• Journal of Korean Society of Disaster and Security
• /
• v.8 no.2
• /
• pp.21-26
• /
• 2015

This study analyzes the failure predict of model slope due to changes in ground condition followed by heavy rainfall with a simulated rainfall system. the movement of a slope from the rainfall penetrating the unsaturated soil is investigated with respect to various conditions of pore-water pressure, earth pressure and moisture content, considering rainfall duration and permeability.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2009.03a
• /
• pp.288-298
• /
• 2009

It is well known that the peak strength envelope of geomaterials with no cohesion, such as sand, gravel and rockfill, exhibits significant curvature over a range of stresses. In a practical design of slope, however, the linear Mohr-Coulomb's failure envelope is used as a failure criterion and consequently gives inaccurate safety factors, especially for some ranges of small normal stresses on shallow failure surfaces. Necessity of a nonlinear shear strength envelope in slope stability analysis is on this point. Hence, this study describes how to evaluate nonlinear shear strength of gravel fill materials using the results of large triaxial tests under consolidated-drained condition, and compares the safety factors from slope stability analyses for a homogeneous gravel fill or rockfill embankment incorporating the non-linearity of strength, so as to show its effects on safety factors.

• Journal of the Korean Geotechnical Society
• /
• v.30 no.2
• /
• pp.65-76
• /
• 2014

For soil improvement, sand mats or sand compaction piles are often constructed on soft marine clays. In such cases, some amounts of sand and clay are inevitably mixed. Sand or gravel often exists in the weathered soils near the slope surface. This research investigates the effect of mixing sand content on consistency limits and shear strength of clays. Firstly, sand was mixed with kaolinite or bentonite at 0, 9, 17, 23, 29, 33, 50% and then liquid and plastic limits were measured. Both plastic and liquid limits decreased as a sand content increased. The water content of clay-sand mixtures with different sand content increased by 10% or 20% step by step and then their undrained shear strength was measured using a portable vane shear device called Torvane. For all cases, undrained shear strength of clay-sand mixtures decreased rapidly until reaching a certain value. Their state changed from undrained to drained state gradually as the sand content increased, which caused their undrained shear strength to decrease. On the other hand, a series of direct shear tests were also conducted on such clay-sand mixtures to investigate the effect of sand content on cohesion and angle of internal friction. It was found from clay-sand mixtures that their cohesion decreased but angle of internal friction increased as the sand content increased.

• Journal of The Geomorphological Association of Korea
• /
• v.25 no.1
• /
• pp.1-17
• /
• 2018

The characteristics and burial ages of sand sediments on the Jiduri coast in Daechung-myeon, Ongjin-gun, Incheon were investigated. Daecheong Island is the area where the characteristics of the rocky coast and sand coast are shown. Various studies have been conducted on the Okjukdong sand dune that appears in the north of the island. However, there has been no study on the sandy sedimentary topography of the Jiduri and Moraewul area in the south. The sandy sedimentary terrain of Jiduri is divided into sandy beaches, sand dunes and sand deposits along the slope including climbing dune. Overall, the depth of sandy sediments in Jiduri is not deep. The characteristics of sandy sediments and burial ages were investigated at an elevation of about 23 m above sea level at the back of Jiduli Beach and 46 m above sea level at the ridge line between Jiduri and Moraewol. From the Jiduri coast to the hillside behind, the average grain size decreases and the sorting becomes better as it moves from the intertidal zone to the beach and the foredune. This indicates the selective sand transport by the wind and can be judged by the terrain formed under the current sedimentation environment. The average grain size at the upper part of the section of JD-1 (elevation of about 23m MSL) was $1.6918{\varphi}$ of medium sand. The sorting was $0.4584{\varphi}$, skewness was -1.0491 and kurtosis was -1.2411, respectively. Particularly, the average particle size of the crosssection issomewhat uniform, but the color of the constituent material changes from brown to black. In the case of JD-2 (about 46 m MSL), the mean grain size of the section was $1.7943{\varphi}$, the sorting was 0.4931, the skewness was -1.1163, and the kurtosis was 1.2133. On the other hand, the brown and black layers of JD-1 exhibited a burial age of $0.1{\pm}0.0ka$ and the JD-2 had a burial age of $0.7{\pm}0.0ka$.

• Journal of the Korean Geotechnical Society
• /
• v.33 no.7
• /
• pp.17-28
• /
• 2017

This paper presents the investigation of dynamic behavior of a single pile in dry sand based on 1g shaking table tests. The natural frequency of soil-pile system was measured, and then a range of loading frequency was determined based on the natural frequency. Additionally, the studies were performed by controlling loading accelerations, pile head mass and connectivity conditions between pile and cap. Based on the results obtained, relatively larger pile head displacement and bending moment occur when the loading frequency is larger than the natural frequency of soil-pile system. However, the slope of the p-y curve is smaller in the similar loading frequency. Also, it was found that inertia force like input acceleration and pile head mass, and relation of the natural frequency of soil-pile system and input frequency have a great influence on the slope of dynamic p-y curve, while pile head conditions don't.

