources by mare than 50% and ameliorate severe polluted sediment.

• Journal of the Korean Society of Marine Environment & Safety
• /
• 제19권6호
• /
• pp.643-648
• /
• 2013

In this paper, we developed a system which can detect and can alarm about the sailing provocative climate by using a photo. The research on domestic shipbuilding industry and in IT fusion technology is under construction, but a reliable safety device which can alarm a sailor about the circumstances of the fog and rain during ship operation as soon as possible due to the constant state in domestic. In this paper, a compact, for system low-power transceiver and data processing equipment for sensing were developed, also a performance evaluation got accomplished with simulation analysis. In results, it is operating normally at least 32.36[dB] and maximum values f 89.20[dB] in the domestic, and 32.55 to 60.66[dB] in the outdoors.

• Journal of Navigation and Port Research
• /
• 제41권3호
• /
• pp.87-92
• /
• 2017

To enhance the reliability and/or resilience of the PNT service included in the e-Navigation strategy of the IMO, the evaluation of the AIS-TWR method for the asynchronous R-mode for maritime service, which is available even in the absence of the GNSS, is described. For the AIS-TWR, which is capable of ranging through message exchange even without high precision synchronization, the operation scenario and the error factors according to the AIS system specifications are proposed and analyzed. Cramer-Rao Lower Bound is presented for the performance evaluation of the AIS-TWR algorithm. A simulation by AIS-TWR method of two AIS systems in a 3 km static environment shows estimation error of about 41m compared to the real value..

• Journal of the Society of Naval Architects of Korea
• /
• 제33권2호
• /
• pp.13-29
• /
• 1996

This paper presents calculated results of the free-surface flow around a Series 60($C_B=0.6$) model. Three-dimensional Navier-Sotkes equations are solved and Baldwin-Lomax algebraic turbulence model is adopted to simulate the high Reynolds-number flow. To reduce computational efforts, velocity components near the wall are extrapolated with a the solved by using the Implicit Approximate Factorization method[2]. The successive-over-relaxation method is used for solving pressure-Poisson equation when obtaining the pressure field projecting the divergence-free velocity field. To simulate the free-surface flows more precisely, the numerical scheme solving the equation for the kinematic boundary condition is very important. In this paper, there numerical schemes are employed and the results are compared with the available experimental data.

• Journal of the Society of Naval Architects of Korea
• /
• 제54권6호
• /
• pp.501-514
• /
• 2017

In the previous research, a study was carried out to estimate the actual performance such as the propeller Revolution Per Minute (RPM) and engine power of a Liquefied Natural Gas Carrier (LNGC) using the full-scale measurement data. After the predicted RPM and engine power were verified by comparing those with the measured values, the suggested method was regarded to be acceptable. However, there was a limitation to apply the method on the prediction of the RPM and engine power of a ship. Since the information of route, speed, and environmental conditions required for estimating the RPM and engine power is generally regarded as the intellectual property of a shipping company, it is difficult to secure the information on a shipyard. In this paper, the RPM and engine power of the 151K LNGC was estimated using the combination of Automatic Identification System (AIS) and European Centre for Medium-Range Weather Forecasts (ECMWF) database in order to replace the full-scale measurement. The simulation approach, which was suggested in the previous research, was identically applied to the prediction of RPM and engine power. After the results based on the AIS and ECMWF database were compared with those obtained from the full-scale measurement data, the feasibility was briefly reviewed.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• 제20권3호
• /
• pp.121-127
• /
• 2020

The small tracking radar targets the target in a real-time, fast-moving, fast-moving target against aircraft with a large RCS that is maneuvering at low speed and a small RCS aircraft maneuvering at high speed (fighters, drones, helicopters, etc.) It is a pulsed radar that detects and tracks. Performing a performance test on a tracking radar in a real environment is expensive, and it is difficult to quantitatively measure performance in a real environment. Describes the composition of the laboratory environment's comprehensive performance test facility and the main requirements and implementation of each configuration.Anechoic chambers to simulate the room environment, simulation target generator to simulate the signal of the room target, target It is composed of a horn antenna driving device to simulate the movement of a vehicle and a Flight Motion Simulatior (FMS) to simulate the flight environment of a tracking radar, and each design and implementation has been described.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 한국항해항만학회 2005년도 춘계학술대회 논문집
• /
• pp.197-204
• /
• 2005

Recently, many ships such as VLCCs, dangerous cargo ships, high speed ferry boats are visiting Yeosu ${\cdot}$ Gwangyang harbor. The traffic volume of the year 2003 has increased as many as 2.5 times of 1988. However there is no suitable ship's routeing system which takes account of today's traffic situations in this area. This study aims at the setting of hazardous factors to mitigate the danger to vessels in Yeosu ${\cdot}$ Gwangyang bay and to secure the safety of maritime environment.