• 한국환경복원기술학회지
• /
• 제11권6호
• /
• pp.81-90
• /
• 2008

Recently, geofiber(polyester) reinforced soil was added on soil-seed mixture spray to control erosion and to improve vegetation growth on rocky slope sites. This research was conducted to compare vegetation effects and soil hardness on three types of soil-seed mixture spray on stone gabion river bank [A type : soil-seed mixture spray underlying 30cm thick sand with geofiber(geofiber reinforced soil system), B type : soil-seed mixture spray underlying 30cm thick sand without geofiber, C type : soil-seed mixture spray]. Evaluation were made concerning vegetation coverage, soil hardness and moisture content. The results of this study showed that A type system was effective for the growth of vegetation and soil hardness when compareed to B type and C type. A type and B type showed higher covering rate than C type on stone gabion river bank, and especially A type showed the highest covering rate. Soil hardness and water content were high on A type vegetation system compared to B type and C type. We noted that high soil hardness and high moisture content with geofiber(geofiber reinforced soil system) were effective both to control erosion from water current impact and to be high coverage and species of vegetation on stone gabion river bank.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2003년도 사면안정학술발표회
• /
• pp.65-81
• /
• 2003

During the last few decades in Korea, the development of hillside or mountain areas has rapidly increased for infrastructure construction such as railroads, highways and housing. Many landslides have occurred during these constructions. Also, the amount and scale of damage caused by landslides have increased every year. In the case of Far East Asia including Korea, the damage of landslides is consequently reported during the wet season. In this paper, the effect of stabilizing piles on slope stability is checked and the behavior of slope soil and piles are observed throughout the year by field measurements in the large-scale cut slopes. In particular a large-scale cut slope situated on the construction site for the express highway in Donghae, Korea. First of all, The behavior of the slope soil was measured by inclinometers during slope modification. Landslides occurred in this area due to the soil cutting for slope modification. The horizontal deformations of slope soil gradually increased and rapidly decreased at depth of sliding surface indicating that the depth of sliding surface below the ground surface can be predicted. On the basis of being able to predict the depth of the sliding surface, stabilizing piles were designed and constructed in this slope. To ensure the stability of the reinforced slope using stabilizing piles, an instrumentation system was installed. The maximum deflection of piles is measured at the pile head and it is noted that the piles deform like deflection on a cantilever beam. The maximum bending stress of piles is measured at the soil layer. The pile above the soil layer is subjected to lateral earth pressure due to driving force of the slope, while pile below soil layer is subjected to subgrade reaction against pile deflection. As a result of research, the effect and applicability of stabilizing piles in large-scale cut slopes could be confirmed sufficiently.

• 한국지반공학회지:지반
• /
• 제12권3호
• /
• pp.127-148
• /
• 1996

최근에 들어 사면이나 사면 근처에 교대등과 같이 기초하중이 비교적 큰 구조물들이 시공되는 예가 점차 많아지는 경 향을 보이고 있다. 그러나 일반적으로 사면 또는 사면 근처 에 설치되는 기초의 경우는 수평지반에 비해 지지력이 현저하게 떨어지기 때문에, 말뚝이나 케이슨 등과 같은 고가의 깊은기초들이 주로 사용되고 있는 실정이다. 따라서 토목섬유 또는 metal strip등의 보강재를 이용하여 사면을 보강하는 경제적인 공법이 필요시 되고,또한 이와같은 공법에 관련된 합리적인 기초지지력 해석법의 제시가 요구되고 있다. 본 연구에서는 사면 근처에 설치되는 얕은 기초의 지지력 보강을 목적으로 strip등의 보강재를 설치할 경우, 'wide slab effect' 개념등 Huang및 Binquet-Lee등이 모형실험등을 통해 제시한 파괴매카니즘 및 Boussinesq해법 등을 토대로 하여 보강사면에 대한 기초지지력 해석법을 제시하였다. 본 해석법에서는 soil dilatancy 등의 영향에 의한 깊이별 보강재-주변흙 사이의 마찰계수 변화를 함수형태로 표현하여 보강재주변흙 사이의 상호작용을 부분적으로 고려하였으며, 아울러 본 연구를 통해 제시된 기초지지력 해석법의 적합성 검토를 위해 Huang등이 제시한 모형실험결과와 서로 비교하였다. 이외에도, 설계에 관련된 여러 변수들이 기초지지력에 미치는 영향에 대해서도 분석이 이루어졌다.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2006년도 춘계 학술발표회 논문집
• /
• pp.724-731
• /
• 2006

The purpose of this study is to estimate a landslide using the SLOPILE program from the slope reinforced by slope stability systems such as soil nailing and pile. To do this, cutting slope located at Donghae-Highway in Kwangwon-Do was considered. The behavior of slope was monitored for a long term by using instrumentation according to the reinforcement stages. The sequence of reinforcement stages was followed as pile installation, boring, soil nailing installation, anchoring and embankment. The result from this case study shows that the safety factor of slope depends on the reinforcement stage more or less.

