• Smart Structures and Systems
• /
• 제23권4호
• /
• pp.359-371
• /
• 2019

As part of a structural health monitoring system, the relative geometric relationship between a ship and bridge has been recognized as important for bridge authorities and ship owners to avoid ship-bridge collision. This study proposes a novel computer vision method for the real-time geometric parameter identification of moving ships based on a single shot multibox detector (SSD) by using transfer learning techniques and monocular vision. The identification framework consists of ship detection (coarse scale) and geometric parameter calculation (fine scale) modules. For the ship detection, the SSD, which is a deep learning algorithm, was employed and fine-tuned by ship image samples downloaded from the Internet to obtain the rectangle regions of interest in the coarse scale. Subsequently, for the geometric parameter calculation, an accurate ship contour is created using morphological operations within the saturation channel in hue, saturation, and value color space. Furthermore, a local coordinate system was constructed using projective geometry transformation to calculate the geometric parameters of ships, such as width, length, height, localization, and velocity. The application of the proposed method to in situ video images, obtained from cameras set on the girder of the Wuhan Yangtze River Bridge above the shipping channel, confirmed the efficiency, accuracy, and effectiveness of the proposed method.

• 한국농공학회논문집
• /
• 제46권5호
• /
• pp.155-163
• /
• 2004

The objectives of this study were to characterize the wastewater flow through the VFS, and relate this to the P removal in the VFS. A total of 68 subsurface wells (20∼40 cm below the soil surface) and 35 surface wells (0~5 cm), and the application of chloride tracer were used to investigate flow paths and soluble reactive P (SRP) removal from the 21 m wide and 33 m long VFS receiving dairy milkhouse waste. The early chloride breakthroughs in wells in the center of the VFS showed that the milkhouse waste flows preferentially down in the center of the hillslope. The locally saturated area created near the discharge pipe in the center of the VFS accelerates surface flow that contributed to rapid transport of P to the down slope area. Although VFS of 33m long eventually reduced SRP to lower than 0.2 mg/L in most cases, SRP is less effectively removed in the areas where soil saturation occurred. It is suggested that the effort to distribute the wastewater uniformly to avoid soil saturation and reduce the flow velocity need to be considered in new designs.

• 지구물리와물리탐사
• /
• 제14권4호
• /
• pp.324-334
• /
• 2011

석모도에서 산출되는 암석시료를 이용하여 파괴강도를 5단계로 나누고 하중을 증가시키면서 손상 진행에 따른 P-, S-파 속도의 변화 특성을 고찰하였다. 재하 전 상태에서부터 일축압축강도의 95%까지 하중을 받은 9개의 수포화 시험편들이 1시간 동안 상온에서 건조되어 가는 동안 탄성파 속도는 암종별로 변화폭이 상이하였으며, P-파의 경우 0.9 ~ 18.3%, S-파 속도는 2.8 ~ 14.8% 로 큰 차이를 보였다. 하중에 의해 건조한 암석에 미세균열이 발생하면 P-파 속도가 일률적으로 감소하는 현상과는 달리, 수포화 암석의 경우는 균열생성에 의한 속도 감소 요인과 수포화에 의한 속도 상승요인의 상호작용에 의해 속도 증감 양상이 매우 복잡하게 나타나지만 대부분의 경우에서 전반적으로 재하 초기단계에서는 속도가 증가하다가 나중에는 감소하는 경향을 보였다. 감소가 시작되는 시점도 암종별로 1 ~ 4단계로 다양하다. 파괴 후에도 형태를 보존한 25h-2와 29-2 시료에 대해서 파괴후의 속도를 측정한 결과는 현저한 공극율의 상승과 함께 탄성파 속도도 현저히 감소하였다. 조암광물별로 보면 석영 함량이 증가하면 탄성계수가 커지며 층상구조형 규산염광물이 증가하면 탄성계수는 작아지는 경향을 보였다.