• Journal of Korea Water Resources Association
• /
• v.55 no.4
• /
• pp.291-300
• /
• 2022

Artificial disturbance in mountainous areas increases the sensitivity to erosion by exposure of the subsoil with a low loam ratio to the surface. In this study, rainfall simulations were conducted to evaluate the erodibility of sand and loamy sand in the interrill erosion by the rainfall-induced sheet flow. The mean diameters of sand and loamy sand used in the experiment were 0.936 mm and 0.611 mm, respectively, and the organic matter content was 2.0% and 4.2%, respectively. In the experimental plot, the runoff coefficient of overland flow increased 1.16 times in loamy sand rather than sand. Mean sediment yields of loamy sand and sand by sheet erosion were 3.71kg/m²/hr and 1.13kg/m²/hr respectively. The erodibility, the rate of soil erosion for rainfall erosivity factor, was 3.65 times greater in loamy sand than in sand. As the gradient of the steep slope increased from 24° to 28°, the sediment concentration and the erodibility for two soils increased by about 20%. The erodibility factor K of sandy soils for small plots was overestimated compared to the measured erodibility. This means that RUSLE can overestimate the sediment yields by sheet erosion on sandy soils.

• Journal of the Korean Geosynthetics Society
• /
• v.10 no.4
• /
• pp.11-18
• /
• 2011

In this study, the reinforcing effect of geogrids in the narrow backfill by sand was experimentally studied. In the model tests, the size of space and the slope of the cut off slope were varied out. The resultant and the distribution of lateral earth pressure were measured. Width of backfill space varied 10 cm, 20 cm, 30 cm at the lower wall level and angle of the cut off slope varied $90^{\circ}$, $75^{\circ}$, $60^{\circ}$. Geogrids were installed in the backfill. Measured results showed that the distribution of the lateral earth pressure due to the narrow backfill developed in a arching shape. And the earth pressure was reduced due to the reinforcement of the backfill by geogrid. geogrid helps reduction of lateral earth pressure.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.57 no.5
• /
• pp.61-67
• /
• 2015

Effect of tillage on time of initial runoff, runoff coefficient, NPS pollution load, soil erosion and crop productivity were studied. Eight runoff plots of $5{\times}30m$ on loamy sand field that were 4 respective plots of 3 % and 8% slope were prepared. Treatment included conventional tillage (CT) and no-till (NT). Time of initial runoff from NT retarded between 247~261 % compared with that from CT. Under 3% slope, runoff coefficient in NT was 63.5 % lower than that in CT. The reduction under 8 % slope was 61.7 %. Differences in runoff reduction between 3% and 8% plots were not significant. NT could reduce more than 60 % of NPS pollution and between 50~85 % of sediment if compared with CT. Productivity of NT was also shown that it was not lower than that of CT. It was expected that the results could be used as a fundamental data for estimating a reduction load in Korea TMDL from a no-till BMP on loamy sand agricultural fields.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.1C
• /
• pp.41-51
• /
• 2008

The load distribution and deformation of single piles which is embedded in Jumunjin sand and Kimhae clay are investigated, based on small scale model tests. Special attention is given to the consideration of flexural rigidity in laterally loaded piles. To consider the flexural rigidity of the pile, tests are performed with the aluminium piles of three different length under different relative densities and undrained shear strength. The test results indicate that the initial slope from the results of tests is proportional to the depth and pile-soil rigidity in both soils. But the increasing rate of the initial slope in the clay is less than in the sand. In addition, the soil resistance is more related to the depth and soil condition than the pile rigidity. Base on the test results, an empirical formula is proposed, which is good agreement with previously published small scale model test and field lateral load test.

• Ocean Systems Engineering
• /
• v.4 no.4
• /
• pp.263-278
• /
• 2014

The spudcan requires the suitable design considering the soil, platform, and environmental conditions. Its shape needs to be designed to secure sufficient reaction of soil so that it can prevent overturning accidents. Its shape also has to minimize the installation and extraction time. Even in the same soil condition, the reaction of soil may be different depending on the shape of spud can, mainly the slope of top and bottom plates. Therefore, in this study, the relation between the slope of plates and the reaction of soil with and without water jetting is analyzed to better understand their interactions and correlations. For the investigation, a wind turbine installation jack-up rig (WTIJ) is selected as the target platform and the Gulf of Mexico is considered as the target site. A multi layered (sand overlying two clays) soil profile is applied as the assumed soil condition and the soil-structure interaction (SSI) analysis is performed by using ANSYS to analyze the effect of the slope change of the bottom plate and water jetting on the reaction of soil. This kind of investigation and simulation is needed to develop optimal and smart spudcan with water-jetting control in the future.