• Geomechanics and Engineering
• /
• 제34권6호
• /
• pp.623-636
• /
• 2023

This study utilized small-scale physical model tests to investigate the impact of different types of geosynthetics, including geocell, planar geotextile, and wraparound geotextile, on the behaviour of strip footings placed on 0.8 m thick soil fills and backfills with a slope angle of 70°. Bearing capacity and settlement of the footing and failure mechanisms are discussed and evaluated. The results revealed that the bearing capacity of footings situated on both unreinforced and reinforced slopes increased with a greater embedment depth of the footing. For settlement ratios below 4%, the geocell reinforcement exhibited significantly higher stiffness, carrying greater loads and experiencing less settlement compared to the planar and wraparound geotextile reinforcements. However, the performance of geocell reinforcement was influenced by the number and length of the geocell layers. Increasing the geocell back length ratio from 0.44 to 0.84 significantly improved the bearing capacity of the footing located at the crest of the reinforced slope. Adequate reinforcement length, particularly for geocell, enhanced the bearing pressure of the footing and increased the stiffness of the slope, resulting in reduced deflections. Increasing the length of reinforcement also led to improved performance of the footing located on wraparound geotextile reinforced slopes. In all reinforcement cases, reducing the vertical spacing between reinforcement layers from 100 mm to 75 mm allowed the slope to withstand much greater loads.

• 한국지반환경공학회 논문집
• /
• 제11권2호
• /
• pp.53-60
• /
• 2010

절토공사 현장의 경우에는 환경문제 및 대지경계 등의 이유로 원지반의 절취량을 최소화 할 수 있는 공법이 지속적으로 요구되고 있으며, 이를 만족하기 위한 많은 공법들이 적용되고 있는 실정이다. 본 연구에서는 절토사면에 대한 보강토 옹벽의 적용성 확대를 위해 제안한 절토사면 보강토 옹벽의 합리적인 토압산정 방안을 제시하기 위하여 실제 현장에서 측정된 계측자료, 수치해석을 통하여 토압산정 방법을 제안하고자 하였다. 연구결과, Rankine 토압에 비해 보강토 옹벽에 작용하는 토압이 저감된 것을 확인할 수 있었으며, 절토사면 보호공과 보강토 옹벽을 함께 시공하는 경우에는 보강토옹벽 전면에 작용하는 토압을 감소시킬 수 있는 것으로 확인되었다.

• 한국철도학회논문집
• /
• 제9권6호
• /
• pp.753-760
• /
• 2006

This paper presents the procedure and results of the numerical modelling that was carried out to investigate the stability of reinforced soil slopes under dynamic railway load. The two-dimensional explicit dynamic finite element method (ABACUS) was used to carry out the numerical analyses. To simulate the railway load, the top surface of the embankment was excited by the uniform distributed load whose frequency and magnitude was estimated by the measured railway acceleration during train passing. The embankment displacements and geogrid axial forces were analyzed to evaluate the stability of reinforced soil slopes under the dynamic train load.

• 건설안전기술
• /
• 통권47호
• /
• pp.56-62
• /
• 2008

In order to apply the Limit Equilibrium Method generally used for the slope stability analysis to the vertical excavation walls reinforced by soil-nailing, in this study, the Limit Equilibrium Method for the temporary shoring facilities reinforced by soil-nailing was proposed, which is based on the stability for the horizontal displacement. In this study, the relation of the internal friction angles of the ground and the vertical excavation depths was arranged, which is satisfying the stability on the horizontal displacement by using the verification of the Limit Equilibrium Method. And then, the rational reinforcing length of soil-nailing was proposed for the critical areas. In addition, the modified safety ratio satisfying the stability on the horizontal displacement was proposed, when the Limit Equilibrium Method was applied to the vertical excavation walls reinforced by soil-nailing.

• Geomechanics and Engineering
• /
• 제32권5호
• /
• pp.523-540
• /
• 2023

The failure of slope can cause remarkable damage to either human life or infrastructures. Stabilizing piles are widely utilized to reinforce slope as a slip-resistance structure. The workability of pile-stabilized slopes is affected by various parameters. In this study, the performance of earth slope reinforced with piles and the behavior of piles under static load, by shear reduction strength method using the finite difference software (FLAC^3D) has been investigated. Parametric studies were conducted to investigate the role of pile length (L), different pile distances from each other (S/D), pile head conditions (free and fixed head condition), the effect of sand density (loose, medium, and high-density soil) on the pile behavior, and the performance of pile-stabilized slopes. The performance of the stabilized slopes was analyzed by evaluating the factor of safety, lateral displacement and bending moment of piles, and critical slip mechanism. The results depict that as L increased and S/D reduced, the performance of slopes stabilized with pile gets better by raising the soil density. The greater the amount of bending moment at the shallow depths of the pile in the fixed pile head indicates the effect of the inertial force due to the structure on the pile performance.

• 한국산학기술학회논문지
• /
• 제10권10호
• /
• pp.2794-2802
• /
• 2009

Soil Nailing 공법은 사면보강과 지반굴착시 많이 사용되고 있는 공법이다. 일반적인 Soil Nailing의 해석은 복잡한 컴퓨터해석을 필요로 하지만 본 연구에서는 한계평형 해석을 이용하여 단순사면에 Soil Nailing 보강검토시 간편하게 사용할 수 있는 설계도표를 제안하였다. 3가지 사면형태와 네일의 길이비, 입사각을 선택하여 한계평형해석에 근거한 Bishop법과 French Method를 적용하여 해석하였으며 신속한 설계가 요구되는 경우나 예비설계단계, 그리고 설계에 대한 최종 검토시 간편하게 사용할 수 있는 안정도표로 정리하였다. 본 연구에서 제안한 도표를 Taylor의 도표와 비교한 결과 유사한 안전율을 계산할 수 있었으며 Soil Nailing 보강도표를 네일의 길이비와 입사각의 선택시 활용한다면 해석에 따른 시간을 많이 줄일 수 있을 것으로 판단된다.