• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.5
• /
• pp.1319-1324
• /
• 1998

The phase and frequency commands of a ratating radar system that utilizes frequency scanning to steer the beam in the azimuth direction and phase shifters in the elevation direction are derived in terms of the angles of the groung based coordinate system. The antenna type considered is slotted arrays that are easy to construct at such high microwave frequency as the X band. The frequency that has non-linear characteristics as a functio ofthe elevation angle is plotted and the derived frequency equation is aproximated to be a simple form to reduce the calculation time for real time multi-function radar systems. It is shown that the approximated frequency command is in good agreement with the exact one if the range of azimuth scanning is limited by ${\pm}10^{\circ}$.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.5A
• /
• pp.543-550
• /
• 2011

In order to improve readability, a leakage-signal canceller has been proposed in UHF-band RFID readers. The proposed canceller is composed of two blocks: an environment monitoring block for detection of Tx and RX power levels and a leakage cancellation block. The leakage canceller consists of directional-couplers, digital attenuators and phase shifters based on the feed-forward scheme. The leakage canceller is located between antenna and reader. An improved experimental characterization of the scheme is presented with results from the reader operating in the Korean RFID frequency band, conforming the validity of the approach with more than 29 dB of leakage cancellation.

• Journal of IKEEE
• /
• v.20 no.4
• /
• pp.385-391
• /
• 2016

We demonstrated experimentally a variable optical frequency comb source using a cascaded dual parallel Mach Zehnder modulator (DPMZM) and a phase modulator (PM). With this simple configuration and applying low drive voltages, we generated variable comb source composed of spectral lines 3, 5, 7, 9 and 11 with 10-GHz frequency spacing, also generated 2 and 3 spectral lines with 20 GHz frequency spacing. The generated comb source maintains high spectral coherence across the entire bandwidth with good spectral flatness (within 1-dB for 2, 3, 5, 7 comb lines, within 2-dB for 9-comb lines and within 3-dB for 11 comb lines). The flat and variable comb source is mainly achieved by manipulating 6 operating parameters of DPMZM, setting RF amplifier gain, connected at phase modulator and phase shifters. Hence the method is simple and offers great flexibility in achieving flat and variable comb spectrum, which is experimentally demonstrated. This brings advantages of power efficiency due to low driving voltages, simplicity and cost effectiveness to the system.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.07b
• /
• pp.719-722
• /
• 2003

Ferroelectric $Pb(Zr_{1-x}Ti_x)O_3$ (PZT) films were deposited on (001) MgO single crystals using sol-gel method. Structural properties and surface morphologies of PZT films were investigated using an X-ray diffractometer and a scanning electron microscopy, respectively. The dielectric properties of PZT films were investigated with the dc bias field using interdigitated capacitors (IDC) which were fabricated on PZT films using a thick metal layer by photolithography and dry etching process. The small signal dielectric properties of PZT films were calculated by a modified conformal mapping method with low and high frequency data, such as capacitance measured by an impedance gain/phase analyzer at 100 kHz and reflection coefficient (S-parameter) measured by a HP 8510C vector network analyzer at 1 -20 GHz. The IDC on PZT films exhibited about 67% of capacitance change with an electric field of 135 kV/cm at 10 GHz. These PZT thin films can be applied to tunable microwave devices such as phase shifters, tunable resonators and tunable filters.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07b
• /
• pp.794-797
• /
• 2004

The object of investigation is represented by PbxSrl-xTiO3(PST) thin films, which were fabricated by the alkoxide-based sol-gel method on Pt/Ti/SiO2/Si substrate. We have investigated both structural and dielectric properties of PST thin films aimed to tunable microwave device applications as a function of Pb/Sr ratio. PST thin films showedtypical polycrystalline structure with a dense microstructure without secondary phase formation. Dielectric properties of PST films were found as strongly dependent on Pb/Sr composition ratio. Increasing of Pb content leads to simultaneous increasing of both dielectric constant and dielectric loss characteristics of PST films. The figure of merit (FOM) Parameter (FOM : (%) tunability / tan (%)) reached a maximal value of 27.5 corresponding to Pb/Sr ratio of 40/60. The tunability increased with increasing Pb content. The dielectric constants, dielectric loss and tunability of the PST thin films at Pb/sr ratio of 40/60 measured at 100 kHz were 335, 0.0174 and 47.89 %, respectively.

