• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2000.11a
• /
• pp.81-84
• /
• 2000

Rotating machine is used extensively and plays important roles in the industrial field. Therefore when rotating machine get out of order, it is necessary to know reasons then deal with the troubles immediately. So many studies far diagnosis of rotating machine are being done. However by this time most of study has an interest in gaining a high recognition But without considering error $rate^{(1)(2)(3)}$ , it is not desirable enough to apply h the actual application system. If the manager of system receives the result misjudging the condition of rotating machine and takes measures, we would lose heavily. So in order to play the creditable diagnosis, we must consider error rate. T h ~ t is. it must be able to reject the result of misjudgment. This study uses nearest neighbor classifier for diagnosis of rotating $machine^{(4)(8)}$ And the Smith's rejection $method^{(1)}$ used to recognize handwritten charter is done. Consequently creditable diagnosis of rotating machine is proposed.

• Proceedings of the KIEE Conference
• /
• 2005.10b
• /
• pp.240-242
• /
• 2005

It is well known that the PD (Partial Discharge) signals are generated if insulators have some defects such as voids in electrical facility and various PD detection methods are developed for preventing electrical troubles. So, an interest for the PD signals is higher and higher according to the high concern for the defects detection method of the aging electrical facility. When the equipment to detect PD signals installed at site and it works, a lot of noises flow in the equipment from surrounding situation and it will be mixed with original PD waveform. So we can not get the desired PD waveform. Therefore, there are many trial to reject or suppress the noise from the PD signals from long times ago. The greater of them used the hardware such as bridge circuits and frequency filters to suppress the noise. This paper proposed a novel noise rejection method in acquired data from PD detection equipment. The noise has the irregular phase and higher signal level than real PD, and noise decision is performed after inspection of pulse distribution in ${\Phi}$-q-n graph of acquired data from PD detection equipments. By experimental results on high voltage electric equipments, it is shown that proposed method has good performance. It is expected that this noise rejection technology is useful in numeric calculation and trend management of PD level.

• KSBB Journal
• /
• v.7 no.3
• /
• pp.179-185
• /
• 1992

An anion-charged membrane was used for selective retention of coenzyme NAD(H) in reactor without any chemical modification. The membrane could reject permeation of NAD (H) (80.9%) but not reject permeation of product. The retention ratio was enhanced in the presence of albumin and Tris-maleate buffer. A bioreactor equipped with a membrane, NTR 7410 was constructed and used in the repeated batch production of sorbitol. NADH-dependent sorbitol dehydrogenase from sheep liver was used for the production of sorbitol from fructose. The coenzyme oxidized was regenerated with alcohol dehydrogenase. 47g/L sorbitol was produced for 198 hr with a substrate conversion ratio of 70%. The retention ratio was almost maintained throughout the entire reaction.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.32 no.4
• /
• pp.27-33
• /
• 2000

A new technique for fractionating pulp stock into a long fiber portion and fines fraction was developed by KRICT in order to enhance the drainage and strength properties of recycled OCC pulp. In order to investigate the effect of fines contents in stock and stages of flotation on fractionation efficiency, flotations were performed at varied fines contents and flotation stages. Based on the result of multi-stage flotation fractionation it could be said that fines smaller than 15${\mu}{\textrm}{m}$ stabilize flotation froth of OCC. Although the amounts and the fines contents of flotation reject could be increased by multi-stage flotation fractionation of OCC, flotation stages more than 3 times were found to be inefficient in terms of fines concentrating degree. In order to satisfy the both conditions of reducing long fiber loss and of increasing flotation reject, several kinds of fractionating promoters were searched and investigated. And high molecular weight cationic polyacrylamide was chosen as a long fiber flocculating and flotation froth-stabilizing agent.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.47 no.6
• /
• pp.98-105
• /
• 2015

Demands of thermal recording paper have been increased significantly by increase in usage of invoice, fax, and label. Thermal recording paper was mainly made based on virgin fiber. It is necessary to find a suitable alternative to virgin fiber in terms of environment protectional resources conservation. In this paper, deinking properties of different recovered papers were analyzed in order to use the recovered paper as raw material of thermal recording paper. Recovered paper were ONP, OMG and white ledger. Flotation reject of OMG was high because inorganic pigments in coating layer could be removed by upstream of froth. Brightness of white ledger and OMG were much higher than that of ONP. Therefore, properties of pulp made from the recovered paper could be enhanced with increase in blending ratio of white ledger and OMG. However, blending ratio of OMG caused the increase of flotation reject. Consequently, the optimum blending ratio of ONP, OMG, and white ledger was 3:3:3 for eco-friendly thermal recording paper. Under the condition, brightness was about 70% and ERIC was below 300 ppm.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.12
• /
• pp.2458-2467
• /
• 1994

This paper proposes a new design method for obtaining the impulse responses which satisfy the prescribed conditions designing for maximally flat FIR lowpass filters and highpass filters. The bandpass filters and band-reject filters have been directly derived from the addition and subtraction of impulse responses of a lowpass filter and a highpass filter. The two-dimensional maximally flat FIR lowpass filter, highpass filters, bandpass filters and band-reject filters with zero-phase have been designed by transforming the impulses of the one-dimensional filters designed in this research, which do not destroy lines and edges at the image signal processing.