• 조명전기설비학회논문지
• /
• 제28권2호
• /
• pp.54-59
• /
• 2014

The electric power can be converted into the mechanical power by a corona discharge system. This way has not stronger force than a electric motor. But it has been applied in various industrial fields because of many advantages, no moving parts, smaller noise, simpler structure, minimizing et al. In this paper, corona discharge system with multiple corona electrode installed in form of the ring, has been studied by focusing on the electrical and mechanical characteristics. Intensity of the corona discharge depends on applied electric field, and electric field is related to the applied voltage, discharge gap spacing(s), distance between each corona electrodes(d). As a result, in the case d/s=0.9, most intensive discharge occurred in this experiments. In the region of d/s<0.9, ionic wind velocity has saturation value in spite of decreasing corona current, because each ion velocities increase by the increasing electric field.

• Journal of Microbiology and Biotechnology
• /
• 제15권6호
• /
• pp.1207-1213
• /
• 2005

In a search for bacteria capable of degrading styrene better than previously isolated strains, bacterium IS-3 was isolated from activated sludge and found to be most closely related to Pseudomonas sp. Styrene degradation by this strain was tested in liquid cultures and polyurethane-packed biofilters. In liquid cultures, the rate of styrene degradation by this bacterium increased from 24.93 to $76.53\;{\mu}mol\;g^{-1}\;DCW\;H^{-1}$ for an initial mass range from 8.7 to $34.8{\mu}mol$. The maximum styrene elimination capacity was 580-635 $g/m^{3}\cdot$h at a space velocity (SV) of 50-200/h. The critical elimination capacities guaranteeing $95\%$ removal of the input styrene were determined to be 635, 170, and 38 $g/m^{3}\cdot$h, respectively, at SVs of 50, 100, and 200/h. Kinetic analysis revealed that the maximum styrene elimination velocity ($V_{m}$) for this biofilter was 1,000 g/m$\cdot$h, and the saturation constant ($K_{m}$) was 454 ppmv. Together, these results suggest that a polyurethane biofilter containing Pseudomonas sp. IS-3 could have potential practical applications for the effective removal of styrene gas.

• Journal of Microbiology and Biotechnology
• /
• 제13권1호
• /
• pp.70-76
• /
• 2003

The benzene removal characteritics of the polyurethane (PU) biofilter immobilized with S. maltophilia T3-c, that could efficiently degrade benzene, was investigated. Maximum capacity to eliminate benzene was maintained at $100-110g{\cdot}m^-3{\cdot}h^-1$ when space velocity (SV) ranged from 100 to $300 h^-1$ -1/, however, it decreased sharply to $55 g{\cdot}m^-3{\cdot}h^-1^$ as SV increased to $400 h^-1$. The critical elimination capacities that guaranteed $90\%$ removal of inlet loading of the PU biofilter were determined to be 70,30, and $15 g{\cdot}m^-3{\cdot}h^-1$ at SV 100,200, and $300 h^-1$, respectively. Based on the result of a kinetic analysis of the PU biofilter, maximum benzene elimination velocity ($V_m$) was $125 g{\cdot}m^-3^\;of\;PU{\cdot}h^-1$ and saturation constant ($K_m$) was $0.22 g{\cdot}m^-3^$ of benzene ($65{\mu}{\cdot}I^-1$). This study suggests that the biofilter utilizing S. maltophilia T3-c and polyurethane is a very promising technology for effectively degrading benzene.