• Transactions on Electrical and Electronic Materials
• /
• v.4 no.2
• /
• pp.24-28
• /
• 2003

(Ba,Sr,Ca)TiO$_3$ powders, prepared by the sol-gel method, were mixed with organic binder and the BSCT thick films were fabricated by the screen printing techniques on alumina substrates. All the BSCT thick films, sintered at 1420$^{\circ}C$, showed the typical XRD patterns of a perovskite polycrystalline structure. The average grain sizes decreased with increasing amounts of ZrO$_2$, and the BSCT(40/40/20) thick films doped with 2wt% MnO$_2$ showed a value of 8$\mu\textrm{m}$. The thickness of thick films by four-cycle on printing/drying was approximately 951$\mu\textrm{m}$. The relative dielectric constant decreased with increasing Ca content and MnO$_2$ doping amount. The relative dielectric constant, dielectric loss and tunability of the BSCT(50/40/10) thick films doped with 2.0wt% ZrO$_2$ were 772, 0.184％ and 15.62%, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.7 no.2
• /
• pp.147-156
• /
• 1996

In this paper we proposed a beam steering equation for the planar slotted waveguide array antenna. The tilt angle measured from the rotating axis and the aperture distribution of the antenna were the most important factors for the beam steering. From the equation, we calculated the frequency and phase distribution of the aperture for any desired beam direction. And we developed a high speed control algorithm delivering the phase data to the phase shifters of a one-dimensional phased array antenna. To reduce complexity of the control circuit and the phase delivery time, we proposed the serial phase repeating method. Because of its simplicity, we expect it can be useful for a large 2- dimensional fully phased array antenna.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.39 no.4
• /
• pp.72-83
• /
• 2002

In this paper, a novel low-power VLSI system architecture was proposed. By exploiting software control of supply voltages, it simplifies hardware implementation, reduces power consumption efficiently, and avoids complicated interface circuits. The proposed architecture models clock frequency-supply voltage relationship by software modelling, enables individual control of supply voltages for all chips in the system, and restricts clock frequency to discrete levels of $f_{CLK}$, $f_{CLK}$2, $f_{CLK}$3... where $f_{CLK}$ is the master clock frequency A prototype system was implemented by modifying off-the-shelf microprocessor evaluation board and adding simple discrete devices such as level shifters and voltage switches. It was measured that the power consumption was reduced from 0.58W to 0.12W in the Prototype system. system.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2003.11a
• /
• pp.536-540
• /
• 2003

A new concept of adaptive focusing, using a Rotman lens, is presented in this paper. A Rotman lens is a microwave lens which is able to focus microwave power on its focal arc or generate multiple beams. By adding the array of phase shifters between a Rotman lens and antenna elements, the wavefront can be adaptively modulated to focus objects distributed in short range rather than far-field zone. From the optical point of view, the propagations of the lens have been simplified from the Fresnel diffraction integral to the Fourier transform. Using Fourier Transform, a beam propagation method has been developed to show improvement of the resolution by controlling wavefront of wave propagating from an aperture-type antenna array. The beam width(or spot size) and intensity have been calculated for a focused beam propagating from an array having $10{\lambda}$ of its size. For the beam with $20{\lambda},\;30{\lambda}$, and $50{\lambda}$ of geometrical focal length, the half-power beamwidth (spot size) is about $1.1{\lambda},\;1.3{\lambda}$, and $1.9{\lambda}$, respectively.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.8
• /
• pp.1839-1844
• /
• 2015

The low-density parity-check(LDPC) code has been adopted in many communication standards due to its error correcting performance, and the quasi-cyclic LDPC(QC-LDPC) is widely used because of implementation easiness. In the QC-LDPC decoder, a cyclic-shifter is required to rotate data in various sizes. This kind of cyclic-shifters are called multi-size circular shifter(MSCS), and this paper proposes a low-complexity structure for MSCS. In the conventional serially-placed two barrel-rotators, the unnecessary multiplexers are revealed and removed, leading to low-complexity. The experimental results show that the area is reduced by about 12%.