• Information and Communications Magazine
• /
• v.13 no.11
• /
• pp.181-191
• /
• 1996

In this paper we discuss narrow-band interference rejection schemes for spectrum overlay communications where direct sequence spread spectrum (DS/SS) communication system and narrow-band communication systems share the same frequency band. In this case, it is essential to reject the narrow-band signals to guarantee the performance of DS/SS system, while it is not necessarily required to reject the DS/SS signal to recover the narrow-band signal. We discuss several schemes such as time domain processing, frequency domain processing and exploiting the device characteristics to reduce the effect of narrow-band signal on DS/SS communication systems. Furthermore, we suggest a structure of tunable notch filter using gyrator that can easily be customized to ASIC.

• Journal of Power Electronics
• /
• v.13 no.6
• /
• pp.975-984
• /
• 2013

This paper proposes a robust optimal nonlinear control with an observer to reject the offset errors of position tracking for surface mounted permanent magnet synchronous motors. We provide the control method to reject offset errors and load torque for designing field oriented control (FOC) based the alternating current (AC) frame. The proposed method consists of a torque generator, a commutation scheme, an electrical controller, and a load torque observer. The mechanical controller is designed to compensate for load torque and the offset error and generate the desired torque. The commutation scheme is proposed to create the desired currents for the desired torque. The electrical controller is developed to guarantee the desired currents. The observer is designed to estimate both the velocity and the load torque. In order to obtain the robustness to parameter uncertainties and a gain tuning guide, the linear quadratic regulator method is applied to the proposed method. The closed-loop stability is proven. A detailed process for the FOC design and an analysis of the control methods based on the AC frame are presented. The performance of the proposed method was validated via experiments. The proposed method obtains the FOC based on the AC frame. Furthermore, the position tracking performance of the proposed method is superior to that of the conventional method.

• Membrane and Water Treatment
• /
• v.10 no.4
• /
• pp.265-275
• /
• 2019

This study aimed to develop a compact partial nitritation step by forming granules with high Ammonia-Oxidizing Bacteria (AOB) fraction using the Air-lift Granulation Reactor (AGR) and to evaluate the feasibility of treating reject water with high ammonium content by combination with the Anammox process. The partial nitritation using AGR was achieved at high nitrogen loading rate ($2.25{\pm}0.05kg\;N\;m-3\;d^{-1}$). The important factors for successful partial nitritation at high nitrogen loading rate were relatively high pH (7.5~8), resulting in high free ammonia concentration ($1{\sim}10mg\;FA\;L^{-1}$) and highly enriched AOB granules accounting for 25% of the total bacteria population in the reactor. After the establishment of stable partial nitritation, an effluent $NO_2{^-}-N/NH_4{^+}-N$ ratio of $1.2{\pm}0.05$ was achieved, which was then fed into the Anammox reactor. A high nitrogen removal rate of $2.0k\; N\;m^{-3}\;d^{-1}$ was successfully achieved in the Anammox reactor. By controlling the nitrogen loading rate at the partial nitritation using AGR, the influent concentration ratio ($NO_2{^-}-N/NH_4{^+}-N=1.2{\pm}0.05$) required for the Anammox was controlled, thereby minimizing the inhibition effect of residual nitrite.

• Journal of Korean Society for Quality Management
• /
• v.47 no.2
• /
• pp.367-380
• /
• 2019

Purpose: The purpose of this study is (1) to empirically examine why laggards resist IT adoption in public service and (2) to investigate the relationship between resistance and negative behavioral intention. Methods: The questionnaire survey was conducted on expressway users who do not use High-pass system. The collected 232 samples were analyzed using structure equation model method with AMOS 22.0. Results: Resistance is found to be a statistically significant factor affecting intention to reject. Also, incompatibility, privacy concern, status quo inertia and relative advantage are found to be statistically significant factors affecting resistance. Conclusion: Laggards have a tendency to intend to reject IT adoption rather than to postpone. They are affected not by monetary, procedural aspect associated with purchasing or registering OBU(On Board Unit). Incompatibility and relative advantage which are inherent attributes of Hi-pass system are more influential factors than privacy concern and status quo inertia. They make ethical and emotional decision partially affected by public-social factors.