• 한국농공학회지
• /
• 제16권3호
• /
• pp.3477-3491
• /
• 1974

Following are the results of the study on the property of falling permeation of stratified soil in the close state under existence of stagnant water on a soil layer. 1. When on the stratified soil a least permeating layer was put on the soil layer the load Pressure was present owing to appearance of saturation close state driving decrease of the pressure in the lower layer, on the other hand when the least permeating layer was placed under the layer the lower least permeating layer pressure was decreased. 2. In the case of least permeating layer the variation of current gradient according to the respective level after treating the layer was enormous and due to usal storage phenomena for the Kl layer which was coarse that was trifle. 3. The permeability of the respective layer of stratified soil in the close state died not always coincide with that of single layer. 4. Generally Zunker's equation of average permeability was valid but actually calculated permeating velocity after treating the layer of stratified soil was seriously differ from the measured value owing to the variation of current gradient, especially when the pressure head at the layer boundany was discontinuous the validity of the equation of average permeability was seemed to be doubtful. 5. The permeating velocity of stratified soil was regulated by the least permeating layer, i.e. it is thought to be rational to estimate the value by calculating the current gradient with its proper permeability, pressure headon the layer and its thickness.

• Bulletin of the Korean Chemical Society
• /
• 제26권2호
• /
• pp.260-264
• /
• 2005

The nature of the active site of Tobacco acetohydroxyacid synthase (AHAS) in the substrate- and cofactorbinding was studied by kinetics and fluorescence spectroscopy. The substrate saturation curve does not follow Michaelis-Menten kinetics at different temperatures (7, 21 and 37 ${^{\circ}C}$), pH (6.5, 7.5 and 8.5) and buffers (Tris-HCl and MOPS). The concentration of one half of the maximum velocity ($S_{0.5}$) decreased in the following order: pyruvate $\gt$ ThDP $\approx$$Mg^{+2}$ $\gt$ FAD. However, the catalytic efficiency (K$_{cat}/S_{0.5}$) inversely decreased in the following order; FAD $\gt$ $Mg^{+2}$ $\approx$ThDP $\gt$ pyruvate, indicating that the cofactors by in decreasing order; FAD, $Mg^{+2}$, ThDP, affect the catalysis of AHAS. The dissociation constant ($K_d$) of the intrinsic tryptophan fluorescence decreased with the same tendency of the concentration of one half of the maximum velocity ($S_{0.5}$) decreasing order. This data provides evidence that the substrate and cofactor binding natures of the active site, as well as its activation characteristics, resemble those of other ThDP-dependent enzymes.

• International Journal of Air-Conditioning and Refrigeration
• /
• 제13권2호
• /
• pp.107-118
• /
• 2005

An experimental investigation was made to study two-phase flow distribution in a T-type distributor of slit fin-and-tube heat exchanger using R-22. Experiments were carried out under the conditions of saturation temperature of $5^{\circ}C$ and mass flow rate varying from 0.6 to 1.2kg/min. The inlet air has dry bulb temperature of $27^{\circ}C$, relative humidity of 50% and air velocity varying from 0.63 to 1.71m/s. A comparison was made between the predictions from the previously proposed tube-by-tube method and the present experimental data for the heat transfer rate of evaporator. Results show that $82.5\%$ increase of air velocity is needed for T-type distributor with four outlet branches than that of two outlet branches under the superheat of $5^{\circ}C$, which resulted in increasing of air-side pressure drop of $130\%$ for the former as compared to the latter.

• International Journal of Air-Conditioning and Refrigeration
• /
• 제17권3호
• /
• pp.81-87
• /
• 2009

The effect of oil on convective boiling of R-123 in an enhanced tube bundle is experimentally investigated at $26.7^{\circ}C$ saturation temperature. The enhanced tube had pores (0.23 mm diameter) and connecting gaps (0.07 mm width), which had been optimized using pure R-123. The effects of oil concentration (0 to 5%), heat flux (10 to $40\;kW/m^2$), mass velocity (8 to $26\;kg/m2^s$) and vapor quality are investigated. The oil significantly reduces the bundle boiling heat transfer coefficient. With 1% oil, the reduction is approximately 35%. Further addition of oil further reduces the heat transfer coefficient. The data are also compared with the pool boiling counterpart. The reduction in the heat transfer coefficient is smaller in a bundle (convective boiling) than in a pool (single-tube pool boiling), with larger difference at a smaller heat flux. Similar to pure R-123 case, the effects of mass velocity and vapor quality are negligible for the convective boiling of R-123/oil mixture.